display Citroen BERLINGO FIRST 2012 1.G Owner's Guide

11 3 AUDIO
-

RADIO SOURCE

Adjusting the front/rear sound
distribution (Fader)
When "FAD"
is displayed, press but-
ton I
or J
.
Button I
increases the volume in the
front.
Button J
increases the volume in the
rear.

Adjusting the right/left sound
distribution (Balance)
When "BAL"
is displayed, press but-
ton I
or J
.
Button I
increases the volume on the
right-hand side.
Button J
increases the volume on the
left-hand side.

Automatic volume correction
This function enables the volume to
be automatically adjusted depending
on the level of noise produced by the
speed of the vehicle.
Press buttons I
or J
to switch the
function on or off.

Selecting radio mode
Press button R
.

Radio reception
Your car radio is subject to phenom-
ena which do not affect domestic ra-
dio sets. Both AM (MW/LW) and FM
reception are subject to various forms
of interference. This is no refl ection on
the quality of the equipment, but is due
to the nature of the signals and the way
in which they are transmitted.
On MW/LW, interference may be no-
ticed when passing under high voltage
power lines or bridges, or in tunnels.
On FM, interference may be the result
of increasing distance from the trans-
mitter, defl ection of the signals by ob-
stacles (mountains, hills, buildings,
etc.), or of being in an area which is
not covered by a transmitter.
Selecting a waveband
Briefl y press button R
to select the FM1,
FM2, FMast and AM wavebands.

AUDIO
11 4 -
Briefl y press button L
or N
to search
for the station immediately above or
below. By continuing to press the
button in the direction selected, you
will obtain continuous scrolling of the
frequency.
The scrolling stops at the fi rst sta-
tion found as soon as the button is
released.
If the TA
traffi c information pro-
gramme is selected, only stations
broadcasting this type of programme
are selected.
Searching for a station occurs fi rst in
"LO"
sensitivity (selection of the most
powerful transmitters) during scan-
ning of the waveband, then in "DX"

sensitivity (selection of the weakest
and most distant transmitters).
To make a direct search in "DX"
sen-
sitivity, press button L
or N
twice.
Manual station search
Press the "MAN"
button.
Briefl y press button L
or N
to in-
crease or decrease the frequency
displayed.
By continuing to press the button in
the direction selected, you will obtain
continuous scrolling of the frequency.
The scrolling stops at the fi rst sta-
tion found as soon as the button is
released.
Pressing the "MAN"
button again
returns you to automatic station
search.

Manual presetting of stations
Select the station required.
Press one of the buttons "1"
to "6"

for more than two seconds.
The sound stops then becomes audi-
ble again, confi rming that the station
has been stored in the memory.
Automatic station search
Automatic presetting of FM
stations (autostore)
Press and hold button R
for
more than two seconds.
Your radio automatically presets the
6 stations with the strongest signal in
FM
. These stations are stored in the
FMast waveband.
If it is not possible to fi nd 6 stations,
the remaining preset positions are
empty.

Recalling preset stations
For each waveband, briefl y press
buttons "1"
to "6"
to recall the cor-
responding station.

AUDIO
11 6 -

EON system
This connects stations which are part
of the same network. It enables the
broadcast of traffi c information, by a
station that is part of the same net-
work as the station to which you are
listening.
This service is available when you
have selected the TA
traffi c informa-
tion programme or the PTY
function.

PTY function

This allows you to listen to stations broad-
casting a specifi c type of programme
(news, culture, sport, rock, etc.).
To search for a PTY
programme:
With FM
selected,
press the "TA"
but-
ton for more than two
seconds to switch this
function on or off.

- select the PTY
function,

- briefl y press button L
or N
to
scroll down the list of the various
types of programmes offered.

- when the programme of your
choice is displayed, keep button
L
or N
pressed for more than two
seconds to carry out an automatic
search (after an automatic search
the PTY
function is switched off).
In PTY
mode the different types of
programmes can be stored in the
memory. To do this, press the pre-
set buttons "1"
to "6"
for more than
two seconds. Briefl y press the corre-
sponding button to recall the type of
programme stored in the memory.

VISUAL INDEX120 -

INSTRUMENTS AND CONTROLS

Overhead storage, sun visor,
courtesy lamp ................14, 58-59
Rear view mirror ......................... 57
Instrument panel, dials,
speedometer ............................ 20
Warning lamps,
indicator lamps ....................21-23
Indicators, displays, screen ...23-27
Setting the time, dimmer,
resetting to zero ..................25-27
Interior fuses ..........................88-90
Parking brake, handbrake .... 64, 78
Front fi ttings ...........................58-59 Electric windows ......................... 56
Hazard warning lamps ................ 60
Audio system ..................... 110-117
Fitting an audio system,
speakers ................................... 93
Heating/
Air conditioning ........ 28-31, 32-33


- vent, demisting, defrosting

- air conditioning A/C,

- air recirculation,

- ventilation.
Opening the bonnet .............. 16, 53