ignition CITROEN C ZERO 2010 User Guide

2
!
Access
33
Lost keys
Visit a CITROËN dealer with the vehicle’s V5 registration document and your personalidentification documents.
The CITROËN dealer will be able to retrieve the key code and the transponder coderequired to order a replacement key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it. Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from working.The remote control does not operate when the key is in the ignition, even when the ignition is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment bythe emergency services more difficult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition whenyou leave the vehicle, even for a shor t time.
Anti-theft protection
Do not make any modifications to the electronic immobiliser system; this could causemalfunctions.
When purchasing a second-hand vehicle
Have the key codes memorised by a CITROËN dealer, to ensure that the keys in your possession are the only ones which can star t the vehicle.

i
!
Access
34
1.Driver's electric window switch.2.Passenger's electric window switch.3.Rear right electric window switch.4. Rear left electric window switch.5.Deactivating the passenger and rear
electric window switches.








Electric windows


Operation

Deactivating the passenger and
rear electric window switches
)For the safety of your children, press switch 55to prevent operation of the passenger and rear electric windows irrespective of their position.
When the button is pressed down, the switches
are deactivated.
When the button is raised, the switches are activated.
System which opens or closes a window manually or automatically. It is fitted with a deactivation system to prevent misuse of the rear controls.
The electric window switches remain operational for approximately 30 seconds after the ignition isswitched off. The windows can no longer be opened or closed after the driver's door is closed. With the i
gnition on: )
Press the switch gently to open or pull it gently to close. The window stops as soonas the switch is released.
-Automatic one-touch mode (driver's side))
Press the switch fully to open. The
driver's window opens completely when
the switch is released. ) Pressing the switch again stops the
movement of the window.

Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operationof the windows, you must reverse the movement of the window. To do this,press the switch concerned.
When the driver operates the passenger electric window switches, they mustensure that no one is preventing correct closing of the windows.
The driver must ensure that passengersuse the electric windows correctly.
Be aware of children when operating the windows.

!
Comfort
42





Door mirrors
The mirrors can be adjusted when the ignitionswitch is in the "ON" or "ACC" position. )Move control A
to the right or to the left to
select the corresponding mirror.)Direct control B in all four directions to adjust the mirror.
When adjustment is complete, return control Ato the central position.
Adjustment


The mirrors can also be foldedmanually.
However, you must never unfold them manually, other wise the mirrors may ynot remain in place correctly whendriving.
Always use control C
to unfold them.

)
With the ignition switch in the "ON" or "ACC" position: press control Cto unfold
them ) With the ignition switch in the "LOCK"
position: press control C within
30 secondsto fold them.
Electric folding/unfolding

i
!
Driving
52










Starting - stopping the vehicle
- Position 1: LOCK
The steering is locked.
- Position 2: ACCThe ancillaries (radio, 12 V socket...)can be used.
- Position 3: ONIgnition on.
- Position 4: START"Ready" lamp on.
Motor ready to drive the vehicle.
Ignition switch
) Inser t the key in the ignition switch.
)
Turn the key to position 4 (START).


Starting
Stopping
)Immobilise the vehicle.
)Place the drive selector in position P.P)Turn the key to position 1 (LOCK).)Remove the key from the ignition switch.)Hold it in this position for a few seconds until the "READY" lamp comes on accompanied by an
audible signal.
) Release the key.
The key returns automaticallyto position 3 (ON).
Key in ignition
If the key has been left in the ignition, an
audible signal is heard on opening the driver's door.

Do not attach any heavy objects to the key as this could weigh down on it whenin the ignition switch and cause a fault.

If you use the ancillaries for a prolonged period (with the key in the ACCposition), you risk discharging theancillaries battery. Star ting your vehiclewill then no longer be possible.Be aware .

4
!
Driving
53





Manual parking brake


Applying
)Pull the parking brake lever fully up to
immobilise your vehicle.
When parking on a slope, direct your wheels against the kerb, apply the parking brake, place the drive selector in position P and switch off the ignition.

Releasing
)
Pull the parking brake lever up gently,
press the release button then lower
the lever full
y.
When the vehicle is being driven, i
f
the parking brake is still on or hasnot been fully released, this warning
lamp comes on.

4
!
Driving
55
To tow your vehicle, the drive selector must be in position N
, refer to "PracticalInformation".



