boot Citroen C3 RHD 2013 2.G User Guide

4
Access
75











Doors


Opening


From outside
)After unlocking the vehicle using theremote control or the key, pull the door handle.
From inside
)
Pull the front door control to open the door;
this unlocks the vehicle completely. ) Pull the rear door control to open the door;
this unlocks only the door opened.

Closing
- When the engine is running, this
warning lamp comes on, accompanied
by a message in the multifunction
screen for a few seconds,
When a door or the boot is not closed correctly:
- When the vehicle is movin
g
(speed higher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by an
audible signal and a message in the multifunction screen for a few seconds.

Version with deadlocking

The interior door controls do not operate when
the vehicle is deadlocked.

Access
76
Manual central locking
control
Locking
)Press button Ato lock the vehicle. The red indicator lamp on the button comes on.


Unlocking
)
Press button A
again to unlock the vehicle.
The red indicator lamp on the button switches off.


Automatic central locking


Locking

When the speed exceeds 6 mph (10 km/h), the
doors and the boot lock automatically.
Unlocking
)Above 6 mph (10 km/h), press button Ato
unlock the doors and the boot temporarily.
If the vehicle is locked from the outside,the red indicator lamp flashes andbutton A is inactive. )In this case, use the remote controlor the key to unlock the vehicle.
If one of the doors is open, theautomatic central locking does not take place.
If the boot is open, the automatic centrallocking of the doors is active.

If one of the doors is open, centrallocking from the inside does not takeplace.
System which provides full manual locking or
unlocking of the doors from the inside. System which provides full automatic locking
or unlocking of the doors and the boot while
driving.
You can activate or deactivate this function.
Driving with the doors locked can makeaccess more difficult for the emergencyser vices in the event an emergency.

4
Access
77
Emergency control
Locking the driver's door
) Inser t the key in the lock, then turn it to
the left.

Unlocking the driver's door
)
Inser t the key in the lock, then turn it to
the right.

Locking the front and rear passenger doors
)
Remove the black cap, located on the edge
of the door, using the key. ) Inser t the key in the recess, then turn it as far as it will go. )
Remove the key and refit the cap.



Unlocking the front and rear passenger doors
)
Pull the interior door opening control.
In the event of a malfunction with the central locking system, the battery must be disconnected to lock the boot and sosecure the vehicle completely.
Check that the rear doors child lock is not on. To lock or unlock the doors manually in the
event of a malfunction of the central lockin
gsystem or failure of the battery.

Activation
)Press button Afor more than two seconds.
A confirmation message appears on themultifunction screen, accompanied by an
audible signal.


Deactivation
)Press button Aagain for more than
two seconds.
A confirmation message appears on themultifunction screen, accompanied by an
audible signal.


Driving with the doors locked may makeaccess more difficult for the emergency services in an emergency.

Access
78











Boot
)After unlocking the vehicle using theremote control or the key, pull the handleand raise the tailgate.
)
Lower the tailgate using the interior grab
handle.
-when the engine is running, this
warning lamp comes on, accompanied
by a message on the multifunction
screen for a few seconds,
Tailgate release
Unlocking
)Fold back the rear benchseat to gainaccess to the lock from inside the boot. )Insert a small screwdriver into hole Aof thelock to unlock the tailgate.

I
f the tailgate is not closed correctly:
Opening

Closing
-when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal and
a message on the multifunction screen for a few seconds.

System for mechanical unlocking of the boot
in the event of a battery or central lockingmalfunction.

Visibility
86
To avoid causing a nuisance to other road
users, the height of the headlamps should be
adjusted in relation to the load in the vehicle. 0. Driver only or driver + front passenger.-. Intermediate setting 1.
5 people. -. 5 people + load in the boot.2.Driver only + maximum authorised load in
the boot.
This position is sufficient to avoid causing dazzle. Higher settings may limit the spread of light from the headlamps.






Headlamp
adjustment
The initial setting is position "0".









LED lamps Allowing the signature of the vehicle to be identified, this daytime external lighting comprises
two sets of six light emitting diodes (LEDs), located below each front lamp unit.
On star ting the vehicle, in daylight the LED
lamps come on automatically, if the lighting stalk is in position "0"
or "AUTO".If the sidelamps and headlamps are switched
on manually or automatically, the LED lampsswitch off.


