towing Citroen BERLINGO MULTISPACE RHD 2017 2.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2017, Model line: BERLINGO MULTISPACE RHD, Model: Citroen BERLINGO MULTISPACE RHD 2017 2.GPages: 292, PDF Size: 10.19 MB
Page 153 of 292

151
Berlingo2VP_en_Chap06_Accessoire_ed02-2016
During use
Never unlock the device when
a
trailer or load carrier is fitted to the
swan
neck.
After use
For
journeys
made
without
a
trailer
or
load carrier, the swan neck must
be
removed and the blanking plug
inserted
in the carrier.
This
measure
applies
particularly if the swan neck
could hinder visibility of the number
plate
or lighting.Removal
Maintenance
Correct operation is only possible if the
swan neck and its carrier remain clean.
Before cleaning the vehicle with a high
pressure
jet wash, the swan neck must
be
removed and the blanking plug
inserted
in the carrier.
Towing a trailer
ACCESSORIES
6
Page 175 of 292

173
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
1. Parking the vehicle
- The occupants must get out of the
vehicle and wait in a safe location.
-
If
possible, park the vehicle on
level, stable and non-slippery
ground.
-
Apply
the parking brake, switch
of
f the ignition and engage first or
reverse
gear. -
Place
a chock under the wheel
diagonally opposite the one to be
changed.CHANGING A WHEEL
under the passenger footwell behind
the
driver's seat.
-
If necessary
, move the seat forward
to access the storage compartment
from
the rear.
-
Remove
the flap then take out the
jack
and the tool carrier.
-
Remove the tools needed from the
carrier
.
1.
Jack.
2.
Wheelbrace.
3.
Chock.
4.
Spanner for the Modutop roof bars
and
rear lamps.
5.
Alloy
wheel trim removal tool.
6.
T
owing eye.
If
the
vehicle
is
fitted
with
a
towbar,
it is sometimes necessary to raise
the
vehicle
slightly
to
make
it
easier
to remove the spare wheel from its
carrier
.
2. Tools
The tools are stowed in a storage area
closed by a flap under a front seat.
However, if the vehicle is not equipped
with a spare wheel, the towing eye is
located in the storage compartment On certain types of ground and/
or if considerable loads are being
transported, call a CITROËN dealer or
a qualified workshop.
The jack and tools are specific to your
vehicle.
Do not use them for other
purposes.
QUICK HELP
8
Changing a wheel
Page 181 of 292

179
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
REMOVABLE SNOW SCREEN
(
BLANKING COVER )
According to country, the removable
snow screen is installed on the lower
part of the front bumper to prevent the
accumulation of snow at the radiator
cooling
fan.
Fitting Removal
- Offer up the snow screen facing its
centring pin A on the front bumper.
-
Put it in place by pressing at each
clip
B located in the four corners.
Do not forget to remove the
snow screen when the exterior
temperature is higher than 10°C
(no
risk
of
snowfall)
and
when
towing. -
Pass a screwdriver into the hole
located
near each of the clips.
-
Use the screwdriver as a lever to
unclip the four clips
B in turn.
QUICK HELP
8
Snow screen
Page 194 of 292

192
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
Without lifting (4 wheels on the
road)
You should always use a towing arm.
BEING TOWED
This procedure involves the use of
the towing eye supplied with the tools
for
changing a wheel.
From the front
- Unclip the cover by pressing the
bottom part.
-
Fully screw in the removable
towing eye.
From the rear
- Unclip the cover using a coin or the
flat part of the towing eye,
-
Fully screw in the removable
towing eye. When towing with the engine
switched
off, there is no braking or
steering
assistance.
Lifting (only 2 wheels on the
road)
It is preferable to raise the vehicle
using
professional lifting equipment.Vehicles fitted with a manual
gearbox (Diesel version)
In
the case of vehicles fitted with
a manual gearbox, the gear lever
must be in neutral, failure to observe
this special condition may result in
damage
to transmission and braking
components and the absence of
braking
assistance when the engine is
started
again.
Section
8,
"Changing
a
wheel".
Having your vehicle towed
Page 199 of 292

197
Berlingo2VP_en_Chap09_Caract-technique_ed02-2016Berlingo2VP_en_Chap09_Caract-technique_ed02-2016
ENGINE CHARACTERISTICS
The engine characteristics (capacity,
maximum power, maximum power
speed, fuel, CO
2 emissions...) for your vehicle are given in the registration
certificate.
These characteristics correspond
to the values type-approved
on a test bed, under conditions
defined
in
European legislation
(Directive 1999/99/EC).
For more information, refer to the
manufacturer's website or sales
brochure
for
the
model. Contact
a
CITROËN
dealer or a qualified
workshop.
WEIGHTS AND TOWED LOADS
These values, expressed in kg, can be found on the manufacturer's VIN plate
or
label.
The maximum weights and towed
loads for your vehicle can be found on
the
vehicle's registration certificate.
The
kerb weight is equal to the weight
without
load + driver (75 kg) + fuel tank
filled
to 90%.
The GTW and towed load values
indicated are valid up to a maximum
altitude
of 1000 metres.
The
value of
the towed load mentioned must be
reduced by 10 % for each additional
1000
metres.
With
load transfer, the braked trailer
weight can be increased, on condition
that the equivalent of this load is
removed from the vehicle so that the
GTW
is not exceeded. High ambient temperatures
may result in a reduction in the
performance of the vehicle in
order
to protect the engine. When the
ambient temperature is higher than
37 °C,
limit the towed weight.
Towing with a lightly loaded
vehicle can adversely affect road
holding.
Towing
a trailer increases braking
distances.
When towing, the maximum permitted
speed is reduced (comply with the
legislation
in force in the country).
The recommended nose weight is
the downward force on the towball
(removable
with or without tools).
GVW: gross vehicle weight, the
maximum
authorised weight.
GTW: gross train weight, the maximum
weight
for vehicle plus trailer.
The location of the manufacturer's
plate is given in chapter 9,
"Identification
markings" section.
In each country, it is imperative that
the maximum towed loads authorised
by local legislation are complied
with.
T
o find out your vehicle's towing
capacities and its gross train weight,
consult
a CITROËN dealer.
TECHNICAL DATA
9
Weights