air condition CITROEN C ZERO 2010 User Guide

i
Comfort
48
In order for these systems to be fully effective, follow the operation and maintenance guidelines below: )If the interior temperature remains very high after the vehicle has been parked in the
sun for a considerable time, first ventilate the passenger compar tment for a few minutesby opening the windows. Place the air flow control at a sufficient level to provide an adequate renewal of air inthe passenger compartment. )Condensation created by the air conditioning results in a discharge of water underthe vehicle when stationary, which is per fectly normal. )To obtain an even air distribution, take care not to obstruct the exterior air intake grilles located at the base of the windscreen, the nozzles, the vents and the air outlets, as wellas the air extractor located in the boot. )Use in preference the intake of exterior air as prolonged use of the air recirculation maycause misting of the windows and side windows.)Operate the air conditioning system for 5 to 10 minutes, once or twice a month to keep itin good working order. )Ensure that the passenger compar tment filter is in good condition and have the filter elements replaced regularly (refer to "Checks").)To ensure correct operation of the air conditioning system, you are also advised to have it checked regularly.)If the system does not produce cold air, do not use it and contact a CITROËN dealer or a qualified workshop.
Recommendations for ventilation and air conditioning

The heating and air conditioning useenergy from the main battery. Their useincreases electrical consumption and reduces the range of the vehicle.
Remember to switch off the heating or air conditioning as soon as it is no longer needed.

3
i
ii
Comfort
49
Air conditioning


The air conditioning can be used as soon as the "Ready" lamp is on.
1. Temperature adjustment
)
Turn the dial from blue (cold) to red (hot) to adjust
t
he temperature to your requirements.


2. Air fl ow adjustment
)Turn the dial to the right to
increase air flow and to the left
to reduce it.

3. Air distribution adjustment
Place the dial in the desired
position to distribute air to:
centra
l and side vents,
central, side and
footwell vents,
footwells,
windscreen, side windows and
footwells
,
Adjustments can be made manually or
automatically.
1. Te mperature 2.Air flow 3.Air distribution4.
Exterior air intake/Interior air recirculation
5. Air conditioning On/Off
6."Max" button

When the dial is placed on "●", the fan air will be at ambient temperature. If you move the dial to "●" while using the heating or air conditioning, these will stop immediately.

With the dial in the "AUTO" position,the air flow is adjusted automatically,according to the interior temperature. w
indscreen and side windows.
The air distribution can be adapted b
y placingthe dial in an intermediate position.

With the dial in the "AUTO" position, air distribution is adjusted automatically, according to the temperature selected.

Comfort
50
4. Air intake/Air recirculation





5. Air conditioning On/Off

Switchin
g on
)
Press the "A/C"button, the associated indicator lamp comes on. The air conditioning does not operate when
the air flow adjustment is set to off.

Switching off
)
Press the "A/C"button again, the
associated indicator lamp goes off.
Switching off may result in some discomfort (humidity, misting).

6. "MAX" button
The intake of exterior air prevents the formationof mist on the windscreen and side windows.
The recirculation of interior air isolates the passenger compar tment from exterior odours and smoke.
Return to exterior air intake as soon as possible
to prevent deterioration of the the air qualit
y and the formation of mist.
) Press this button to recirculatethe interior air. The indicator
lamp comes on to confirm this.
) Press the button again to permit
the intake of exterior air. Theindicator lamp switches off to
confirm this.


The air conditioning is designed to
operate effectively in all seasons,
with the windows closed.
It enables
you to:


- lower the temperature, in summer,

- increase the effectiveness of the demistin
gin winter, above 3 °C.
This button allows the passenger compartment
to be quickly heated or cooled. It only works
when the air flow control is not in the "OFF"position.
Press this button. The correspondin
g
indicator lamp comes on.

The place the temperature control in the
desired position:


- on "●" for maximum ventilation,

- between "●" and "H" for maximum heating,

- between "C" and "●" for maximum air conditioning.

3
i
Comfort
51
) Switch off the demisting/defrostingof the rear screen and door mirrorsas soon as appropriate, so as tolimit electrical consumption and optimise the range of the vehicle.

Front Demist -
Defrost








Rear screen demist - defrost The control button is located to the right of the steering wheel.
)Press this button to demist/defrost
the rear screen and (dependingon version) the door mirrors. The
indicator lamp associated with thebutton comes on.


