seats Citroen C2 2007.5 1.G Owner's Manual

IN BRIEF
4
I
E X T E R I O R
Rear parking assistance signal
This function warns you if an obstacle is detected behind the vehicle whilst reversing.
Tailgate
The split tailgate enables the loading of items depending on their size and the available space in the rear of the vehicle.
Lower tailgate covered storage
This storage area enables you to keep emergency equipment within easy reach...
74
7294
Rear seats
The modular seats allow you to make space from the boot to transport items.
85

1
4
3
2
5
6
IN BRIEF
10
I
G E T T I N G S T A R T E D
Front seats
83
1. Head restraint adjustment.
2. Backrest angle adjustment.
3. Longitudinal adjustment.
4. Seat height and angle.
5. Access to rear seats.
6. Heated seats.

A
II
62
Deactivation of the “Stop & Start” system:
You can if you wish deactivate the “Stop & Start” system, by pressing the “ECO OFF” button located on the left hand side on the central panel.
The warning lamp on the button then comes on, and your vehi cle functions like an ordinary vehicle.
You can reactivate the system with another press on the “ECO OFF” button: The warning lamp on the button goes out.Note: The “Stop & Start” system reactivates automatically each time you restart the vehicle.
Batteries
To operate correctly, the system requires a specifi c battery and also a small additional battery which is situated under one of the front seats.
For a change of battery, consult a CITROËN dealer.
Remark:
If there is a malfunction of the “Stop & Start” system, the “ECO” wa rning lamp fl ashes briefl y, accompanied by an audible alert. The “ECO OFF” warning lamp lights up.
Contact a CITROËN dealer.
If the engine is in shutdown mode, it can restart at any moment.
Before taking any action under the bonnet, it is imperativ e to switch off the ignition.
Before leaving the vehicle, it is also essential to switch off the ignition.
S T O P & S T A R T

1
5
4
3
2
III
84
F R O N T S E A T S
Manual adjustments
Head restraint
To raise or lower the head restraint, pull it forwards at the same time as sliding it.
The adjustment is correct when the top edge of the head restraint is at the same height as the top of the head.
To remove it, bring it to the high position. Lift the tab with the aid of a coin and pull.
Backrest angle
Action the control rearwards and adjust the angle of the back-rest.
It is possible to recline the backrest to an angle of 45° by tilt-ing it until it locks. Press the control to unlock.
Heated seats
The front seats can be heated indi-vidually. Use the controls located at the side of the seats, and select one of the three heating levels:
0: Off.
1: Slight heat.
2: Medium heat.
3: Maximum heat.
The seat temperature adjusts auto-matically.Note: The heated seats only oper-ate when the engine is running.
Seat height and rake adjustment
Lift the control and use the weight of your body to move th e seat to the desired position.
Reach
Lift the control bar and adjust to the desired position.
Access to the rear seat positions
To access the rear seat positions, action the control forwards to fold the backrest and slide the front seat.
Afterwards the front seat will revert to its initial position.
Make sure that the seat is secured in place (particularly if the rear seats are folded).

1
4
3
2
III
86
R E A R S E A T S
The function 3 is available on all models. The other functions are available depending on the version of your vehicl e.
Fore and aft adjustment
From the boot, it is possible to modify the loadspace by slidi ng the seats.
Push down control 2 and adjust to the desired position.
At the front of the seat, it is also possible to adjust knee room.
Raise the bar located under the seat and adjust to the de sired position (several positions).
Rear head restraints
The rear head restraints have two positions:A stowed position for when the seat is not occupied.A deployed position to provide passenger safety, by raising th em to their locking point.
To raise them, pull them upwards to their maximum height, pressin g the unlocking button.

III
87
S E A T C O N F I G U R A T I O N
TRANSPORTING LONG OBJECTS
REAR SEATS
By confi guring the rear seats, you can create space for a variety of objects.
As a safety measure, use the anchoring rings positioned on the boot fl oor.
4-seater ver-sionsVersions with folding backrestsVersions with fully-folding seats

III
89
C H I L D R E S T R A I N T S
ISOFIX anchoring points and the ISOFIX fastening system
The rear seats of your vehicle are equipped with ISOFIX anchoring points. These consist of 2 rings located between the backrest and the vehicle seat, approx. 28 cm apart.
ISOFIX child seats are equipped with 2 latches which are eay to attach to these rings. This fi xing system is intended for children weighing up to 18 kg.
Incorrect installation of a child seat in a vehicle compromises protec-tion of the child in the event of a col-lision. The ISOFIX system enables you to minimise the risks posed by incorrect fi tting. The ISOFIX fas-tening system gives you a conven-ient, strong and reliable fi tting for a child seat in your vehicle.
The ISOFIX child seats approved (1) for your vehicle are:
The KIDDY ISOFIX (1):
This is marketed in the CITROËN network. It can be installed “rear-facing” from birth to 13 kg and “forward-facing” from 9 to 18 kg.
Advice on installing your KIDDY ISOFIX child seat:When this seat is installed “forward-facing”, the vehicle front seat should be adjusted to an intermediate fore/aft position, backrest upright.If “rear-facing”, the shell of the child seat should be in con tact with the backrest of the vehicle front seat.
The “rear-facing” position for the Isofi x KIDDY is not authorised on seats that are individually adjustable.
The RÖMER Duo ISOFIX (1):
This child seat is approved for children from 9 to 18 kg. It must be installed only in the “forward-facing” position. The vehicle's corresponding front seat should be adjusted so that the child's feet are not touching its backrest (slide the rear seat as far rearwards as possible). The use of the top b elt, called Top Tether, is not necessary.
These child seats can also be installed in seat positions that are not equipped with ISOFIX anchorages. In this case, they must be secured to the vehicle seat by means of the vehicle seat belt.
(1): On ISOFIX anchorages, you may fi x only the ISOFIX child seats t hat are approved for your vehicle.

III
90
C H I L D R E S T R A I N T S
Child seats secured by means of the vehicle seat belt
In conformity with Directive 2000/3, the table tells you to what extent each of the seat positions in your vehicle may take a child seat that is secured by means of the vehicle seat belt and approved as “Univer-sal” as a function of the weight of the child.
Consult “User Precautions”, chapter on “Child Safety” at the end of this handbook, in order to ensure that you are installing your child in conditions of maxi-mum safety.
Seat position(s)Weight of child
Up to 10 kg and up to 13 kg (groups 0 and 0+)
9 - 18 kg (group 1)15 - 25 kg (group 2)22 - 36 kg (group 3)
Front passenger’s (a)Fixed seatUUUU
H e i g h t - a d j u s t -able seatU(R)U(R)U(R)U(R)
Rear passenger’s seatUUUU
KEY TO THE TABLEU: Seat position suitable for the installation of a universal rear-facing child seat and a universal forward-facing child sea t posi-tion.U(R): Seat position suitable for installation of a universal rear-facing child seat and of a forward-facing seat. The vehicle seat should be adjusted to the highest position.(a): In the front passenger's seat position, it is imperative to deactivate the front passenger's airbag if you are installing a “rear-facing” child seat there. Otherwise the child risks being killed or seriously injured should the airbag deploy. Before placing your child in the front passenger’s seat position, consult the legislation currently in force in your country on the carrying of chil dren in this position.
Take care to comply with the fi tting instructions given in the child seat manufacturer’s installation guide.