turn signal Citroen C1 2012 1.G Owner's Manual

.Familiarisation
5
When this bar flashes,
accompanied by an audible signal,you have around 5litres of fuel
remaining.
1. Interior release lever.2.Exterior safety catch. 3.Bonnet stay.
Low fuel level
Unscrew the cap using the key.
After filling the fuel tank, screw the cap back on
fully to the right until it clicks and close the flap.
Fuel tank capacity: approximately35 litres.
After opening the flap, inser t the key in the filler cap, then turn it slightly to the left then return to
the right.
The key returns to its initial position and the cap is unlocked.

Opening


Fuel t ank
Bonnet
3084

30Access























Fuel tank
)
Open the fuel filler flap. )
Inser t the key in the filler cap, turn it slightly
to the left and then return to the right.
The key returns to its initial position and the filler cap is then unlocked.
Low fuel level

When the low fuel level is reached,
the last bar
flashes, accompanied byan audible signal.
You have approximately 5 litres remaining.In cer tain driving conditions and depending on
the engine, the distance which can be travelled
with the fuel remaining may be less than30 miles (50 km).
When the frequency of the flashing increases, you have approximately 3 litres remaining.)Unscrew the cap with the key.

)Hang the filler cap on the bracket, located
on the inner face of the filler flap.


A label affixed on the inside of the flap reminds you which type of fuel to use.
When you fill the fuel tank, do not continue after
the 3rd cut-off of the pump. This could cause
malfunctions.
The capacity of the fuel tank isapproximately 35 litres.)After filling the fuel tank, screw the cap
back on fully to the right until it clicks
thenclose the flap.
The fuel tank must be filled with theengine switched off.
f
If you run out of fuel, the emissioncontrol system warning lamp may come on in the instrument panel. It will go off
automatically after the engine has been started a few times.

5
43 Driving

EASY mode (automatic
mode)
Select position E
using the gear lever.
The gear engaged is displayed in the
instrument panel screen.
The gearbox continuously selects the mostsuitable gear.
Manual mode
Place the gear lever in position M, then changeup or down using:
- the gear lever, pushing:


- rearwards, "+"to change up,

- forwards, "-"to change down.
- or the steering mounted controls paddles.
The gear engaged is displayed on the
instrument panel screen.
If the engine speed is too low, the gearbox automatically changes down to prevent stalling.
In the event of overheating of the clutch, position N is selected automatically and the
symbol N flashes accompanied by an audible
signal.


Operating fault
Stoppin
g the engine

Before switching off the engine, you can change to position Nto be in neutral.
In all cases, it is essential that you apply the
parking brake to immobilise the vehicle.
With the i
gnition on, illumination
of this warning lamp indicates a gearbox fault.
Contact a CITROËN dealer or a qualified
workshop.

Stopping - Moving off on a
slo
pe
The gearbox is an electronically controlledmanual gearbox without a clutch pedal.
To hold the vehicle on a slope, it is necessary
to use the brake pedal or the parkin
g brake and not the accelerator pedal.
When moving off on a slope, accelerateprogressively while releasing the parking brake.

Always press the brake pedal while starting the engine.
Never select neutral N
while the vehicle is moving.In all cases, it is essential to apply the parking brake to immobilise the vehicle.

On a slope, use the brake to immobilisethe vehicle and place the gear lever in position N , E
or R.
Do not keep the vehicle immobilisedusing the accelerator.

If you press the accelerator pedal beyond the point of resistance, theelectronic gearbox gearbox changes
down for sharper acceleration.
Te m p o r a r i ly taking control of gear changes
You can temporarily take control of gear changes using the "+"and "-"
steering
mounted controls; if the engine speed allows,
the
gear change command is acted on.
This function allows you to anticipate cer tain
situations such as over taking a vehicle or approaching a corner.
After a few moments with no action on thecontrols, the gearbox returns to automaticcontrol of the gears.

OFF
44Visibility















































Lighting control stalk
Lamps off
2
.Sidelamps
3. Dipped beam / Main beam
headlamps



Dipped beam / Main beam
headlam
ps
Dipped beam headlamps: pull the stalk.
Main beam headlamps:
push the stalk.


Lighting on audible warning
When the driver's door is opened with the
ignition off, a continuous audible signal is heard
if you have left your lighting on.

Headlamp flash

Pull the stalk fully towards you.
Selection is b
y rotation of ring A.

Front foglamps and rear
fo
glamp
)Turn the ring B forwards to turn it on.)Turn the ring B
rearwards to switch it off.

Vehicles fi tted with a rear
foglamp only (ring B)

In clear weather or in rain, both day andnight, the front foglamps and the rear foglamp are dazzling and their use is prohibited.
Do not forget to switch them off whenthey are no longer needed.
The rear foglamp only operates if the dipped beam / main beam headlampsare on.

6
45 Visibility








LED daytime running lamps *
On starting the vehicle, the LED daytime running lamps come on automatically, if the lighting stalk is in the OFFposition.
If the sidelamps and headlamps are switched on manually or automatically, the LED lamps switch off.
Deactivation/activation

Vehicles fi tted with front
foglamps and a rear foglamp (ring C)
Turn the ring C
: )forwards a 1 st
time to switch on the front
foglamps, )forwards a 2nd time to switch on the rear foglamp, )rearwards a 1 sttime to switch off the rear foglamp, )rearwards a 2nd
time to switch of the frontfoglamps.


Direction indicators
Left:
stalk downwards. Right:
stalk upwards.
The front foglamps only operate if thesidelamps or dipped beam / main beamheadlamps are on. The rear foglamp only operates if the front foglamps are on.
In countries where exterior lighting by day is nota legal requirement, it is possible to deactivate
the function in the following way.
- Engine stopped, lighting off and parking brake applied, switch on the ignition (key in
the Running position (2nd notch)).
- Within a period of 5 seconds, turn the
lighting control stalk ring Afrom the OFF
position to the Sidelamps
position thenreturn to the OFF
position three times.
An audible signal con
firms the deactivation of
the daytime running lamps.

*
LED: li
ght-emitting diodes.
In countries where daytime running lamps are required by law, this "Daytimerunning lamps" function is alwaysactivated by default and must not dedeactivated.



To reactivate the daytime running lamps, repeat this procedure. An audible signal confirms the
reactivation of the daytime running lamps.