battery replacement CHRYSLER TOWN AND COUNTRY 2015 5.G Owners Manual

▫Sound Horn With Remote Lock............24
▫Using The Panic Alarm..................25
▫Power Open/Close Power Liftgate — If
Equipped............................26
▫Power Open/Close Left Power Sliding Door — If
Equipped............................26
▫Power Open/Close Right Power Sliding Door —
If Equipped..........................27
▫Turn Off Flash Lights With RKE Lock — If
Equipped............................27
▫Programming Additional Transmitters........28
▫Transmitter Battery Replacement...........28
▫General Information....................30
!REMOTE STARTING SYSTEM — IF EQUIPPED . .31
▫How To Use Remote Start................31
!DOOR LOCKS.........................36
▫Manual Door Locks.....................36
▫Power Door Locks — If Equipped..........38
!KEYLESS ENTER-N-GO™.................40
!WINDOWS...........................45
▫Power Vent Windows — If Equipped........45
▫Power Windows.......................45
!SLIDING SIDE DOOR....................50
▫Power Sliding Side Door — If Equipped......51
▫Sliding Side Door Child Protection Lock......55
!LIFTGATE............................58
▫Power Liftgate — If Equipped.............59
10 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

than 10 seconds. Then, Push and hold the LOCK
button while still holding the UNLOCK button.
3. Release both buttons at the same time.
4. Test the feature while outside of the vehicle by Push-
ing the LOCK/UNLOCK buttons on the RKE trans-
mitter with the ignition switch in the OFF position and
the Key Fob removed.
5. Repeat these steps if you want to return this feature to
its previous setting.
NOTE:Pushing the LOCK button on the RKE transmit-
ter while you are in the vehicle will activate the Vehicle
Security Alarm. Opening a door with the Vehicle Security
Alarm activated will cause the alarm to sound. Push the
UNLOCK button to deactivate the Vehicle Security
Alarm.
Programming Additional Transmitters
If you do not have a programmed RKE transmitter,
contact your authorized dealer for details.
Transmitter Battery Replacement
The recommended replacement battery is one CR2032
battery.
NOTE:
•Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
•Do not touch the battery terminals that are on the back
housing or the printed circuit board.
28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

MAINTAINING YOUR VEHICLE
CONTENTS
!ENGINE COMPARTMENT — 3.6L..........627
!ONBOARD DIAGNOSTIC SYSTEM — OBD II . .628
▫Loose Fuel Filler Cap Message............628
!EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS..........................629
!REPLACEMENT PARTS..................631
!DEALER SERVICE......................631
!MAINTENANCE PROCEDURES...........632
▫Engine Oil..........................632
▫Engine Oil Filter......................635
▫Engine Air Cleaner Filter................635
▫Exhaust System......................636
▫Maintenance-Free Battery...............639
▫Air Conditioner Maintenance.............640
▫Body Lubrication.....................642
▫Windshield Wiper Blades...............643
▫Cooling System......................644
▫Brake System........................651
▫Automatic Transmission................653
7

Your vehicle has a simple ignition actuated test, which you
can use prior to going to the test station. To check if your
vehicle’s OBD II system is ready, you must do the following:
1. Cycle the ignition switch to the ON position, but do
not crank or start the engine.
NOTE:If you crank or start the engine, you will have to
start this test over.
2. As soon as you cycle the ignition switch to the ON
position, you will see the MIL symbol come on as part
of a normal bulb check.
3. Approximately 15 seconds later, one of two things will
happen:
•The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system isnot readyand you should
notproceed to the I/M station.
•The MIL will not flash at all and will remain fully
illuminated until you turn OFF the ignition or start the
engine. This means that your vehicle’s OBD II system
isreadyand you can proceed to the I/M station.
If your OBD II system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
system to update. A recheck with the above test routine
may then indicate that the system isnow ready.
Regardless of whether your vehicle’s OBD II system is
ready or not, if the MIL is illuminated during normal
vehicle operation you should have your vehicle serviced
before going to the I/M station. The I/M station can fail
your vehicle because the MIL is on with the engine
running.
630 MAINTAINING YOUR VEHICLE

Alterations/Modifications, Vehicle...............7
Antenna, Satellite Radio.....................386
Antifreeze (Engine Coolant)..................646
Disposal..............................649
Anti-Lock Warning Light....................326
Appearance Care.........................655
Ashtray................................291
Assistance Towing.........................170
Assist, Hill Start..........................513
Auto Down Power Windows..................47
Automatic Dimming Mirror..................141
Automatic Door Locks......................39
Automatic Headlights......................231
Automatic Temperature Control (ATC)..........457
Automatic Transmission....................484
Adding Fluid..........................654
Fluid and Filter Changes..................654
Fluid Change..........................654
Fluid Level Check.......................654
Fluid Type............................653
Gear Ranges...........................488
Special Additives.......................653
Torque Converter.......................495
Auto Up Power Windows....................48
Battery.................................639
Jump Starting..........................614
Keyless Transmitter Replacement (RKE)........28
Saving Feature (Protection)................239
Belts, Seat...............................128
Body Mechanism Lubrication.................642
B-Pillar Location..........................523
Brake Assist System.......................508
Brake Control System, Electronic..............504
Brake Fluid.............................681
Brake System............................503
Anti-Lock (ABS)........................503
FluidCheck...........................65110
INDEX 703

iPod®/USB/MP3 Control
Bluetooth® Streaming Audio...............190
Jack Location............................596
Jack Operation...........................595
Jump Starting............................614
Key Fob
Arm The Alarm.........................18
Disarm The Alarm.......................19
Programming Additional Key Fobs...........17
Programming Additional Transmitters.........17
Key-In Reminder..........................15
Keyless Enter-N-Go........................40
Keyless Entry System.......................21
Key, Replacement..........................16
Key, Sentry (Immobilizer)....................15
Lane Change Assist........................237
Lap/Shoulder Belts.........................65
Latches................................131
Hood................................229
Lead Free Gasoline........................551
Leaks, Fluid.............................131
Life of Tires.............................537
Liftgate.................................58
Light Bulbs..............................131
Lights.................................131
Airbag................................98
Alarm...............................331
Anti-Lock.............................326
Automatic Headlights....................231
Back-Up..............................676
Battery Saver..........................239
Brake Assist Warning....................511
Brake Warning.........................331
Bulb Replacement.......................671
Center Mounted Stop....................67710
INDEX 711