oil filter Citroen C3 RHD 2015 2.G Owner's Manual

9
Limit the causes of excess consumption
Spread loads throughout the vehicle; place the heaviest items in the
bottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance (roof
bars, roof rack, bicycle carrier, trailer...). Use a roof box in preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refit your summer tyres.
Observe the recommendations on maintenance
Check the tyre pressures regularly, when cold, referring to the label in
the door aperture, driver's side.
Carry out this check in particular:
-
b
efore a long journey,
-

a
t each change of season,
-

a
fter a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have your vehicle serviced regularly (engine oil, oil filter, air filter,
passenger compartment filter...) and observe the schedule of
operations recommended in the manufacturer's service schedule.
With a
b
l
ueH
di
d
i
esel engine, if the SCR system is faulty your vehicle
becomes polluting; go to a CITROËN dealer or a qualified workshop
without delay to have the emissions of nitrous oxides brought back to
the legal level.
When refuelling, do not continue after the third cut-off of the nozzle to
avoid any over flow.
At the wheel of your new vehicle, it is only after the first 1 800 miles
(3
000 kilometres) that you will see the fuel consumption settle down to
a consistent average.
Eco-driving
.

17
Any fault resulting in the illumination of a warning lamp must be investigated further by
reading the associated message in the multifunction screen.
If you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified workshop.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the
following warning lamps indicates a fault which
requires action on the part of the driver.STOP fixed, alone or
associated with
another warning
lamp, accompanied
by an audible signal
and a message in the
screen. Illumination of the warning lamp is
associated with a serious braking
system or engine coolant temperature
problem.
Stop as soon as it is safe to do so as the engine may
cut out when driving.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Service temporarily. Minor problems have occurred for
which there is no specific warning
lamp. Identify the problem by reading the message shown in
the screen, such as, for example:
-

t
he engine oil level,
-

t
he screenwash level,
-

t
he remote control battery,
-

s
aturation of the particle filter on d
i
esel vehicles
(refer to the "Particle filter (
di

esel)" section).
For any other faults, contact a CITR
oËn

dealer or
a
qualified workshop.
fixed. Major problems have occurred for
which there is no specific warning
lamp. Identify the problem by reading the message shown
in the screen and contact a CITR
oËn

dealer or
a
qualified workshop.
Warning/indicator
lampis on Cause Action / Observations
1
Monitoring

149
diesel engines
1. Screenwash fluid reservoir.
2. Coolant header tank.
3.


a
i
r f i l t e r.
4.


b
r
ake fluid reservoir.
5.
bat

tery.
6.


Fusebox.
7.
E

ngine oil dipstick.
8.
E

ngine oil filler cap.
9.
P

riming pump (on fuel filter).
10
Checks

152
Additive level (Diesel with
particle filter)
according to your version of instrument panel,
the additive reservoir low level is indicated by:
To p p i n g u p
The reservoir must be topped up without delay
by a CITROËN dealer or a qualified workshop.
Used products
- fixed illumination of the particle filter warning lamp, accompanied
by an audible signal,
or
-

f
ixed illumination of the service
warning lamp, accompanied
by an audible signal and a
message that the particle filter
additive level is too low.
do n
ot discard used oil or fluids into
sewers or onto the ground.
Take used oil to a CITR
oËn
dealer or
a qualified workshop (France) or to an
authorised waste disposal site.
av
oid prolonged contact of used oil or
fluids with the skin.
Most of these fluids are harmful to
health or indeed very corrosive.
Coolant level
The coolant level should be close
to the "MaX " mark but should never
exceed it.
When the engine is warm, the temperature of
the coolant is regulated by the fan.
Changing the coolant
The coolant does not have to be replaced at
routine services.
Fluid specification
The coolant must conform to the
manufacturer's recommendations. Top up the level when necessary.
The cooling fan may star t after
switching off the engine: take care
with articles and clothing that might
be caught by the fan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off the
engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up the level.
Screenwash fluid level
Fluid specification
For optimum cleaning and to avoid freezing,
this fluid must not be topped up or replaced
with plain water.
In wintry conditions, it is recommended that you
use an ethyl alcohol or methanol based fluid.
Checks