Parking the vehicle

To stop the motor, you must select position P.P
You must apply the parking brake to immobilise
the vehicle.
To remove the key from the ignition switch, thedrive selector must be in position P.P

5
i !
Visibility
57





Front and rear foglamps
Foglamps selection ring.
The foglamps operate with the sidelamps and
dipped and main beam headlamps. Front and rear
foglamps. In good or rainy weather, both dayand night, the front foglamps and the rear foglamp is prohibited. In these situations, the power of its beam may
dazzle other drivers. Do not forget to switch off the front foglamps and the rear foglamp whenthey are no longer necessary.


Lighting on reminder
There is an audible signal when the driver's door is opened, to warnthe driver if the vehicle lighting is on, with the ignition off. Switching off the lighting stops theaudible signal.
)
To switch on the front foglamps, turn
the ring for wards once. ) To switch on the rear foglamp, turn the ring
forwards twice.) To switch off the rear foglamp, turn the ring rearwards twice.)
To switch off the front foglamps, turn
the ring rearwards once.
The ring returns to its initial position
automatically.
The rear foglamp is switched off automatically when you switch off the sidelamps, or
the dipped or main beam headlamps.

i
i
i
Visibility
58
Daytime running lamps
Special daytime lighting so that the vehicle can
be seen more easily. The daytime running lamps come on automatically when star ting the motor, if no
other lighting is on.
They cannot be deactivated. With the main li
ghting control ring in the AUTO
position, the sidelamps and dipped beam
headlamps come on automaticall
y, without anyaction by the driver, when a low level of ambientlight is detected.
When the light returns to a sufficient level or the
wipers are switched off, the lighting is switched
off automatically.
The sensor is located at the base of the
windscreen.
Automatic illumination of headlamps
Automatic lighting off
When the lighting stalk is in the "dipped or mainbeam headlamps" position, if the ignition switch
is in the "LOCK" or "ACC" position or if thekey has been removed, the lighting switches
off automatically when the driver's door isopened .
The driver is is aler ted by an audible signal. The initial setting is position "0".









Headlamp
adjustment

To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according to the load in the
vehicle. 0. Driver only or driver + 1 front passenger.
1 or 2.
4 people (including the driver). 3.4 people (including the driver) + maximumauthorised load.4.
Driver + maximum authorised load.

Even though these lamps are located inthe same lamp unit as the front foglamp, the operate with a specific bulb.
Their use is covered by road vehiclelighting regulations.
In foggy weather or in snow, thesunshine sensor may detect sufficient light. The lighting will not come on automatically. Do not cover the sunshine sensor, theassociated functions will no longer becontrolled.

7
i
Safety
69











Direction indicators

Selection of the left or right direction indicators
to signal a change of direction of the vehicle. )Left: lower the lighting stalk beyond
the point of resistance. )Right: raise the lighting stalk beyond
the point of resistance.









Hazard warning lamps

A visual warning by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.)
Press this button, the direction indicators flash.
They can operate with the ignition off.





Horn
Audible warning system to aler t other road
users to an imminent danger. ) Press the central part of the steering wheel.

Use the horn moderately and only in the following circumstances:


- immediate danger,

- approaching a location lackingvisibility.

7
i
!
Safety
71

Operating fault

When the vehicle is stationar
y

The warning lamp comes on for a few seconds when the ignition is switchedon (ON position). If it does not go off or does not come on, contact a CITROËNdealer or a qualified workshop. I
f this warning lamp comes oncontinuously it indicates a malfunction of the wheel anti-lock braking system
which could result in a loss of controlof the vehicle on braking.
You must stop as soon as it is safe to do so.Contact a CITROËN dealer or a qualifiedworkshop.
When the vehicle is moving
Illumination of these twowarning lamps indicates a
malfunction of the electronic brake force distributionwhich could result in a loss of control of
the vehicle on braking.
You must stop as soon as it is safe to do so.Contact a CITROËN dealer or a qualifiedworkshop.
When replacing wheels (tyres and rims),
ensure that they conform to the manufacturer's recommendations.
The illumination o
f this warning lampit indicates a malfunction of the wheelanti-lock braking system, which could result in a loss of control of thevehicle when braking.
Contact a CITROËN dealer or a qualified
workshop.
Emergency braking assistance
System which, in an emergency, enables you
to obtain the optimum braking pressure more quickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake pedal is pressed.
The effect of this is a reduction in theresistance of the pedal and an increase in
braking efficiency.
When braking in an emergency, press firmly without releasing the pressure.