instrument panel Citroen C4 PICASSO DAG 2010.5 1.G Owner's Manual

11
F A M I L I A R I S A T I O N

8. Controls:
- Trip mileage recorder reset button
- Lighting rheostat

9. Warning lamps display (with the
MyWay or NaviDrive multifunction
screen)

10. Electric parking brake

11. Instrument panel

12. Hazard warning lamps

13. Switch panels:
- Emergency or assistance
- Lane departure warning system

14. ESP deactivation button

15. Steering lock - Ignition switch

16. Multifunction screen steering
mounted controls

17. Horn

1. Controls:
- Lighting
- Direction indicators
- Front and rear foglamps

2. Paddles for automatic gearbox or
6-speed electronic gearbox system

3. Cruise control and speed limiter
steering mounted controls

4. Direction indicator warning lamps

5. Audio and telematics system
steering mounted controls

6. Selector for automatic gearbox or
6-speed electronic gearbox system

7. Controls:
- Windscreen wipe
- Screenwash
- Rear screen wipe
- Trip computer
I N S T R U M E N T S A N D C O N T R O L S

18. Optional function controls
(on steering wheel)

19. Fusebox access cover

20. Controls:
- Fuel fi ller fl ap
- Front and rear parking sensors
- Stop & Start
- Volumetric alarm deactivation
- Headlamp adjustment

21. Bonnet release

22. Mirror controls

18
F A M I L I A R I S A T I O N
Seat belts not fastened/
unfastened warning lamp This warning lamp informs you if
the driver’s or front passenger’s
seat belt is not fastened (de-
pending on model), and if the
front passenger’s (depending
on model) or the second-row
passengers’ seat belts are unfastened.
The illuminated positions represent
those whose seat belts are not fas-
tened/unfastened.
Once the function has been activated,
when starting the engine, the system
automatically locks the doors once you
reach approximately 6 mph (10 km/h).
This function can be deactivated
by pressing button A for more than
two seconds.
Tyre under-inflation detection
This function warns you if a tyre is de-
fl ated or punctured.
This system does not absolve the driver
of the need to regularly check the tyre
pressures.
The service warning lamp comes
on, and a vehicle outline is dis-
played, accompanied by a mes-
sage and an audible signal.
Under-infl ation warning
The STOP warning lamp comes
on, and a vehicle outline is dis-
played, accompanied by a mes-
sage and an audible signal.
Puncture
 40

 124
 88
M O N I T O R I N G
Automatic central locking
Instrument panel
with multifunction screen A or C
with the MyWay or NaviDrive
multifunction screen

1. Instrument panel.

2. Multifunction screen.

3. Control buttons.

4. Warning lamps display zone.
 30

 31 Manual central locking
You can use electrical central locking or
unlocking by pressing on button
A .
If one of the doors is open or is not
closed properly, central locking will not
work.

27
F A M I L I A R I S A T I O N
D R I V I N G
Stop & Start
Engine going into STOP mode The "ECO" warning lamp comes
on in the instrument panel and
the engine goes into stand-by:
- with the 6-speed electronic gear-
box system ; at speeds below
4 mph (6 km/h), press the brake
pedal or put the gear lever into neu-
tral (position N) .
In certain circumstances the STOP
mode may not be available; the "ECO"
warning lamp fl ashes for a few seconds
then goes off.

 150 The
"ECO" warning lamp goes
off and the engine restarts:
- with the gear lever in position A or M ,
release the brake pedal,
- or with the gear lever in position N and
the brake pedal released, change to
position A or M ,
- or select reverse gear.
In certain condition, START mode may
be invoked automatically; the "ECO"
warning lamp fl ashes then goes off.

 151 Deactivation/Reactivation
You can deactivate the system at any
time by pressing the
"ECO OFF" button;
the button's warning lamp comes on.
The system is reactivated automati-
cally every time you start the engine
with the key. Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition
with the key.

