ECO mode Citroen C4 AIRCROSS RHD 2012 1.G Repair Manual

283
AUDIO-CD system


The system is protected in such a way that it will onlyoperate in your vehicle.

01 First steps - Control panel


For safety reasons, the driver must carry out operations
which require prolonged attention while the vehicle is stationary.
When the en
gine is switched off and to prevent
discharging of the battery, the system switches off following the activation of the energy economy mode.



CONTENTS

02 Steering mounted controls

03 General operation

04 Radio

05 Music media players

06 USB player

07 BLUETOOTH
®
streaming

08 BLUETOOTH
®
telephone

Error messages p.
p.
p.
p.
p.
p.
p.
p.
p. 284
286
287
291
297
305
307
309
320

286
02 STEERING MOUNTED CONTROLS

SPEAK
Press this button to activate voice reco
gnition (" Listening
" is displayed).
Durin
g voice recognition, press this button briefl y to pause voice recognition.
Make a lon
g press on this button to end voice recognition.
Press this button briefl
y to activate voice recognition, even during a call.

Increase / reduce audio volume.

START CALL

Press this button to answer an incoming call.
I
f there is a 2ndincoming call, press to put the1stcall on hold and speak to the 2tndcaller.
In this case, press brie
fl y to switch from one caller to the other.
To start a three-wa
y conversation, pressSPEAK to change to voice recognitionmode and say " Incorporate the call".
END CALL
Press this button to re
ject an incoming call.
During a conversation, press this button to end a call.
Search for a higher / lower radio frequency.
Next /
previous CD track.
CD fast forwards / backwards.

Lon
g press: audio system on / off.

Short press: selection of the source in thefollowing order: FM1 / FM2 / FM3 / MW /
LW / CD.

287
1
1
1
11
03GENERAL OPERATION

Press the "PWR" button.
Th
e last source selected beforeswitching off resumes operation.
The audio equipment functions can be
used when the ignition switch is in the "ON" or "ACC" position.
To switch o
ff, press the "PWR" button
again.

ADJU
STING THE VOLUME

SETTING THE AUDIO MODES

Press the "
SOUND" button several
times; the audio modes change in the following order:

SUB PUNCH / TYPE / FIELD /
BASS / MID / TREBLE / FADER /
BALANCE / OFF.
Turn the "V
OL" dial respectively to the
left to decrease the volume or to theright to increase it. To access the personalised sound
functions quickl
y, press and hold
this button, then turn it to reach the
personalised sound setting of your choice.
Release the button to store thesetting. QUICK ACCESS MODE SWITCHING ON / OFF

The audio settin
g mode is deactivated when the radio is operated or a CD is played or after approximately 10 seconds without anyaction.I
f you press this button for more than2 seconds in the audio setting mode,
the system switches to "Hold" mode.
The audio mode selected will be
retained until you press this button again for more than 2 seconds. "HOLD" MODE

290
03
1
1
GENERAL OPERATION
This permits automatic adjustment of the "VOLUME", "BASS","MID" and "TREBLE" settings in relation to the vehicle speed.
"
SCV" AUTOMATIC VOLUME ADJUSTMENT
Turn the "
SOUND" dial to set the
volume of the bass unit.
Only vehicles fi tted with the "PremiumSound" system can offer the "SUB
PUNCH" setting. "SUB PUNCH" BASE UNIT VOLUME SETTING
If the "SUB PUNCH" is chan
ged, the sound cuts out briefl y.
Pr
ess the "SOUND" button for morethan two seconds to gain access to
the functions setting mode.
Then,
press this same button several
times; the functions setting mode changes in the following order:
AF
/ CT / REG / TP-S / PTY (languages) / SCV / PHONE / OFF.
Turn the "
SOUND" dial respectively to
the left to deactivate the function or to
the right to activate it.

293
04
1
RADIO

The "Radio Data System" (RDS) function on the FM waveband permits:


- access to the displa
y of information, such as the name of the station, ...

- listenin
g to the same station while travelling through different regions,

- temporar
y tuning to traffi c information announcements.
Most FM stations use RD
S. These stations transmit non-audible
data in addition to their programmes.
The data transmitted in this wa
y allows you access to various
functions, mainly displaying of the name of the station, automatic
retuning to alternative frequencies or temporary retuning to traffi c
information announcements.
RD
S allows you to continue listening to the same station by meansof alternative frequencies that carry the same station. However,
in certain conditions, RDS alternative frequencies may not beprovided throughout the country. Radio stations do not cover thewhole country, which explains the loss of reception of the station
during a journey. "AF" ALTERNATIVE FREQUENCIES
Your radio automaticall
y checks and selects the best frequency for
the radio station to which it is tuned (if the station broadcasts onseveral transmitters or frequencies).
The frequenc
y of a radio station covers approximately 30 miles (50 km). The change from one frequency to another explains the
temporary loss of reception during a journey.
If the station to which
you are listening does not have severalfrequencies in the region in which you are currently located, you can
deactivate alternative frequencies.
Some stations are or
ganised in a network.
In different re
gions, they broadcast different or shared programmes
depending on the time of day.
Y
ou can follow:
- a regional station only,
- the entire network, with the possibilit
y that you will be listening
to a different programme.
REG REGIONAL MODE

On long distance journeys, when the stored station becomes weak, the radio searches fi rst for another frequency for the same station (AF).
Then, if this fails, it searches for a frequency broadcasting the regional programme (REG). If this also fails, the radio returns to the storedstation.
The "AF", "REG" and "TP" functions
can be deactivated or activated via the"TUNE" button functions setting mode.



















