battery Citroen C4 AIRCROSS RHD 2017 1.G Owner's Manual

General safety recommendations 1 41
Direction indicators

1
42
Hazard warning lamps

1
42
Hor n
14

2
Braking assistance systems

1
43
Trajectory control systems

1
45
Front seat belts

1
47
Airbags
1

51
Child seats

1
56
Deactivating the passenger's front airbag

1
58
ISOFIX child seats

1
65
Child lock

1
71
Safety
Fuel tank 173
Snow chains
1
75
Automatic power cut-off to accessories

1
76
Changing a wiper blade

1
76
Towing a trailer

1
77
Fitting roof bars

1
79
Bonnet
18

0
Petrol engines

1
81
Diesel engines

1
82
Checking levels

1
83
Checking components

1
86
Practical information
Temporary puncture
repair kit 1 89
Changing a wheel

1
93
Changing a bulb

1
99
Changing a fuse

2
05
12 V battery

2
11
Towing the vehicle

2
15
Running out of fuel (Diesel)

2
18
In the event of a breakdown
Petrol engines 219
Petrol weights
2
20
Diesel engines

2
25
Diesel weights

2
26
Dimensions
2

31
Identification markings
2

33
Technical data
Bluetooth® telephone with voice
recognition 23 5
AUDIO -TELEMATIC TOUCH SCREEN system

2
47
AUDIO - CD TOUCH SCREEN system

2
89
AUDIO - CD system

3
13
Audio and telematics
Alphabetical index
Contents

14
Warning lamps
When the engine is running or the vehicle is being driven, the
illumination of one of the following warning lamps indicates a
malfunction which requires action on the part of the driver.
The warning lamp comes on in the instrument panel or appears in the
instrument panel screen.Warning /indicator lampis on Cause Action / Observations
Parking brake
/
Brake fluid
level
/ Electronic
brake force
distribution fixed.
It comes on for a few seconds, then
goes off when the ignition is switched
to "ON".
The parking brake is on or not fully
released. It is accompanied by a message. Release the parking brake
to make the warning lamp go off.
The brake fluid level is too low. It is accompanied by a message. Top up with brake fluid and contact a CITROËN dealer or a qualified workshop.
The electronic brake force distribution
(EBFD) is faulty. You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer or a qualified
workshop.
Engine self-
diagnosis
system flashing.
The engine management system has
a fault. Risk of destruction of the catalytic converter.
Have it checked by a CITROËN dealer or a qualified
workshop.
fixed. The emission control system has a
fault.
The warning lamp should go off when the engine is started.If it does not go off, contact a CITROËN dealer or qualified
workshop without delay.
Battery charge *fixed. The battery charging circuit has a
fault (dirty or loose terminals, slack or
cut alternator belt,

...). The warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified
workshop.
The illumination of a warning lamp may be accompanied by the display
of an additional message, to assist you in identifying the problem.
If you encounter any problems, you should contact a CITROËN
dealer or a qualified workshop.
* Depending on the country of sale.
Instruments

20
Screen 1 Screen 2Cause Solution - ActionObservations
Warning messages (ignition at "OFF")
You have forgotten to switch off the
vehicle lighting.Switch off the vehicle lighting by
placing the control at OFF.There is an intermittent audible
signal.
The alarm has been triggered.
The battery for the Keyless Entry
and Starting system is flat. Replace the battery (see "Changing
the batteries").
The electronic key that you have on
your person is not recognised. Check that you have the correct
electronic key.If the message persists, contact a
CITROËN dealer.
The electronic key is still in the
vehicle and you have tried to lock
the doors or boot from the outside. Ensure that you have the electronic
key on your person before locking
the vehicle.
One of the doors or the boot is not
properly closed when locking the
vehicle from the outside. Close the door or the boot, then
lock the vehicle.
Instruments

23
Screen 1 Screen 2Cause Solution - ActionObservations
Warning messages (ignition at "ON")
Fault with the electric power
steering.Stop the vehicle, wait few moments
then start the engine again.If the message remains after
restarting, contact a CITROËN
dealer or a qualified workshop.
The battery for the "Keyless Entry
and Starting" system is flat. Replace the battery.
For more information on the
Emergency
procedure with
the Keyless Entr y and Star ting
system and changing the
batteries in particular, refer to the
corresponding section.
The electronic key that you have on
your person is not recognised. Check that you have the correct
electronic key.If the message persists, contact a
CITROËN dealer.
The electronic key is still in the
vehicle and you have tried to lock
the doors or boot from the outside. Ensure that you have the electronic
key on your person before locking
the vehicle.
One of the doors or the boot is not
properly closed when locking the
vehicle from the outside. Close the door or the boot, then
lock the vehicle.
Fault with the "Keyless Entry and
Starting" system. Contact a CITROËN dealer.
1
Instruments

27
Screen 1 Screen 2Cause Solution - ActionObservations
You have moved off with the parking
brake not fully released.Release the parking brake.
The oil pressure is too low or there
is a fault with the engine lubrication
system. Stop the vehicle and contact a
CITROËN dealer or a qualified
workshop.
Battery charge fault. Stop the vehicle and contact a
CITROËN dealer or a qualified
workshop.
Airbag or pretensioner fault. Contact a CITROËN dealer or a qualified workshop to have the
systems checked.
Fault with automatic headlamp
adjustment system. Contact a CITROËN dealer or a
qualified workshop.Only on vehicles fitted with xenon
headlamps.
Fault with the stability control
system (ASC). Contact a CITROËN dealer or a
qualified workshop.
Fault with the four wheel drive
transmission system. Contact a CITROËN dealer or a
qualified workshop.
1
Instruments

