steering wheel Citroen C4 2009 1.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2009, Model line: C4, Model: Citroen C4 2009 1.GPages: 279, PDF Size: 12.3 MB
Page 116 of 279
111
IX
D R I V I N G
Operation in manual mode
Move the selector to position M .
Paddle controls
behind the steer-
ing wheel
The paddles behind the steering
wheel give you access to the six for-
ward gears. - In manual mode, it is not neces-
sary to release the accelerator
completely during gear changes.
- A request to change gear is ac- cepted only if the engine speed
permits it.
- For safety reasons, depending on the engine speed, a change
down may be performed auto-
matically.
In situations of high engine speeds
(heavy acceleration), a change up
will not occur unless the driver op-
erates the paddle.
Acceleration
For optimum acceleration (e.g. to
overtake another vehicle), simply
press the pedal beyond the point of
resistance at the end of its travel, by
p r e s s i n g d o w n fi r m l y .
Vehicle stationary,
with the engine running
In the event of a prolonged stop with
the engine running, the gearbox
changes automatically to neutral N . Stopping the vehicle
Before stopping the engine, you can
choose:
to leave the vehicle in neutral;
move the selector to position N .
to leave the vehicle with a gear
engaged ( R , A or M ); place the
selector in the chosen position
prior to stopping the engine. In
this case, the vehicle cannot be
moved.
In all cases, it is essential to apply
the parking brake. Check that the
parking brake warning lamp is on in
the instrument panel.
Do not use the accelerator to hold
your vehicle on a gradient. Use ei-
ther the brake pedal or the parking
brake.
Before doing anything in the en-
gine compartment, check that the
selector is in neutral N .
Changing gear
Pull the " + " paddle to change up
a gear.
Pull the " - " paddle to change
down a gear.
The paddles do not permit you to se-
lect neutral or reverse gear, or to exit
reverse gear.
- If the vehicle stops or reduces speed (for example when ap-
proaching a stop sign), the gearbox
c h a n g e s d o w n a u t o m a t i c a l l y , t o fi r s t
gear if needed.
Page 121 of 279
116
IX
D R I V I N G
SPEED LIMITER
System which prevents the vehi-
cle from exceeding the speed pro-
grammed by the driver.
Once the limit speed has been
reached, the accelerator pedal no
longer has any effect.
The speed limiter is switched
on manually: a speed of at least
20 mph (around 30 km/h) must be
programmed.
The speed limiter cannot, in any cir-
cumstances, take the place of the
observance of speed limits or of the
vigilance and responsibility of the
driver.
Steering wheel controls
The speed limiter controls are lo-
cated on the left-hand side of the
steering wheel.
Displays on the instrument panel
The programmed information is
grouped together in zone A of the
instrument panel display.
Programming
Rotate the control 1 to the "LIM" po-
sition.
On selection of the function, the
previous memorised speed and the
information "OFF" are displayed on
the instrument panel.
With the engine running, you can
adjust the memorised maximum
speed, by means of short or long
presses on:
button 4 to increase the memo-
rised maximum speed,
button 2 to decrease the memo-
rised maximum speed.
Successive presses will modify the
maximum speed in steps of 1 mph
and a sustained press in steps of
3 mph. Activation
When the desired maximum speed
is displayed, press button
3 so that
the limitation is activated.
The information "OFF" then disappears from the instrument panel display.
While the function is active, pressing
the accelerator pedal will not enable
the programmed speed to be ex-
ceeded, except if you press the pedal
hard down to beyond the end-of-
travel switch.
The speed of your vehicle may vary
slightly in relation to that memo-
rised.
Deactivation
Press on button 3 .
This action causes the information
"OFF" to appear on the instrument
panel display.
This action does not cancel the
memorised maximum speed which
remains displayed in zone A of the
instrument panel.
Page 123 of 279
118
IX
D R I V I N G
CRUISE CONTROL
System which automatically main-
tains the vehicle speed programmed
by the driver, without any action on
the accelerator pedal.
