Citroen C CROSSER DAG 2008 1.G Manual Online

A C C E S S
III
83
FUEL TANK
To fi ll the tank safely:


it is imperative that the engine is
switched off,

 pull the control A located at the bot-
tom left of the driver’s seat to re-
lease the fuel fi ller fl ap,

 open the fuel fi ller fl ap B ,

 turn the cap C to the left,
When you have fi lled the tank:

 refi t the cap, inserting the upper part
fi rst,

 screw in the cap to the right,

 close the fl ap.
Ensure that the fuel fi ller fl ap is closed
correctly.
 remove the cap C ,

 fi ll the tank, but do not continue
after the 3 rd
cut-off of the nozzle ;
this could cause malfunctions.
Low fuel level
Filling
A label, affi xed on the inside of the fl ap,
reminds you of the type of fuel to be
used in relation to your engine. When the tank’s minimum
level is reached (approxi-
mately 10 litres), this indica-
tion appears on the instru-
ment panel display.
The symbol
fl ashes slowly
(approximately once per second).

You have enough fuel remaining
to drive approximately 30 miles
(50 km) .
When the symbol begins to

fl ash rapidly (approximately
twice per second), there is not
much fuel remaining in your tank (ap-
proximately 5 litres).
This symbol indicates that the
fuel tank cap is located on the
left-hand side of the vehicle.
Location of the cap

1. Opening.

2. Closing.
System for fi lling with fuel, after taking
into account the detection of the associ-
ated low level.

Capacity of the tank: approximately
60 litres.

V I S I B I L I T Y
IV
84
LIGHTS STALK
Main lighting
The various front and rear lights of
the vehicle are designed to adapt the
driver’s visibility progressively in relation
to the climatic conditions:
- side lights, to be seen,
- dipped headlamps to see without dazzling other drivers,
- main beam headlamps to see clearly when the road is clear.
Additional lighting
Other lights are installed to fulfi l the re-
quirements of particular driving condi-
tions:
- rear fog lamps to be seen from a distance,
- front fog lamps for even better visibility,
- daytime lights to be seen during the day. Manual controls
The lighting commands are issued di-
rectly by the driver by means of the ring

A and the lever B . lights off,
automatic switching on of the
lights,
side lights only,

B. lever for inversion of the lights by
pulling: dipped headlamps / main
beam headlamps.
In the lights off and side lights modes,
the driver can switch on the main beam
headlamps directly (“headlamp fl ash”)
for as long as he pulls the lever.
Displays
Lighting of the corresponding indicator
light on the instrument panel confi rms
the selective switching on of the lighting
selected.

A. main lighting mode selection ring,
with:
dipped headlamps or main
beam headlamps.
System for selection and control of the
various front and rear lights providing
the vehicle’s lighting.
Certain functions of the lights stalk
(automatic lighting, sensitivity) can
be confi gured via the colour display
“Equipment” menu.

V I S I B I L I T Y
IV
85
Front and rear fog lamps

C. fog lamps selection ring.
The fog lamps operate with the dipped
and main beam headlamps. front and rear fog lamps

 To switch on the front fog lamps,
turn the push ring C forwards one
notch.

 To switch on the rear fog lamps, turn
the push ring C forwards two notch-
es.

 To switch off the front fog lamps,
turn the push ring C rearwards one
notch.

 To switch off the rear fog lamps,
turn the push ring C rearwards two
notches.
The ring C returns to its initial position
automatically.
The front fog lamps are switched on au-
tomatically when you switch on the rear
fog lamps.
The rear fog lamps are switched off
automatically when you switch off the
dipped/main beam headlamps or the
front fog lamps.
On vehicles fi tted with daytime lights,
the rear fog lamps can be switched on
even if the lights stalk is in the “OFF”
position. In good or rainy weather, both
day and night, the front fog
lamps and the rear fog lamps
are prohibited. In these situations,
the power of their beams may dazzle
other drivers.
Do not forget to switch off the front
fog lamps and the rear fog lamps
when they are no longer necessary.
Lights on buzzer
The triggering of an audible signal
when the driver’s door is opened
warns the driver that he has forgot-
ten to switch off his vehicle’s lights,
with the ignition off.
In this case, switching off the lights
stops the audible signal.
If condensation is present, it is advis-
able to switch the headlamps on for a
few minutes in order to clear it.

V I S I B I L I T Y
IV
86
In foggy weather or in snow,
the brightness sensor can de-
tect suffi cient light. The lights
will not come on automatically.
Do not cover the brightness sensor,
the associated functions will no long-
er be controlled.
Automatic lighting
Daytime lights *
* According to country. This warning light comes on
on the instrument panel.
The instruments and controls (instru-
ment panel, multifunction display, air
conditioning control panel, ...) are lit. Automatic switching off
When the lights stalk is at “dipped head-
lamps or main beam headlamps”, if the
ignition switch is at “LOCK” or “ACC” or
if the key has been removed from the
ignition switch, the lights switch off au-
tomatically
when the driver’s door is
opened .
On vehicles which are equipped with
daytime lights, the dipped headlamps
come on when the vehicle is started.
The side lights and the dipped head-
lamps come on automatically, without
any action on the part of the driver, if a
low level of exterior light is detected or
if the wipers are switched on.
When the light returns to a suffi cient
level or the wipers are switched off, the
lights are switched off automatically.
The sensor is located at the base of the
windscreen.
Contact a CITROËN dealer to adjust
the sensitivity of the sensor.
The sensitivity of the automatic light-
ing can be confi gured via the colour
display “Equipment” menu.

