fuel Citroen C4 PICASSO 2013 1.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2013, Model line: C4 PICASSO, Model: Citroen C4 PICASSO 2013 1.GPages: 420, PDF Size: 9.66 MB
Page 314 of 420
312
Checks
The various caps and covers allow access for checking the levels of the various fluids, for replacing cer tain components and for primingthe fuel system.
Diesel engines
1.
Screenwash and headlamp wash reser voir.2.
Coolant reservoir. 3.
Brake fluid reservoir.4.
Battery / Fuses. 5.
Fusebox.
6.Air filter.
7. Engine oil dipstick. 8.Engine oil filler cap.9.
Priming pump * .
*
According to engine.
Page 315 of 420
313
8
Checks
Fuel
Capacity of the tank: approximately 57 litres (petrol) or 55 litres (Diesel).
Low fuel level
Refuelling
When the low fuel level is reached,
this warning lamp in the instrumentpanel comes on, accompanied by anaudible warning, a message and the
last bar of the fuel gauge comes on in orange.
) Take care to select the pump that delivers
the correct type of fuel for your vehicle. ) Introduce the nozzle so as to push in themetal non-return flap A. )
Make sure that the nozzle is pushed in as
far as possible before star ting to refuel (risk
of blowback). ) Maintain this position throughout the
refuelling operation. ) Push the fuel flap to close it.
If you are filling your tank to the top, do
not persist after the 3rd cut- off; this could cause malfunctions.
A label on the inside of the fuel filler flapreminds you of the type of fuel to use,
depending on your engine type.
Additions of fuel must be of at least 5 litres to
be registered by the fuel gauge. When it
first comes on, about 6 litresof fuel
remain in the tank.
Until sufficient fuel has been added, this warninglamp appears every time the ignition is switched
on, accompanied by an audible warning and amessage. This audible warning and message
are repeated with increasing frequency as the fuel level drops towards "0".
Refuel as soon as possible to avoid running out.
Opening the filler flap may result in an inrush of air. This is entirely normal and results from the
sealing of the fuel system.
) Press the rear edge of the flap to open it
(the filler cap is par t of it).
With Stop & Star t, never refuel with the
system in STOP mode; you must switchoff the ignition with the START/STOP button.
Page 316 of 420
314
Checks
The petrol or Diesel engine of your vehicle is fitted with a catalytic conver ter, a device which helps to reduce the level of harmful emissions
in the exhaust gases.
For petrol en
gines, you must use unleaded fuel.The filler neck is narrower, allowing only
unleaded petrol nozzles to be introduced.
If you have put in the wrong fuel for your vehicle, you must have thefuel tank drained and filled withthe correct fuel before star ting the engine.
Fuel cut- of f
Your vehicle is equipped with a safety device
which cuts off the fuel supply in the event of acollision.
Page 317 of 420
315
8
Checks
Misfuel prevention (Diesel) *
Operation
When a petrol filler nozzle is introduced into the
fuel filler neck of your Diesel vehicle, it comes
into contact with the flap. The system remainsclosed and prevents filling.Do not persist but introduce a Diesel type filler nozzle.
*
Depending on country of sale. Mechanical device which prevents fillin
g the tank of a Diesel vehicle with petrol. It avoids the risk of engine damage that can result from filling with the
wrong fuel.
It remains possible to use a fuel can tofill the tank. In order to ensure a good flow of fuel,do not place the nozzle of the fuel can in direct contact with the flap of the misfuel prevention device and pour slowly.
Travelling abroad
As Diesel fuel pump nozzles may be different in other countries, thepresence of the misfuel prevention device may make refuelling impossible.
Before travelling abroad, werecommend that you check with the CITROËN dealer network, whether your vehicle is suitable for the fuel pumps inthe country in which you want to travel.
Page 318 of 420
316
Checks
Quality of the fuel used for
petrol engines
The petrol engines are perfectly compatible
with E10 or E24 type petrol biofuels (containing10 % or 24 % ethanol), conforming to Europeanstandards EN 228 and EN 15376.
E85 type fuels (containing up to 85 % ethanol)
are reserved exclusively for vehicles marketed
for the use of this type of fuel (BioFlex
vehicles). The quality of the ethanol mustcomply with European standard EN 15293.
Quality of the fuel used for
Diesel engines
The Diesel engines are perfectly compatible
with biofuels which conform to current andfuture European standards (Diesel fuel whichcomplies with standard EN 590 mixed with abiofuel which complies with standard EN 14214)
available at the pumps (containing up to 7 %Fatty Acid Methyl Ester).
The B30 biofuel can be used in cer tain Diesel engines; however, this use is subject to strict
application of the special ser vicing conditions.Contact a CITROËN dealer or a qualified
workshop.
