water Citroen C1 2012 1.G Owner's Manual

3
33 Comfort

















Vent ilat ion
3.
Side vents.
4. Diffusion grille.
5. Air outlets to the footwells.
1.
Windscreen demisting/defrosting vent. 2.Side window demisting/defrosting vents.
The air conditioning system does not contain chlorine and does not presentany danger to the ozone layer.


Recommendations for use
If the interior temperature remains very high after a prolonged period parked in the sun, first ventilate the passenger compartment for a few minutes. For an even air distribution, make sure thatyou do not block the outside air inlet grille, the vents, the air passages and the air outlets to the footwells.Ensure that the passenger compartmentfilter, located below the windscreen, in the engine compartment, is in good condition. Have the filter elements replaced regularly.If you drive in dusty conditions, changethem twice as often.Operate the air conditioning system for 5 to10 minutes, once or twice a month, to keepit in perfect working order. In order to ensure that your air conditioning system continues to operate correctly, youare advised to have it checked regularly.The condensation created by the air conditioning results in a flow of water under the vehicle when stationary which isperfectly normal.If the system does not produce cold air, do not use it and contact a CITROËN dealer or a qualified workshop.

7
53 Safety

*
According to model.
The driver must ensure that thepassengers use the seat belts correctly and that they are all properly restrainedbefore setting off. Wherever you are seated in the vehicle,always fasten your seat belt, even for shor t journeys. Do not invert the seat belt buckles as they will not fulfil their role fully. If the seats have armrests * , the lap par tof the seat belt must always pass under the armrest.The seat belts are fitted with an inertia reel permitting automatic adjustment of the length of the strap to your size. The seat belt is stored automatically when notin use.Before and after use, ensure that theseat belt is reeled in correctly.The lower part of the strap must be positioned as low as possible on the pelvis. The upper par t must be positioned in the hollow of the shoulder.
The inertia reels are fitted with an automaticlocking device which comes into operation in the event of a collision, on emergency braking or if the vehicle rolls over. You can release the device by pulling rapidly on the strap and releasing it.
In order to be effective, a seat belt: - must be tightened as close to the body as
possible, - must restrain one adult only, - must not bear any trace of cuts or fraying,- must be pulled in front of you with asmooth movement, checking that it doesnot twist, - must not be transformed or modified to avoid altering its performance.In accordance with current safety regulations, all repairs and checks must be carried out bya CITROËN dealer who can guarantee thatthe work is carried out correctly, or qualifiedworkshop. Have your seat belts checked regularly by a CITROËN dealer or a qualified workshop and particularly if the straps show signs of damage.Clean the seat belt straps with soapy water or a textile cleaning product, sold by CITROËN dealers.
After folding or moving a seat or rear bench seat, ensure that the seat belt is positioned and rolled up correctly.


Recommendations for children:



- use a suitable child seat if the passenger isless than 12 years old or shor ter than one metre fifty,

- do not use the strap-guide *
when a child seat is installed.

- never use the same seat belt to securemore than one person,

- never allow a child to travel on your lap.Depending on the nature and seriousnessof the impacts, the pre-tensioning device may be triggered before and independently of theair bags. Triggering of the pre-tensioners is accompanied by a slight emission of harmless smoke and a noise, due to the activation of the pyrotechnic cartridge incorporated in the system.
In all cases, the airbag warning lamp comes on.
Following an impact, have the seat beltssystem checked, and if necessary replaced, by a CITROËN dealer or a qualifiedworkshop.

10
87 Checks
Screenwash fluid level
Top up the level when necessary.
Coolant level
Fluid specifi cation
For optimum cleaning and to avoid freezing,
this fluid must not be topped up or replaced
with plain water.



Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet the
D
OT4 standard.


The coolant level should be close to the "MAX" mark but should never exceed it.
When the engine is warm, the temperature of
the coolant is regulated by the fan. This can
operate with the ignition off.
In addition, as the cooling system is pressurised, wait at least one hour after switching off the engine before carrying out anywork.
To avoid any risk of scalding, unscrew the cap by two turns to allow the pressure to drop.
When the pressure has dropped, remove thecap and top up the level.
Changing the coolant
The coolant does not have to be changed.
Fluid specifi cation
The coolant must conform to the
manufacturer's recommendations.









Used products
Avoid prolonged contact of used oil or fluids
with the skin.
M
ost of these fluids are harmful to health or indeed very corrosive.
Do not discard used oil or fluids intosewers or onto the ground.Take used oil to a CITROËN dealer or a qualified workshop (France) or to an authorised waste disposal site.