153
according to your version of instrument panel, the
start of saturation of the particle filter is indicated by:
- fixed illumination of the particle filter warning lamp, accompanied
by an audible signal,
or
-

t
emporary illumination of
the service warning lamp,
accompanied by an audible
signal and a message that
there is a risk of blockage of
the particle filter.
as s

oon as the traffic conditions permit, regenerate
the filter by driving at a speed of at least 40
mph
(60

km/h) until the warning lamp goes off.
If the warning lamp stays on, refer to the "Additive
level" section.
Checks
12 V battery
The battery does not require any maintenance.
However, check that the terminals are clean
and correctly tightened, particularly in summer
and winter.
The presence of this label, in particular with
the Stop & Start system, indicates the use of
a specific 12
V lead-acid battery with special
technology and specification. The involvement
of a CITROËN dealer or a qualified workshop
is essential when replacing or disconnecting
the battery. When carrying out work on the battery, refer
to the "12 V battery" section for details of the
precautions to be taken before disconnecting
the battery and following its reconnection. Unless other wise indicated, check these components in accordance with the manufacturer's
service schedule and according to your engine.
Other wise, have them checked by a CITROËN dealer or a qualified workshop.
On a new vehicle, the first operations of
regeneration of the particle filter may be
accompanied by the smell of "burning",
which is per fectly normal.
Following prolonged operation of the
vehicle at very low speed or at idle,
you may, in exceptional circumstances,
notice the emission of water vapour at
the exhaust on acceleration. This does
not affect the behaviour of the vehicle
or the environment.
Particle filter (Diesel)
Air filter and passenger compartment filter
Refer to the manufacturer's
service schedule for details of the
replacement intervals for these
components.
de

pending on the environment (e.g. dusty
atmosphere) and the use of the vehicle
(e.g.

city driving), replace them twice as often
if necessary .
a c

logged passenger compartment filter may
have an adverse effect on the per formance
of the air conditioning system and generate
undesirable odours.
Replace the oil filter each time the
engine oil is changed.
Refer to the manufacturer's
service schedule for details of
the replacement interval for this
component.
Oil filter
10
Checks

192
Fuse N°Rating Functions
F1 20 AEngine control unit supply, cooling fan unit control relay,
multifunction engine control main relay, injection pump (
die

sel).
F2 15 AHorn.
F3 10 AFront / rear wash-wipe.
F4 20 A
da

ytime running lamps, LE
d d
aytime running lamps.
F5 15 A
di

esel heater (
di
esel), particle filter additive pump (
di
esel), air
flow sensor (Diesel), fuel pump (1.1i and 1.4i), blow-by heater
and electrovalves (VTi).
F6 10 AABS/ESP control unit, secondary stop switch.
F7 10 AElectric power steering, automatic gearbox.
F8 25 AStarter control.
F9 10 ASwitching and protection unit (Diesel).
F10 30 AFuel heater (Diesel), blow-by heater (1.1i, 1.4i and Diesel),
fuel pump (VTi), injectors and ignition coils (petrol), electronic
thermostat and canister purge electrovalve (1.1i and 1.4i).
F11 40 AHeater blower.
Fuse table
Practical information

205
EngineVTi 68PureTech 68 VTi 82PureTech 82
Gearbox Manual
(5-speed) Manual
(5 speed) Manual
(5-speed) ETG electronic
(5-speed) Manual
(5-speed)
Model code: SC... ZMZ0ZMZ 6 HMZ0HMZ0/P HMZ 6
Cubic capacity (cc) 999999 1 19 9 1 19 9
bo

re x stroke (mm) 71 x 84.171 x 84.1 75 x 90.5 75 x 90.5
Max power: EU standard (kW)* 5060 6060
Max power engine speed (rpm) 6 0006 000 5 7505 760
Max torque: EU standard (
nm

