fuse CITROEN C3 DAG 2009 User Guide

11
PRACTICAL INFORMATION

Fuse N° Rating Functions

F12 30 A Windscreen wipers slow/fast speed.

F13 40 A Built-in systems interface supply (ignition positive).

F14 30 A Valvetronic supply (VTi).

F15 10 A Right-hand main beam headlamps.

F16 10 A Left-hand main beam headlamps.

F17 15 A Left-hand dipped beam headlamps.

F18 15 A Right-hand dipped beam headlamps.

F19 15 A Oxygen sensors and electrovalves (VTi),
electrovalves (Diesel), EGR electrovalve (Diesel).

F20 10 A Pumps, electronic thermostat (VTi) water in fuel
sensor (Diesel).

F21 5 A Fan assembly control supply, ABS/ESP.

11
PRACTICAL INFORMATION
Table of maxi-fuses
Fuse N° Rating
Functions

MF1 * 60 A Fan assembly.

MF2 * 30 A ABS/ESP pump.

MF3 * 30 A ABS/ESP electrovalves.

MF4 * 60 A Built-in Systems Interface (BSI) supply.

MF5 * 60 A Built-in Systems Interface (BSI) supply.

MF6 * - Not used.

MF7 * - Passenger compartment fusebox.

MF8 * - Not used.
* The maxi-fuses provide additional protection for the e lectrical systems. All work on the maxi-fuses must be carried out by a
CITROËN dealer.

11
PRACTICAL INFORMATION
BATTERY
Procedure for charging your battery
when it is fl at or for starting the engine
using another battery.
The battery is located under the bonnet.
To gain access to it:

 open the bonnet using the interior
lever, then the exterior lever,

 secure the bonnet strut,

 remove the plastic cover by pulling
on its grip for access to the two ter-
minals,

 unclip the fuse box to remove the
battery, if necessary.
Access to the battery
Starting using another battery

 Connect the red cable to the posi-
tive terminal (+) of the fl at battery A ,
then to the positive terminal (+) of
the slave battery B .

 Connect one end of the green or
black cable to the negative terminal
(-) of the slave battery B .

 Connect the other end of the green
or black cable to the negative termi-
nal (-) of the fl at battery A .

 Start the slave vehicle.

 Operate the starter of the broken
down vehicle and let the engine
run.

 Wait until the engine returns to idle
and disconnect the cables.