Place the air distribution control in
this position.
Switching on
Switchin
g off

The demisting/defrosting switches off
automatically to prevent an excessive electric consumption. ) It is possible to stop the demisting/
defrosting operation before it is switched
off automatically by pressing the button
again. The indicator lamp associated withthe button goes off.
For rapid demisting - defrosting, youcan also press the "MAX
" button. The air conditionin
g starts (indicator lamp on)
and exterior air intake is selected (indicator
lamp off).
Place the temperature control
between "●" and " H
".
Pl
ace the air flow control in the
desired position. Front demisting-de
frosting can be used as soon as the "Ready" lamp is on.
Rear screen demistin
g/defrosting can onlyoperate when the "Ready" lamp is on.

!
Safety
72
Anti-slip regulation (ASR)
and electronic stability
programme (ESP)














Trajectory control systems



Deactivation

In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft ground, ...), it may be advisable to deactivate
the ASR and ESP systems, so that the wheels can move freely and regain grip. ) Press this button button, located on the
dashboard to the right of the steeringwheel, until the corresponding symbol
appears in the instrument panel screen.
Activation
These systems are activated automatically each time the vehicle is started.
They come into operation in the event of a grip
or trajectory problem.
The displa
y of this symbol indicates
that the ASR and ESP systems are deactivated.

Reactivation

These systems are not reactivated automatically.
)Press this button again to reactivate themmanually.
The symbol going off in the instrument panel indicates
the reactivation of the ASR and ESP systems. The anti-slip regulation (also known as Traction Control) optimises traction to prevent skidding
of the wheels, by acting on the brakes of the
driving wheels and on the engine.
The electronic stability programme acts on the
brake of one or more wheels and on the engine
to keep the vehicle on the trajectory requiredby the driver, within the limits of the laws of physics.
This is indicated b
y flashing of this
warning lamp in the instrument panel.


The ASR/ESP systems offer exceptional safety in normal driving, butthis should not encourage the driver to take extra risks or drive at high speed.
The correct functioning of these systems depends on obser vation of the manufacturer’s recommendationsregarding the wheels (tyres and rims),the braking components, the electronic components and the assembly and repair procedures used by theCITROËN dealer network.
After an impact, have these systems checked by a CITROËN dealer or a qualified workshop.



Operating fault
The display of this message in the instrument panel indicates a malfunction of
these systems.
Contact a CITROËN dealer or a
qualified workshop
to have the ASR /ESP systems checked.

i
!
Safety
76





Airbags
The airbags have been designed to maximise
the safety of the occupants in the event of
violent collisions. They supplement the action
of the force-limiting seat belts. In this case, the electronic detectors record and analyse the front and side impacts suffered in
the impact detection zones:
- in the event of a serious impact, the airbags are deployed instantaneously and protect
the occupants of the vehicle; immediately after the impact, the airbags deflate rapidlyso that they do not hinder the visibility of
the occupants or their possible exit from
t
he vehicle,
- in the event of a minor impact or rear impact and in cer tain roll-over conditions,
the airbags will not be deployed; the seat
belt alone is su
fficient to provide maximum protection in these situations.

The airbags do not operate whenthe ignition is off.
This equipment only operates once. If a
second impact occurs (during the sameor a subsequent accident), the airbagwill not operate.
The deployment of one or more airbags is accompanied by a slight discharge of harmless smoke and a noise, due to theactivation of the pyrotechnic cartridgeincorporated in the system.This smoke is not harmful, but sensitiveindividuals may experience some irritation.
The noise of the detonation may result in a slight loss of hearing for a shorttime.

Impact detection zones
A.
Front impact zone. B.
Side impact zone.
Front airbags


Deployment

The airbags are deployed simultaneously,
unless the passenger's front airbag is
deactivated, in the event of a serious front
impact applied to all or par t of the front impact
z
one A , in the longitudinal centreline of the
vehicle on a horizontal plane and directed from
th
e front to the rear of the vehicle.
The front airbag inflates between the front
occupant of the vehicle and the dashboard to
cushion their forward movement. S
ystem which protects the head and chest of
the driver and front passenger in the event of
a front impact.
The driver's airbag is fitted in the centre of the steering wheel; the front passenger's airbag isfitted in the dashboard above the glove box.