The cruise control is switched on
manually: the vehicle speed must be
at least 25 mph (approx. 40 km/h)
and you must engage:
- fourth gear on a manual gearbox,
- second gear, in sequential mode, on an electronic gearbox or
automatic gearbox,
- position A on an electronic
gearbox or D on an automatic
gearbox.
The cruise control cannot, in any
circumstances, take the place of the
observance of speed limits or of the
vigilance and responsibility of the
driver. Steering wheel controls
The cruise control switches are
located on the left-hand side of the
steering wheel.
Displays on the instrument panel
The programmed information is
grouped together in zone
A of the
instrument panel display. Programming
Rotate the control
1 to the "REG"
position.
Activation
On selection of the function via con-
trol 1, no cruise speed has yet
been memorised.
Once the desired speed has been
reached using the accelerator, press
button 2 or button 4 . The cruise
speed is then memorised. It is dis-
played in zone A of the instrument
panel.
You can then release the accelera-
tor pedal. The vehicle will automati-
cally keep to the speed chosen.
The speed of your vehicle may vary
slightly in relation to that memo-
rised.
You can adjust the memorised speed
on the instrument panel display by
pressing on:
button 4 to increase the speed,
button 2 to decrease the speed.
Successive presses modify the
cruise speed in steps of 1 mph and a
sustained press in steps of 3 mph.
Page 141 of 279
136
XI
P R A C T I C A L I N F O R M A T I O N
TEMPORARY TYRE REPAIR KIT Using the kit
The kit is located in the boot under
t h e fl o o r . I t i s i n s t a l l e d i n t h e t o o l b o x ,
l o c a t e d u n d e r t h e s t o r a g e b o x .
S w i t c h o f f t h e i g n i t i o n .
Tick the wheel to be repaired
on the speed limitation sticker
e n c l o s e d t h e n a f fi x t h e s t i c k e r
to the vehicle's steering wheel
t o r e m i n d y o u t h a t a w h e e l i s i n
t e m p o r a r y u s e .
Clip the bottle 1 on the compres-
sor 2 .
Check that the switch A is tilted
to position "0" .
Connect the pipe of the bottle 1
t o t h e v a l v e o f t h e t y r e t o b e r e -
p a i r e d .
Unwind the pipe of the compres-
sor 2 f u l l y , t h e n c o n n e c t i t t o t h e
b o t t l e .
Connect the compressor's elec-
tric plug to the vehicle's 12 V
s o c k e t .
Start the vehicle and leave the
e n g i n e r u n n i n g .
C o m p l e t e s y s t e m c o n s i s t i n g o f a
compressor and a bottle of sealant
which permits
temporary repair of
t h e t y r e s o t h a t y o u c a n d r i v e t o t h e
n e a r e s t g a r a g e .
This repair kit is available from
C I T R O Ë N d e a l e r s .
It is designed to repair holes of
a maximum diameter of 6 mm,
l o c a t e d e x c l u s i v e l y o n t h e t y r e
t r e a d o r s h o u l d e r . A v o i d r e m o v i n g
a n y f o r e i g n b o d i e s w h i c h h a v e
p e n e t r a t e d t h e t y r e .
Page 191 of 279
184
06
4
1
23
51
23
4
5
2
1
STEERING WHEEL CONTROLS
1. Volume increase.
2. Volume decrease.
3. Mute.
4. RADIO: selection of the previous or next stored station. C D / M P 3 / U S B : selection of the previous or next directory. CD CHANGER: selection of the previous or next CD.
5. R A D I O : a u t o m a t i c s e a r c h f o r a h i g h e r f r e q u e n c y . C D / M P 3 / C D C H A N G E R / U S B : selection of the next track. CD/MP3/CD CHANGER: continuous press: fast forwards play.
1. Displays the main screen.
2. S e l e c t i o n o f t h e t y p e o f i n f o r m a t i o n d i s p l a y e d o n t h e r i g h t -hand side of the screen for the monochrome screen A .
