rear wiper Citroen C4 PICASSO 2008 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2008, Model line: C4 PICASSO, Model: Citroen C4 PICASSO 2008 1.GPages: 266, PDF Size: 7.14 MB
Page 3 of 266
2
4
12
3
3
IN BRIEF
I
6
O P E N I N G
Opening rear screen
This opening gives you enhanced access to the boot, even if you are parked close to a wall or to another vehicle.
Opening
- Press on control 2. The handhold 4 is in line with the rear wiper.
Closing
- Lower the rear screen.
Opening the tailgate
- Press on control 1.
Note : You cannot open the tail-gate if the rear screen is already open.
Closing the tailgate
- Lower the tailgate, using one of the handholds 3, located on the inside of the tailgate trim.
- Past the balancing point, allow the tailgate to close itself (do not assist it or slow it down).
MODUBOX (22 kg maximum)C4 Picasso
The Modubox is composed of a s h o p p i n g t r o l l e y a n d a fl e x i b l e b a g which can be used independently of each other depending on your needs.
Page 12 of 266
4
3
2
1
AB
3
2
1
0
4
A
B
C
D
E
F
IN BRIEF
I
15
D R I V I N G
LIGHTING CONTROL
Ring A
1 Off
2 Automatic lighting
3 Sidelamps
4 Dipped beams / Main beams
Ring B
Front foglamps
Rear foglamps
Windscreen wiper
3 Rapid wipe.
2 Normal wipe.
1 Intermittent wipe.
0 Off.
4 Automatic wipe by pressing downwards, and single wipe.
Note : To deactivateautomatic wipe :
- go to position 1, then return to position 0.
Rear screen wipe
Stop.
Intermittent.
Timed wash and wipe.
A Warning lamps for direction indicators and vehicle lamps
B Audio system controls
C Multifunction display controls
D Horn
E Optional function controls
F Cruise control and speed limiter
Page 44 of 266
123
L
J
H
MR
OII
45
M U L T I F U N C T I O N S C R E E N C
Main Menu
Press on the button O to view the "Main Menu" of the multifunction screen. This menu gives you ac-cess to the following functions :
It is recommended that the driver should not manipulate the controls described below while the vehicle is in motion.
1 - Time
2 - Outside temperature
3 - Date and display zone
When the outside temperature is between +3 °C and -3 °C, the dis- p l a y o f t e m p e r a t u r e fl a s h e s ( i c e risk).Radio-CD
( S e e R a d i o - C D )
Trip computer, for :
- Entering the distance to your destination
- A c c e s s t o t h e l o g o f a l e r t s ( r e c a l l of alerts signalled previously)
- Access to the status of functions, such as automatic headlamps and windscreen wipe.
Personalisation - C o n fi g u r a t i o n , f o r a c t i v a t i n g / d e a c t i v a t i n g :
- operation of the rear wiper
- automatic guide-me-home lighting- Xenon dual-function directional headlamps
- electronic parking brake automatic f u n c t i o n s ( a p p l i c a t i o n / r e l e a s e )
- door selectivity
- lighting of daytime-running lampsand for choosing :- brightness intensity, time, date and units
- the display language
Bluetooth® hands-free kit
( S e e R a d i o - C D )
Note : The outside temperature displayed may be greater than the actual temperature if the vehicle is parked in bright sunlight.
Controls
O - Access to the "Main Menu"
J or M - Scrolling in the screen menus
L - Validation and Selection in the menus of the func-tion chosen or the value m o d i fi e d
H - Cancellation of the opera-tion or return to the previ-ous display
R - Selection of the type of in-formation to be displayed p e r m a n e n t l y ( d a t e , r a d i o -CD, trip computer) on the right of the screen
Page 78 of 266
4
3
A
2 1II
79
All lamps off
LIGHTING CONTROL
1 Stop
2 Automatic lighting
3 Sidelamps
4 Dipped beams / Main beams
Sidelamps on
Dipped beams / main beams on
Turn the ring A forwards.
Turn the ring A forwards.
Automatic lighting of headlamps
The sidelamps and dipped beams come on automatically when the a m b i e n t l i g h t i s i n s u f fi c i e n t o r i f t h e windscreen wipers are in continu-ous operation.
Pull the control stalk fully towards you to swap between dipped beams and main beams.
EXTERIOR SIDE LIGHTERS
These illuminate :
- the zones facing the driver’s and passenger’s doors,
- the zones forward of the door mirrors and rearward of the front doors.
I l l u m i n a t i o n / e x t i n c t i o n
The side lighters come on :
- when you unlock the vehicle or press on the lighting button on the remote control.
- when you remove the key from the ignition,
- when you open a door,
- when you use the remote control to locate your vehicle.
They are timed to go out automati-cally.
They go out as soon as the light is a g a i n s u f fi c i e n t o r a p p r o x . 5 m i n u t e s after the windscreen wipers have ceased.
To activate this function, place the control A on position 2.
Do not cover the sunlight sen-sor which is located behind the interior rear view mirror and visible from outside the wind-screen.
Turn the ring A forwards.
S I G N A L L I N G
Page 79 of 266
4
3
A
2 1II
79
All lamps off
LIGHTING CONTROL
1 Stop
2 Automatic lighting
3 Sidelamps
4 Dipped beams / Main beams
Sidelamps on
Dipped beams / main beams on
Turn the ring A forwards.
Turn the ring A forwards.