)9595 118 118
Max torque engine speed (rpm) 3 0003 000 2 7502 750
Fuel Unleaded UnleadedUnleadedUnleaded
Catalytic converter Ye sYe s Ye sYe s
Engine oil capacity (in litres)
with filter replacement 3.25
3.25 3.253.25
Petrol engines and gearboxes
* The maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation
(d irective 1999/99/EC).
.../S: model fitted with Stop & Start.
12
Technical data

206
* The maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation (d irective 1999/99/EC).
Petrol engines and gearboxes
Engine PureTech 82
S&S VTi 95PureTech 110
S&S V Ti 120
Gearbox ETG electronic
(5-speed) ETG electronic
(5-speed) Manual
(5-speed) Manual
(5-speed)
a

utomatic
(4-speed)
Model code: SC... HMZ 6 / PS8FP0/PH
nZ 6 / S 5

FS05FS9
Cubic capacity (cc) 1 19 91 397 1 19 9 1 598
bo

re x stroke (mm) 75 x 90.577 x 7575 x 90.5 77 x 85.8
Max power: EU standard (kW)* 607081 88
Max power engine speed (rpm) 5 7606 000 5 500 6 000
Max torque: EU standard (
nm

)11813 6 205 160
Max torque engine speed (rpm) 2 7504 000 1 500 4 250
Fuel Unleaded Unleaded Unleaded Unleaded
Catalytic converter Ye sYe sYe s Ye s
Engine oil capacity (in litres) with filter
replacement 3.25
4.25 3.5 4.25
.../S: model fitted with Stop & Start.
Technical data

209
For more information on the operation and use of your LPG vehicle, refer to the specific insert attached to the other vehicle documents.
LPG engine and gearbox
Engine1.4 i
Gearbox Manual (5-speed)
Model code: SC...
kF

T0/GPL
kF

T0/1GPL
Cubic capacity (cc) 1 360
bo

re x stroke (mm) 75 x 77
Max. power: EU standard (kW)* 51.5 / 54
Max. power speed (rpm) 5 200 / 5 200
Max torque: EU standard (
nm

) 115 / 118
Max. torque speed (rpm) 3 300 / 3 300
Fuel LPG / Unleaded
Catalytic converter Ye s
Engine oil capacity (in litres) with filter
replacement 3.0
*

T
he maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation
(
d

irective 1999/99/EC).
12
Technical data

211
* The maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation (d irective 1999/99/EC).
diesel engines and gearboxes
Engine HDi 70 FAP e- HDi 70 FAPHDi 75 BlueHDi 75 HDi 90
Gearbox Manual
(5-speed) ETG electronic
(5-speed) Manual
(5-speed) Manual
(5-speed) Manual
(5-speed)
Model code: SC... 8HR48HP4/PS 9H
k

0
bH
W 69HJ0
Cubic capacity (cc) 1 3981 3981 560 1 5601 560
bo

re x stroke (mm) 73.7 x 82 73.7 x 82 75 x 88.3 75 x 88.3 75 x 88.3
Max. power: EU standard (kW)* 5050555568
Max. power engine speed (rpm) 4 0004 0004 000 3 5004 000
Max. torque: EU standard (
nm

)160160 185233 230
Max. torque engine speed (rpm) 1 7501 7501 500 1 7501 750
Fuel
die

sel
die
sel
die
sel
die
sel
die
sel
Catalytic converter Ye sYe sYe sYe sYe s
Particle filter (F
aP

) Ye sYe s
n

oYe s
n

o
Engine oil capacity (in litres)
with filter replacement 3.75
3.753.753.753.75
.../S: e-HDi model fitted with Stop & Start.
12
Technical data