under engine Citroen C5 2012 (RD/TD) / 2.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2012, Model line: C5, Model: Citroen C5 2012 (RD/TD) / 2.GPages: 316, PDF Size: 9.75 MB
Page 145 of 316
IX
!
!
143
DRIVING
In the event of a fault with the sys-
tem, the "ECO OFF"
switch warning
lamp fl ashes then comes on con-
tinuously.
Have it checked by a CITROËN
dealer or a qualifi ed workshop.
In the event of a fault in STOP mode,
the vehicle may stall: all the instru-
ment panel warning lamps come on.
It is then necessary to switch off the
ignition and start the engine again
using the key.
Operating fault
The Stop & Start system
makes use of advanced tech-
nology. For any work on the sys-
tem go to a qualifi ed workshop with
the skills and equipment required,
which a CITROËN dealer is able to
provide.
Before doing anything under
the bonnet, deactivate the
Stop & Start system to avoid
any risk of injury resulting from au-
tomatic operation of START mode.
Maintenance
This system requires a 12 V battery
with a special specifi cation and tech-
nology (reference numbers available
from CITROËN dealers).
Fitting a battery not listed by
CITROËN introduces the risk of mal-
function of the system.
To charge the battery, use a 12 V
charger and observe the polarity.
Page 153 of 316
IX
151
DRIVING
In the event of a steep descent or
under excessive acceleration, the
speed limiter (which does not act
on the brakes) may not be able to
prevent the vehicle from exceeding
the programmed speed.
Use of a fl oor mat other than that
recommended by CITROËN may
affect the normal operation of the
accelerator pedal and hamper the
operation of the speed limiter.
Floor mats approved by CITROËN
are fi tted with a 3rd fi xing located in
the pedal area to avoid any risk of
interference with the pedals.
Suspension / Resumption
)
Press on button 3
.
This action causes the information
"PAUSE"
to appear in zone A
of the
instrument panel.
This action does not cancel the
memorised maximum speed which
remains displayed in zone A
of the
instrument panel.
Overriding the programmed
speed
The accelerator pedal has an end-
of-travel switch. In order to exceed
the memorised maximum speed at
any time, you can press the pedal
all the way down. While the speed
is being exceeded, the speed dis-
played in zone A
will fl ash. You have
only to release the accelerator pedal
to return below the maximum speed,
to restore the function.
The speed will also fl ash if the speed
limiter is not able to prevent the vehi-
cle from exceeding the programmed
speed (e.g. on a steep descent or
under excessive acceleration).
To reactivate the speed limiter, re-
lease the accelerator to slow to a
speed lower than the programmed
speed.
Return to normal driving
)
Either press on button 5
.
)
Or select the speed limiter func-
tion.
)
Or stop the engine.
Operating fault
If there is a fault, a message is
displayed accompanied by an au-
dible signal and illumination of the
SERVICE
warning lamp.
Have it checked by a CITROËN
dealer or a qualifi ed workshop.
Page 169 of 316
X
!
167
CHECKS
DIESEL ENGINES
The various caps and covers allow
access for checking fl uid levels, for
replacing certain components and
for priming the fuel system.
1.
Screenwash and headlamp wash
reservoir.
2.
Power steering fl uid reservoir or
power steering and suspension
fl uid reservoir, depending on
equipment.
3.
Engine coolant header tank.
4.
Engine oil dipstick.
5.
Engine oil fi ller cap.
6.
Air fi lter.
7.
Brake fl uid reservoir.
8.
Battery.
As the Diesel fuel system op-
erates under high pressure,
any work on the fuel system
is prohibited.
Vehicles fi tted with the HDi 140
en-
gine may be fi tted with metal spring
suspension. In this case, a differ-
ent power steering fl uid reservoir is
fi tted.
HDi 115
/ e-HDi 115
HDi 140
Page 170 of 316
X!
168
CHECKS
HDi 160 - HDi 200 engines
(with particle emissions filter)
1.
Screenwash and headlamp wash
reservoir.
2.
Power steering and suspension
fl uid reservoir.
3.
Engine coolant header tank.
4.
Engine oil dipstick.
5.
Engine oil fi ller cap.
6.
Air fi lter.
7.
Brake fl uid reservoir.
8.
Battery.
As the Diesel fuel system ope-
rates under high pressure:
- All work on the fuel system is
prohibited.