RDS

296
04
11
RADIO

CHANGING THE DISPLAY LANGUAGE OF THE "PTY" PROGRAMME
Press the "TUNE" button
for more than
two seconds to access the functions setting mode.
Then,
press this button several times
in succession; the functions setting
mode changes in the following order:
AF
/ CT / REG / TP-S / PTY (languages) / SCV / PHONE / OFF.
Turn the "TUNE" dial to the le
ft or
to the right to select the language(ENGLISH, FRANCAIS, DEUTSCH,SVENSK, ESPAGNOL, ITALIANO). FUNCTIONS SETTING MODE

This
permits activation or deactivationof the functions below.
Press the "T
UNE" button for more than
two seconds to access the functionssetting mode.
Then, press this button several times
in succession; the
functions setting
mode changes in the following order:
AF
/ CT / REG / TO-S / PTY (languages) / SCV / PHONE / OFF.

Turn the "TUNE" dial respectivelyto the left to deactivate the function("OFF") or to the right to activate it("ON").

The "PH
ONE" is not operational at present.
The
functions setting mode is deactivated after approximately10 seconds without any action.

297
05MUSIC MEDIA PLAYERS

This can play audio CDs (CD-DA, CD-Text, CD-R/RW) or MP3 CDs.
EJECTING A DISC
















CD PLAYER


SELECTING CD MODE
I
f the player already contains a disc,
press the "CD" button.
"
CD", the track number and the playing
time appear in the screen.

Insert circular compact discs onl
y.
8 cm compact discs must be inserted in the centre of the pla
yer slot.
After inserting a disc, printed face upwards, the player starts
automatically.
Pr
ess this button to remove the
disc from the player. The system
automatically switches to radio mode.

Once ejected, if the compact disc is not removed withinfi fteen seconds, it is reloaded into the player.

298
05
11
1
1
1
MUSIC MEDIA PLAYERS
Random playing of a disc

Pr
ess the "RDM" button to startrandom play of the tracks on the disc."RDM" appears in the screen.

To exit this mode, press this button
again.
AUDIO CD
Press and hold button "" or " " to carry out a fast backwards or forwards search respectively.
Pla
y begins when the button is
released.
Fast search
Press button " " or " " to select theprevious or next track respectively.
Selectin
g a track
Press the "RPT" button to repeat
the play of the current track. "RPT"appears in the screen.
To exit this mode, press this button
again.
Repeatin
g a track Pla
ying the beginning of each track

Press the "
SCAN" button to start playback of the fi rst ten secondsof each track on the disc. "SCAN"
appears in the screen and the
corresponding track number fl ashes.
To exit this mode,
press this button
again.

On CD-R/RWs, the quality of the playback sound depends on theencoding software, the burning device and the burning speed used.

299
1
2
1
05

CD-TEXT DISPLAY
Press the "DISP" button several times
in succession; the CD-Text informationappears in the following order:
DI
SC NAME / TRACK NAME /
NORMAL DISPLAY MODE.
The CD pla
yer and the CD changer are compatible with the display
of CD-Text information.

In the case o
f compact discs containing both CD-DA and MP3 fi les, play automatically begins with the CD-DA fi les.
To switch play between the two types o
f fi le, press the "CD" buttonfor more than two seconds until an audible signal is heard.
While usin
g these compact discs, the "Repeat", Random play" and
"Playing of the beginning of the tracks" functions are only applied to
fi les of the same format. I
f the information exceeds
12 characters, press the "PAGE"button to see the rest.
In th
e absence of CD-Text information
to be displayed, "NOTITLE" appears on the screen.








MP3 / ID3 TAG CD


SELECTING AN MP3 FOLDER

Turn the "F
OLDER" dial respectively to
the right to select a folder in ascendingorder or to the left to select a folder in
descending order.
The
CD player and the CD changer are compatible with the playing of MP3 fi les.
These must be recorded in I
SO9660 Level 1 / Level 2, Joliet or Romeo format on CD ROMs, CD-Rs or CD-RWs. The CDs can contain a maximum of 255 fi les and 100 folders on 16 levels.
The ID3 version 1 Ta
g can be displayed while playing MP3 fi les.
MUSIC MEDIA PLAYERS

300
05
1
1
1
1
1
MUSIC MEDIA PLAYERS
REPEATING THE TRACKS IN A FOLDER

Pr
ess the "RPT" button for more than
two seconds to repeat the playing of
the tracks contained in the currentfolder. "D-RPT" appears in the screen.
To exit this mode, press this button
a
gain.

Pr
ess the "RDM" button to start random playing of the tracks in the current folder. "RDM" appears in the screen.

To exit this mode, press this button
again. PLAYING THE BEGINNING OF EACH TRACK
MP3 / ID3 TAG DISPLAY

Press the "DI
SP" button several times
in succession; the MP3 information
appears in the followin
g order:
F
OLDER NAME / TRACK NAME / NORMAL DISPLAY MODE.
Press the "
SCAN" button to start playing the fi rst ten seconds of each
track in all of the folders. "SCAN"
appears in the screen and thecorresponding track number fl ashes.
To exit this mode, press this button
a
gain.
RANDOM PLAYING OF A FOLDER
RANDOM PLAYING OF A DI
SC

Pr
ess the "RDM" button for more than
two seconds to start random playing of
the tracks in all of the folders. "D-RDM"
appears in the screen.
To exit this mode,
press this button
again. When pla
y begins, "READING" appears in the screen then
disappears to make way for the folder number, the track number,
the playing time and "MP3".