radio Citroen C ZERO 2011 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2011, Model line: C ZERO, Model: Citroen C ZERO 2011 1.GPages: 164, PDF Size: 8.98 MB
Page 54 of 164
i
!
Driving
52
Starting - stopping the vehicle
- Position 1: LOCK
The steering is locked.
- Position 2: ACC
The ancillaries (radio, 12 V socket...) can
be used.
- Position 3: ON
Ignition on.
- Position 4: START
"Ready" lamp on.
Motor ready to drive the vehicle.
Ignition switch
)
Inser t the key in the ignition switch.
)
Turn the key to position 4 (START)
.
Starting
Stopping
)
Immobilise the vehicle.
)
Place the drive selector in position P
.
)
Turn the key to position 1 (LOCK)
.
)
Remove the key from the ignition switch.
)
Hold it in this position for a few
seconds until the " READY"
lamp
comes on accompanied by an
audible signal.
)
Release the key.
The key returns automatically to
position 3 (ON)
.
Do not attach any heavy objects to the
key as this could weigh down on it when
in the ignition switch and cause a fault.
If you use the ancillaries for a prolonged
period (with the key in the ACC
position),
you risk discharging the ancillaries
battery. Starting your vehicle will then no
longer be possible. Be aware
.
Page 91 of 164
8
!
i
Practical information
89
Never charge the battery without
first disconnecting the terminals and
removing it from the vehicle.
Do not disconnect the terminals when
the "Ready" lamp is on, nor when the
vehicle is being charged.
Before disconnecting
You must wait 2 minutes after switching
off the ignition before disconnecting the
battery.
Batteries contain harmful substances
such as sulphuric acid and lead. They
must be disposed of in line with legal
requirements and never put out with
household waste.
Take used batteries to an authorised
collection point.
)
Disconnect the negative (-) terminal.
)
Lift the protective cover on the (+) terminal 2
.
)
Slacken nut 3
.
)
Disconnect the positive (+) terminal.
)
Remove the battery.
)
Charge the battery following the
instructions given by the manufacturer of
the battery charger.
)
Reconnect the battery starting with the (+)
cable.
After reconnecting
After reconnecting the battery, switch
on the ignition and wait 1 minute
before star ting, to allow initialisation
of the electronic systems. However,
if minor problems persist after doing
this, contact a CITROËN dealer or a
qualified workshop.
Remember to enter the radio code
yourself, referring to the relevant
section.
Ensure that the battery posts and cable
terminals are clean. If they are covered
with sulphates (whitish or greenish
deposit), disconnect and clean them.
Page 109 of 164
8
Practical information
107
Fuse N°
Rating
Functions
14
15 A
Rear wiper.
15
7.5 A
Instrument panel.
16
7.5 A
Heating.
17
20 A
Heated seat.
18
10 A
Option.
19
7.5 A
Door mirror heating.
20
20 A
Windscreen wiper.
21
7.5 A
Airbags.
22
30 A
Heated rear screen.
23
30 A
Heating.
24
-
Non used.
25
10 A
Radio.
26
15 A
Passenger compartment fuse.
Access to the fuses
See "Access to tools".
Page 114 of 164
i
!i
Practical information
112
"Protection":
vehicle cover, translucent bumper protectors,
side rubbing strips...
"Multimedia":
audio systems, speed camera warning,
universal solar charger...
The fitting of electrical equipment
or accessories which are not
recommended by CITROËN may result
in a failure of your vehicle's electronic
system and excessive electrical
consumption.
Please note this precaution. You
are advised to contact a CITROËN
representative to be shown the range
of recommended equipment and
accessories.
Installation of radio
communication
transmitters
Before installing any after-market radio
communication transmitter, you can
contact a CITROËN dealer for the
specification of transmitters which can
be fitted (frequency, maximum power,
aerial position, specific installation
requirements), in line with the Vehicle
Electromagnetic Compatibility Directive
(2004/104/EC).
Depending on the legislation in force
in the country, it may be compulsory
to have a high visibility safety vest,
warning triangle and spare bulbs and
fuses available in the vehicle.
Page 129 of 164
127
The system is coded in such a way that it will only
operate in your vehicle. If it is to be installed in another
vehicle, contact your CITROËN dealer for confi guration
of the system.
AUDIO SYSTEM/BLUETOOTH
01 First steps
For safety reasons, the driver must only carry out
operations which require prolonged attention while the
vehicle is stationary.
When the motor is switched off and to prevent
discharging of the battery, the audio system may switch
off after a few minutes.
