hydraulic Citroen C4 2005 2.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine 404
BRAKES
B3FP7E2D
ABS/ESP HYDRAULIC BLOCK
Components Supplier Type Observations
Hydraulic blockBOSCHABS REF 8.0
Installed under the front LH
ESP 8.0chassis member. 4 regulation channels.
The emergency braking control is incorporated in the primary piston at «a».
B3FP7E3C
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 404

Downloaded from www.Manualslib.com manuals search engine 408
BRAKES
B3FP7EUC
BLEEDING AND FILLING THE BRAKING SYSTEM
Filling the braking circuit.
WARNING: Use only the approved and recommended hydraulic fluids.
IMPERATIVE: Only use new brake fluid that has not emulsified; avoid any introduction of
impurities into the hydraulic circuit.
Fill the brake fluid reservoir (4).
Bleeding the primary braking circuit.
WARNING: During the bleed operations: take care to maintain the level of the brake fluid
in the reservoir, keep it topped up.
WARNING: The ABS system must not be in action during the bleed operation.
WARNING: Respect the sequence for the opening of the bleed screws.
Front brake caliper : Bleed screw (8).
Rear brake caliper : Bleed screw (9).
Bleed each brake caliper, proceeding in the following sequence:
- Front LH wheel.
- Front RH wheel.
- Rear LH wheel.
- Rear RH wheel.
B3FP7ETC
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 408

Downloaded from www.Manualslib.com manuals search engine 412
BRAKES
ABS/ESP HYDRAULIC BLOCK XSARA
Braking system specifications
- 'X'braking circuit.
- Front: disc brakes, ventilated
(according to model).
- Rear: drum brakes with automatic adjustment.
- Cable operated handbrake acting on the rear wheels.
(1)Hydraulic valve block «ABS Bosch 5.3»or
(1)Hydraulic valve block «ABS Bosch 5.3 REF»or
(1)Hydraulic valve block «ABS with ESP Bosch 5.7».
(2)Load sensitive braking compensator
(according to model).
B3FP09HC
B3FP09JC
2
1
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 412

Downloaded from www.Manualslib.com manuals search engine 413
BRAKES
BRAKE SPECIFICATIONS
Gyrometer sensor (7) Hydraulic block
C4AP17YCB3HP002C
Observations Part no. Supplier Components
XSARA
ESP hydraulic
blockBOSCH 5.7 ESPLocated on the front
LH wheelarch:
4 adjustmentchannels.IMPERATIVE: Respect the direction of fitting of the gyrometer/
accelerometer sensor
(connector towards the rear of the vehicle).WARNING: The gyrometer/accelerometer sensor should not be
subjected to any impact. Any gyrometer/accelerometer sensor
having suffered an impact must be replaced.
Tightening torque (15): 0,6 ± 0,1 m.daN.
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 413

Downloaded from www.Manualslib.com manuals search engine 425
BRAKES
BRAKE SPECIFICATIONSXSARA PICASSO
Braking system specifications
- 'X'braking circuit.
- Front: disc brakes, ventilated.
- Rear: drum brakes with automatic adjustment.
- Cable operated handbrake acting on the rear wheels.
- Load sensitive braking compensator
(non ABS versions).
(1)Hydraulic valve block «ABS Bosch 5.3» or
(1)Hydraulic valve block + ECU.
(2)Load sensitive braking compensator
(according to version).
B3FP09HC
B3FP08ND
2
1
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 425

Downloaded from www.Manualslib.com manuals search engine 427
BRAKES
BLEEDING THE BRAKING SYSTEMXSARA PICASSO
Tools Bleeding equipment of type «LURO» or similar.
IMPERATIVE: For bleeding the secondary circuit, use ELIT, LEXIA or PROXIA diagnostic tools.
Draining.
Drain the brake fluid reservoir as empty as possible using a syringe.
Disconnect the brake fluid warning lamp connector.
Retrieve the brake fluid reservoir from its supply pipes by pulling upwards.
Finish emptying the reservoir of brake fluid.
Clean the brake fluid reservoir.
Refit the brake fluid reservoir.
Reconnect the brake fluid warning lamp connector.
Filling.
Refill the reservoir with brake fluid.
WARNING: Use only the recommended hydraulic fluids.
Bleeding.
NOTE:Two technicians are required.
IMPERATIVE: During bleed operations, ensure that the level of brake fluid is maintained
in the reservoir and top it up, use only new brake fluid.
Bleed each wheel cylinder, proceeding in the following order:
- Rear right hand wheel.
- Front left hand wheel.
- Rear left hand wheel.
- Front right hand wheel.
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 427