boot CITROEN C3 2023 User Guide

42
In the event of a breakdown
Tool kit
Set of tools supplied with the vehicle.
Accessing the tools

The tools are located under the boot floor carpet,
with the spare wheel.
List of tools

1.Jack
To raise the vehicle.
2.Jack handle
3. Wheel wrench
To remove the wheel bolts.
4. Removable towing eye
For more information on Towing the vehicle
and using the removable towing eye, refer to the
corresponding section.
These tools are specific to the vehicle and may vary according to the level of
equipment.
Do not use them for any other purpose.
The jack must only be used to change a wheel with a damaged or punctured tyre.
Do not use any jack other than the one
supplied with the vehicle.
If the vehicle does not have its original jack,
contact a CITROËN dealer.
The jack does not require any maintenance.
Spare wheel
Access to the spare wheel
The spare wheel is installed in the boot, under
the floor carpet.
Removing the spare wheel

► Rotate the fixing screw to unlock the spare
wheel.
►

Lift the spare wheel towards you from the
rear

.
►

T
ake the wheel out of the boot.
Removing the jack

► Rotate the fixing screw to unlock the jack on
one end.
►

T
ilt the jack towards the right and lift it from
the rear.

47
In the event of a breakdown
8► Ensure that the cover is refitted correctly all
around to ensure correct sealing.
Rear lamps
Model 1

1. Sidelamps / Brake lamps
(P21/5W - 12V - 21W/5W)
2. Direction indicators (PY21W
- 12V - 21W)
3. Reversing lamp (P21W
- 12V - 21W)
Model 2

1.Sidelamps / Brake lamps
(P21/5W - 12V - 21W/5W)
2. Direction indicators (PY21W
- 12V - 21W)
3. Reversing lamp (P21W
- 12V - 21W)
4. Additional sidelamps (W3W
- 12V - 3W)
5. Connecting tail lamps (W3W
- 12V - 3W)
Changing bulbs
These bulbs are changed after removing the tail
lamp assembly.
►
Open the boot.
►


Unscrew the nut and remove it. Be careful
not to drop it inside the wing.
►


Unclip the lamp unit and carefully extract it
pulling straight towards the outside.
A

standard pair of pliers or the wheel wrench
(depending on equipment) may be necessary to
remove the nut.
Sidelamps/Brake lamps / Reversing lamp /
Direction indicators


► Turn the bulb holder a eighth of a turn anti-
clockwise and remove it.
►

Remove the bulb and replace it.
Additional sidelamps / Connecting tail
lamps (if equipped)


► Turn the bulb holder a quarter of a turn and
pull it out.
►
Pull the bulb out and change it.
Interior lighting
Courtesy lamp (10W - 12V - 10W)

► Using a thin, flap tip screwdriver , unclip the
entire console surrounding the courtesy lamp.
►

Remove the defective bulb and replace it.
►


Fit the console back into place around the
courtesy lamp and clip it correctly

.

58
In the event of a breakdown
the booster (or to an earth point on the assisting
vehicle).
►
Connect the other end of the green or black
cable to the earth point


C
on the broken down
vehicle.
►

Start the engine on the assisting vehicle and
leave it running for a few minutes.
►


Operate the starter on the broken down
vehicle and let the engine run.
If the engine does not start immediately

, switch
off the ignition and wait a few moments before
trying again.
►

W
ait for it to return to idle.
►

Disconnect the jump leads in reverse order:
first remove (-) terminal then (+) terminal..
►


Refit the cover to the (+) terminal, if the
vehicle has one.
►


Allow the engine to run for at least
30

minutes, with the vehicle stationary, so that
the battery reaches an adequate state of charge.
Driving immediately without having
reached a sufficient level of charge may
affect some of the vehicle's functionalities.
Disconnecting/removing the
battery
In order to maintain an adequate state of charge
for starting the engine, it is recommended that
the battery be disconnected if the vehicle is
taken out of service for a long period.
Before disconnecting the battery: ►

Close all openings (doors, boot, windows).
►

Switch off all electrical consumers (audio
system, wipers, lighting, etc.).
►

Switch off the ignition and wait for 4
minutes.


