sport mode CHRYSLER TOWN AND COUNTRY 2014 5.G Warranty Booklet

Welcome From FCA US LLC
If you have opened this guide, chances are you have
questions about the correct use of child restraints in your
vehicle. This supplement has been developed to help an-
swer those questions. This document is intended to supple-
ment the information provided in the Owner ’s Manual
and/or User Guide that came with your vehicle. If you no
longer have your Owner ’s Manual or User Guide, please
visit
www.techauthority.com to order a replacement.
This guide does not cover the proper selection of car seats or
the proper usage of car seats. For questions about car seat
selection and usage, please visit NHTSA’s website:
http://
www.safercar.gov/parents/Car-Seat-Safety.htm. This
website also features videos showing step-by-step instal-
lation of different types of car seats.How To Use This Supplement
Section two of this supplement, “Installing Child Re-
straints,” provides general information about the installa-
tion of child restraints in vehicles. It provides step-by-step
instructions for installing a car seat using either the seat
belts or the LATCH anchorages in your vehicle. Read this
section to learn how to:
•Locate LATCH and Tether anchorages in vehicles
•Install a car seat using LATCH
•Install a car seat using seat belts
This section also includes key warnings about the misuse of
car seats. Read and follow all of these warnings when
transporting children in your vehicle.
Section three provides instructions for using the built-in
(integrated) child restraint, if your vehicle is equipped with
one.
Section four provides information that is specific for the
Model Year, Make and Model of your vehicle. To use this
section, first refer to the table of contents to find your
vehicle. Some listings will include a range of model years.
Click on the section for your vehicle to find information
about:
•Locating the LATCH anchorages in your vehicle
•Frequently asked questions about LATCH
•Directions for locating and using the Tether Anchorages
in your vehicle
•Seat belt systems in your vehicle for installing car seats
•Frequently asked questions about seat belts and car seats
Copyright ©2015 FCA US LLC
INTRODUCTION 3

Installing Child Restraints
Children 12 years or younger should ride properly buckled
up in a rear seat, if available. According to crash statistics,
children are safer when properly restrained in the rear seats
rather than in the front.
Every state in the United States and all Canadian provinces
require that small children ride in proper restraint systems.
This is the law, and you can be prosecuted for ignoring it.
NOTE:
For additional information, refer towww.seatcheck.org
or call 1-866-SEATCHECK. Canadian residents should
refer to Transport Canada’s website for additional infor-
mation: http://www.tc.gc.ca/eng/motorvehiclesafety/
safedrivers-childsafety-index-53.htm
Rear-Facing Car Seats And Air Bags
WARNING!
•Never place a rear-facing child restraint in front of an
air bag. A deploying passenger Advanced Front Air
Bag can cause death or serious injury to a child 12
years or younger, including a child in a rear-facing
child restraint.
•Only use a rear-facing child restraint in a vehicle with
a rear seat.
Lower Anchors And Tethers For CHildren (LATCH)
Restraint System
Your vehicle is equipped with the child restraint anchorage
system called LATCH, which stands for Lower Anchors and
Tethers for CHildren. The LATCH system has three vehicle
anchor points for installing LATCH-equipped child seats.
There are two lower anchorages located at the back of the
seat cushion where it meets the seatback and one top tether
anchorage located behind the seating position. These an-
chorages are used to install LATCH-equipped child seats
without using the vehicle’s seat belts. Some seating posi-
tions may have a top tether anchorage but no lower anchor-
ages. In these seating positions, the seat belt must be used
with the top tether anchorage to install the child restraint.
NOTE:The LATCH system was phased into vehicles during
the 2000–2002 model years. Certain 2000 and 2001 model
year vehicles did not feature lower anchorages. These
vehicles had tether anchorages only. See the section
“LATCH and Tethers in Your Vehicle” for more information.
Locating The LATCH And Tether Anchorages
The lower anchorages are round bars that are found at the
rear of the seat cushion where it meets the seat-
back. If the bars are not readily visible, they are
located below the anchorage symbols on the seat-
back (if equipped). You will easily feel them if you
run your finger along the gap between the seat-
back and seat cushion.
There are tether strap anchorages behind the rear
seating positions located on the back of the seat or
near the floor. See the section “LATCH and Teth-
ers in Your Vehicle” for more information about
finding tethers in your vehicle, as not all seating positions
have a tether anchorage and some may be hidden behind a
panel or cover.
Always follow the directions of the child restraint manufac-
turer when installing your child restraint. Not all child
restraint systems will be installed as described here.
Installing Child Restraints Using The LATCH Lower
Anchorages
1. If the selected seating position has a Switchable Auto-
matic Locking Retractor (ALR) seat belt, stow the seat
belt, following the instructions below. See the section
“Seat Belt Systems in Your Vehicle” to check what type of
seat belt each seating position has.
2. Loosen the adjusters on the lower straps and on the
tether strap of the child seat so that you can more easily
attach the hooks or connectors to the vehicle anchorages.
3. Place the child seat between the lower anchorages for
that seating position. For some second row seats, you
may need to recline the seat and/or raise the head
restraint to get a better fit. If the rear seat can be moved
forward and rearward in the vehicle, you may wish to
move it to its rear-most position to make room for the
child seat. You may also move the front seat forward to
allow more room for the child seat.
4. Attach the lower hooks or connectors of the child re-
straint to the lower anchorages in the selected seating
position.
5. If the child restraint has a tether strap, connect it to the
top tether anchorage. See the section “LATCH and Teth-
ers in Your Vehicle” for directions to attach a tether
anchor.
6. Tighten all of the straps as you push the child restraint
rearward and downward into the seat. Remove slack in
the straps according to the child restraint manufacturer ’s
instructions.
7. Test that the child restraint is installed tightly by pulling
back and forth on the child seat at the belt path. It should
not move more than 1 inch (25.4 mm) in any direction.
INSTALLING CHILD RESTRAINTS 5