panel Citroen C4 PICASSO RHD 2013 1.G Manual PDF

198
Driving
Assistance in exiting from a
parallel parking space
) With the vehicle stationary, press
this control at the steering wheel,
)
Press on "Exit parking slot
" in
the touch screen tablet.
) Operate the direction indicator for the exitside chosen.)
Engage reverse or for ward gear and
release the steering wheel.
)
The assisted parking manoeuvre is in
progress. Without exceeding 3 mph(5 km/h), move for wards and backwards,
aided by the warnings from the "Parking sensors" system, until the indication of the end of the manoeuvre.
The manoeuvre is complete when the vehicle'sfront wheels are clear of the parking space.
At the end of the manoeuvre, the indicator lamp
in the instrument panel goes off, accompanied
by a message and an audible signal.
The assistance is deactivated: you can take over control.

)When you want to leave a parallel parkingspace, star t the engine.
or
)Select "Park Assist
" in the " Driving assistance
" menuof the touch screen tablet toactivate the function.
This indicator lam
p comes on in
the instrument panel to confirm the
activation of the function.

199
4
Driving
) Once you have identified a
parking zone, press this control
at the steering wheel,


Assistance with bay parking manoeuvres
)
Select "Park Assist" in the"Driving assistance " menuof the touch screen tablet to
activate the function.
This indicator lamp comes on in
the instrument panel to confirm the
activation of the function.
) Operate the direction indicator on the
parking side chosen to activate the
measurement function. You should drive at a distance of between 0.5 m and 1.5 m from the row of parked vehicles.
) Drive slowly following the instructions until
the system finds a free space.
)
Move for wards slowly until a message is
displayed, accompanied by an audiblesignal, asking you to engage reverse gear.
or
) Limit the speed of the vehicle to
a maximum of 12 mph (20 km/h) and select " Start parking in a
bay " on the touch screen tablet.

When several successive bays are found, the vehicle will be directed towards the last one.

200
Driving

During a bay parking manoeuvre, thePark Assist system is automaticallydeactivated once the rear of the vehicle is within 50 cm of an obstacle.
) Select reverse, release the steerin
g wheeland star t moving without exceeding 5 mph (8 km/h).
)The assisted parking manoeuvre is in progress.
Without exceeding 5 mph (8 km/h), follow
the instructions displayed in the instrumentpanel, aided by the warnings from the"Parking sensors" system, until the indication of the end of the manoeuvre. At the end of the manoeuvre, the operatin
gindicator lamp goes out in the instrument panel,
accompanied by a message and an audible
signal. The assistance is deactivated: you can takeover control.



During parking and exit fromparking manoeuvres, the reversingcamera function may come intooperation. It facilitates monitoring of the surroundings of the vehicle,by displaying additional information in the instrument panel (see thecorresponding section).

201
4
Driving
The system is deactivated automatically:


- on switching off the ignition,

- if the engine stalls,

- if no manoeuvre is star ted within 5 minutes
of selection of the t
ype of manoeuvre,

- after a prolonged stop of the vehicle during a manoeuvre,

- if the road wheel anti-spin regulation (ASR) is triggered,

- if the speed of the vehicle exceeds thestated limit,

- when the driver interrupts movement of the steering wheel,

- if the driver presses the Park Assist control.

- after 4 manoeuvre c
ycles,

- on opening the driver's door,

- if one of the front wheels encounters anobstacle.
The operation indicator lamp goes off in the
instrument panel and a message is displayed
accompanied b
y an audible signal.
The driver should then take back control of thevehicle's steering.


Deactivation


If the system is deactivated during a manoeuvre, the drive should reactivate it manually to repeat the measurement.
The s
ystem is switched off automatically:
- when towing a trailer,
- if the driver's door is opened,
- if the speed of the vehicle is above 42 mph(70 km/h).
To switch the system of for a prolonged period, contact a CITROËN dealer or a qualified workshop.

In the event of a fault with the system,
this warning lamp is displayed in the
instrument panel and a messa
ge appears,
accompanied b
y an audible signal.
Operating faults
In the event of a fault with the power steering, this warning lamp
comes on in the instrument panel accompanied by an aler t message.
Contact a CITROËN dealer or a qualified
workshop.
Switching off

If the lateral distance between your vehicle and the space is too great, the system maynot be able to measure the space.
Anything projecting beyond the envelopeof the vehicle (long or wide load) is not taken into account by the Park Assist system during a manoeuvre.

In bad weather or in winter, ensure thatthe sensors are not covered by road dir t, ice or snow.
In the event of a fault, have the systemchecked by a CITROËN dealer or a qualified workshop.
The indicator lamp
for the function flashes for a few seconds.
If the fault occurs during the use of
the system, the indicator lamp goesoff.

203
5
Visibility

Displays

Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
li
ghting selected is on.
The rear sidelamps and directionindicators are located on the tailgate. When they are on, opening the tailgateautomatically transfers illumination tothe lamps located in the rear bumper, to
maintain the safety of the vehicle.


Main lighting

Lighting off / daytime running lamps.

Automatic illumination of headlamps.
Daytime running lamps / Dippedbeam / Main beam.

Sidelamps.
Di
pped headlamps or main beam
headlamps.
Turn the ring Ato place the desired symbolagainst the mark.
Selection of main lighting mode


Model without AUTO li
ghting



Model with AUTO lighting
Headlamp dipping
Pull the stalk Btowards you to switch thelighting between dipped and main beam headlamps or to activate automatic headlamp
dipping.

In the lamps off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining a pull on the stalk.

205
5
Visibility

Operation of the rear foglamps is inhibited with the tailgate open. Opening the boot when these lamps are on causes them and their indicator lamp in the instrument panel to go off. They do not come back onautomatically when the boot is closed: they must be switched on again using the control stalk.

