service Citroen C5 2014.5 (RD/TD) / 2.G Owner's Manual

On-line handbook
If the "MyCITRoËn" function is not available on the CITRoËn public website for your country, you
can find your handbook at the following address:
http://service.citroen.com/ddb/ Find your handbook on the CITROËN website, under "MyCITROËN".
Select:
Select one of the following means of access to
view your handbook on-line...
This personal and customisable space allows you to establish di rect and special contact with CITROËN.
the language,
the vehicle, its body style,
the print edition of your handbook appropriate for the date of registration of your vehicle.
Scan this code for direct access to your handbook.
Referring to the handbook on-line also gives you
access to the latest information available, easily
identified by the bookmark, associated with this
symbol:

14
Limit the causes of excess consumption
Spread loads throughout the vehicle; place the heaviest items in the
bottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance
(roof bars, roof rack, bicycle carrier, trailer...). Use a roof box in
preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refit your summer tyres.
Observe the recommendations on
maintenance
Check the tyre pressures regularly, when cold, referring to the label in
the door aperture, driver's side.
Carry out this check in particular:
-
b
efore a long journey,
-

a
t each change of season,
-

a
fter a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have your vehicle serviced regularly (engine oil, oil filter, air filter,
passenger compartment filter...) and observe the schedule of
operations recommended in the manufacturer's service schedule.
With a BlueHDi Diesel engine, if the SCR system is faulty your vehicle
becomes polluting; go to a CITROËN dealer or a qualified workshop
without delay to have the emissions of nitrous oxides brought back to
the legal level.
When refuelling, do not continue after the third cut-off of the nozzle to
avoid any over flow.
At the wheel of your new vehicle, it is only after the first 1 800 miles
(3 000 kilometres) that you will see the fuel consumption settle down to
a consistent average.
Eco-driving

15
Instrument panels - petrol and Diesel - manual and automatic gearbox
A. Fuel gauge
B. Indicator:
●

C
oolant temperature
●

C
ruise control/Speed limiter information
C.
Spe

edometer
D.
R

ev counter E. I
ndicator:
● E ngine oil temperature
●

G
ear lever position and gear engaged
(Automatic gearbox)
F.
C

ontrols:
●

L
ighting dimmer
●

R
eset the trip mileage recorder and
service indicator G. I
nstrument panel screen indicating:
● D epending on the page selected with the
left-hand thumb wheel on the steering
wheel:
-

D
igital speed repeater
-

T
rip computer
-
N

avigation (guidance) information
-

D
isplay of message alerts
-

E
ngine oil level check
-

S
ervice indicator
●
P

ermanently:
-

T
rip mileage recorder
-

T
otal mileage recorder
Panel grouping together the dials and vehicle operation indicator and warning lamps.
1
Monitoring

21
Service indicator
More than 2 000 miles (3 000 km)
remain before the next service is
due
When the ignition is switched on, no service
information appears on the instrument panel
central screen.
Between 600 miles (1 000 km)
and 2 000 miles (3 000 km) remain
before the next service is due
For 7 seconds after the ignition is switched on, the
spanner symbolising the service operations comes
on. The instrument panel central screen indicates the
distance remaining before the next service is due.
Example: 1 900 miles remain before the next service
is due.
For 7 seconds after the ignition is switched on, the
central screen indicates:
Less than 600 miles (1 000 km)
remain before the next service is due
Example: 500 miles remain before the next
service is due.
For 7 seconds after the ignition is switched on,
the central screen indicates:
The spanner remains on in the screen to
indicate that a service must be carried out
soon.
Indicators
This information is displayed for a few seconds
when the ignition is switched on. It informs
the driver when the next service is due, in
accordance with the manufacturer's servicing
schedule.
The point at which the service is due is
calculated from the last indicator zero reset. It
is determined by two parameters:
-

t
he distance travelled,
-

t
he time elapsed since the last service.
1
Monitoring

22
Service indicator zero resetService overdue
For 7 seconds after the ignition is switched
on, the spanner flashes to indicate that
the service must be carried out as soon as
possible.
Example: the service is overdue by 180 miles.
For 7 seconds after the ignition is switched on,
the central screen indicates:
The spanner remains on in the screen to
indicate that a service should have been
carried out. The distance remaining may be
weighted by the time factor, depending
on the driver's driving routine.
Therefore, the spanner may also come
on if you have exceeded the period
since the last service, indicated in the
manufacturer's service schedule.
After each service, the service indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:
F

s
witch off the ignition,
F

p
ress and hold the trip distance recorder
zero reset button,
F

s
witch on the ignition; the distance recorder
display begins a countdown,
F

w
hen the display indicates "=0", release
the button; the spanner disappears.
Following this operation, if you wish to
disconnect the battery, lock the vehicle and
wait at least five minutes for the zero reset to
be taken into account.
Monitoring

