key Citroen C4 CACTUS 2014 1.G User Guide

49
E3_en_Chap02_ouvertures_ed01-2014
If the problem persists, contact a
CITROËN dealer as soon as possible.
If the battery is flat, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.
Changing the battery
F Remove the flat battery from its location.
F
F it the new battery into its location
observing the original direction of fitment.
F

C
lip the cover onto the casing.
In the event of a fault with the remote control,
you can no longer unlock, lock or locate your
vehicle.
F

F

irst of all, use the key in the lock to unlock
or lock your vehicle.
F

T

hen, reinitialise the remote control.
Fault with the remote
control
Reinitialisation
F Switch off the ignition and remove the
ignition key.
F

P
ress the closed padlock immediately for a
few seconds.
F

T
urn the key to position 2 (Ignition on) .
F

S
witch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Battery ref.: CR2032 / 3 volts.
F

U
nclip the cover using a small screwdriver
at the cutout.
F

L
ift off the cover.
2
Access

50
E3_en_Chap02_ouvertures_ed01-2014
Lost keys
Go to a CITROËN dealer with the vehicle's registration document, your personal
identification documents and if possible the key code label.
The CITROËN dealer will be able to look up the key code and the transponder code
required to order a new key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your
pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of
your vehicle. You run the risk of stopping it from working and the remote control would have
to be reinitialised.
No remote control can operate when the key is in the ignition switch, even when the ignition
is switched off, except for reinitialisation.
Locking the vehicle
Driving with the doors locked may make access to the passenger compartment by the
emergency services more difficult in an emergency.
As a safety precaution, never leave children alone in the vehicle, except for a very short period.
In all cases, it is essential to remove the key from the ignition switch when leaving the vehicle.
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could
cause malfunctions.
When purchasing a second-hand vehicle
Have the pairing of all of the keys in your possession checked by a CITROËN dealer, to
ensure that only your keys can be used to open and start the vehicle.Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
Access

52
E3_en_Chap02_ouvertures_ed01-2014
Doors
From outside
F After unlocking the vehicle using the remote control or the key, pull the door
handle.
Opening
From inside
F Pull the interior control lever of a front door; this unlocks the vehicle completely.
The interior opening control on a rear
door does not work if the child lock is on.
Refer to the "Child lock" section. When a door is not fully closed:
-

e
ngine running
, a message appears in
the screen,
-
v
ehicle moving
, a message appears in
the screen, accompanied by an audible
signal.
Closing
Access

53
E3_en_Chap02_ouvertures_ed01-2014
Secondary control
Driver's door
(locking/unlocking)
Insert the key in the lock to lock or unlock the
d o o r. Procedure for mechanically locking and
unlocking the doors in the event of a fault with
the central locking system or a battery failure.
Front and rear passenger doors
Locking
In the event of a fault with the central
locking system, it is essential to
disconnect the battery to lock the boot
and so ensure complete locking of the
vehicle.
On the rear doors, check that the child
lock is not on.
F

R
emove the black cap located on the edge
of the door, using the key.
F

I
nsert the key into the aperture without
forcing, then without turning, move the
latch sideways towards the inside of
the door.
F

R
emove the key and refit the cap.
Unlocking
F

P
ull the interior door opening control lever.
2
Access

54
E3_en_Chap02_ouvertures_ed01-2014
Boot
Opening
F After unlocking the boot (see the "Remote control key" section), press the opening
control and raise the tailgate. F
L ower the tailgate using the interior grab
handle.
Closing Boot release
Unlocking
F Fold the rear seat backrest to gain access
to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
System for mechanical unlocking of the boot
in the event of a battery or central locking
malfunction.
If the tailgate is not fully closed:
-
e
ngine running
, a message appears in
the screen,
-

v

ehicle moving , a message appears in
the screen, accompanied by an audible
signal.
Access