V I S I B I L I T Y
IV
87
MANUAL ADJUSTMENT
OF THE HEADLAMPS
To avoid dazzling other road users, the
height of the headlamps must be ad-
justed in relation to the load in the ve-
hicle.
AUTOMATIC HEADLAMP
ADJUSTMENT
On vehicles with xenon bulbs: when
stationary , the system automatically
corrects the height of the beam, what-
ever the load of the vehicle. The driv-
er is then assured of having optimum
lighting and not causing a nuisance to
other road users.

In cases of malfunction ,
this message appears on
the multifunction display.
7-seat version

0. Driver only or Driver
+ 1 passenger in the front.

1 or 2. Driver + 1 passenger in the
front + 2 passengers on the
third bench seat.

3. 7 occupants (including the driver
with or without maximum authorised
load) .

4. Driver + maximum authorised load.
5-seat version

0. Driver only or Driver
+ 1 passenger in the front.

1 or 2. 5 occupants
(including the driver).

3. 5 occupants (including the driver) +
maximum authorised load.

4. Driver + maximum authorised load.
Do not touch the xenon bulbs. Consult
a CITROËN dealer.

V I S I B I L I T Y
IV
88
WIPER CONTROLS
Manual controls
The wiper commands are issued direct-
ly by the driver by means of the lever A
and the ring B . single wipe.
Windscreen wipers

A. wiping speed selection lever:
park.
intermittent (the speed can be
set manually),
slow.
fast.

B. intermittence adjustment ring.
You can increase or decrease the
wiping frequency when the intermittent
mode is active. Windscreen wash
Pull the wipers stalk towards you.
The windscreen wash then the wipers
operate for a set time.
The headlamp wash is also activated
if
the dipped headlamps are on .
Headlamp wash
Press the end of the lights stalk to
activate the headlamp wash, when the
dipped headlamps are on.
System for selection and control of the
various front and rear wiping modes for
the elimination of rain and cleaning.
The vehicle’s various front and rear wip-
ers are designed to improve the driver’s
visibility progressively in relation to the
climatic conditions.

Certain windscreen wiper functions
(intermittence, ...) can be confi gured
via the colour display “Equipment”
menu.

V I S I B I L I T Y
IV
89

A. rear wiper selection ring:
park
intermittent wipe
wipe with screen wash
Rear wiper
The wiper wipes twice then switches to
intermittent mode with an interval of a
few seconds.
Keep the ring in this position to operate
the screen wash with several wipes of
the wiper. The intermittence of the rear wiper
can be confi gured via the colour
display “Equipment” menu.

V I S I B I L I T Y
IV
90
COURTESY LIGHTS Front courtesy light Map reading lights
There are two map reading lights, one
on each side of the courtesy light.
Press the corresponding transparent
block A .
Position 1
The courtesy light comes on when a
door or the tailgate is opened.
When the door or the tailgate is closed
again, the lighting gradually dims for a
few seconds before switching off.
However, the courtesy light is switched
off automatically in the following cases:
- When the doors and the tailgate
are closed and the ignition switch is
placed in the “ON” position.
- When the doors and the tailgate are closed and you lock the vehicle from
inside or using the remote control.
System for selection and control of the
various passenger compartment lights.
Position 2
The courtesy light is off, regardless of
whether the doors or tailgate are open
or closed. The durations of lighting of the front
courtesy lights can be confi gured
via the colour display “Equipment”
menu.

V I S I B I L I T Y
IV
91
Rear courtesy light
Position 1 “ON”
The courtesy light is permanently on. - When the doors and the tailgate are
closed and you lock the vehicle from
inside or using the remote control.

Automatic switching off
of the courtesy lights
To prevent discharging of the battery,
the courtesy lights and map reading
lights switch off automatically after
30 minutes.
The courtesy lights are switched on
again if the ignition switch is placed in
the “ON” or “ACC” position, if you open
then close a door or the tailgate or if
you use the remote control.
Boot courtesy light
Position 1 “ON”
The courtesy light is on, regardless of
whether the tailgate is open or closed.
Position 2 “

C H I L D S A F E T Y
V
92
Although one of CITROËN’s main cri-
teria when designing your vehicle, the
safety of your children also depends on
you. INSTALLING A CHILD SEAT USING A THREE POINT SEAT BELT
Intermediate longitudinal position
* The rules for transporting children are specifi c to each country. Consult the
current legislation in your country.
GENERAL POINTS RELATING
TO CHILD SEATS
“Forwards-facing”
“Rearwards-facing”
For maximum safety, please follow
these precautions:
- in accordance with Directive 2003/20, all children under the
age of 12 or less than one me-
tre fi fty * tall must travel in ap-
proved child seats suited to
their weight , on seats fi tted with
a seat belt or ISOFIX mountings * ,
- statistically, the safest seats in
your vehicle for the transpor-
tation of children are the rear
seats,
- a child weighing less than 9 kg
must travel in the “rearwards-
facing” position both in the
front and in the rear. When a “rearwards-facing”
child seat is installed on the

front passenger seat , it is
essential that the passenger
air bag is disarmed. Otherwise,
the
child would risk being seriously
injured or killed if the air bag were
to infl ate.

CITROËN recommends that children
should travel in the
rear seats of your
vehicle:
- “rearwards-facing” up to the age
of 2,
- “forwards-facing” over the age
of 2. When a “forwards-facing” child seat is
installed on the
front passenger seat ,
adjust the vehicle’s seat to the interme-
diate longitudinal position with the seat
back upright and leave the passenger
air bag armed.