CONTENTS
02 Radio
03 Audio
04 Using the telephone
05 Audio settings
06 Configuration
07 Screen menu map
Frequently asked questions p.
p.
p.
p.
p.
p.
p.
p. 128
129
132
138
144
145
146
147
After a battery disconnection, a code has to be entered
for operation of the radio.
A maximum of fi ve attempts are possible. For the last
two attempts, a 15 minutes wait is imposed between
each attempt.
Refer to the end of this document to fi nd the label
indicating this code:
Page 130 of 164
1
2
74
5
6
3
8
9
7
01
128
FIRST STEPS
1. On/Off and volume adjustment.
2. CD eject.
3. Selection of source:
FM1, FM2, CD, USB, AUX, Streaming.
Accept an incoming call.
Long press:
- access to calls log of the telephone
connected,
- or end a call in progress.
4. Selection of a preset radio station.
Radio: long press: preset a radio station.
Other than radio: see relevant sections.
5. Display the list of stations received,
the CD/USB tracks or folders.
Long press: update the list of stations
received.
6. Abandon current operation
.
Up one level (menu or folder).
7. Automatic search for a lower/higher radio
frequency.
Selection of previous/next CD, USB track.
Navigation in a list.
Maintained press: fast forwards or
backwards.
8. Main menu.
9. Audio settings:
equalizer, treble, bass, loudness,
distribution, left/right balance, front/rear
balance, automatic volume.
Page 131 of 164
02
1
12
2
3
129
RADIO
Press SRC/TEL several times in
succession and select the FM1 or FM2
radio band.
Press a button to listen to the
corresponding preset station.
Select the desired radio station and
confi rm by pressing "OK"
.
RADIO
Press LIST
to display the list of stations
received in alphabetical order.
The exterior environment (hills, buildings, tunnel, car park, below ground...) may prevent reception, even in RDS station tracking mode.
This phenomenon is normal in the propagation of radio waves and is in no way indicative of a fault with the audio system.
A long press on LIST
builds or updates
the list of stations; audio reception is cut
momentarily.
Make a long press on one of the buttons
to preset the station being heard.
The name of the station is displayed
accompanied by an audible signal to
confi rm the preset.
A press changes to the next or previous
letter (e.g. A, B, D, F, G, J, K, ...).
MANAGE THE LIST
PRESETTING AND SELECTING A STATION
Page 132 of 164
1
2
02
1
2
130
RDS, if displayed, enables you to continue listening to the same
station by automatic retuning to alternative frequencies. However,
in certain conditions, coverage of an RDS station may not be
assured throughout the country as radio stations do not cover
100 % of the territory. This explains the loss of reception of the
station during a journey.
RADIO
RDS
When the radio is displayed in the
screen, press MENU
then select
"Radio"
.
Select or deselect "RDS"
to activate or
deactivate RDS then confi rm with "OK"
to save the setting.
ENTER A FREQUENCY MANUALLY
Press MENU
, select "Radio"
, then
select "Write freq."
.
Press +
or -
to select the desired
frequency and confi rm with "OK"
.
Page 133 of 164
1
2
02
1
131
RADIO
Radio text is information transmitted by the radio station related to
the current programme or song.
With the radio displayed on the screen,
press MENU
then select "Radio"
.
Select or deselect "
TXT
"
to activate or deactivate the display of
Radio Text.
DISPLAY RADIO TEXT
RECEIVING TA MESSAGES
The TA (Traffi c Announcement) function gives priority to TA alert
messages. To operate, this function needs good reception of a
radio station transmitting this type of message. When a traffi c
report is transmitted, the current audio source (Radio, CD,
USB, ...) is interrupted automatically to play the TA message.
Normal playback of the audio source resumes at the end of the
transmission of the message.
Press MENU
, select "Radio"
, then
select or deselect "TA"
to activate
or deactivate the reception of traffi c
messages.
Page 148 of 164
07
146
SCREEN MENU MAP
1
2
2
2
2
1
2
2
2
1
2
2
2
2
3
3
1
2
2
4
4
4
1
2
3
2
3
3
3
3
3
3
3
2
2
3
3
3
MENU
Radio
TA
RDS
TXT
Write freq.
Media
Normal
Random
Random all
Telephone
Call
Repeat
TA Phone status Directory
Calls list
Bluetooth
BT management
Search Missed calls
Dialed calls
Answered calls
Confi g.
Displaying
Scrolling text Language
Deutsch
English
Español
Français
Italiano
Nederlands
Português
Version
System
Português-Brasil
Русский
Türkçe