bulbs Citroen C4 PICASSO 2008 1.G Owner's Manual

12
3
4
182
VIFRONT LENS
 Dipped beam
 Main beam
 Sidelamp
 Direction indicator
Note : A slight misting may appear on the internal sur-face of the headlamp glass in some climatic conditions (e.g. low temperature or humidity) ; this disappears af-ter the lamps have been on for a few minutes.
C H A N G I N G B U L B SH A L O G E N H E A D L A M P S
Dipped beam
1. Remove the rubber plug.
2. Rotate the bulb-holder a quarter turn anti-clockwise and remove it from its housing.
3. Replace the bulb H7.
4. Reposition the bulb-holder by pushing it in, tighte -ning it by a quarter turn (clockwise).
5. Put back the rubber plug.
Changing a halogen bulb should only be done after the headlamp has been switched off for a few minutes (risk of serious burns).
Do not touch the bulb directly with your fi ngers, use lint-fre e cloths.
It is imperative to use only anti-U.V. type bulbs in order not to damage the headlamp.
When using a high-pressure washer on persistant marks, do not direct at the lamps or their outlines for too long, so as not to damage their coating and their seals.

12
3
4
184
VI Main beam (H7)
1. Remove the rubber plug.
2. Rotate the bulb-holder a quarter turn anti-clockwise and remove it from its housing.
3. Replace the bulb H7.
4. Reposition the bulb-holder by pushing it in, tighte -ning it by a quarter turn (clockwise).
5. Put back the rubber plug.
FRONT LENS WITH XENON DUAL-FUNCTIONDIRECTIONAL HEADLAMPS
Xenon dual-function headlamp (dipped/main beam)
C H A N G I N G B U L B SX E N O N D U A L - F U N C T I O N H E A D L A M P S
If the headlamp bears this symbol, any operation to change the Xenon dual-function directional headlamp D1S is the preserve of professionals (risk of electrocution).
Contact a CITROËN dealer.
It is recommended to change both bulbs at the same time if one of them is faulty. Sidelamp (see “Halogen headlamps”)
 Direction indicator (see “Halogen headlamps”)
When using a high-pressure washer on persistant marks, do not direct at the lamps or their outlines for too long, so as not to damage their coating and their seals.

1
23
A
B
VI
185
REAR LENS
Note the bulb that is faulty.
Bulbs
 Direction indicator: PY21W.
 Stoplamp and sidelamp :P21/5W.
 Reversing lamp : P21W.
Rear lamp units on the bodywork
1. With the tailgate open, press on the plastic cover A, located close to the lens, to release it from its housing.2. Undo the two screws B on the side of the lens and detach the lamp by pulling it rearwards.3. Disconnect the connector linking the lens unit with the tailgate.4. Remove the bulb-holder.5. Replace the bulbs. To remove a bulb, rotate it a quarter turn. To refi t the bulb, rotate it a quarter turn in the other direction.6. Reposition the bulb-holder.7. Reconnect the connector to the lens unit.8. Reattach the lamp unit on the body work and do up the two screws.9. Reposition the plastic cover by exerting pressure.
Rear lamps on the tailgate
1. With the boot open, remove the plastic cover on the tailgate.
2. Remove the bulb-holder from its housing.
3. Replace the bulb. To remove a bulb, rotate it a quarter turn. To refi t the bulb, rotate it a quarter turn in the other direction.
4. Reposition the bulb-holder.
5. Refi t the plastic cover.
C H A N G I N G B U L B SR E A R L E N S - C 4 P I C A S S O

3
2
1
4
186
VIREAR LENS
Note the bulb that is faulty.
Bulbs :
 Direction indicator : PY21W.
 Stoplamp : P21W.
 Reversing lamp : P21W.
 Sidelamp : LED
Contact a CITROËN dealer.
Rear lamps
1. With the tailgate open, undo the 3 screws located on the side of the lens unit and pull it rearwards to detach.
2. Disconnect the connector lin-king the lens unit to the boot. Do not disconnect the LEDs.
3. Remove the seal.
4. Remove the bulb-holder.
5. Replace the bulbs. To remove a bulb, rotate it a quarter turn. To fi t the bulb, rotate it a quarter turn in the other direction.
6. Reposition the bulb-holder.
7. Put back the seal.
8. Reconnect the connector to the lens unit.
9. Stow the harness in the open-ing provided in the bodywork.
10. Reattach the lens unit on the bodywork and do up the 3 screws.
Third stoplamp with bulb
1. With the boot open, detach the interior trim.
2. Undo the nuts.
3. Using a thin screwdriver, de-tach the 3 retaining lugs.
4. Remove the lamp via the ex-terior of the tailgate.
5. Remove the bulb-holder.
6. Change the faulty bulb(s).
Check that the vehicle lamps work correctly after each operation.
C H A N G I N G B U L B S
R E A R L E N S - G R A N D C 4 P I C A S S O
Third stoplamp with LED
Contact a CITROËN dealer

198
VI
A C C E S S O R I E S
A wide range of accessories and parts are available from the CITROËN network.and parts are available and parts
These accessories and parts have been tested and approved for reli-ability and safety.
They are all adapted to the needs of your vehicle and come with a CITROËN guarantee.of your vehicle and come your vehicle
There are 5 families into which these accessories and parts are arranged :
"Comfort and leisure" :
fl oor mats*, boot tray, boot carpet, sun visors, mini-bar, fragrance dif-fuser, boosters and child seats, roof bars, bicycle carrier, ski carri-ers, roof box, towbars, etc.
The fi tting of electrical equipment or accesso-ries which are not rec-ommended by CITROËN may result in a failure of your ve-hicle’s electrical system and overconsumption.
We ask you to take note of this warning and advise you to con-tact a dealer who can show you the range of approved equip-ment and accessories.
"Safety" :
anti-intrusion alarm, anti wheel theft, stolen vehicle locating, medical kit, warning triangle, high-visibility vest, dog guard, snow chains, front foglamps kit, rear parking assistance, etc.
"Navigation and communication" :
audio systems, navigation sys-tems, CD changer, DVD player, Bluetooth hands-free kit, auxiliary cable to connect a portable MP3 player, USB Box, loudspeakers, etc.
Depending on the country of sale, the law may require you to carry high-visibility vests, warn-ing triangles and replacement bulbs in the vehicle.
"Personalisation" :
seat covers, alloy wheels, wheel trims, mud fl aps, door sill protec-tors, etc.
"Boutique products" :
screen wash fl uid, cleaning and in-terior/exterior maintenance prod-ucts, bodywork touch-up aerosol and pen, etc.
* To avoid any risk of interfering with the pedals :
- check that the fl oor mat is cor-rectly positioned and fi xed,
- never use more than one fl oor mat.