lock Citroen C ZERO 2011 1.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2011, Model line: C ZERO, Model: Citroen C ZERO 2011 1.GPages: 164, PDF Size: 8.98 MB
Page 37 of 164
2
!
Access
35
Doors
From outside
)
After unlocking the vehicle using the
remote control or the key, pull the door
handle.
From inside
)
Pull the front or rear door control to open
the door.
If the doors are locked, opening the driver's
door does not unlock the other doors.
- opening the driver's door unlocks the other
doors,
- the front passenger or rear doors must
then be unlocked manually using the front
locking control before they can be opened.
If a door or the boot is not closed
correctly, this warning lamp comes
on in the instrument panel until the
door in question or the boot is closed.
Opening
Closing
Locking/unlocking from
the inside
)
Press the button on the driver's door
towards the front to lock and towards the
rear to unlock the vehicle completely.
The buttons on the front and rear
passenger doors only lock /unlock the
door in question.
Page 38 of 164
Access
36
Boot
Opening
)
After unlocking the vehicle using the remote
control or the key, press the handle A
and
open the tailgate.
)
Pull the handle B
downwards to guide the
tailgate down,
)
release the handle and press the exterior
sur face of the tailgate gently to close it.
Closing
Page 44 of 164
!
Comfort
42
Door mirrors
The mirrors can be adjusted when the ignition
switch is in the "ON" or "ACC" position.
)
Move control A
to the right or to the left to
select the corresponding mirror.
)
Direct control B
in all four directions to
adjust the mirror.
When adjustment is complete, return control A
to the central position.
Adjustment
The mirrors can also be folded
manually.
However, you must never unfold them
manually
, other wise the mirrors may
not remain in place correctly when
driving.
Always use control C
to unfold them.
)
With the ignition switch in the "ON" or
"ACC" position: press control C
to unfold
them
)
With the ignition switch in the "LOCK"
position: press control C within
30 seconds
to fold them.
Electric folding/unfolding
Page 54 of 164
i
!
Driving
52
Starting - stopping the vehicle
- Position 1: LOCK
The steering is locked.
- Position 2: ACC
The ancillaries (radio, 12 V socket...) can
be used.
- Position 3: ON
Ignition on.
- Position 4: START
"Ready" lamp on.
Motor ready to drive the vehicle.
Ignition switch
)
Inser t the key in the ignition switch.
)
Turn the key to position 4 (START)
.
Starting
Stopping
)
Immobilise the vehicle.
)
Place the drive selector in position P
.
)
Turn the key to position 1 (LOCK)
.
)
Remove the key from the ignition switch.
)
Hold it in this position for a few
seconds until the " READY"
lamp
comes on accompanied by an
audible signal.
)
Release the key.
The key returns automatically to
position 3 (ON)
.
Do not attach any heavy objects to the
key as this could weigh down on it when
in the ignition switch and cause a fault.
If you use the ancillaries for a prolonged
period (with the key in the ACC
position),
you risk discharging the ancillaries
battery. Starting your vehicle will then no
longer be possible. Be aware
.
Page 60 of 164
i
i
i
Visibility
58
Daytime running lamps
Special daytime lighting so that the vehicle can
be seen more easily.
The daytime running lamps come on
automatically when star ting the motor, if no
other lighting is on.
They cannot be deactivated. With the main lighting control ring in the AUTO
position, the sidelamps and dipped beam
headlamps come on automatically, without any
action by the driver, when a low level of ambient
light is detected.
When the light returns to a sufficient level or the
wipers are switched off, the lighting is switched
off automatically.
The sensor is located at the base of the
windscreen.
Automatic illumination of headlamps
Automatic lighting off
When the lighting stalk is in the "AUTO"
position, if the ignition switch is in the "LOCK"
or "ACC" position or if the key has been
removed, the lighting switches off automatically
when the driver's door is opened
.
The initial setting is position "0"
.