The use of any other type of (bio)fuel (vegetable or animal oils, pure or diluted,
domestic fuel...) is strictly prohibited (risk of
damage to the engine and fuel system).
Page 319 of 420
317
8
Checks
Running out of fuel (Diesel)
On vehicle fitted with HDi engines, the fuel system must be primed if you run out of fuel;
refer to the corresponding engine compar tment
view.
1.6 litre HDi engine
)
Fill the fuel tank with at least five litres of diesel.
)
Open the bonnet. )
If necessary, unclip the styling cover for
access to the priming pump. ) Squeeze and release the priming pumprepeatedly until resistance is felt (there may be resistance at the first press). )
Operate the star ter until the engine starts(if the engine does not star t at the first
attempt, wait around 15 seconds before
tr
ying again). ) If the engine does not star t after a few
attempts, operate the priming pump again
then star t the engine. ) Clip the styling cover back in place. )
Close the bonnet.
If the tank on your vehicle is fitted witha misfuel prevention device, refer to the"Misfuel prevention (Diesel)" section.
If the engine does not star t first time, don't keep trying but star t the procedureagain from the beginning.
Page 322 of 420
320
Checks
fluids with the skin. Most of these fluids are harmful tohealth or indeed very corrosive.
Do not discard used oil or fluids into sewers or onto the ground.
Take used oil to a CITROËN dealer or a qualified workshop (France) or to anauthorised waste disposal site.
Used products
To p p i ng up
The reser voir must be topped up without delay by a CITROËN dealer or a qualified workshop.
Diesel fuel additive level
(Diesel with particle
emissions filter)
The additive reservoir low level isindicated by fixed illumination of this
warning lamp, accompanied by an
audible signal and a message that
the par ticle emissions filter additive
l
evel is too low.
The warning lamp comes on when the ignition
is switched on, or ever
y time the stalk is
operated, until the reser voir is refilled.
Next time
you stop, refill the screenwash / headlamp wash reser voir.
Screenwash/headlamp
wash level low
In the case of vehicles fitted with
headlamp washers, when the fluid
reservoir low level is reached this
warning lamp comes on in the
instrument panel, accompanied by
an audible signal and a message.
Page 335 of 420
9
333
Technical data
Identifi cation markings
Various visible markings for the identification of your vehicle.
A
.Vehicle Identification Number (VIN) under the bonnet. This number is engraved on the chassisnear the right hand front wheel arch.
The tyre pressures must be checked when the tyres are cold, at least once
a month.
If the tyre pressures are too low, thisincreases fuel consumption.
C
.Manufacturer's label.
This self-destroying label affixed to
the centre pillar, right or left hand side,contains the following information.
- the manufacturer's name,
- the European whole vehicle type approval number,
- the vehicle identification number (VIN),
- the maximum authorised weight (gross vehicle
weight),
- the maximum authorised weight with trailer (gross
train weight),
- the maximum front axle weight,
- the maximum rear axle weight.
D.Tyre/paint label. This label, affixed to the centre pillar, on
the driver's side, contains the
followinginformation.
- the tyre inflation pressures with and
without load,
- the t
yre sizes (including the tyre load
index and speed rating),
- the inflation pressure for the spare
w
heel,
- the paint colour code.
B
.Vehicle Identification Number (VIN) on
the windscreen lower cross member. This number is indicated on a self-adhesive label which is visible through the
windscreen.
Page 383 of 420
381
Level 1Level 2Comments
Confi guration
Secondary page
SystemConfi guration
Units Set the units used to display distance, fuelconsumption and temperature.
Erase data Select the desired data in the list then press Delete.
Factor
y settings Return to factory settings.
Confi rm
Save the settings.
Confi guration
Secondary page
Time/Date
Confi rm Set the date and time then confi rm.
Confi guration
Secondary page
Screen settingsBri
ghtness
Make the setting then confi rm.
Automatic text scrolling
Deactivate animations
Validat
e
Page 388 of 420
06
386
Modify system settings
System
Select "System confi guration
".
Pr
ess on Confi guration
to display the primarypage then go to the secondary page.
Select "Units" to change the units of distance, fuel consumption and temperature.
Select "Factory settings " to return to theoriginal settings.
Select "Delete data
" to delete the list of recent
destinations, personal points of interest, contacts in the list.
Choose the item then select " Delete".
CONFIGURATION
Select " Screen settings". Pr
ess on Confi gurationto display the primary page then go to the secondary page.
Select " Brightness" to switch off the screen or
adjust the brightness.
Activate or deactivate " Activate automatic text
scrolling " and " Activate animations
".