seats Citroen C3 2008 1.G Owner's Manual

A
64
II
Deactivation of the "Stop & Start" system:
You can if you wish deactivate the "Stop & Start" system, by pressing the "ECO OFF" button located on the left hand side on the central panel.
The warning lamp on the button then comes on, and your vehi cle functions like an ordinary vehicle.
You can reactivate the system with another press on the "ECO OFF" button: The warning lamp on the button goes out.Note: The "Stop & Start" system reactivates automatically each time you restart the vehicle.
Batteries
To operate correctly, the system requires a specifi c battery and also a small additional battery which is situated under one of the front seats.
For a change of battery, consult a CITROËN dealer.
Remark:
If there is a malfunction of the "Stop & Start" system, the "ECO" wa rning lamp fl ashes briefl y, accompanied by an audible alert. The "ECO OFF" warning lamp lights up.
Contact a CITROËN dealer.
If the engine is in shutdown mode, it can restart at any moment.
Before taking any action under the bonnet, it is imperativ e to switch off the ignition.
Before leaving the vehicle, it is also essential to switch off the ignition.
S T O P & S T A R T

90
III
C H I L D R E S T R A I N T S
ISOFIX anchoring points and the ISOFIX fastening system
The lateral rear seats of your vehicle are each equipped with regulation ISOFIX anchoring points. These consist of 2 rings located between the backrest and the vehicle seat, approx. 28 cm apart.
ISOFIX child seats are equipped with 2 latches which are eay to attach to these rings. This fi xing system is intended for children weighing up to 18 kg.
Incorrect installation of a child seat in a vehicle compromises protection of the child in the event of a collision. The ISOFIX system enables you to minimise the risks posed by incorrect fi tting. The ISOFIX fastening system gives you a convenient, strong and reliable fi tting for a child seat in your vehicle.
The ISOFIX child seat that is approved and supplied by the CITROËN network is the approved and supplied by approved KIDDY Isofi x child seat (1).
It can be installed "rear-facing" from birth to 13 kg and "forward-facing" from 9 to 18 kg.
Advice on installing your KIDDY Isofi x child seat:In the "forward facing" position, the vehicle’s corresponding front seat should be adjusted between the furthest forward and the medium fore/aft position, with the backrest upright.
If "rear-facing", the shell of the child seat should be in contact with the backrest of the vehicle front seat.
Child seats secured by means of the vehicle seat belt
In conformance with the European Directive, the table tells yo u to what extent each of the seat positions in your vehicle may take a child seat that is secured by means of the vehicle seat belt and approved as "Uni versal" according to the weight of the child.

3
96
III
For long and bulky loads with the Moduboard shelf fully deployed.
With a few simple actions in the rear of the vehicle it is possible to create a fl at load area stretching from the boot aperture to the front seat backrests, rear benchseat backrests folded.
The boot can be divided into compartments depending on requirements:B- To protect fragile objects,C- To accommodate a long and bulky load,D- To take a long and bulky load as well as fragile objects,E- To take a long object and still retain 2 rear seats and two- thirds of the boot,F- To separate a fragile object from a long object.
M O D U B O A R D S H E L F

B
99
III
R E A R P A R C E L S H E L F
Removal
To remove it, detach the cords. Push up vertically, then lift on each side.
Storage areas
Tilt the shelf to stow it against the rear seats.
Refi tting
Present the shelf to its fi xing points and push vertically until it is fully engaged.
To attach the shelf and tailgate, take the cords and fi x them at B
Do not place any hard or heavy item on the rear shelf.
These could be dangerous if thrown around during harsh braking or, if they touch the rear screen, could damage the heating elements.