Headlamp
adjustment
To avoid causing a nuisance to other road
users, the height of the halogen headlamps
should be adjusted according to the load in
the vehicle.
0.
Driver only or driver + 1 front passenger.
1 or 2.
4 people (including the driver).
3.
4 people (including the driver) + maximum
authorised load.
4.
Driver + maximum authorised load.
Although these lamps are located in
the same unit as the front foglamp,
they operate with a specific bulb.
Their use is covered by road vehicle
lighting regulations.
In foggy weather or in snow,
the sunshine sensor may detect
sufficient light. The lighting will not
come on automatically.
Do not cover the sunshine sensor,
the associated functions will no longer
be controlled.
Page 62 of 164
!
Visibility
60
Courtesy lamp
Position 1 "ON"
The cour tesy lamp is permanently on.
Position 2 "●"
The cour tesy lamp comes on when opening
a door or the boot; when the door or boot is
closed again, the lighting gradually dims for a
few seconds before going off.
However, the cour tesy lamp is switched off
immediately when the doors and boot are
closed and you lock the vehicle from the inside
or using the remote control.
Position 3 "OFF"
The cour tesy lamp is permanently off.
Before leaving the vehicle, ensure that
the cour tesy lamp is not on.
If left on, it discharges the ancillaries
battery, even if the main battery is
charged or on charge.
Starting your vehicle will then no longer
be possible.
Page 70 of 164
!
Child safety
68
The incorrect installation of a child seat in a
vehicle compromises the child's protection
in the event of an accident.
When installing a child seat using the seat
belt, check that the seat belt is tightened
correctly on the child seat and that it
secures the child seat firmly on the seat of
your vehicle.
Remember to fasten the seat belts or the
child seat harnesses keeping the slack
in
relation to the child's body to a minimum,
even for shor t journeys.
For optimum installation of the "for wards-
facing" child seat, ensure that the back of
the child seat is in contact with the back
of the vehicle's seat and that the head
restraint does not cause any discomfor t.
If the head restraint has to be removed,
ensure that it is stored or attached securely
to prevent it from being thrown around the
vehicle in the event of sharp braking.
Children under the age of 10 must not travel
in the "for wards-facing" position on the front
passenger seat, unless the rear seats are
already occupied by other children, cannot
be used or are absent.
Deactivate the passenger airbag * when a
"rear wards-facing" child seat is installed on
the front seat. Other wise, the child would
risk being seriously injured or killed if the
airbag were to inflate.
Advice on child seats
Installing a booster seat
The chest par t of the seat belt must be
positioned on the child's shoulder without
touching the neck.
Ensure that the lap part of the seat belt
passes correctly over the child's thighs.
CITROËN recommends the use of a
booster seat which has a back, fitted with a
seat belt guide at shoulder level.
As a safety precaution, do not leave:
- one or more children alone and
unsuper vised in a vehicle,
- a child or an animal in a vehicle which
is exposed to the sun, with the windows
closed,
- the keys within reach of children inside
the vehicle.
To prevent accidental opening of the doors,
use the "Child lock".
Take care not to open the rear windows by
more than one third.
To protect young children from the rays of
the sun, fit side blinds on the rear windows.
*
According to country and current local
legislation.
Child lock
Mechanical system to prevent opening of the
rear doors using their interior controls.
The control is located on the edge of each rear
door.
Child lock on
)
Lower the control A
to position 1
.
Child lock off
)
Raise the control A
to position 2
.
Page 72 of 164
!
Safety
70
Braking assistance systems
Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the stability and
manoeuvrability of your vehicle when braking,
in par ticular on poor or slippery sur faces. Group of supplementary systems which help
you to obtain optimum braking in complete
safety in emergency situations:
- anti-lock braking system (ABS),
- electronic brake force distribution (EBFD),
- emergency braking assistance (EBA).
Emergency or
assistance call
This system allows you to make an emergency
or assistance call to the emergency ser vices or
to the dedicated CITROËN ser vice.
