gearbox Citroen C1 RHD 2012 1.G Owner's Manual

.
.
Contents
Horn 48
Hazard warning lamps 48
Parking brake 48
Emergency braking assistance 49
ABS, EBFD, CSC systems 49
ASR and ESP systems 50
Seat belts 51
Airbags 54
Safety
Rev counter 19
Instrument panel 19
Warning lamps 20
Distance recorder 23
Indicators 23
Setting the time 25
Monitoring Familiarisation
Keys / Remote control 26
Doors 28
Electric windows 28
Rear windows 29
Boot 29
Fuel tank 30
Access
Ventilation 33
Heating 34
Air conditioning 35
Mirrors 37
Steering wheel adjustment 37
Front seats 38
Rear seats 39
Comfort Eco-driving
Interior fi ttings 40
Boot fi ttings 41
Fittings
Electronic gearbox 42
Driving
Lighting control stalk 44
LED daytime running lamps 45
Headlamp adjustment 46
Courtesy lamp 46
Windscreen wiper stalk 47
Visibility

Familiarisation
6

Manual air conditioning

This air conditioning system optimises the
distribution of the air and its temperatureinside the passenger compartment.

Electronic gearbox

This five-speed electronic gearbox offers achoice between the comfort of automatedoperation or the pleasure of manual gear
changing.


Auxiliary socket for portable equipment

Compatible with many MP3 players, this socket allows you to listen to your favourite
tracks while travelling. Refer to the conditions of use in the "Audio" section.

Interior
102
35
42

.Familiarisation
7
1. Headlamp adjustment 2.Passenger's airbag deactivation3.Adjustable side air vent 4.Wiper stalk
5.Steering lock and ignition
6. Driver's front airbag

Horn
7.Dashboard fusebox (under the instrument
panel trim, on the right and on the left)8. Rev counter 9.Passenger's door mirror control
10. Steering mounted controls for the electronic gearbox11.
Passenger's electric window control12 .
Gear lever
13.Cup holder


Instruments and controls

Familiarisation
16
Electronic gearbox
Moving off
With the parking brake applied, press the brakepedal then select position N to star t the engine.
With your foot on the brake, select position R , Eor M.Release the parking brake, take your foot off
the brake
pedal, then accelerate. Select position
Eusing the gear lever.
The gear engaged is displayed in the
instrument panel screen.

The gearbox continuously selects the most
suitable gear.


Manual mode

Press the clutch pedal fully when changinggear.

Reverse
To engage reverse gear, push the gear lever fully to the right then towards the rear. Reverse gear can only be engaged when the vehicle is stationary, engine at idle.






Driving safely


EASY mode (automatic mode)Manual gearbox
43
43
42
Place the gear lever in position M
, then changeup or down through the gears by pressing the lever:


- rearwards, "+"to change up,

- forwards, "-"to change down.
You can also use the steering mounted control
paddles.
The
gear engaged is displayed in the
instrument panel screen.

.
17















































Eco-driving
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.

Optimise the use of your
gearbox
With a manual gearbox, move off gently, change up without waiting and drive by changing up quite soon.
With the electronic gearbox stay in Easy "E"without pressing the accelerator pedal heavily or suddenly.
Drive smoothly
Maintain a safe distance between vehicles, use engine braking rather than the brake pedal, and press the accelerator progressively. These practices contribute towards a reduction in fuel consumption and CO2 emissions and also helps reduce the
background traffic noise.

Control the use of your electrical equipment
Before moving off, if the passenger compartment is too warm, ventilate it byopening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windowsand leave the air vents open. Remember to make use of equipment that canhelp keep the temperature in the passenger compartment down (sun blinds, ...).Switch off the air conditioning as soon as the desired temperature is attained.Switch off the demisting and defrosting controls, if not automatic.


Switch off the headlamps and the foglamp whenthe level of light does not require their use.

Avoid running the engine before moving off,particularly in winter; your vehicle will warmup much faster while driving.

As a passenger, if you avoid connecting your multimedia devices (film, music, video game...), you will contribute towards limitingthe consumption of electrical energy, and soof fuel.
Disconnect your por table devices beforeleaving the vehicle.

1
Monitoring
19








Instrument panel
1.Total or trip distance recorder display button,
trip zero reset button
2. Display of warning lamps 3.
Direction indicators4.
Speedometer
5. Fuel gauge 6
. To t a l / trip distance recorder 7.Front foglamp warning lamp8.
Rear foglamp warning lamp9.Main beam headlamp warning lamp
10. Dipped beam headlamp warning lamp






Rev counter
Approaching the maximum engine speed, when
the rev counter needle crosses into the red
zone, you must change up.
11. Indicator of gear engaged or position of thegear lever for the electronic gearbox.

