ESP Citroen C5 DAG 2007.5 (DC/DE) / 1.G Owner's Manual

I
8
9
10
1718
11
1
2
1213
14
153
5
8
6
4
7
16
19
20
21
IN BRIEF
1 Electric windows / Rear view mirrors / Child
safety controls
2 Memorisation of driver's seat and exterior rear
view mirror adjustments
3 Bonnet release
4 Controls at the steering wheel:
Speed limiter
Cruise control
5 Horn
6 Audio/telematic controls under steering wheel
7 Driver's airbag
8 Navigation controls
9 Driver's air vent
10 Instrument panel
11 Driver's air vent
12 Lighting control
13 Windscreen wiper / Screen wash controls
14 Ignition switch
15 ESP / Parking assistance controls
16 Steering column adjustment
17 Knees airbag
18 - Oddments tray
- Fusebox access fl ap
19 Checks / Anti-intrusion alarm / Parking space
sensor controls
20 Lighting / Direction indicators / Foglamp / Voice
recognition controls
21 Manual headlamp height adjustment
-
-
D A S H B O A R D

32
II
STOP warning lamp
When the warn-ing lamp comes on, you must stop the vehicle and switch off the engine. Contact a CITROËN dealer.switch off the engineswitch off
Parking brake
The permanent lighting of this warning lamp confi rms that the parking brake is applied.
If this warning lamp fl ashes, it indi-cates a fault with its application or release. Consult a CITROËN cates a fault with its application application
dealer as soon as possible.
See “Brakes”.
With the engine running, and when displayed at the same time as the STOP warning lamp, it indi-cates that the brake fl uid level is too low.
If this warning lamp comes on, stop immediately and contact a CITROËN dealer.stop immediately and immediately
See “Brakes”.
Battery charge
This warning lamp comes on temporarily when the engine is switched on. If it remains on permanently, contact a CITROËN dealer.remains on permanens on
In the event of a battery failure, the application of the electronic parking brake when the engine is switched off is not guaranteed. You must therefore apply the parking brake before switching off the engine.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
SERVICE
This warning lamp remains on perma-nently, as long as the fault displayed on the instru-ment panel screen is present (for serious faults).
Consult a CITROËN dealer as soon as possible.
This warning lamp remains on only for a short time for faults that are minor.
Contact a CITROËN dealer.
ESP/ASR
Operating
If either of the ESP or ASR systems is active, the warning lamp fl ashes.
For a malfunction
With the engine running, the light-ing of this warning lamp along with a message on the instrument panel screen, the lighting of the SERV-ICE warning lamp and a sound signal, indicates a system fault.
Contact a CITROËN dealer.
Deactivation
The lighting of this warning lamp and the light on the ESP deactiva-tion button confi rms that the sys-tem is deactivated.
See “Dynamic stability control” (ESP).
Coolant temperature
It comes on for a few sec-onds each time you switch on the ignition.
If this warning lamp comes on, engine running, it tells you that the coolant temperature is rising abnormally.
This warning lamp is linked with the STOP warning lamp.
It is essential to stop the vehi-cle.
Check the coolant level.
If the level is too low, contact a CITROËN dealer.If the level is too

70
II
T Y R E D E F L A T I O N D E T E C T I O N
Wheel not detected
The defl ation detection system is a driving aid, but which does not absolve the driver from the need to be vigilant and responsible.
This system does not dispense with the requirement to check the t yres on a regular basis (see “Vehicle identifi ca-tion”), to make sure that the vehicle is behaving correctly and to avoid premature tyre wear arising from driving too fast etc.
Do not forget to check the pressure in the spare wheel.
Any repair or replacement of a tyre on a wheel that is equipped with a sensor must be carried out by a CITROËN dealer.Any repair or replacement repair or
The system may suffer from temporary interference caused by radio transmissions on neighbouring frequencies.
Automatic detection:
A message indicates to you which tyre is punctured.
Driver request detection:
The vehicle outline indicates the punctured tyre(s).
Puncture
Automatic detection:
A message indicates to you which wheel is not detected.
Driver request detection:
The vehicle outline indicates the wheel(s) which is/are not detected.
Press on CheckAutomatic detection
Press on CheckAutomatic detection
The message is accompanied by the STOP warning lamp lighting up and a beep.
Note:If you have fi tted a wheel/wheels not equipped with tyre defl ation detection (e.g. snow tyres), contact a CITROËN dealer.
The message is accompanied by the SERVICE warning lamp lighting up and a beep.
Contact a CITROËN dealer to have the faulty sensor(s) replaced.

75
II
A
B
A U T O M A T I C G E A R B O X
Operation in SPORT or SNOW automatic mode
Lever at D:
Press on button A to select the SPORT driving mode.
Press on button B to select the SNOW driving mode.
Pressing again on button A or B returns you to NORMAL driving mode.
NORMAL mode is selected by default when the engine is started. This driving mode is suitable for normal driving conditions.
No warning lamp will light up in the instrument panel.
SNOW mode facilitates starting and smooth driving when road adherence conditions are poor.
The instrument panel display lights up.
SPORT mode is for more responsive driving, to provide maximum performance and acceleration.
The instrument panel display lights up.
Remark: The driving mode selected before you switched off the engin e will be retained the next time you start up.
If there is an operating fault, the gearbox is stuck in a gear, do not exceed 100 km/h (approx. 60 mph).
Juddering may be felt when selecting R for reverse gear or when returning to position D.
Consult a CITROËN dealer as soon as possible.
Do not stop your engine if the gear selector lever is in position D or R.

