tow Citroen BERLINGO 2014.5 2.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2014.5, Model line: BERLINGO, Model: Citroen BERLINGO 2014.5 2.GPages: 244, PDF Size: 9.96 MB
Page 5 of 244
3
corresponds to
a left hand drive
vehicle.corresponds to
a
right hand drive
vehicle.
10.
TECHNOLOGY on
BOARD
6.
107-1
10
ACCESSORIES
7.
111-128
CHECKS
8.
129-149
QUICK HELP
Emergency
or assistance 10.1
eMyW
ay
10.3
Audio system
10.59
T
owing a trailer
107
Other accessories
109 T
rade range
T
elematic unit
Opening the bonnet
1
12
Petrol engine
1
13
Diesel engine
1
14
Levels
1
15
Checks
1
17
Fuel
1
19
Fuel cut-off
120
Diesel priming pump
120
AdBlue® additive and
SCR system
(
b
lueH d i d iesel)
121Battery
129
Changing a wheel
131
Removable
snow screen
135
Snow chains
136
Changing a bulb
137 a fuse
142 a wiper blade
146
Being towed
147
Precautions
148
9.
150-156
TECHNICAL
DATA
Dimensions 150
Engines 155
W
eights
155
Identification markings
156The "T
echnology on board"
section presents the new
audio/navigation systems.
Contents
CONTENTS
Page 8 of 244
6Rear view mirror 83
Front courtesy lamp 76
Changing courtesy lamp bulbs
1
39
Spare wheel, jack, changing a wheel, tools
131-135
Snow chains
136 Front, lateral airbags
94-97
Passenger's airbag
deactivation
97, 100
Battery
, recharging, starting
129
Opening the bonnet
1
12
Towing, towbar, coachbuilders, floor cab fuses
144
Front seats, adjustments, head
restraint
69-70
Extenso Cab
71-72
Seat, bench configurations
73
Seat belts
92-93
Accessories
109-1
10
INTERIOR
Rear courtesy lamp 76
Changing courtesy
lamp bulbs
139
Load space
79-81
-
stowing rings,
-
load retainer
,
-
trim,
-
12 volt socket,
-
ladder separation or partition,
-
removable flap. Child seats
98-106
Parking brake, handbrake
85
T
owing, lifting
147
T
owbar
107-108
T
owed loads
155
Location
Page 9 of 244
7
INTERIOR
Rear view mirror 83
Front courtesy lamp 76
Changing courtesy lamp bulbs
1
39
Spare wheel, jack, changing a wheel, tools
131-135
Snow chains
136 Front, lateral airbags
94-97
Passenger's front airbag deactivation
97, 100
Battery
, recharging, starting
129
Child seats
98-106
Parking brake, handbrake
85 Front seats, adjustments,
head restraint
69-70
Extenso Cab
71-72
Seat, bench configurations
73
Seat belts
92-93
T
owing, lifting
147
T
owbar
107-108
T
owed loads
155
Rear courtesy lamp
76
Changing courtesy lamp bulbs
1
39
Load space
79-81
-
stowing rings,
-
load stop,
-
trim,
-
12 volt socket,
-
ladder separation or partition,
-
removable flap.
Opening the bonnet
1
12
Accessories
109-1
10
Towing, towbar, coachbuilders,
floor cab fuses
144
1
OVERVIEW
Location
Page 18 of 244
16Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2
emissions.
ECO-DRIVING
Optimise the use of your gearbox
With a manual gearbox, move off gently and change up
without waiting. During acceleration change up early.
With an automatic or electronic gearbox, give preference
to automatic mode and avoid pressing the accelerator
pedal heavily or suddenly.
The gear shift indicator invites you engage the most
suitable gear: as soon as the indication is displayed in the
instrument panel, follow it straight away.
For vehicles fitted with an electronic or automatic gearbox,
this indicator appears only in manual mode.
Drive smoothly
Maintain a safe distance between vehicles, use engine
braking rather than the brake pedal, and press the
accelerator progressively. These practices contribute
towards a reduction in fuel consumption and CO
2
emissions and also helps reduce the background traffic
noise.
If your vehicle has cruise control, make use of the system
at speeds above 25 mph (40 km/h) when the traffic is
flowing well.
Control the use of your electrical equipment
Before moving off, if the passenger compartment is too
warm, ventilate it by opening the windows and air vents
before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the
air vents open.
Remember to make use of equipment that can help keep
the temperature in the passenger compartment down
(sunroof and window blinds...).
Switch off the air conditioning, unless it has automatic
regulation, as soon as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not
automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the
level of light does not require their use.
Avoid running the engine before moving off, particularly in
winter; your vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia
devices (film, music, video game...), you will contribute
towards limiting the consumption of electrical energy, and
so of fuel.
Disconnect your portable devices before leaving the vehicle.
Motoring & Environment
Page 24 of 244
22
Berlingo-2-VU_en_Chap03_Pret-a-partir_ed02-2014
From the inside
Unlock and open the side door using
this handle, guiding the rearward
sliding to the point of resistance. Pass
this point to hold the door open.
Good practice
Take care not to block the guide space
on the floor to allow the door to slide
correctly.
If your vehicle is parked on a slope,
guide the sliding of the side door. In
fact, the door could open or close more
rapidly due to the slope of the ground
and could cause injury.
For safety and operation reasons, do
not drive with the sliding side door
open.