Programming

For countries where exterior lighting by day is
not a legal requirement, you can activate or deactivate the function via the multifunction
screen configuration menu.
In countries where daytime lamps are a legal requirement:- this function is activated by default;it cannot be deactivated, - in daylight, the sidelamps and number plate lamps also come on, - If the sidelamps or headlampsare switched on manually or automatically, the LED lamps switch off.
In these countries, for versions not fitted with LED lamps, it is thedipped beam headlamps that comeon automatically on star ting thevehicle .

5
Visibility
91








Interior mood lighting
Switching on

At night, the illumination of the central
dashboard storage compar tment comes
on automatically when the sidelamps areswitched on.On cer tain versions, three lamps located in the
suppor t between the roof and the automatic
da
y/night interior mirror come on as well.
Switching off
The interior mood lighting switches off automatically when the sidelamps areswitched off.
It can be switched off manually using the instrument panel lighting rheostat button. ) With the lighting on, press several times on
the left hand button of the instrument panel
to pro
gressively reduce the dashboard lighting level. ) Press again to reduce the lighting level
to the minimum and switch off the interior
mood lighting.

This comes on automatically when the boot is opened and goes off automatically when the boot is closed.




Boot lamp

The dimmed passenger compar tment lighting improves visibility in the vehicle when the light
is poor.
The lighting time varies according tothe circumstances:

- when the ignition is off, approximately ten minutes,

- in energy economy mode,approximately thirty seconds,

- when the engine is running, no limit.

Fittings
96








Boot fi ttings
Rear parcel shelf(see following page for details)2.Hooks(see following page for details)3.Location for Hi- Fi amplifier4.Stowing rings5.Storage box (version equipped with a
temporary puncture repair kit)
(see following page for details) or
Tool box (version equipped with a spare
wheel) (refer to section "Practical Information -§ Changing a wheel")

6
Fittings
97





Rear parcel shelf


To remove the shelf: )unhook the two cords, )raise the shelf slightly, then unclip it on each side.







Hooks
The hooks can be used to hold shopping bags.






Storage box
)
Raise the boot carpet by pulling the strap
upwards to gain access to the storage box.
This has areas for storing a temporary puncture
repair kit, a box of spare bulbs, a first aid kit,
two warn
ing triangles, ...
) refit the boot floor carpet by folding itslightly in the middle.

11
Practical information
147

















Temporary puncture repair kit
Description of the kit
A.
"Sealant" or "Air" position selector.
B. On "I"
/ off "O"
switch. C.
Deflation button. D.
Pressure gauge (in bar or p.s.i.).E.
Compartment housing:


- a cable with adaptor for 12 V socket,

- various inflation adaptors for
accessories, such as balls, bicycle
t
yres...F
.Sealant car tridge. G.White pipe with cap for repair.
H. Black pipe for inflation. I.
Speed limit sticker.

Access to the kit

This kit is installed in the storage box, under the boot floor.


The speed limit sticker I
must be affixedto the vehicle's steering wheel to remind you that a wheel is in temporary use.
Do not exceed a speed of 50 mph(80 km/h) when driving with a tyre repaired using this type of kit.

Complete s
ystem consisting of a compressor
and a sealant car tridge which permits temporary repair of a tyre so that you can rdrive to the nearest garage.
It is designed to repair most punctures which could affect the tyre, located on the tyre tread or shoulder.

Practical information
152














Changing a wheel
The tools are installed in the boot under the
floor.
To gain access to them: )open the boot, )raise the floor,)remove the polystyrene storage box,)unclip and remove the box containing the
tools.
Access to the tools
Procedure for changing a faulty wheel for the spare wheel using the tools provided with the vehicle.

List of tools

All of these tools are specific to your vehicle. Do not use them for other purposes.
1.Wheelbrace.
For removing the wheel trim and removal of
the wheel fixing bolts. 2. Jack with integral handle.
For raising of the vehicle. 3. "Bolt cover" tool.
For removing the bolt protectors (covers)on alloy wheels. 4.Socket for the security wheel bolts (located
in the glove box).
For adapting the wheelbrace to the special "security" wheel bolts (if your vehicle has
them).