coolant Citroen BERLINGO MULTISPACE RHD 2014.5 2.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2014.5, Model line: BERLINGO MULTISPACE RHD, Model: Citroen BERLINGO MULTISPACE RHD 2014.5 2.GPages: 276, PDF Size: 12.15 MB
Page 144 of 276

Berlingo_2_VP_en_Chap07_Verification_ed02-2014
142
dIESEL EnGInE
4. Brake and  clutch  fluid  reservoir.
5. Â
Air
 filter.
6.
Â
Engine
 oil  dipstick. 7.
 Engine  oil  filler  cap.
8. Â
Power
 steering  fluid  reservoir.
9.
Â
Priming
 pump.
1.
 Screenwash
Â
reservoir.
2.
Â
Fusebox.
3.
Â
Engine
Â
coolant
Â
header
Â
tank.
Battery
 connections:
+
 Positive  terminal.
-
 Negative  point  (earth).
Take
Â
care
Â
when
Â
working
Â
under
Â
the
Â
bonnet.
Under the bonnet
Page 146 of 276

Berlingo_2_VP_en_Chap07_Verification_ed02-2014
144
cooling system
Only use the fluid recommended by the manufacturer.
Otherwise,
 you  risk  seriously  damaging Â
your
 engine.
When
 the  engine  is  warm,  the Â
temperature
 of  the  coolant  is  controlled Â
by
 the  engine  fan. Â
As
 this  fan  can Â
operate
 with  the  ignition  key  removed Â
and
 because  the  cooling  system  is Â
pressurised, wait for at least one hour
after the engine has stopped before
carrying
 out  any  work.
Slacken
 the  cap  by  1/4  of  a  turn  to Â
release the pressure to prevent any
risk
 of  scalding.  When  the  pressure Â
has
 dropped,  remove  the  cap  and  top Â
up
 the  level  with  coolant.
If
 fluid  has  to  be  added  frequently, Â
this
 indicates  a  fault  which  must  be Â
checked
 by  a  CITROËN  dealer  as Â
soon
 as  possible.
Power steering fluid level
The vehicle must be parked on level ground with  the  engine  cold.  Unscrew Â
the cap integrated with the gauge and
check
 the  level  which  must  be  between Â
the
 MIN  and  MAX  marks. In
 order  to  regenerate  the  filter,  you  are advised to drive at a speed higher
than
 40  mph  (60  km/h)  for  at  least  five  minutes
 as  soon  as  possible,  when Â
traffic
 conditions  permit  (until  the Â
message
 disappears  and  the  service Â
warning
 lamp  goes  off).
d
uring regeneration of the particle
emission
 filter,  the  noise  of  a  relay Â
operating
 may  be  heard  under  the Â
dashboard.
If
 the  message  is  still  displayed  and Â
if
 the  service  warning  lamp  remains Â
on, contact a CITR
o Ë n dealer or a
qualified
 workshop.
topping up
The
Â
level
Â
must
Â
be
Â
between
Â
the
Â
MIN
Â
and
Â
MAX
Â
marks
Â
on
Â
the
Â
expansion
Â
bottle.
Â
If
Â
more
Â
than
Â
1
Â
litre
Â
of
Â
fluid
Â
is
Â
required
Â
to
Â
top
Â
up
Â
the
Â
level,
Â
have
Â
the
Â
system
Â
checked
Â
by
Â
a
Â
CITROËN
Â
dealer
Â
or
Â
a
Â
qualified
Â
workshop.
Screenwash and headlamp
wash level
For best quality cleaning and for your safety , we would advise that you use
products
 of  the  CITROËN  range.
For
 optimum  cleaning  and  to  avoid Â
freezing,
 this  fluid  must  not  be  topped Â
up
 or  replaced  with  plain  water.
Capacity
 of  the  screenwash  reservoir: Â
approximately
 3  litres.
If
 your  vehicle  is  fitted  with  headlamp Â
washers, the capacity of the reservoir
is
 6  litres.
diesel additive level
( d iesel with particle
emission filter)
topping up
This  additive  must  be  topped  up  by Â
a
 CITROËN  dealer  or  a  qualified Â
workshop
 without  delay.
Waste products
avoid prolonged contact of used oil
with  the  skin.
Brake
 fluid  is  harmful  to  health  and Â
very
 corrosive.
Do
 not  dispose  of  used  oil,  brake  fluid Â
or coolant into drains or into the ground
but into the containers dedicated to this
use at a CITR
o Ë n dealer (France) or
an
 authorised  waste  disposal  site.
The
Â
minimum
Â
level
Â
of
Â
this
Â
additive
Â
is indicated by lighting of the service
warning
Â
lamp,
Â
accompanied
Â
by
Â
an
Â
audible
Â
signal
Â
and
Â
a
Â
message
Â
in
Â
the
Â
screen.
When this occurs with the engine
running it is due to the start of
saturation
Â
of
Â
the
Â
particle
Â
emission
Â
filter
Â
(exceptionally prolonged urban type
driving
Â
conditions:
Â
low
Â
speed,
Â
long
Â
traffic
Â
jams,
Â
...).
Levels