boot Citroen C4 DAG 2009 1.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2009, Model line: C4 DAG, Model: Citroen C4 DAG 2009 1.GPages: 279, PDF Size: 12.28 MB
Page 69 of 279
77
V I S I B I L I T Y
V
Special position of the
windscreen wipers
In the minute following switching off
of the ignition, any action on the stalk
positions the wipers in the centre of
the windscreen.
This action enables you to position
the wiper blades for winter parking,
cleaning or replacement.
To park the wipers after this has
been done, switch on the ignition
and operate the stalk. For optimum and lasting wiping of
t h e " fl a t - b l a d e " w i p e r b l a d e s , i t i s
advisable to:
- handle them with care,
- clean them regularly using soapy water,
- change them approximately every 6 months,
- avoid using them to retain card- board on the windscreen. COURTESY LAMPS
Selection and control of the various
passenger compartment lamps.
1. Front courtesy
lamp
2. Map reading
lamps
Front courtesy lamp In this position, the courtesy
lamp comes on gradually: Permanently off.
Permanent lighting.
In permanent lighting mode, differ-
ent lighting times are available:
- with the ignition off, approxi- mately ten minutes,
- in energy economy mode, ap- proximately thirty seconds,
-
with the engine running, unlimited.
- when the vehicle is unlocked,
- when a door or the boot is opened,
- when the key is removed from the ignition,
- when the remote control locking button is activated, in order to lo-
cate your vehicle. It switches off gradually:
- when the vehicle is locked,
- when the ignition is switched on,
- 30 seconds after the last door is
closed.
Map reading lamps
With the ignition on, press the
corresponding switch.
Page 70 of 279
77
V I S I B I L I T Y
V
Special position of the
windscreen wipers
In the minute following switching off
of the ignition, any action on the stalk
positions the wipers in the centre of
the windscreen.
This action enables you to position
the wiper blades for winter parking,
cleaning or replacement.
To park the wipers after this has
been done, switch on the ignition
and operate the stalk. For optimum and lasting wiping of
t h e " fl a t - b l a d e " w i p e r b l a d e s , i t i s
advisable to:
- handle them with care,
- clean them regularly using soapy water,
- change them approximately every 6 months,
- avoid using them to retain card- board on the windscreen. COURTESY LAMPS
Selection and control of the various
passenger compartment lamps.
1. Front courtesy
lamp
2. Map reading
lamps
Front courtesy lamp In this position, the courtesy
lamp comes on gradually: Permanently off.
Permanent lighting.
In permanent lighting mode, differ-
ent lighting times are available:
- with the ignition off, approxi- mately ten minutes,
- in energy economy mode, ap- proximately thirty seconds,
-
with the engine running, unlimited.
- when the vehicle is unlocked,
- when a door or the boot is opened,
- when the key is removed from the ignition,
- when the remote control locking button is activated, in order to lo-
cate your vehicle. It switches off gradually:
- when the vehicle is locked,
- when the ignition is switched on,
- 30 seconds after the last door is
closed.
Map reading lamps
With the ignition on, press the
corresponding switch.
Page 71 of 279
78
V I S I B I L I T Y
V
This comes on automatically when
the boot is opened and switches
off automatically when the boot is
closed.
Different lighting times are available:
- when the ignition is off, approxi-mately ten minutes,
- in energy economy mode, ap- proximately thirty seconds,
- when the engine is running, no limit.
The sill lighting is at the bottom of
each door panel.
The lamps come on automatically
when a door is opened and switch
off automatically when all of the
doors are closed.
BOOT LIGHTING Sill illumination
Page 77 of 279
84
VI
F I T T I N G S
REAR ARMREST
Comfort and storage device for the
rear passengers.
Lower the rear armrest for a
more comfortable position.
Raise the cover to gain access
to its storage compartment.
T h i s h a s a s t o r a g e t r a y , t w o c a n
holders and two pen holders.