SLIDING SIDE DOOR
From the outside
Pull the handle towards you then
towards the rear and open the side
door, guiding the rearward sliding to
beyond the point of resistance to hold
it open.
Operation in the event of a
battery failure
Front and side passenger doors
In the event of a battery or of the
central locking fault, use the lock to
lock the doors mechanically.
-
T
o open the door and get out of the
vehicle, pull the interior control.
-
T
o lock the door, insert the key in
the lock, located on the edge of the
door, then turn it one eighth of a
turn.
Driver's door
-
Insert the key in the lock, then turn
it to the right to lock or to the left to
unlock.
access
Page 25 of 244
23
Berlingo-2-VU_en_Chap03_Pret-a-partir_ed02-2014
In practice
It is possible to drive with the right-
hand door open to make it easier to
carry long loads. The left-hand door is
kept closed by the distinctive "yellow"
lock, positioned at the base of the door.
This closed door must not be used as
a load retainer.
Driving with the right-hand door open
is a special dispensation. Comply with
the usual safety indications to warn
other drivers.
HINGED REAR DOORS
From outside
Pull the lever to open the right-hand
door.
To close, start with the right-hand door
then close the left-hand door.
To open, pull the handle towards you. The hinged rear doors are
asymmetrical (2/3 - 1/3), with the
smaller door on the right.
They are fitted with a central lock. With the roof rear flap, the rear
bumper has been reinforced to
serve as a footrest when entering
the vehicle.
Access
READY TO GO
3
Page 26 of 244
24
Berlingo-2-VU_en_Chap03_Pret-a-partir_ed02-2014
From inside
When present on the vehicle, pulling
this handle towards you opens the
left-hand door.
Opening to approximately 180°
A check strap system permits
extension of the opening from
approximately 90° to approximately
180°.
Pull the yellow control when the door
is open.
The check strap will engage again
automatically on closing.When parked with the
rear doors open to 90°,
the doors mask the rear
lamps. To signal your
position to other road
users driving in the same
direction who may not
have seen your vehicle,
use a warning triangle
or other device required
by the legislation in your
country.
Access
Page 38 of 244
36
Berlingo-2-VU_en_Chap03_Pret-a-partir_ed02-2014
Warning lamp isindicatesSolution - action
Dipped beam
headlamps
/
Daytime
running lams on.a manual selection or
automatic illumination of
headlamps.
Turn the ring on the lighting control stalk to the
second position.
illumination of the dipped beam headlamps
from the time the ignition is switched on:
daytime running lamps (depending on the
country in which the vehicle is sold).
Chapter 4, "Steering mounted controls" section.
Main beam
headlamps pulling of the stalk towards
you.Pull the stalk to return to dipped beam
headlamps.
Direction
indicators flashing with
audible signal.a change of direction via
the lighting stalk. To the Right: control to be pushed upwards.
To the Left: control to be pushed downwards.
Front
foglamps on.
a manual selection. The foglamps only operate if the sidelamps or
dipped beam headlamps are on.
Rear
foglamps on.
a manual selection. The foglamps only operate if the sidelamps or
dipped beam headlamps are on. In conditions of
normal visibility, switch them off to avoid breaking
the law. "This lamp is a dazzling red."
Instruments and controls
Page 54 of 244
52
Berlingo-2-VU_en_Chap04_Ergonomie_ed02-2014
DIRECTION INDICATORS
"Motorway" function
Press the control up or down to flash
the corresponding direction indicator
three times.
LIGHTING CONTROL
Left: downwards passing the
point of resistance.
Right: upwards passing the
point of resistance.
Front and rear lighting
Lighting off
Automatic illumination of
headlamps
SidelampsDipped beam (green)
Main beam (blue)
Dipped beam/main beam change
Pull the stalk fully towards you.
Lighting-on audible warning
On switching off the ignition, all of the
lamps turn off, except dipped beam if
automatic guide-me-home lighting has
been activated.
To activate the lighting control, turn
ring
A to the lighting off position "0"
then to the selection of your choice.
On opening the driver's door, there is
an audible warning if you have left the
lighting on.
Checking by means of the
indicator lamps in the instrument
panel is described in the
"Instruments and controls" section of
chapter 3.
Direction indicatorsSelection is by turning ring A.
Steering mounted controls
Page 58 of 244
56
Berlingo-2-VU_en_Chap04_Ergonomie_ed02-2014
Screenwash and headlamp wash
Pull the stalk towards you, the wash-
wipe is accompanied by a timed sweep
of the wipers.
The headlamp wash is linked with the
wash-wipe, it is triggered if the dipped
headlamps are on.Turn the ring past the first
position: the rear screenwash
then the rear wiper operates
for a fixed time.
In winter, in the event of a
considerable amount of snow
or ice, switch on the heated
rear screen. Once the screen is
clear, remove the snow or ice which
has accumulated on the rear wiper
blade. You can then operate the rear
windscreen wiper.
To top up the levels, refer to the
"Levels" section of chapter 7.
Special position of the
windscreen wipers
Refer to the "Changing a
windscreen wiper blade" section of
chapter 8.
To park the wipers in their normal
position after this has been done,
switch on the ignition and move the
stalk. Turn the ring to the first
position.
Rear screenwash
Rear wiper
In the minute following switching
off of the ignition, any action on
the stalk positions the wipers
against the windscreen uprights.
This action enables you to position
the wiper blades for winter parking,
cleaning or replacement.
Steering mounted controls