35
When the engine is
running, this indicates the
temperature of the coolant.
Range
When the engine is
running, this indicates
the distance which can
still be travelled with the
fuel remaining in the tank
based on the average
fuel consumption over the
last few miles/kilometres
travelled. This value may vary following a change
in the style of driving or the relief,
resulting in a large variation in the
current fuel consumption.
If you only add a few litres, the value
displayed will be incorrect. Therefore,
you must fill the tank whenever
possible.
Coolant temperature
gauge
If the bar is close to the critical
position located
on the right, the temperature is too high.
The symbol flashes when your engine is
overheating.
You must stop your vehicle as soon as it is
safe to do so.
Wait a few minutes before switching off the
engine. When the range is less than 30 miles (50 km)
,
dashes are displayed.
Refuel as soon as possible. The display of the
range is updated.
Wait for the engine to cool before
topping up the level. The cooling system
is pressurised.
To avoid any risk of scalding, unscrew
the cap by two turns to allow the
pressure to drop.
When the pressure has dropped,
remove the cap and top up the level,
if
necessary.
Contact a CITROËN dealer or a
qualified workshop. When you disconnect the battery,
the previous fuel consumption data
is lost and the value displayed will be
different from that displayed before the
battery was disconnected. The distance
displayed must be considered an
approximate indication.
1
Instruments

39
If the battery is disconnected, the
settings memory is cleared and
the default unit (km/L) is restored
automatically.If the battery is disconnected, the
settings memory is cleared and
the default unit (°C) is restored
automatically.
F

p

ress the INFO
button to scroll through the
units (km/L, L/100km, mpg (US), mpg (UK)
and RETURN) in succession.
F

p

ress and hold the INFO
button for a
few seconds to confirm your selection.
Choice of the temperature
display unit
F press and hold the INFO
button for a few
seconds to scroll the units (°C and °F) in
succession.
The mode selected is confirmed. In the menu screen:
F
p
ress the INFO
button to select the
temperature unit setting symbol
(thermometer):
Choice of the fuel consumption
unit
The distance, speed and quantity of fuel units
will also be changed in accordance with your
choice of fuel consumption unit.
In the menus screen:
F

p
ress the INFO button to select "UNIT" .
F

p
ress and hold the INFO button for a
few
seconds to display the " UNIT" screen.
1
Instruments

40
If you select the "- - -" setting, no
message will be displayed in message
display situations.
If the battery is disconnected, the
settings memory is cleared and the
default language (ENGLISH) is restored
automatically.
F

p

ress the INFO
button to scroll the
languages (Japonais, English, Deutsch,
Français, Espanol, Italiano, Russe "- - -" and
RETURN) in succession,
F

p

ress and hold the INFO
button for a few
seconds to confirm your selection.
Choice of the display LANGUAGE
In the menu screen:
F p ress the INFO button to
select


"LANGUAGE" :
F

p
ress and hold the INFO button for a few
seconds to display the "LANGUAGE"
screen:
Instruments

41
If the battery is disconnected, the
settings memory is cleared and
the default choice (ON) is restored
automatically.As a safety measure, it is
recommended that you stop for a break
every two
hours.
You can activate or deactivate the sound
associated with the INFO
button.
Activation / deactivation of the
"INFO" button sound
In the menu screen:
F
p
ress the INFO button to select
the INFO button sound activation
/
deactivation symbol (located in
menu 2/3) :
F

p
ress and hold the INFO button for a few
seconds to scroll the choices (ON, OFF) in
succession.
The mode selected is confirmed.
Changing the display interval of
the "REST REMINDER" message
The "REST REMINDER" function allows you to programme
an alert message reminding you to take a break.
The "REST REMINDER" message appears accompanied
by an audible signal.
You can change the display interval of the "REST
REMINDER" message.
In the menu screen:
F
p ress the INFO button to select "ALARM"
(located in menu 2/3) :
F

p
ress and hold the INFO button for a few
seconds to display the "ALARM" screen,F
p ress the INFO
button to select the display
interval of the "REST REMINDER"
message,
F

p
ress and hold the INFO button for a
few seconds to confirm.
If the battery is disconnected, the
settings memory is cleared and
the default value (OFF) is restored
automatically.
1
Instruments

45
If no action is carried out within
10 seconds, the selection menu closes
automatically.
To select the mode:
F

P

ress the "
PWR / VOL " button to switch on
the audio system.
F

P

ress the MENU
button.
F

P

ress the SEL
knob to scroll through the
menus and select " RDS setting - CT ON -
CT OFF " (clock time).
F

T

urn the SEL
knob to the left or to the right
to select "CT OFF" (manual mode) or "CT
ON" (automatic mode).
F

P

ress the SEL
knob to confirm.
The digital clock does not display
seconds.
The time setting is lost if the battery is
disconnected.
Manual adjustment
F Press the PWR / VOL button to switch on
the audio system.
F

P
ress the MENU button.
F

P
ress the SEL knob to scroll through the
menus and select " Time Setting Adjust ".
F

T
urn the SEL knob to select " ON" for
access to the time setting.
F

P
ress the SEL knob to confirm.
F

T
urn the SEL knob to adjust the time.
F

P
ress the SEL knob to confirm.
1
Instruments