- HDi engines make use of ad-
vanced technology.
All maintenance and repairs require
special qualifi cations which only a
CITROËN dealer can guarantee.
HDi 160
HDi 200
Page 171 of 316
X!
169
CHECKS
V6 HDi 240 engine
(with particle emissions filter)
V6 HDi 240
1.
Screenwash and headlamp wash
reservoir.
2.
Power steering and suspension
fl uid reservoir.
3.
Engine coolant header tank.
4.
Engine oil dipstick.
5.
Engine oil fi ller cap.
6.
Air fi lter.
7.
Brake fl uid reservoir.
8.
"+" and "-" terminals for emergency
starting with a slave battery.
As the Diesel fuel system ope-
rates under high pressure:
- All work on the fuel system is
prohibited.
- HDi engines make use of ad-
vanced technology.
All maintenance and repairs require
special qualifi cations which only a
CITROËN dealer can guarantee.
Page 172 of 316
X
!
170
CHECKS
CHECKING LEVELS
Oil level
The check is carried out either
when the ignition is switched
on using the oil level indicator
on the instrument panel, or
using the dipstick.
This manual check will only be cor-
rect if the vehicle is on level ground
and the engine has been off for more
than 30 minutes.
It is normal to top up the oil level be-
tween two services (or oil changes).
CITROËN recommends that you
check the level, and top up if neces-
sary, every 3 000 miles (5 000 kms).
After topping up the oil, the check
when switching on the ignition with
the oil level indicator in the instru-
ment panel is not valid during the
30 minutes after topping up.
If a level drops signifi cantly, have
the corresponding system checked
by a CITROËN dealer or a qualifi ed
workshop.
Check all of these levels regularly
and top them up if necessary, unless
otherwise indicated.
Take care when working under the
bonnet, as certain areas of the en-
gine may be extremely hot (risk of
burns).
Engine oil change
Refer to the servicing booklet for
details of the interval for this opera-
tion.
In order to maintain the reli-
ability of the engine and emis-
sion control system, the use
of additives in the engine oil is
prohibited.
Oil specifi cation
The oil must be the correct grade
for your engine and conform to the
manufacturer's recommendations.
Brake fluid level
The brake fl uid level should
be close to the "MAX" mark.
If it is not, check the brake
pad wear.
Changing the fl uid
Refer to the servicing booklet for de-
tails of the interval for this operation.
Fluid specifi cation
The brake fl uid must conform to the
manufacturer's recommendations
and meet the DOT4 standard.
Power steering or power
steering and suspension
fluid level
For topping up, it is necessary
to go to a CITROËN dealer or
a qualifi ed workshop.
Dipstick
There are two marks on
the dipstick:
A
= max; never exceed
this level,
B
= min; top up the oil
level via the oil fi ller cap,
using the correct grade of
oil for your engine.
Page 176 of 316
XI
174
PRACTICAL INFORMATION
TEMPORARY PUNCTURE
REPAIR KIT
Using the kit
The kit is located in the boot under
the fl oor.
)
Switch off the ignition.
)
Affi x the speed limitation sticker
to the vehicle's steering wheel
to remind you that a wheel is in
temporary use.
)
Check that the switch A
is in po-
sition "0"
.
)
Connect the pipe of the cartridge 1
to
the valve of the tyre to be repaired.
)
Connect the compressor's elec-
tric plug to the vehicle's 12 V
socket.
)
Start the vehicle and leave the
engine running. Complete system consisting of a
compressor and a sealant cartridge
which permits the temporary repair
of the tyre so that you can drive to
the nearest garage.
This repair kit is available from
CITROËN dealers or a qualifi ed
workshop.
It is designed to repair holes of a
maximum diameter of 6 mm, lo-
cated exclusively on the tyre tread
or shoulder. Avoid removing any
foreign bodies which have pene-
trated the tyre.
Page 178 of 316
XI
!
176
PRACTICAL INFORMATION
)
Connect the compressor's elec-
tric plug to the vehicle's 12 V
socket again.
)
Start the vehicle again and leave
the engine running.
)
Adjust the pressure using the
compressor (to infl ate: switch A
in position "1"
; to defl ate:
switch A
in position "0"
and
press button B
), in accordance
with the vehicle's tyre pressure
label (located on the door aper-
ture on the left-hand side), then
remember to check that the leak
has been plugged correctly (no
further loss of pressure after
several miles [kilometres]).