3. A b a n d o n t h e o p e r a t i o n i n p r o g r e s s and return to the previous display.
4. N a v i g a t i o n t h r o u g h t h e m e n u s .
5. C o n fi r m a t i o n o f t h e f u n c t i o n s e l e c t e d . I f y o u r v e h i c l e i s fi t t e d w i t h t h e B l u e t o o t h s y s t e m : p i c k u p a n i n c o m i n g c a l l o r h a n g u p a c a l l w h i c h i s i n p r o g r e s s .
I f y o u r v e h i c l e i s fi t t e d w i t h t h e B l u e t o o t h s y s t e m :
1. P r e s s : a c t i v a t i o n o f t e l e p h o n e v o i c e r e c o g n i t i o n (if the telephone offers this function).
2. Press: displays the phone book, of the call list.
Page 228 of 279
32
4
1
2 3
51
2 3
4
51
2
3
4
STEERING WHEEL CONTROLS
STEERING WHEEL CONTROLS
1. Volume increase.
2. Volume decrease.
3 . Mute.
4 . RADIO: selection of the previous or next stored station. MP3/JUKEBOX: selection of the previous or next directory. CD CHANGER: selection of the previous or next CD.
5 . R A D I O : a u t o m a t i c s e a r c h f o r a h i g h e r f r e q u e n c y . CD/MP3/JUKEBOX/CD CHANGER: selection of the next track. CD/MP3/CD CHANGER: continuous press: fast forwards play.
1. Displays the main screen.
2. Selection of the mode displayed ( T R I P , T E L , N A V o r A U D I O ) .
3 . A b a n d o n t h e o p e r a t i o n i n p r o g r e s s and return to the previous display.
4 . N a v i g a t i o n t h r o u g h t h e m e n u s .
5 . C o n fi r m a t i o n o f t h e f u n c t i o n s e l e c t e d .
1. Short press: A c t i v a t i o n o f t h e v o i c e r e c o g n i t i o n .
2. WHEN THE TELEPHONE IS NOT IN USE: L o n g p r e s s : a c c e s s t o t h e t e l e p h o n e m e n u ( p h o n e b o o k , c a l l l i s t , . . . ) . INCOMING CALL: Short press to accept. L o n g p r e s s t o r e j e c t t h e c a l l . CALL IN PROGRESS: S h o r t p r e s s t o h a n g u p . L o n g p r e s s t o a c c e s s t h e t e l e p h o n e m e n u .
3 . Personalisation: S h o r t p r e s s : c o n fi r m a t i o n o f t h e s e l e c t i o n m a d e u s i n g t h e d i a l .
4 . Rotation: Move around the phone book, the call list. Selection of personalisation.
Page 276 of 279
136
XI
P R A C T I C A L I N F O R M A T I O N
This repair kit is available from
CITROËN dealers.
It is designed to repair most punc-
tures which could affect the tyre, lo-
cated on the tyre tread or shoulder.
Avoid removing any foreign bodies
which have penetrated the tyre.
TEMPORARY PUNCTURE
REPAIR KIT
Complete system consisting of a
compressor and an incorporated
sealant cartridge which permits
tem-
porary repair of the tyre so that you
can drive to the nearest garage.
The kit is stowed in the boot below the
fl o o r . I t i s fi t t e d i n t h e t o o l b o x , l o c a t e d
below the storage compartment. Using the kit
This procedure, comprising several
steps, must be carried out in full.
Switch off the ignition.
Turn the selector A to the
"SEALANT" position.
Check that the switch B is in po-
sition "0" .
Connect the white pipe C to the
valve of the tyre to be repaired.
Connect the compressor's electric
plug to the vehicle's 12 V socket.
A f fi x t h e s p e e d l i m i t a t i o n s t i c k e r
to the vehicle's steering wheel
to remind you that a wheel is in
temporary use.
Start the vehicle and leave the
engine running.
Access to the kit