Lights Citroen BERLINGO 2017 2.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2017, Model line: BERLINGO, Model: Citroen BERLINGO 2017 2.GPages: 292, PDF Size: 10.19 MB
Page 55 of 292

53
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
STOP & START
The Stop & Start system puts the 
engine temporarily on standby - ST OP 
mode
  -   during   stops   in   the   traffic   (red  
lights,
  traffic   jams,   or   other...).
The engine restarts automatically - 
START mode - as soon as you want to 
move
  off.
The
  restart   takes   place   instantly,  
quickly
  and   silently.
Perfect for urban use, the Stop & Start 
system reduces fuel consumption and 
exhaust emissions as well as the noise 
level
  when   stationary.
Operation
Going into engine STOP modeThe "ECO" warning lamp 
comes on in the instrument 
panel and the engine goes 
into
  standby:
-
 
with a manual gearbox
 , at speeds 
below
  12   mph   (20   km/h),   when   you  
put the gear lever into neutral and 
release the clutch pedal,
-
 
with a 6-speed electronic 
gearbox
, at speeds below 5 mph 
(8
  km/h),   when   you   press   the   brake  
pedal or put the gear lever into 
position 
N. If
  your   vehicle   is   fitted   with   the   system,  
a time counter calculates the sum of 
the periods in ST
OP mode during a 
journey.   It   rests   itself   to   zero   every   time  
the
  ignition   is   switched   on   with   the   key.
With a 6-speed electronic 
gearbox, for your comfort during 
parking   manoeuvres,   STOP
 
 mode  
is not available for a few seconds after 
coming
  out   of   reverse   gear.
STOP mode does not affect the 
functionality of the vehicle, such as 
braking,   power   steering,   for   example.
Never refuel with the engine in 
STOP mode; you must switch off 
the   ignition   with   the   key.Special cases: STOP mode 
unavailable
STOP
 
mode   is   not   invoked   when:
-  
the vehicle is on a steep slope 
(rising or fallin
g),
-  
the driver's door is open,
-
  
the driver's seat belt is not 
fastened,
-
  
the vehicle has not exceeded 
  
6   mph   (10   km/h)   since   the   last  
engine
  start   using   the   key,
-  
the engine is needed to maintain 
a comfortable temperature in the 
passenger compartment,
-
  
demisting is on,
-
  
some special conditions (battery 
charge, engine temperature, 
braking
  assistance,   ambient  temperature...)
  where   the   engine  is needed to assure control of a 
system.
In this case, the 
"ECO" 
warning
  lamp   flashes   for   a  
few
  seconds,   then   goes   off.
This operation is perfectly normal. 
READY TO GO
3 
Stop & Start