ignition Citroen C CROSSER 2011 1.G Owner's Manual

10
FAMILIARI
S
AT I
ON

INSTRUMENTS AND CONTROLS
1.
Steering lock and ignition.
2.
Door mirror controls.
Electric window and rear electric
window deactivation controls.
3. Lighting and direction indicator control stalk. Headlamp wash control.
4.
Central adjustable air vents.
5
. Sunshine sensor.
6
. Cooled upper glove box.
7
. Lockable lower glove box.
Passenger’s airbag deactivation.
F
usebox.
8. Heated seat controls.
9.
Armrest with storage compartments.
12 volt socket
(120 W max).
10. Cup holder.
11.Four wheel drive system position selector.
12.
Removable ashtray/
12 volt socket
(120 W max).
13. Automatic air conditioning controls.
14.
Temperature sensor.
15.
Hazard warning lamps switch.
16.
Colour screen/Audio system.

13
FAMILIARI
S
AT I
ON
SITTING COMFORTABLY

I
gnition switch
1.LOCK
position.
2.ACC
position.
3.
ON
position.
4.STA RT
position.
75

Electric window controls
1. Driver’s electric window control.
2. Passenger’s electric window control.
3. Rear right electric window control.
4. Rear left electric window control.

Also...
5. Deactivation of the front passen-ger and rear electric window con-trols.

77


Sunroof controls
1.
Opening control.
2
. Closing control.
3.
Tilt opening control.

Also...
3.
Allows sunroof opening/closing tobe stopped at any time.
82



A heavy object (key fob...), attachedto the key and weighing down onits shaft in the ignition switch, couldcause a malfunction.

16
FAMILIARI
S
AT I
ON
MONITORING

Instrument panel Switch panel
When the ignition is on, the orange and
red warning lamps come on.
When the en
gine is running, these
warning lamps should go off.
If warnin
g lamps remain on, refer to the
page concerned.
Warning lamps
 21

A.
Passenger’s airbag deactivated
warning lamp.
109
B.Hazard warning lamps switch.
102
C.
Front passenger’s seat belt notfastened or unfastened warning lamp.
106

22


Detection of driver

I
MONITORING
23

Warning lamp



is on



Cause



Actions/Observations



Diesel
preheating
Fixed This comes on when the
ignition switch is in the
ON position. Wait until this goes off before starting.
The duration for which this is on is determined
by the exterior climatic conditions.

Parking brake/
Brake fl uid
level
Fixed This comes on for a few
seconds when the ignition
is turned to "ON" then
goes off. It is accompanied by a message on
the instrument panel screen.
The parking brake is
applied or has not been
released fully. It is accompanied by a message on the
instrument panel screen. Release the parking
brake to switch off the warning lamp.
The brake fl uid level is
too low. It is accompanied by a message on the
instrument panel screen. Top up with brake fl uid
and contact a CITROËN dealer or a qualifi ed
workshop.

Emission
control system
Fixed or
fl ashing This comes on or fl ashes
in the event of a fault with
the system. Contact a CITROËN dealer or a qualifi ed
workshop.
It should go off a few seconds after starting
the engine.

Battery charge
Fixed This comes on if a
charging circuit fault
occurs. It should go off when the engine is started.
It is accompanied by a message on
the instrument panel screen. Check the battery
terminals (refer to the "Battery" section).

I
MONITORING
24

Warning lamp



is on



Cause



Actions/Observations







Driver's
seat belt not
fastened
Fixed The driver has not
fastened or has
unfastened their seat belt. This is accompanied by a message on
the instrument panel screen.
Fasten the driver's seat belt.





ABS
Fixed This comes on if an anti-
lock braking system fault
occurs. It is accompanied by a message in the
instrument panel screen. The vehicle retains
conventional braking without assistance but
you are advised to stop. Have it checked by
a CITROËN dealer or a qualifi ed workshop.