Naturally Aspirated engine version

Turbo engine version
►
Disconnect the negative cable.
►

Disconnect the positive cable.
► Remove the mounting bracket if you need to
remove the battery .
Be careful not to cause accidental short
circuits between the positive and
negative battery terminals.
Do not allow smoking, sparks or flames
around fuel or the battery.
After reconnection
After reconnecting the battery, turn on the
ignition and wait 1 minute before starting the
engine, to enable the electronic systems to
initialise.
If minor problems nevertheless persist following
this operation, contact a CITROËN dealer.
Referring to the relevant section, initialise or
reset certain equipment:
–

Date and time.
–


Preset radio stations.
Towing the vehicle
General recommendations
Observe the legislation in force in the
country where you are driving.
Ensure that the weight of the towing vehicle is
higher than that of the towed vehicle.
The driver must remain at the wheel of the
towed vehicle and must have a valid driving
licence.

59
In the event of a breakdown
8When towing a vehicle with all four wheels on
the ground, always use an approved towing
arm; rope and straps are prohibited.
The towing vehicle must move off gently.
When the vehicle is towed with its engine
off, there is no longer braking and steering
assistance.
A professional towing service must be
called if:
–

Broken down on a motorway or main road.
–


Not possible to put
the gearbox into neutral,
unlock the steering, or release the parking
brake.
–

T

owing with only two wheels on the ground.
–

No approved towbar available.
Access to the tools

The towing eye is stored under the boot floor
carpet.
Towing your vehicle
To access the front screw thread:

► Remove the cover .
To be towed:
►

Screw the towing eye in fully
.
►

Install the towbar
.
►

Put the gearbox into neutral.
Failure to observe this instruction could
result in damage to certain components
(braking, transmission, etc.) and to the
absence of braking assistance the next time
the engine is started.
►

Unlock the steering and release the parking
brake.
►


Switch on the hazard warning lamps on both
vehicles.
►


Move off gently
, drive slowly and only for a
short distance.