P/S
Monitoring
22



Deactivating
the passenger's airbag
fixed. The passen
ger's airbag control
is set to the OFF
position.
The passen
ger's front airbag is deactivated.
In this case you can install a
"rear facing" child seat.
Set the control to the ON
position to activate the passenger's
front airbag. In this case, do not fit a child seat in the rear-facing position.



Battery charge

fixed. The battery charging circuit has
a fault (dirty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.

Electric power steering
fixed. The electric power steering has a fault. Drive carefull
y at reduced speed.
Have it checked by a CITROËN dealer or qualified workshop.



Front seat beltnot fastened /
unfastened(depending on version)

flashing, then above
12 mph (20 km/h),
accompanied b
y an
audible signal.
The driver and/or front
passenger has not fastened or has unfastened their seat belt. Pull the strap then inser t the tongue in the buckle.



Emissioncontrolsystem fixed. The emission control system has a fault. This lamp should
go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop without delay.

Electronicgearbox
fixed. The electronic gearbox has a
fault. Contact a CITROËN dealer or a qualified workshop without
delay.
Warning lampis onCauseAction/Observations

Monitoring
24
Electronic gearbox indicator
Lever on EASY mode(automatic mode)
Lever
in manual mode
"Neutral"
"Reverse"


1stgear
2 ndgear
3rdgear
4
th gear
5 thgear

I
f this warning lamp comes on with
the engine running, this indicates
a
fault with the electronic gearboxgearbox.
Contact a CITROËN dealer or a qualified
workshop.
"!" warning lamp
"M"is displayed when this operating modeis selected.
It is switched off on switching to EASY mode.
"E"
is displayed when this operatingmode is selected.
It goes off on switching to manual
mode.

42Driving
The position of the gear lever ( R
, N
, Eor M )
and the gear engaged (1 to 5 ) are displayed in
the instrument panel screen.




















Electronic gearbox
Reverse "R". This gear will beengaged when stationary or at a
speed below approximately 4 mph (6 km/h).
Engagement of reverse gear is accompanied
by an audible signal.


Moving off

With the parking brake applied, press the brakepedal then select position Nto star t the engine.
With your foot on the brake, select position R , Eor M.
Release the parking brake, take your foot off
the brake
pedal, then accelerate. The
five-speed electronic gearbox gearboxoffers a choice between the ease of automated operationor the driving pleasure of manual gear changing
.
You can chan
ge from position Eto position Mand vice versa at any time.
Gear lever positions
Select the driving mode by moving the gear
lever.
N eutral "N".
Position the lever to the right inposition N, to star t the engine.
E
asy "E": automatic gear changing.
M
anual (+ / -) "M": manual gear changing.


Steering mounted control paddles
Press behind the +steering mounted control
paddle to change up.
Press behind the -steering mounted control
paddle to change down.
With the engine running, in these three positions, an audible signal is heard when the driver's door is opened.

Display in the instrument panel

5
43 Driving

EASY mode (automatic
mode)
Select position E
using the gear lever.
The gear engaged is displayed in the
instrument panel screen.
The gearbox continuously selects the mostsuitable gear.
Manual mode
Place the gear lever in position M, then changeup or down using:
- the gear lever, pushing:


- rearwards, "+"to change up,

- forwards, "-"to change down.
- or the steering mounted controls paddles.
The gear engaged is displayed on the
instrument panel screen.
If the engine speed is too low, the gearbox automatically changes down to prevent stalling.
In the event of overheating of the clutch, position N is selected automatically and the
symbol N flashes accompanied by an audible
signal.


Operating fault
Stoppin
g the engine

Before switching off the engine, you can change to position Nto be in neutral.
In all cases, it is essential that you apply the
parking brake to immobilise the vehicle.
With the i
gnition on, illumination
of this warning lamp indicates a gearbox fault.
Contact a CITROËN dealer or a qualified
workshop.

Stopping - Moving off on a
slo
pe
The gearbox is an electronically controlledmanual gearbox without a clutch pedal.
To hold the vehicle on a slope, it is necessary
to use the brake pedal or the parkin
g brake and not the accelerator pedal.
When moving off on a slope, accelerateprogressively while releasing the parking brake.

Always press the brake pedal while starting the engine.
Never select neutral N
while the vehicle is moving.In all cases, it is essential to apply the parking brake to immobilise the vehicle.

On a slope, use the brake to immobilisethe vehicle and place the gear lever in position N , E
or R.
Do not keep the vehicle immobilisedusing the accelerator.

If you press the accelerator pedal beyond the point of resistance, theelectronic gearbox gearbox changes
down for sharper acceleration.
Te m p o r a r i ly taking control of gear changes
You can temporarily take control of gear changes using the "+"and "-"
steering
mounted controls; if the engine speed allows,
the
gear change command is acted on.
This function allows you to anticipate cer tain
situations such as over taking a vehicle or approaching a corner.
After a few moments with no action on thecontrols, the gearbox returns to automaticcontrol of the gears.