LUGGAGE SECURING RINGS
U s e t h e 2 r e a r s i d e fi x i n g s a n d
the 6 securing rings on the boot
fl o o r a n d t h e b a c k o f t h e r e a r
bench seat to secure your lug-
gage.
For safety reasons in the event of
s h a r p b r a k i n g , y o u a r e a d v i s e d t o
p l a c e h e a v y o b j e c t s o n t h e fl o o r a s
close as possible to the back of the
bench seat.
Hooked onto the stowing rings by
m e a n s o f r e a r s i d e fi x i n g s , t h i s e n a b l e s
you to secure your luggage.
Luggage retaining net
Page 84 of 279
84
VI
F I T T I N G S
REAR ARMREST
Comfort and storage device for the
rear passengers.
Lower the rear armrest for a
more comfortable position.
Raise the cover to gain access
to its storage compartment.
T h i s h a s a s t o r a g e t r a y , t w o c a n
holders and two pen holders.
LUGGAGE SECURING RINGS
U s e t h e 2 r e a r s i d e fi x i n g s a n d
the 6 securing rings on the boot
fl o o r a n d t h e b a c k o f t h e r e a r
bench seat to secure your lug-
gage.
For safety reasons in the event of
s h a r p b r a k i n g , y o u a r e a d v i s e d t o
p l a c e h e a v y o b j e c t s o n t h e fl o o r a s
close as possible to the back of the
bench seat.
Hooked onto the stowing rings by
m e a n s o f r e a r s i d e fi x i n g s , t h i s e n a b l e s
you to secure your luggage.
Luggage retaining net
Page 85 of 279
84
VI
F I T T I N G S
REAR ARMREST
Comfort and storage device for the
rear passengers.
Lower the rear armrest for a
more comfortable position.
Raise the cover to gain access
to its storage compartment.
T h i s h a s a s t o r a g e t r a y , t w o c a n
holders and two pen holders.
LUGGAGE SECURING RINGS
U s e t h e 2 r e a r s i d e fi x i n g s a n d
the 6 securing rings on the boot
fl o o r a n d t h e b a c k o f t h e r e a r
bench seat to secure your lug-
gage.
For safety reasons in the event of
s h a r p b r a k i n g , y o u a r e a d v i s e d t o
p l a c e h e a v y o b j e c t s o n t h e fl o o r a s
close as possible to the back of the
bench seat.
Hooked onto the stowing rings by
m e a n s o f r e a r s i d e fi x i n g s , t h i s e n a b l e s
you to secure your luggage.
Luggage retaining net
Page 137 of 279
133
XI
P R A C T I C A L I N F O R M A T I O N
CHANGING A WHEEL
Access to the tools
The tools are located in the spare
w h e e l , u n d e r t h e b o o t fl o o r .
To gain access to them:
open the boot,
l i f t t h e fl o o r ,
unclip and remove the box con-
t a i n i n g t h e t o o l s . List of tools
A l l o f t h e s e t o o l s a r e s p e c i fi c t o y o u r
v e h i c l e . D o n o t u s e t h e m f o r o t h e r
p u r p o s e s .
1. Wheelbrace
2. Centring guide
3. Tool for bolt protectors on alu-
minium wheels
4. Jack with handle
5. Aluminium wheel central embel-
lisher removal tool
6. Socket for anti-theft bolts (locat-
ed in the glove box)
A d j u s t s t o t h e w h e e l b r a c e .
7. R e m o v a b l e t o w i n g e y e Access to the spare wheel
The spare wheel is installed in the
b o o t , u n d e r t h e fl o o r .
Removing the wheel
U n d o t h e y e l l o w c e n t r a l s c r e w b y
a q u a r t e r t u r n .
Raise the spare wheel towards
y o u r e a r w a r d s .
Remove the wheel from the boot
s p a c e .
Page 138 of 279
133
XI
P R A C T I C A L I N F O R M A T I O N
CHANGING A WHEEL
Access to the tools
The tools are located in the spare
w h e e l , u n d e r t h e b o o t fl o o r .