70
Alphabetical index
A
ABS 23
Adjusting headlamps
20
Adjusting seat

14
Adjusting the air distribution

17
Adjusting the air flow

17
Adjusting the headlamp beam height

20
Adjusting the height and reach of
the steering wheel

15
Adjusting the temperature

17
Advice on care and maintenance

41
Advice on driving

4, 31
Airbags

26–27
Airbags, front

26–27
Air conditioning

16–17
Air conditioning, manual

17
Air intake

18
Air vents

16
Anti-lock braking system (ABS)

23
Antitheft / Immobiliser

10
B
Battery, 12 V 39, 56, 58
Battery, remote control
10
Bodywork

41
Bonnet

35–36
Boot

11
Brake discs

40
Brake lamps

47
Brakes 40
Bulbs
45
Bulbs (changing)

45–47
C
Capacity, fuel tank 35
Cap, fuel filler
35
Care of the bodywork

41
Central locking

9–10
Changing a bulb

45–47
Changing a fuse

48, 51
Changing a wheel

42
Changing the remote control battery

10
Checking the levels

37–38
Checks

37, 39–41
Checks, routine

39–40
Child lock

30
Children

25
Children (safety)

30
Child seats

25, 28–29
Child seats, conventional

29
Cleaning (advice)

41
Closing the boot

11
Control, emergency boot release

11
Control, emergency door

10
Control stalk, lighting

20
Control stalk, wipers

21
Courtesy lamp

47
Courtesy lamps

19
D
Dimensions 60
Dipstick
37
Direction indicators (turn signals)

20, 46–47
Doors

11
Driving

31
Driving economically

4
E
EBFD 23
Eco-driving (advice)
4
Electric windows

12
Electronic brake force distribution (EBFD)

23
Emergency warning lamps

23
Engine

35–36, 41
Engine compartment

37
Engine, petrol

60
Engines

60
Environment

10
F
Filling the fuel tank 35
Filter, air
40
Filter, oil

40
Filter, passenger compartment

16, 40
Fitting a wheel

43–44
Fittings, boot

19

71
Alphabetical index
Fittings, interior 18
Flap, fuel filler
35
Flashing indicators

20, 46
Fluid, brake

38
Fluid, engine coolant

38
Folding the rear seats

15–16
Fuel

4
Fuel consumption

4
Fuel level, low

35
Fuel (tank)

35
Fusebox, dashboard

48
Fusebox, engine compartment

48, 51
Fuses

48, 51
G
Gauge, fuel 35
Gearbox, manual
32, 40
Gear lever, manual gearbox

32
Gear shift indicator

33
Glove box

18
H
Hazard warning lamps 23
Headlamps (adjustment)
20
Headlamps, dipped beam

46
Headlamps, halogen

20, 45
Headlamps, main beam

46
Heating

16
Hooks 19
Horn
23
I
Indicator, coolant temperature 7
Indicators, direction
20, 46
Indicator, service

7
Inflating tyres

40, 61
Instrument panels

5
J
Jack 42
Jump starting
56
K
Key 9–10
Key with remote control
9, 31
L
Labels, identification 60
Lamps, rear
47
LEDs - Light-emitting diodes

46–47
Level, brake fluid

38
Level, engine coolant

7, 38
Level, engine oil 37
Levels and checks
37–38
Level, screenwash fluid

21, 38
Light-emitting diodes - LEDs

46–47
Lighting, exterior

20
Lighting, interior

19
Locating your vehicle

9
Locking

9
Locking from the inside

10
Locking the doors

10
M
Maintenance (advice) 41
Maintenance, routine
39
Map reading lamps

19
Markings, identification

60
Mirrors, door

15
O
Obstacle detection 33
Oil change
37
Oil consumption

37
Oil, engine

37
On-board tools

42
Opening the bonnet

35–36
Opening the boot

11
Opening the doors

11

92
MAINTENANCE
Necessity of maintenance
Your CITROËN vehicle has been manufactured using the latest technology
and under the strictest quality control standards. It is also designed t\
o
minimize maintenance requirements with longer service intervals to save \
you both time and money.
However, scheduled maintenance is necessary to ensure your CITROËN
vehicle operates properly and efficiently for the reasons listed below:
Lubricants:
Your CITROËN vehicle uses various kinds of oils and fluids, including
engine oil, transmission fluid, differential fluid, battery fluid, and engine
coolant. These oils and fluids play very important roles, such as lubricating
and cooling the vehicle and preventing rust. Periodically they need to b\
e
properly refilled or replaced.
Rubber parts:
Hoses, belts and boots use rubber parts, which are bound to crack when
worn out. They need to be replaced with new ones if they should wear out.
Normal deterioration
Vehicles are equipped with many parts for which it is impossible to avoid\

normal wear and tear. These parts include: tires, brake pads, clutch
disc, etc. They are indispensable for basic vehicle functions and must be
replaced regularly.
Maintenance services at CITROËN Authorised Dealers
A CITROËN Authorised Dealer has factory-trained technicians and genuine
CITROËN parts to service your vehicle properly. For expert advice and
quality service, visit a CITROËN Authorised Dealer.
Inadequate, incomplete or insufficient servicing may result in operational
problems with your vehicle that could lead to vehicle damage, an acciden\
t,
or personal injury.
We appreciate your understanding of the importance of these instructions,\

and we look forward to servicing your vehicle at CITROËN Authorised
Dealers.Failure to perform scheduled maintenance may result in
reduced vehicle performance or possible breakdowns,
as well as exclusion from warranty coverage
WARNING!
Maintenance and Warranty