80
II
A
E L E C T R I C P A R K I N G B R A K E
D Y N A M I C E M E R G E N C Y B R A K I N G
Dynamic emergency braking
In the event of a failure of the vehicle’s main braking system or in an excep-tional situation (e.g. driver taken ill, under instruction, etc) a continuous pull on control A will stop the vehicle.
The electronic stability programme (ESP) provides stability during dynami c emergency braking.
If the dynamic emergency braking malfunctions, one of the following mes-sages will be displayed on the instrument panel screen:“Parking brake faulty”.
“Parking brake control faulty”.

86
II
A
E L E C T R O N I C S T A B I L I T Y P R O G R A M M E
The ESP system offers increased driving safety but is not in place to encourage the driver to take addi-tional risks or to drive at excessive speeds.
The functioning of this system is subject to compliance with the manufacturer’s recommendations on wheels (tyres and rims), brake parts and electronic components, as well as with the assembly and repair procedures approved by CITROËN.repair procedures repair procedures
After any collision, contact a CITROËN dealer.
Electronic Stability Programme (ESP) and Traction Control (ASR)
These systems are closely associated with ABS and additional to it. In the event of a loss of control of the vehicle by the driver, the ESP system acts automatically on one or more wheels and also on the engine to bring the vehicle back on trajectory. The ASR system optimises traction and prevents wheel spin by acting on the brakes of the driving wheels as well as on the engine. It also improves steering stability during acceleration.
Operation
If either of the ESP or ASR systems is active, the warning lamp fl ashes.
Deactivation
In exceptional conditions (vehicle stuck in snow, soft ground, e tc.) it may prove useful to deactivate the ESP/ASR systems to allow the wheels to spin and thus regain traction.
Press on control A, the warning lamp and the light on control A light up. The ESP/ASR systems are no longer active.
The ERSP/ASR systems will activate again:Automatically after the ignition has been switched off.
Automatically when you drive at above approx. 50 km/h (approx. 30 mph).
Manually with another press on button A.
Operational anomaly
If there is a system fault, the warning lamp lights up, accompa nied by a message on the instrument panel screen, the lighting of the SERVICEwarning lamp and a beep.
Contact a CITROËN dealer to have the system checked.

88
II
“ H Y D R A C T I V E I I I + ” S U S P E N S I O N
Position changes may only be made when the engine is run-ning.
Adjustable ground clearance responds to all types of situation. Apart from a few specifi c situa-tions, driving in the normal road position is imperative.
To change the position
Press once on one of the adjust-ment controls. The change in posi-tion is indicated by a message on the instrument panel screen:
Maximum height
Changing a wheel (Not possible if speed > 10 km/h).
Intermediate position
For an increased ground clearance (Not possible if speed > 40 km/h).
For use on diffi cult roads when travelling at reduced speed, as well as on carpark ramps.
Normal road position
Note: If the speed authorised for a par-ticular position is exceeded, the vehicle reverts automatically to the normal road position.
Minimum height
To facilitate loading or unloading the vehicle.
For workshop inspections.
Not to be used in normal driving (Not possible if speed > 10 km/h).
For your safety if you are operating underneath the vehicle, it is obligatory to support the vehicle with axle stands.
Viewing of the position of the vehicle
Once the adjustment has been made, a message is displayed on t he instru-ment panel screen.

90
II
P A R K I N G A S S I S T A N C E
As the vehicle approaches the obstacle, the sound signal becomes more and more urgent and the shaded areas are displayed closer and closer to the vehicle.
Proximity sensors are located in the front and rear bumpers of your vehi-cle.
When manoeuvring whether forwards or in reverse, at a speed below approximately 10 km/h (6 mph), they warn you of the presence of any obstacle located within their detection zone, by means of:A sound signal emitted by the front or rear loudspeakers.
Display of the outline of your vehicle with shading corresponding to the area where an obstacle is detected.
As the vehicle approaches the obstacle, the sound signal tells you the posi-tion of the obstacle according to whether the sound is coming from the front LH or RH or the rear LH or RH loudspeakers.Note: The sound volume of your audio equipment reduces automatically when a signal is being emitted.

99
III8285838184
7896
A
A
A U T O M A T I C A I R C O N D I T I O N I N G
M O N O Z O N E
The monozone system regulates the temperature, air distribution and air fl ow for the whole of the passenger com-partment.
2. Temperature adjustment
Turn control 2 to change the temperature:Clockwise to increase the temperature.
Anti-clockwise to reduce the temperature.
The chosen temperature is displayed.
An adjustment around 21 will give you the optimum comfort level. However, depending on your preferences anywhere between 18 and 24 is quite usual.
Operating the air conditioning system on “AUTO” guar-antees good ventilation inside the cabin.Note: The value indicated on the display corresponds to a comfort level and not to a temperature in Celsius or Fahrenheit.
Manual mode
One or more functions can be adjusted manually, while still retaining the other functions in automatic mode.
Press one of the buttons, except the temperature adjustment 2. The light A goes out.
Changing to manual mode may result in a decrease in comfort level (temperature, humidity, smell, misting) and is not advised for optimum comfort.
To return to “AUTO” mode, press button 1. Light Acomes on.

100
III
B
A U T O M A T I C A I R C O N D I T I O N I N G
M O N O Z O N E
3. Adjusting the air distribution
Press on buttons 3 to change the air fl ow dis-tribution.
The symbol (arrows) corresponding to the chosen dis-tribution lights up:Windscreen and front windows.Front air vents (central, side and soft diffusion grille if open) and rear air vents.
Front and rear footwells.Note: You cannot select distribution to the windscreen/front windows and to the front/rear air vents at the same time.