To gain access to them:
open the boot,
l i f t t h e fl o o r ,
unclip and remove the box con-
t a i n i n g t h e t o o l s . List of tools
A l l o f t h e s e t o o l s a r e s p e c i fi c t o y o u r
v e h i c l e . D o n o t u s e t h e m f o r o t h e r
p u r p o s e s .
1. Wheelbrace
2. Centring guide
3. Tool for bolt protectors on alu-
minium wheels
4. Jack with handle
5. Aluminium wheel central embel-
lisher removal tool
6. Socket for anti-theft bolts (locat-
ed in the glove box)
A d j u s t s t o t h e w h e e l b r a c e .
7. R e m o v a b l e t o w i n g e y e Access to the spare wheel
The spare wheel is installed in the
b o o t , u n d e r t h e fl o o r .
Removing the wheel
U n d o t h e y e l l o w c e n t r a l s c r e w b y
a q u a r t e r t u r n .
Raise the spare wheel towards
y o u r e a r w a r d s .
Remove the wheel from the boot
s p a c e .
Page 141 of 279
136
XI
P R A C T I C A L I N F O R M A T I O N
TEMPORARY TYRE REPAIR KIT Using the kit
The kit is located in the boot under
t h e fl o o r . I t i s i n s t a l l e d i n t h e t o o l b o x ,
l o c a t e d u n d e r t h e s t o r a g e b o x .
S w i t c h o f f t h e i g n i t i o n .
Tick the wheel to be repaired
on the speed limitation sticker
e n c l o s e d t h e n a f fi x t h e s t i c k e r
to the vehicle's steering wheel
t o r e m i n d y o u t h a t a w h e e l i s i n
t e m p o r a r y u s e .
Clip the bottle 1 on the compres-
sor 2 .
Check that the switch A is tilted
to position "0" .
Connect the pipe of the bottle 1
t o t h e v a l v e o f t h e t y r e t o b e r e -
p a i r e d .
Unwind the pipe of the compres-
sor 2 f u l l y , t h e n c o n n e c t i t t o t h e
b o t t l e .
Connect the compressor's elec-
tric plug to the vehicle's 12 V
s o c k e t .
Start the vehicle and leave the
e n g i n e r u n n i n g .
C o m p l e t e s y s t e m c o n s i s t i n g o f a
compressor and a bottle of sealant
which permits
temporary repair of
t h e t y r e s o t h a t y o u c a n d r i v e t o t h e
n e a r e s t g a r a g e .
This repair kit is available from
C I T R O Ë N d e a l e r s .
It is designed to repair holes of
a maximum diameter of 6 mm,
l o c a t e d e x c l u s i v e l y o n t h e t y r e
t r e a d o r s h o u l d e r . A v o i d r e m o v i n g
a n y f o r e i g n b o d i e s w h i c h h a v e
p e n e t r a t e d t h e t y r e .
Page 148 of 279
143
XI
P R A C T I C A L I N F O R M A T I O N
Rear lamps
(5-door model)
I d e n t i f y t h e f a i l e d b u l b .
1. Sidelamps: W 5 .
2. Stop lamps and sidelamps:
P 2 1 / 5 .
3. Direction indicators:
P Y 2 1 W .
Open the boot:
First remove the top part of the
r e a r l a m p u n i t b y u n d o i n g t h e
screw A .
For access to the nut B , detach
t h e b o o t r e a r t r i m b y r e m o v i n g
t h e p i n s . U n d o B .
Remove the bottom part of the
l a m p u n i t .
Turn the bulb a quarter turn and
c h a n g e i t .
Changing the bulbs
Rear lamps
(3-door model)
I d e n t i f y t h e f a i l e d b u l b .
1. Direction indicators:
P 2 1 W .
2. Reversing lamps: P 2 1 W .
3. Stop lamps and sidelamps:
P 2 1 / 5 .