Airbags and
pretensioners
Fixed This comes on for a few
seconds when the ignition
is turned to "ON" then
goes off. It should go off when the engine is started. If it
does not go off, contact a CITROËN dealer or
a qualifi ed workshop.
This comes on if an
airbag or pretensioner
fault occurs. It is accompanied by a message on
the instrument panel screen. Have the system
checked by a CITROËN dealer or a qualifi ed
workshop without delay.




Dynamic
stability control
system (ASC)
Fixed This comes on if
a dynamic stability control
system fault occurs. It is accompanied by a message on
the instrument panel screen. Have the system
checked by a CITROËN dealer or a qualifi ed
workshop without delay.

I
MONITORING
25 Each time the engine is started: a series of warning lamps and/or messages come on, applying a checking self test. They go
off after a few seconds. Engine running: the warning lamp or the message becomes a warning if it remains on continuously
or fl ashes. This initial warning may be accompanied by an audible signal and a message on the screen. Do not ignore these
warnings.
The messages displayed may differ between the type 1 instrument panel and the type 2 instrument panel.
When the cause of the appearance of the warning lamp or warning message has been rectifi ed, the warning disappears
from the screen automatically. If the cause of the warning is not rectifi ed, you can return to the previous screen at any time
by pressing the INFO
button on the dashboard.
The symbol "!"
is displayed.
To return to the previous screen (with the "!"
symbol), you must press the INFO
button several times.
Warning messages (ignition at "OFF")

You can close the warning messages which show these symbols in order to move on to the next screen.
To do this, press the INFO
button according to the symbol displayed.
Press briefl y
. Press and hold
.
Symbols which appear in the top right corner of the screen.



Message



is on



Cause



Solution - action



Observations




Key in
ignition


Fixed The driver's door is open
and you have forgotten
to remove the key from
the ignition. Turn the ignition switch
to the LOCK position
and remove the key. Only if the engine has
been started.
An intermittent audible
signal is heard.


Lighting


left on


Fixed You have forgotten to
switch off the vehicle
lighting. Switch off the vehicle
lighting by placing the
stalk at OFF. An intermittent audible
signal is heard.

I
MONITORING
26
Warning messages (ignition at "ON")


Message



is on



Cause



Solution - action



Observations



ABS
Fixed Anti-lock braking system
(ABS) fault. Contact a CITROËN dealer
or a qualifi ed workshop. The vehicle retains
conventional braking
without assistance
but you are advised
to stop.

Braking
system
Fixed Associated warning
lamp.
The level of brake
fl uid in the reservoir is
too low. Stop and top up, otherwise
contact a CITROËN dealer
or a qualifi ed workshop. If the message
remains on after
topping up, contact a
CITROËN dealer or
a qualifi ed workshop.
Associated warning
lamp.
Braking system fault. Contact a CITROËN dealer
or a qualifi ed workshop.
You must stop as
soon as it is safe
to do so.


Parking brake
on
Fixed You have moved off with
the parking brake still
applied. Release the parking brake.

Coolant
temperature
Flashing
High engine temperature. If the message fl ashes
,
wait for the engine to cool
before topping up the level,
if necessary.

You must stop
your vehicle as
soon as it is safe
to do so.


Flashing
If the message fl ashes
and the service
warning light comes
on
, contact a CITROËN
dealer or a qualifi ed
workshop without delay.

Seat belt
Fixed The driver has not fastened
or has unfastened his seat
belt. Fasten your seat belt. There is an
intermittent audible
signal above 5 mph
(8 km/h).

I
MONITORING
30

Prevention messages Information messa
ges (ignition at "ON")


Message



is on



Status of the system



2WD two wheel
drive system
Flashing When the "2WD" (2 wheel drive) mode is selected using the
transmission mode selector.

4WD four wheel
drive system
Flashing When the "4WD" (4 wheel drive) mode is selected using the
transmission mode selector.
This mode is the default mode.

4WD LOCK four
wheel drive system
Flashing When the "LOCK" (4 wheel drive) mode is selected using the
transmission mode selector.