 151
Going into engine START mode

I
30M O N I T O R I N G
MONOCHROME INSTRUMENT PANEL (WITH MULTIFUNCTION SCR
EEN A)

1. Rev counter

2. Gear shift indicator for a manual
gearbox or gear selector lever and
gear for the electronic gearbox
system or automatic gearbox
3. "Foot on brake" warning lamp for
the electronic gearbox system or
automatic gearbox/Electric parking
brake

4. Speedometer

5. Cruise control or speed limiter
setting
A. Lighting rheostat (available day
and night)

B. Trip mileage recorder reset
Central screen Controls
TWO-TONE INSTRUMENT PANEL (WITH MULTIFUNCTION SCRE
EN C)

6. Fuel gauge

7. Trip mileage recorder

8. Multifunction screen A/C

9. Total mileage recorder
In this zone, the following infor- mation appears in succession
when the ignition is switched on:
- service indicator,
- engine oil level indicator,
- total mileage recorder.

I
31
M O N I T O R I N G
INSTRUMENT PANEL WITH MYWAY OR NAVIDRIVE MULTIFUNCTION SCREEN

1. Cruise control or speed limiter
setting

2. Speedometer

3. MyWay or NaviDrive multifunc-
tion screen
4. Rev counter

5. "Foot on brake" warning lamp for
the electronic gearbox system or
automatic gearbox/Electric park-
ing brake

6. Fuel gauge
A. Lighting rheostat (available day
and night)

B. Trip mileage recorder reset
Central screen Controls

7. Gear shift indicator for a manual
gearbox or selector lever posi-
tion and gear for the electronic
gearbox system or automatic
gearbox

8. Trip mileage recorder

9. Total mileage recorder
In this zone, the following infor- mation appears in succession
when the ignition is switched on:
- service indicator,
- engine oil level indicator,
- total mileage recorder.

10. Warning lamp zone.

III
56
C O M F O R T
Air conditioning
To ensure that your system operates
correctly, it is recommended that you
have it checked regularly.
Water arising from condensation
in the air conditioning drains away
through a hole provided for this pur-
pose. A pool of water may thus form
under the vehicle when stationary.
To preserve the sealing of the air
conditioning compressor, operate
the air conditioning at least once a
month.
Regardless of the season, the air
conditioning is useful, since it re-
moves humidity and condensation.
To be effective, the air conditioning
should only be used with the win-
dows closed.
If after a lengthy stop in bright sun-
light the interior temperature is
excessive, air the passenger com-
partment by opening the windows
for a few moments, then close them
again.
The air conditioning operates by
using power from the engine. This
results in a slight increase in fuel
consumption.
Dust filter/Odour filter (active
carbon)
There is a fi lter for excluding odours
and dust.
This fi lter has to be changed in
accordance with the vehicle's ser-
vicing schedule (see "Maintenance
and Warranty Guide").
Air circulation
Air vents on the fl oor underneath the
front seats provide enhanced heat-
ing for the rear seat positions; take
care not to obstruct them.
Air vents
The air vents to the face have grilles
and thumbwheels to adjust the air
fl ow and direction (up-down, right-
left).
The automatic regulation of the air
conditioning in the passenger com-
partment uses a number of sensors
(sunshine sensor, ambient tempera-
ture sensor...) that relieve you of the
need to make frequent adjustments
to the displayed temperature.
Take care not to obstruct the sun-
shine sensor, located on the dash-
board behind the instrument panel.
Sensors

IV
91
A C C E S S
FUEL TANK

Capacity of the tank: approxi-
mately 60 litres.
Low fuel level When the low fuel level is
reached, this warning lamp
on the instrument panel
comes on, accompanied by
an audible warning and a message
on the multifunction screen.
When it fi rst comes on, about 7 litres
of fuel remain in the tank.
Until suffi cient fuel has been
added, this warning lamp appears
every time the ignition is switched
on, accompanied by an audible
warning and a message. Depending
on version, this audible warning
and message are repeated with
increasing frequency as the fuel
level drops towards " 0 ".
Refuel as soon as possible to avoid
running out. A label on the inside of the fuel fi ller
fl ap reminds you of the type of fuel
to use, depending on your engine
type.
Additions of fuel must be of at least
5 litres to be registered by the fuel
gauge.
Refuelling

If you are fi lling your tank to
the top, do not persist after the
3rd cut-off; this could cause
malfunctions.
With Stop & Start, never refuel with
the system in STOP mode; you
must switch off the ignition with the
key. Opening the fi ller cap may result in
an inrush of air. This is entirely nor-
mal and results from the sealing of
the fuel system.

