hood release CHRYSLER TOWN AND COUNTRY 2007 4.G Owners Manual

TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released. First pull
the hood release lever located under the left side of the
instrument panel.
Next, push to the left the safety catch located under the
front edge of the hood, near the center.Use the hood prop rod to secure the hood in the open
position.
To prevent possible damage, do not slam the hood to
close it. Lower the hood until it is open approximately 12
Hood release Lever
Hood Safety Catch
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149
3

Continued operation could result in failure of the univer-
sal joint due to water and dirt contamination of the
grease. This would require complete replacement of the
joint assembly.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors, liftgate, sliding doors and hood hinges,
should be lubricated periodically to assure quiet, easy
operation and to protect against rust and wear. Prior to
the application of any lubricant, the parts concerned
should be wiped clean to remove dust and grit; after
lubricating excess oil and grease should be removed.
Particular attention should also be given to hood latching
components to insure proper function. When performing
other underhood services, the hood latch, release mecha-
nism and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the fall and spring. Apply a smallamount of a high quality lubricant such as MoparLock
Cylinder Lubricant directly into the lock cylinder.
Windshield Wiper Blades
The rubber edges of the wiper blades and the windshield
should be cleaned periodically with a sponge or soft cloth
and a mild nonabrasive cleaner. This will remove accu-
mulations of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
426 MAINTAINING YOUR VEHICLE

Head Phones........................... 266
Head Restraints......................... 122
Headlights............................ 151
Bulb Replacement...................... 452
High Beam/Low Beam Select Switch........ 155
Lights On Reminder.................... 153
Replacing............................ 452
TimeDelay .......................... 153
Heated Seats........................... 122
Heater............................... 276
Heater, Engine Block..................... 310
Hitches
TrailerTowing ........................ 367
HomeLink(Garage Door Opener) Transmitter . . . 175
Hood Release.......................... 149
Hook, Coat............................ 196
Hoses.............................434,438
Ignition............................... 12Key ................................. 12
Ignition Key Removal..................... 12
Illuminated Entry........................ 20
Immobilizer (Sentry Key)................... 15
Indicator, Traction Control................. 217
Infant Restraint........................ 74,75
Information Center...................... 171
Information Center, Vehicle................. 171
Inside Rearview Mirror.................... 94
Instrument Cluster..............207,208,209,210
Instrument Panel and Controls.............. 206
Instrument Panel Lens Cleaning............. 446
Integrated Child Seat...................... 73
Integrated Power Module (Fuses)............ 448
Interior Appearance Care.................. 444
Interior Lights.......................150,151
Intermittent Wipers (Delay Wipers).....157,298,300
Introduction............................. 4
INDEX 493
10