23
Engine oil level indicator*
On versions fitted with an electric oil level
indicator, the state of the engine oil level is
displayed in the instrument panel for a few
seconds, after the servicing information.
The level read will only be correct if the vehicle
is on level ground and the engine has been off
for more than 30 minutes.Oil level correct
This is indicated by the display of the message
"Oil level incorrect" in the instrument panel
screen, accompanied by the service warning
lamp and an audible signal.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to
avoid damage to the engine.
Refer to the "Checking levels" section.
Oil level indicator fault
* Depending on version.In the event of a fault with the electric
indicator, the oil level is no longer
monitored.
If the system is faulty, you must check
the engine oil level using the manual
dipstick located under the bonnet.
Refer to the "Checking levels" section.
Oil level incorrect
This is signalled by the display of the message
"Oil level measurement invalid" in the
instrument panel.
Contact a CITROËN dealer or a qualified
workshop.
1
Monitoring

24
Engine oil temperature
gauge
Under normal operating conditions, the bars
should be within section 1.
In severe operating conditions, the bars may
extend into section 2 .
In this event, slow down, and if necessary,
stop the engine and check the levels (see
corresponding section).
Coolant temperature gauge
Under normal operating conditions, the bars
should be within section 1 .
In severe operating conditions, the bars
may extend into section 2 , the engine
coolant temperature warning lamp A and the
STOP


warning lamp come on, stop as soon
as it is safe to do so . Switch off the ignition.
The cooling fan may continue to operate for
a cer tain time .
Contact a CITROËN dealer or a qualified
workshop.
If the SERVICE warning lamp comes on, check
the levels (see corresponding chapter). On horizontal ground, illumination of the fuel
low warning lamp indicates that you are at the
reser ve level.
An alert message is displayed in the instrument
panel.
Fuel gauge
Monitoring

26
Warning and indicator lamps
Warning/indicator lampis on Cause Action / Observations
STOP fixed, associated with
another warning lamp. It is associated with a punctured tyre
or the engine coolant temperature. Stop as soon as it is safe to do so.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Service temporarily. A minor fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in the
screen, such as, for example:
-

t
he closing of the doors, boot, rear screen or
bonnet,
-

t
he remote control battery,
-

t
he tyre pressures,
-

s
aturation of the particle emission filter (Diesel).
For any other faults, contact a CITROËN dealer or a
qualified workshop.
fixed. A major fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in the
screen and contact a CITROËN dealer or a qualified
workshop.
Visual indicators which inform the driver of the occurrence of a malfunction or fault (warning lamp)
or of the operation of a system (operation or deactivation indicator lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the ignition is switched on.
When the engine is started, these warning lamps should go off.
If they remain on, before moving off, refer to the information for the warning lamp concerned.
Associated warnings
The illumination, fixed or flashing, of certain warning lamps may be accompanied by an audible
signal and a message in the screen.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the
following warning lamps indicates a malfunction
or fault which requires action on the part of the
driver.
The illumination of a warning lamp is always
accompanied by the display of an additional
message, to assist you in identifying the fault.
If you encounter any problems, contact a
CITROËN dealer or a qualified workshop.
Monitoring

30
Warning/indicator lampis on Cause Action / Observations
Under-inflation fixed. The pressure in one or more wheels
is too low. Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
+ flashing then fixed,
accompanied by the
Service warning lamp.The tyre pressure monitoring system
has a fault or no sensor is detected
on one of the wheels. Under-inflation detection is not assured.
Have the system checked by a CITROËN dealer or a
qualified workshop.
Monitoring

36
With the Audio system switched on, once
this menu is selected, you can configure
your Bluetooth hands-free kit (pairing), view
the different telephone directories (calls log,
services...) and manage your calls (start a call,
end a call, double call, secret mode...).Adjusting the date time
"Bluetooth - Telephone -
A udio" menu
For safety reasons, configuration of the
multifunction screen by the driver must
only be done when stationary. For more information, refer to the Audio
system section.
F

P

ress on A
.
F

U

se C to select the "Date and time" menu,
then confirm your choice with a press on

C
on the steering wheel or D on the audio
system.
F

S

elect the screen configuration using C .
Confirm with a press on C on the steering
wheel or D on the audio system.
F

S

elect the date and the time settings,
using B. Confirm with a press on C on the
steering wheel or D on the audio system.
F

Press C to select the values you wish to
modify. Confirm your choice with a press
on C on the steering wheel or D on the
audio system.
F

C

onfirm with "OK" on the screen.
Monitoring