 Press control switch A , situated
on the switch panel on the left of
the dashboard, until the fuel fl ap
opens.
This control switch remains ac- tive for a few minutes after
switching of the ignition. If nec-
essary, switch the ignition on
again to reactivate it.

 Take care to select the pump
that delivers the correct type of
fuel for your vehicle.

 Introduce the nozzle so as to push
in the metal non-return fl ap B.

 Make sure that the nozzle is
pushed in as far as possible
before starting to refuel (risk of
blowback).

 Maintain this position throughout
the refuelling operation.

 Push the fuel fl ap to close it.

V
93
V I S I B I L I T Y
EXTERIOR LIGHTING CONTROLS
Control stalk for the selection and con-
trol of the various front and rear lamps
providing the vehicle's lighting.
Main lighting
The various front and rear lamps of
the vehicle are designed to adapt
the driver's visibility progressively in
relation to the climatic conditions:
- sidelamps, to be seen,
- dipped beam headlamps to see without dazzling other drivers,
- main beam headlamps to see clearly when the road is clear.
Additional lighting
Other lamps are fi tted to fulfi l the re-
quirements of particular driving con-
ditions:
- a rear foglamp to be seen from a distance,
- front foglamps for even better forward vision,
- directional headlamps for im- proved visibility when cornering,
- daytime running lamps to be seen during the day. Programming
Various automatic lighting control
modes are also available depending
on options:
- guide-me-home lighting,
- automatic illumination of head-
lamps,
- directional lighting.
Manual controls Lamps off.
Automatic illumination of
headlamps.
Sidelamps only.
Dipped headlamps or
main beam headlamps.

B. Stalk for switching headlamps:
pull to switch the lighting be-
tween dipped headlamps/main
beam headlamps.
In the lamps off and sidelamps
modes, the driver can switch on the
main beam headlamps temporarily
("headlamp fl ash") by maintaining a
pull on the stalk.
Displays
Lighting of the corresponding indi-
cator lamp on the instrument panel
confi rms the switching on of the
lighting selected.
The lighting commands are issued
directly by the driver by means of
the ring
A and the stalk B .
A. Main lighting mode selection
ring: turn it to position the symbol
required facing the mark.

V
98
V I S I B I L I T Y
DIRECTIONAL LIGHTING
When the dipped or main beam
headlamps are on, this function en-
ables the light beam to follow the di-
rection of the road.
The use of this function, coupled
with the xenon headlamps only,
considerably improves the quality of
your lighting when cornering.
with directional lighting

without directional lighting Programming
The function is activat-
ed or deactivated via
the multifunction screen
confi guration menu.
Operating fault If a malfunction occurs, this
warning lamp fl ashes on the
instrument panel, accompa-
nied by a message on the
multifunction screen.
Consult a CITROËN dealer.
When stationary or moving at very low
speed or when reverse gear is engaged,
the system is inactive.
The status of the system remains in the
memory when the ignition is switched
off.
On vehicles fi tted with daytime running
lamps, the function is activated if the light-
ing stalk is in the "AUTO" or "Dipped/
main beam headlamps" position. In po-
sition "0" , the function is not activated.

V
98
V I S I B I L I T Y
DIRECTIONAL LIGHTING
When the dipped or main beam
headlamps are on, this function en-
ables the light beam to follow the di-
rection of the road.
The use of this function, coupled
with the xenon headlamps only,
considerably improves the quality of
your lighting when cornering.
with directional lighting

without directional lighting Programming
The function is activat-
ed or deactivated via
the multifunction screen
confi guration menu.
Operating fault If a malfunction occurs, this
warning lamp fl ashes on the
instrument panel, accompa-
nied by a message on the
multifunction screen.
Consult a CITROËN dealer.
When stationary or moving at very low
speed or when reverse gear is engaged,
the system is inactive.
The status of the system remains in the
memory when the ignition is switched
off.
On vehicles fi tted with daytime running
lamps, the function is activated if the light-
ing stalk is in the "AUTO" or "Dipped/
main beam headlamps" position. In po-
sition "0" , the function is not activated.