Automatic lighting of headlamps
The sidelamps and dipped beams come on automatically when the a m b i e n t l i g h t i s i n s u f fi c i e n t o r i f t h e windscreen wipers are in continu-ous operation.
Pull the control stalk fully towards you to swap between dipped beams and main beams.
EXTERIOR SIDE LIGHTERS
These illuminate :
- the zones facing the driver’s and passenger’s doors,
- the zones forward of the door mirrors and rearward of the front doors.
I l l u m i n a t i o n / e x t i n c t i o n
The side lighters come on :
- when you unlock the vehicle or press on the lighting button on the remote control.
- when you remove the key from the ignition,
- when you open a door,
- when you use the remote control to locate your vehicle.
They are timed to go out automati-cally.
They go out as soon as the light is a g a i n s u f fi c i e n t o r a p p r o x . 5 m i n u t e s after the windscreen wipers have ceased.
To activate this function, place the control A on position 2.
Do not cover the sunlight sen-sor which is located behind the interior rear view mirror and visible from outside the wind-screen.
Turn the ring A forwards.
S I G N A L L I N G
Page 82 of 266
3
2
1
0
4
II
81
Windscreen wipe
3 Rapid wipe.
2 Normal wipe.
1 Intermittent wipe.
0 Stop.
4 Automatic wipe by pressing downwards, and single wipe.
Note : To deactivate automatic wipe :
- go to position 1, then return to position 0.
Position 1 : The wipe interval will adjust automatically depending on of the speed of the vehicle.
Note : In position 2 or 3 : when the vehicle is stationary the wipe interval will reduce automatically.
F o r s a f e t y , t h e w i p e r s y s t e m i s d e a c t i v a t e d a p p r o x . o n e m i n u t e a f t e r you switch off the ignition.
When you switch on the ignition, to reactivate the function :
- return to the Stopposition,
- go to the position desired.
Vehicle equipped with a rain sensor
Position 4 by pressing downwards : The wipe interval will adjust auto-matically as a function of the intensity of the rain.
Note : A press downwards produces a single wipe without deactivating automatic wipe.
IMPORTANT :
Do not cover the rain sensor, which is located behind the interior rear view mirror and visible from outside the windscreen.
If washing the vehicle, switch off the ignition or deactiva te automatic wipe.
Changing the wiper blades
For replacement, the wipers should be stopped in themaintenance position.
Switch off the ignition, then within a minute action the wiper control stalk. The wipers will position themselves in the middle of the wi ndscreen.
After replacement, the wipers will resume their normal position when you switch on the ignition and action the wiper stalk.
For optimum wiping, change the wiper blades once they start t o leave marks on the screen ; otherwise, change them once or twice a year (e .g. in autumn and in spring).
For safety, the wiper system is deactivated approx. one minute after you switch off the ignition.
W A S H / W I P E
Page 83 of 266
A
B
82
II
A - Headlamp wash
Provided the dipped beams are on, pull the control stalk towards you : screen wash will then be ac-companied by a timed sweep of the wipers as well as by a head-lamp wash.
Check that the front and rear wipers are able to operate freely if you are using a bicycle carrier, for example.
If the windscreen is frozen when you are starting a journey, ma ke sure that you de-ice it before using the front and rear wipers.
Remove any accumulation of snow from the base of the windscreen.
B - Rear screen wipe
Rear screen wipewill deployautomatically, provided the windscreen wipers are operating, when you engage reverse gear.
Activation / deactivation of this function is possible via the “Personalisation - C o n fi g u r a t i o n ” m e n u i n t h e “ M a i n m e n u ” .
Note : Deactivation may be essential if you install a bicycle-carrier on t he tailgate.
Stop.
Intermittent rear screen wipe.
Timed rear screen wash and wipe.
W A S H / W I P E
Page 261 of 266
505050
VI
A1A2A3
ABCD
A1
A2
A3
B2
D1
D2
D1
A4
B1B2B3
D2
A4
B1
B3
C
A
B
D
D3
D3
D4
D4
C O N F I G U R A T I O N
A C C E S S I N G T H E M E N U - S T R U C T U R E
T h e C o n fi g u r a t i o n m e n u e n a b l e s y o u t o p r o g r a m m e y o u r N a v i D r i v e as well as certain functions of your vehicle.
WHAT ARE THE FUNCTIONS OF THE CONFIGURATION MENU ?
CONFIGURING THE DISPLAY OF YOUR NAVIDRIVE
Choose the colour of the display.
Adjust the brightness of the display.
A d j u s t t h e d a t e a n d t h e t i m e a n d d e fi n e t h e f o r m a t 1 2 H o r 2 4 H .
Choose a feminine voice or a masculine voice and adj ust the voice synthesiser volume.
CONFIGURE THE VOICE OF YOUR NAVI DRIVE
CHOOSE THE LANGUAGE OF THE VOICE SYNTHESISER AND OF THE DISPLAY
Choose the duration for guide-me-home lighting and activate or deactivate the directional headlamps.
DEFINE THE VEHICLE PARAMETERS (ACCORDING TO EQUIPMENT )DEFINE THE V THE
Choose system of measurement: metric or imperial.
Activate or deactivate the voice commands.
Activate or deactivate the audio/video auxiliary inpu t.
Activate or deactivate the automatic triggering of th e rear wiper when you engage reverse gear.
HOW TO ACCESS THE CONFIGURATION MENU ?
Press button MENU. R o t a t e t h e c o n t r o l t o s e l e c t t h e C o n fi g u r a t i o n i c o n .Press on the control to validate.