For more information on the use of this
function, refer to the "Audio and telematics"
section.
When braking in an emergency, press
very firmly without releasing the
pressure.
Activation
The anti-lock braking system comes into
operation automatically when there is a risk of
wheel lock.
Normal operation of the ABS may make itself
felt by slight vibration of the brake pedal.
Page 73 of 164
7
i
!
Safety
71
Operating fault
When the vehicle is stationary
The warning lamp comes on for a few
seconds when the ignition is switched
on (ON position). If it does not go off or
does not come on, contact a CITROËN
dealer or a qualified workshop. Fixed illumination of this warning
lamp indicates a malfunction of the
wheel anti-lock braking system which
could result in a loss of control of the
vehicle on braking.
You must stop as soon as it is safe to do so.
Contact a CITROËN dealer or a qualified
workshop.
When the vehicle is moving
Illumination of these two
warning lamps indicates a
malfunction of the electronic
brake force distribution
which could result in a loss of control of the
vehicle on braking.
You must stop as soon as it is safe to do so.
Contact a CITROËN dealer or a qualified
workshop.
When replacing wheels (tyres and rims),
ensure that they conform to the manufacturer's
recommendations.
Illumination of this warning lamp
indicates a malfunction of the wheel
anti-lock braking system, which
could result in a loss of control of the
vehicle when braking.
Contact a CITROËN dealer or a qualified
workshop.
Emergency braking assistance
System which, in an emergency, enables you
to obtain the optimum braking pressure more
quickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake
pedal is pressed.
The effect of this is a reduction in the
resistance of the pedal and an increase in
braking efficiency.
When braking in an emergency, press
firmly without releasing the pressure.
Page 77 of 164
7
i
Safety
75
The driver must ensure that passengers use
the seat belts correctly and that they are all
restrained securely before setting off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
Do not interchange the seat belt buckles as
they will not fulfil their role fully.
The seat belts are fitted with an iner tia reel
permitting automatic adjustment of the length
of the strap to your size. The seat belt is
stowed automatically when not in use.
Before and after use, ensure that the seat
belt is reeled in correctly.
The lower part of the strap must be
positioned as low as possible on the pelvis.
The upper par t must be positioned in the
hollow of the shoulder.
The iner tia reels are fitted with an automatic
locking device which comes into operation in
the event of a collision, emergency braking
or if the vehicle rolls over. You can release
the device by pulling firmly on the strap and
releasing it so that it reels in slightly.
Recommendations for children
Use a suitable child seat if the passenger is
less than 12 years old or shor ter than one
and a half metres.
Never use the same seat belt to secure more
than one person.
Never allow a child to travel on your lap. In order to be effective, a seat belt must:
- be tightened as close to the body as
possible,
- be pulled in front of you with a smooth
movement, checking that it does not
twist,
- be used to restrain only one person,
- not bear any trace of cuts or fraying,
- not be conver ted or modified to avoid
affecting its per formance.
In accordance with current safety
regulations, for all repairs on your vehicle,
go to a qualified workshop with the skills
and equipment needed, which a CITROËN
dealer is able to provide.
Have your seat belts checked regularly by
a CITROËN dealer or a qualified workshop,
par ticularly if the straps show signs of
damage.
Clean the seat belt straps with soapy
water or a textile cleaning product, sold by
CITROËN dealers.
After folding or moving a seat or rear bench
seat, ensure that the seat belt is positioned
and reeled in correctly.
In the event of an impact
Depending on the nature and
seriousness of the impact
, the
pretensioning device may be deployed
before and independently of the airbags.
Deployment of the pretensioners is
accompanied by a slight discharge of
harmless smoke and a noise, due to the
activation of the pyrotechnic car tridge
incorporated in the system.
In all cases, the airbag warning lamp
comes on.
Following an impact, have the seat belts
system checked, and if necessary replaced,
by a CITROËN dealer or a qualified
workshop.