In good or rainy weather, by both day and night, the front foglamps and therear foglamps are prohibited. In thesesituations, the power of their beams may dazzle other drivers. They should only be used in fog or falling snow.In these weather conditions, you shouldswitch on the foglamps and dippedbeam headlamps manually, as thesunshine sensor may detect sufficient light.Do not forget to switch off the front andrear foglamps when they are no longer necessary.


Switching off the lightingwhen switching off the ignition

When the ignition is switched off, all of thelamps switch off immediately, except for thedipped beam headlamps if automatic guide-me-home lighting is activated.


Switching on the lightingwhen switching on the ignition

To reactivate the lighting control stalk, turn the ring A
to position A"0"- lighting off, thento the position of your choice.
If the lighting is switched on manually after switching off the ignition, there is an audiblesignal when a front door is opened to warnthe driver that they have forgotten to switch
off the vehicle's lighting, with the ignition off.
They switch off automatically after a periodwhich depends on the state of charge of thebattery (entry to energy economy mode).

206
Visibility
Manual guide-me-home
lighting

Switching on
)
With the ignition off, "flash" the headlamps using the lighting stalk.)
A fur ther "headlamp flash" switches thefunction off.


Switching off

The manual guide-me-home lighting switches
off automatically after a set time. The temporar
y illumination of the dipped beam
headlamps after the vehicle's ignition has been switched off makes the driver's exit easier when
the light is poor.
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only. )Within one minute of switching off the ignition, operate the lighting control stalk up
or down depending on the traffic side (for
example: when parking on the left; lighting
control stalk upwards; the right hand
sidelamps are on).
This is confirmed by an audible signal and
illumination of the corresponding directionindicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the central position.

207
5
Visibility
Automatic illumination
of headlam
ps

Activation
)Turn the ring to the "AUTO"position. The activation of the function is accompanied
by the display of a message. When a low level of ambient li
ght is detected by a sunshine sensor, the number platelamps, sidelamps and dipped beam headlamps
are switched on automatically, without any
action on the par t of the driver. They can alsocome on if rain is detected, at the same time as
automatic operation of the windscreen wipers.

As soon as the brightness returns to asufficient level or after the windscreen wipers
are switched off, the lamps are switched off
automatically.
Deactivation
) Turn the ring to another position.Deactivation of the function is
accompanied by the display of a message.

Operating fault

In the event of a malfunction of the sunshine sensor, the lighting comes on, this warning lamp is displayed
In fog or snow, the sunshine sensor may detect sufficient light. In this case, thelighting will not come on automatically. Do not cover the sunshine sensor, coupled with the rain sensor andlocated in the centre of the windscreen behind the rear view mirror; the associated functions would no longer be controlled.



Automatic "guide-me-
home" lighting


When the automatic illumination of headlampsfunction is activated, under low ambient light the dipped beams headlamps come on
automatically when the ignition is switched off.

Programming
Activation or deactivation, as well as the
duration of the guide-me-home lighting, is set in the " Driving aids" menu, then "Vehicle
settings".
Contact a CITROËN dealer or a qualifiedworkshop.
in the instrument panel accompanied by an audible signal and/or a message.

209
5
Visibility

The system may suffer interference or not work correctly:


- under conditions of poor visibility(for example, snowfall, heavy rainor thick fog, ...),

- if the windscreen is dir ty, misted or obscured (by a sticker, ...) in front of the camera,

- if the vehicle is facing highly reflective signs.


The system is not able to detect:


- road users that do not have their own lighting, such as pedestrians,

- road users whose lighting is
obscured, such as vehicles running behind a safety barrier (on amotorway, for example),

- road users at the top or bottom of a steep slope, on twisty roads, oncrossroads.Switching off
)
In the "Driving assistance"menu, press the button, its
indicator lamp goes o
ff and
the the system changes to
"automatic illumination of headlamps" mode. To reactivate the s
ystem, flash the headlampsagain.
Depending on thesituation, one of these two indicator lamps comes on.

Switching on
)
Put the lighting control stalk ring
in the "AUTO" position.
)
In the " Driving assistance"
menu, press the button, its
indicator lamp comes on.

Operation



- dipped beam is maintained, this
indicator lamp comes on in the
instrument panel.
)Flash the headlamps(going beyond the point
of resistance) to activate
the function.

Once the function is activated, the system
operates as follows:
If the ambient li
ght level is very low and the
traffic conditions permit:


- m
ain beam comes on
automatically: this indicator lamp
comes on in the instrument panel. If the ambient li
ght level is sufficient and/or
if the traffic conditions do not allow illumination
of the main beam headlamps:
Pause
If the situation requires a change of headlampbeam, driver can take over at any time.
) Flashing the headlamps
again pauses the
function and thesystem changes to "automatic illumination of headlamps" mode:


- i
f the AUTO indicator lamp was on in green, the system changes to main
beam,

- i
f the AUTO indicator lamp was on in
blue, the system changes to dippedbeam.

213
5
Visibility








Directional lighting
on, this system allows the light beams to better
follow the road.
The use of this system, coupled with the
xenon headlamps and the cornering lighting,considerably improves the quality of your lighting round bends.
w
ith directional lighting
without directional lighting

Operating fault

This system is inactive:


- when stationary or at low speeds,

- when reverse is engaged.

If a fault occurs, this warning lamp flashes
in the instrument panel, accompanied by
a message in the screen.
Contact a CITROËN dealer or a qualified
workshop.

The directional li
ghting can be activated or deactivated via the " Driving aids" menu, then
"Vehicle settings".