warning CHRYSLER VOYAGER 2020 Vehicle Warranty
[x] Cancel search | Manufacturer: CHRYSLER, Model Year: 2020, Model line: VOYAGER, Model: CHRYSLER VOYAGER 2020Pages: 270, PDF Size: 3.86 MB
Page 74 of 270

The vehicle or TPMS manufacturer may advise checking the TPMS
regularly to confirm it is in working order. In addition, a new pressure
sensor, certain components, or reprogramming may be necessary when a
tire is serviced. Consult your vehicle owner ’s manual, vehicle manufac-
turer, or a Bridgestone Firestone Run-Flat Certified Retailer for questions
regarding TPMS operation and service.
RUN-FLAT OR LOW TIRE PRESSURE OPERATION
WARNING!
Serious personal injury or death may result from a tire failure or
accident due to improper run-flat or low tire pressure operation.
Read and follow the instructions below, and the other maintenance
and safety recommendations elsewhere in this manual.
General Instructions
The Tire Pressure Monitoring System (TPMS) required in your vehicle
may have different methods of alerting you when your tire has lost
inflation pressure. The international standard for the definition of run-flat
operation is pressure at or below 10 psi (70 kPa); however, some vehicle
manufacturers may have established a different pressure limit. Consult
your vehicle owner ’s manual for the details of your TPMS. Once the
TPMS has indicated that a tire has reduced inflation pressure, the run-flat
mode of operation has commenced. During this phase of operation,
please follow these instructions:
• Reduce speed as much as safely and reasonably possible; do not
exceed 50 mph (80 km/h).The greater the speed, the less distance the
tire can travel.
• Avoid abrupt or aggressive acceleration, braking, or cornering ma-
neuvers as much as safely and reasonably possible. Pot holes and
other road hazards should be avoided. Careful driving limits potential
damage to the tire, wheel, and vehicle.
• Proceed to a safe and convenient location for tire service as soon as
possible. Take note of your mileage; your operation distance is limited.
See Distance—How Far You Can Drive,” the next section in this
manual.
BRIDGESTONE® - FIRESTONE®
73
Page 80 of 270

Ply Composition and Materials:The actual number of plies in the
sidewall and tread area and the generic name(s) of their cord material(s)
are marked on at least one sidewall. For example:
• TREAD 2 PLY POLYESTER + 2 STEEL
• SIDEWALL 2 PLY POLYESTER
Radial: Radial ply tires will have the word radialon at least one
sidewall. An “R” in the tire size designation also indicates radial ply
construction.
Tubeless or Tube Type: Tires are marked as either “tubeless” or “tube
type,” whichever is applicable, on at least one sidewall.
UNIFORM TIRE QUALITY GRADING
The Uniform Tire Quality Grading (“UTQG”) standards are intended to
assist you in making an informed choice in your purchase of passenger
car tires by providing information indicating relative performance of
these tires in the areas of tread wear, wet braking traction (straight-
ahead), and temperature resistance. All passenger car tires must conform
to federal safety requirements in addition to these grades.
Treadwear
The treadwear grade is a comparative rating based on the wear rate of the
tire when tested under controlled conditions on a specified government
test course. For example, a tire graded 150 would wear one and one half
(1 1/2) times as well on the government course as a tire graded 100. The
relative performance of tires depends upon the actual conditions of their
use, however, and may depart significantly from the norm due to
variation in driving habits, service practices and differences in road
characteristics and climate.
Traction
The traction grades, from highest to lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to stop on wet pavement as measured
under controlled conditions on specified government test surfaces of
asphalt and concrete. Warning: The traction grade assigned to a tire is
based on straight-ahead braking traction tests, and does not include
acceleration, cornering, hydroplaning, or peak traction characteristics.
BRIDGESTONE® - FIRESTONE®
79
Page 81 of 270

Temperature
The temperature grades are A (the highest), B, and C, representing the
tire’s resistance to the generation of heat and its ability to dissipate heat
when tested under controlled conditions on a specified indoor laboratory
test wheel. Sustained high temperature can cause the material of the tire
to degenerate and reduce tire life, and excessive temperature can lead to
sudden tire failure. The grade C corresponds to a level of performance
which all passenger car tires must meet under the Federal Motor Vehicle
Safety Standard No.109. Grades B and A represent higher levels of
performance on the laboratory test wheel than the minimum required by
law.
WARNING!
The temperature grade is established for a tire that is properly
inflated and not overloaded. Excessive speed, underinflation, or
excessive loading, either separately or in combination, can cause
heat buildup and a possible tire failure.
BRIDGESTONE® - FIRESTONE®80
Page 83 of 270

B.Improper use or operation, including, without limitation: Im-
proper inflation pressure, overloading, tire/wheel spinning, use of
an improper wheel, tire chain damage, misuse, misapplication,
negligence, tire alteration, or for racing or competition purposes.
C. Insufficient or improper maintenance, including, without limita-
tion: Failure to rotate tires as recommended in this manual, wheel
misalignment, worn suspension components, improper tire mount-
ing or demounting, tire/wheel assembly imbalance, or other
vehicle conditions, defects, or characteristics.
D. Contamination or degradation by petroleum products or other
chemicals, fire or other externally generated heat, or water or other
material trapped inside the tire during mounting or inflation.
E. Improper repair. Improper repair voids this Limited Warranty
F. For RFT tires only, improper run-flat or low tire pressure opera-
tion, including, without limitation: Exceeding speed, distance, or
other run-flat/lowpressure operation limitations.
2. Rapid tread wear or wear-out. Original equipment tires have no mileage warranty.
3. Weather/ozone cracking after 4 years from date of tire manufacture.
4. Ride disturbance or vibration after 1/32 inch (0.8mm) of tread wear use.
5. Tires with sealant, balance, or other filler material that was not originally applied or inserted by the tire manufacturer.
6. Tires used in commercial service.
7. Tires purchased and normally used outside the United States and Canada.
8. The cost of applicable federal, state, and local taxes.
9. Failure to follow any of the safety and maintenance recommendations or warnings contained in this manual.
This Limited Warranty is in addition to and/or may be limited by any
other applicable written warranty you may have received concerning
special tires or situations.
BRIDGESTONE® - FIRESTONE®
82