55
E3_en_Chap02_ouvertures_ed01-2014
Front electric window controls
The electric window switches
remain operational for approximately
45 seconds after the ignition is
switched off or until a front door
is opened. If, during this period of
45
seconds, you open a door while
operating a window, the window stops.
The window switch will then only be
operative after the ignition is switched
on again.
1.
F

ront left electric window switch.
2.
F

ront right electric window switch.
F

P

ress the switch to open the window.
F

P

ull the switch to close the window.
The window stops when you release the switch. Always remove the key from the ignition
when leaving the vehicle, even for a
short time.
In the event of contact during operation
of the windows, reverse the movement
of the window. To do this, press the
corresponding switch.
When the driver operates the
passenger electric window switch, they
should ensure that no one is preventing
correct closing of the window.
The driver should ensure that the
passenger uses the electric window
c o r r e c t l y.
Be particularly aware of children when
operating the windows.
2
Access

80
Auxiliary socket
USB por t(s)*
For best reception, it is recommended
that the "CITROËN MULTICITY
CONNECT" connection key be plugged
into the USB port located in the glove
box (depending on version). When a USB port is used, the portable
device charges automatically.
For more information on the use of
this equipment, refer to the "Audio and
telematics" section.
It permits the connection of a portable device
to listen to your music files using the vehicle's
speakers.
The management of the files is done using your
portable device.
It allows the connection of a portable device or
a USB memory stick.
It reads the audio files which are sent to your
audio system and played via the vehicle's
speakers.
You can manage these files using the steering
mounted controls or the audio system.
* Depending on version. For more information on using this
equipment, refer to the "Audio and
telematics" section.
Fittings

86
E3_en_Chap05_conduite_ed01-2014
Starting - Stopping the engine
F Insert the key in the ignition switch. The system recognises the starting code.
F

T
urn the key fully towards the dashboard to
position 3 (Starting) .
F

W
hen the engine starts, release the key.
Starting
Avoid attaching heavy objects to the
key, which could pull down in it when in
the ignition switch and cause faults.Key left in the "Ignition on"
position
On opening the driver's door, an alert
message is displayed, accompanied by an
audible signal, to remind you that the key is
still in the ignition switch at position 1 (Stop) .
F Immobilise the vehicle.
F
T urn the key fully towards you to
position 1 (Stop) .
F

R
emove the key from the ignition switch.
Switching off
If the key has been left in the ignition
switch at position 2 (Ignition on) ,
the ignition will be switched off
automatically after one hour.
To switch the ignition back on, turn the
key to position 1 (Stop) , then back to
position 2 (Ignition on) .
Driving

104
E3_en_Chap05_conduite_ed01-2014
Memorising speeds
Memorisation
This function allows speeds to be saved, which can then be offered to set the two systems: the speed limiter (to limit the speed of the vehicle) or the
cruise control (for a vehicle cruising speed).
You can memorise up to six speed settings for each of the two systems. By default, some speeds are already memorised.F

I
n the secondary page, press
" Speed settings ".
For safety reasons, the driver must
carry out these operations when
stationary.
F

S
elect the system for which you want to
memorise speeds:
F

Sel
ect the "Driving assistance "
menu.
F

E
nter the new value using the numerical
keypad and confirm.
F

C
onfirm to save the modification and quit
the menu.
●

s
peed limiter or
●

c
ruise control.
F

C
hoose the speed setting you want to
m o di f y. This button restores the factory
settings.
This function is accessible in the touch screen
tablet.
Driving

127
E3_en_Chap06_visibilite_ed01-2014
Courtesy lamp
1. Courtesy lamp
2. Map reading lamps F

W
ith the ignition on, press the
corresponding switch.
Map reading lamps
With the "permanent lighting" mode,
the lighting time varies according to the
circumstances:
-

with the ignition off, approximately ten minutes,- in energy economy mode, approximately thirty seconds,
- with the engine running, unlimited.
In this position, the courtesy lamp
comes on gradually:
Permanently off.
Permanent lighting.
-

w

hen the vehicle is unlocked,
-

w

hen the key is removed from the ignition,
-
w

hen opening a door,
-

w

hen the remote control locking button is
pressed, in order to locate your vehicle. Take care to avoid leaving anything in
contact with the courtesy lamp.
Courtesy lamp
It switches off gradually:
-
w hen the vehicle is locked,
-

w
hen the ignition is switched on,
-

3
0 seconds after the last door is closed.
6
Visibility