Ambient
temperature
Fixed This indicates the ambient temperature.
When the vehicle is stationary or if the speed is below 12 mph (20 km/h)
the temperature displayed may not be the true temperature.


Display



is on



Cause



Solution - action



Observations



Service
indicator
Fixed Informs the driver of
the time remaining
before the vehicle's
scheduled service. Contact a CITROËN
dealer or a qualifi ed
workshop. This is displayed for a few
seconds when the ignition is
switched on.

Break
advised
Fixed Informs the driver that
they should stop to
take a break. You are advised to
take a break. This is displayed when the
driving time that you set
previously is reached.
An audible signal is heard
3 times and is then heard every
5 minutes until the vehicle stops.

I
31 The total distance is dis-
played in zone 1
of the
screen and the trip dis-
tance in zone 2
(refer to
the "Distance recorders"
section).
Distance recorder (A and B)
INFORMATION IN THE
IN
STRUMENT PANEL SCREEN
Information displa
y
With the ignition on, press the INFO

button, located on the dashboard to the
right of the instrument panel, to display
the various information in succession:


- distance recorder A,

- distance recorder B,

- service indicator,

- coolant temperature,

- range,

- trip computer,

- setting menu. This displays the dis-
tance and the number of
months remaining before
the next service in line
with with the manufac-
turer’s servicing sched-
ule (refer to the "Service
indicator" section).
Service indicator
When the engine is run-
ning, this indicates the
temperature of the cool-
ant (refer to the "Coolant
temperature indicator"
section).
Coolant temperature When the engine is
running, this indicates
the number of miles
(kilometres) which can
still be travelled with the
fuel remaining in the tank
based on the average
fuel consumption over
the last few miles (kilometres) travelled
(refer to the "Range" section).
Range
This indicates the aver-
age fuel consumption,
the average speed and
the current fuel con-
sumption (refer to the
"Trip computer" section).
Trip computer

When the vehicle is sta-
tionary
, this allows the
user to change the follow-
ing settings (refer to the
"Setting menu" section):


- the display language,

- the temperature dis-
play units,

- the fuel consumption units,

- the option to reset the average
fuel consumption and the average
speed,

- the break (rest) reminder display in-
terval.


Setting menu

I
!
!
MONITORING
32 The total distance is
displayed in zone 1
of
the screen and the trip
distance in zone 2
.
DISTANCE RECORDERS (A/B)

System for measuring the total distance
travelled by the vehicle during its
service life and the distance travelled in
a day or other period until it is reset to
zero by the driver.
Zero reset
With the ignition on, press the INFO
button for more than 2 seconds until
zeros appear. When the engine is
running, this indicates
the temperature of the
coolant.
COOLANT TEMPERATURE
If the bar is close to the critical
position
located on the right, the temperature is
too high.
The symbol fl ashes when your engine
is overheating.

You must stop your vehicle as soon
as it is safe to do so.


Wait a few minutes before switching
off the engine.

Wait for the engine to cool before
topping up the level. The cooling
system is pressurised.
When the engine is
running
, this indicates
the distance which can
still be travelled with the
fuel remaining in the tank
based on the average
fuel consumption over the
last few miles/kilometres
travelled.
RANGE
When the range is less than 30 miles
(50 km)
, dashes are displayed.
Refuel as soon as possible. The display
of the range is updated.
To avoid any risk of scalding, unscrew
the cap by two turns to allow the
pressure to drop.
When the pressure has dropped,
remove the cap and top up the level, if
necessary.
Contact a CITROËN dealer or a
qualifi ed workshop. This fi gure may increase following a
change in the style of driving or the
relief, resulting in a reduction in the
current fuel consumption.
If you only add a few litres, the
value displayed will be incorrect.
Therefore, you must fi ll the tank
whenever possible.
When you disconnect the
battery, the previous fuel
consumption data is lost and the
value displayed will be different from
that displayed before the battery was
disconnected. The distance displayed
must be considered an approximate
indication.