8i
ii
i
!
i
Practical information
85
)Check that the charging warninglamp in the instrument panel is on fixed.
Fast charging stops automatically whenthe battery is around 80 % charged.It is possible to attain a level of 100 %charged by restarting the procedure. However, the time taken by this additional charge will be relatively long,
as the charging rate is reduced.

During the fast charge, the vehicle's air conditioning may start automatically,if needed to cool the main battery. It istherefore perfectly normal to hear thenoise of a fan running from outside thevehicle and to see a puddle of water form under the vehicle.

As a safety measure, the motor will not star t when the charging cable isconnected to the vehicle's socket. Also, any attempt to star t the motor interrupts the charging procedure. It will then be necessary to disconnectand reconnect the charging cable plug to continue charging, following the instructions for using the charging station.


If the ambient temperature is below 0 °C, the charging time may be longer.
If the ambient temperature is below -25 °C, charging may not be possible. If this is not the case, charging has not star ted;
check the operating instructions for the charging station.
)
The charging warning lamp in the
instrument panel goes off when charging
has finished.
Disconnect the charging cable followingthe instructions for the charging terminal.) Close the charging socket cover and
the flap.

After charging, close the chargingsocket cover and flap. Take care to avoid the ingress of water or dust to the socket and its cover or the charging plug. Risk of fire or electrocution.

Vehicle out of use for a longperiod
When your vehicle is going to be outof use for a long period, charge the main battery completely every three months (following the normal charging procedure).
Before charging, check that the ancillaries battery is not disconnected or discharged. If this is the case, refer to the "ancillaries battery" section for reconnecting or charging the battery.

!
i
!
Practical information
86





Ancillaries battery

All of the electrical components of your vehicle(other than the electric motor, the heating and
the air conditioning) are powered by this 12 V
ancillaries battery.
It is located in the front compartment and isrecharged by the main battery, during phases
of operation ("Ready" lamp on in the instrument
panel) and charging.
If the ancillaries battery is discharged,it will not be possible to star t the motor and the main battery cannot becharged.
)Open the front bonnet using the interior release lever, then the exterior safety catch. )Secure the bonnet stay.)Slacken nut 1.)Remove the battery protective cover for access to the two terminals.



Access to the battery
Disconnecting the battery is not recommended.However, if the vehicle is not to be used for a prolonged period of more than a month, it may be necessary todisconnect and store it to avoid theelectrolyte freezing.


After prolonged disconnection of the battery, you must contact a CITROËNdealer or a qualified workshop to havethe electronic control unit reinitialised.

8
i
!
Practical information
105











Changing a fuse

The extraction tweezer is fitted to the back of
the fusebox cover in the dashboard (right hand side).
For access: )Unclip the cover and remove it completely by pulling it towards you.)Remove the tweezer.



Access to tools
Before changing a fuse, the cause of the failure
must be identified and rectified. ) Check that the ignition switch is in
the "LOCK " position.)
Identify the failed fuse by checking
the condition of its filament.
Changing a fuse
Good Failed
)
Use the special tweezer to extract the fuse from its location.)
Always replace the failed fuse with a fuse
of the same rating. ) Check that the number marked on the box,
the rating marked on the top of the fuse
and the tables below all agree.

CITROËN will not accept responsibility for the cost incurred in repairing your vehicle or for rectifying the malfunctionsresulting from the installation of accessories not supplied and not recommended by CITROËN andnot installed in accordance with itsinstructions, in par ticular when the consumption of all of the additional equipment connected exceeds 10 milliamperes.

Yo u r v e h i c l e’s electrical system isdesigned to operate with standard or optional equipment.
Before installing other electrical equipment or accessories in your vehicle, contact a CITROËN dealer or a qualified workshop.

Practical information
106
Dashboard fuses
The fusebox is placed in the lower dashboard (right-hand side).
Fuse N°RatingFunctions
17. 5 A Left hand front and rear sidelamps.
215 A
Accessory socket.
3-
Not used.
47. 5 A Starter motor.
520
A Audio system.
6
- Not used.
77.5 A
Vehicle equipment, ri
ght hand front and rear sidelamps.
87. 5 A Electric door mirrors.
97. 5 A Supervisor controller.
107.5 A
Air conditioning.
1110 A
Rear foglamp.
12 15 A
Door locking.
13 10 A
Courtesy lamp.