)
Remove the compressor, then
store the whole kit.
)
Drive at reduced speed (50 mph
[80 km/h] max) limiting the dis-
tance travelled to approximately
120 miles (200 km).
)
Visit a CITROËN dealer or a
qualifi ed workshop as soon as
possible to have the tyre repaired
or replaced by a technician. Take care as sealant cartridge
contains ethylene-glycol. This
product is harmful if swallowed
and causes irritation to the eyes.
Keep it out of reach of children.
The expiry date of the sealant is
indicated on the base of the car-
tridge.
The cartridge is designed for a sin-
gle use; even if only partly used, it
must be replaced.
After use, do not discard the car-
tridge into the environment, take it
to a CITROËN dealer or an autho-
rised waste disposal site.
Do not forget to obtain a new car-
tridge, available from CITROËN
dealers or a qualifi ed workshop.
If the vehicle is fi tted with tyre under-
infl ation detection, the tyre under-
infl ation warning lamp will remain on
after the wheel has been repaired
until the system is reinitialised by
a CITROËN dealer or a qualifi ed
workshop.
Page 181 of 316
XI
!
179
PRACTICAL INFORMATION
Removing a wheel
)
Park the vehicle on stable, fi rm
ground that is not slippery. apply
the parking brake.
)
If your vehicle is equipped with
"Hydractive III+" suspension,
with the engine running at idle,
adjust the ground clearance to
its maximum height.
)
Switch off the ignition and en-
gage fi rst gear or reverse gear
depending on any slope (for a
vehicle with automatic gearbox,
select position P
).
)
If your vehicle is fi tted with
"Hydractive III+" suspension,
position the chock, whichever di-
rection the gradient may be in, in
front of the front wheel diametri-
cally opposite to the one to be
replaced.
)
Position the jack at one of the four
jacking-points provided on the un-
derbody close to the wheels, then
use the wheelbrace to unwind the
jack until it reaches the ground.
)
Remove the protector from each
bolt using tool 3
.
)
Slacken the wheel bolts.
Before positioning the jack:
)
Always adjust the vehicle’s
ground clearance to the "maxi-
mum height" position and re-
tain this adjustment for as long
as the jack is under the vehicle
(do not use the hydraulic ad-
justments),
)
Immobilise your vehicle on hor-
izontal, stable and non-slippery
ground,
)
Ensure that any passengers
have left the vehicle and are in
a safe place .
Never get underneath the vehicle if
it is supported only by the jack.
The jack and all of the tools are
specifi c to your vehicle. Do not use
them for any other applications.
Have the original wheel repaired
and refi tted as soon as possible.
)
Continue to extend the jack until
the wheel is a few centimetres
off the ground.
)
Undo the bolts, remove the wheel.
Page 195 of 316
XI
193
PRACTICAL INFORMATION
FUSEBOX C
Fuse N°
Rating
Function
F1
15 A
Rear screen wipe (Tourer)
F2
30 A
Locking and deadlocking relay
F3
5 A
Airbags
F4
10 A
Automatic gearbox - additional heater unit (Diesel) - electrochrome rear view mirror
F5
30 A
Front window - sunroof - passenger door lighting - passenger door mirror adjustment
F6
30 A
Rear window
F7
5 A
Vanity mirror lighting - Glove box lighting - interior lamps - torch (tourer)
F8
20 A
Radio - CD changer - Steering mounted controls - Screen - Under-infl ation detection -
Electric boot ECU
F9
30 A
Cigar lighter - front 12 V socket
F10
15 A
Alarm - Steering mounted controls, signalling and wiper controls
F11
15 A
Low current ignition switch
F12
15 A
Driver’s electric seat - instrument panel - seat belt not fastened warning lamps - air
conditioning controls
F13
5 A
Engine relay unit - Hydraulic suspension pump cut-off relay - airbag ECU supply
F14
15 A
Rain and sunshine sensor - parking sensors - passenger’s electric seat - trailer relay unit -
HIFI amplifi er ECU - Bluetooth system - Lane Departure Warning System
F15
30 A
Locking and deadlocking relay
F17
40 A
Heated rear screen - heated door mirrors
FSH
SHUNT
PARK SHUNT