light Citroen C6 2009 1.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2009, Model line: C6, Model: Citroen C6 2009 1.GPages: 189, PDF Size: 9.28 MB
Page 91 of 189

107
III
C
D
I N T E R I O R L I G H T I N G
LATERAL AMBIANCE LIGHTING
This is in the zone designated by the arrows.
Adjustments
With the vehicle lamps on, press on buttons C or D to change the brightness of the lateral ambiance lighting.
FLOOR LIGHTING
In the front and the rear of the vehi-cle, when a door is opened, this lights up the interior of the vehicle.
Changing the bulb
T o c h a n g e t h e b u l b f o r t h e fl o o r lighting (front or rear): Detach the cover. Use a W 5 W bulb.
Rear
PAVEMENT LIGHTING
With the door open, this lights up the ground next to the vehicle.
Changing the bulb
To change the bulb for the door sill lighting: Detach the cover. Use a W 5 W bulb.
Page 94 of 189

110
III
I N T E R I O R C O M F O R T
CIGAR-LIGHTER
Front cigar-lighter
The front cigar-lighter is on the central console.
Rear cigar-lighter
The two rear cigar-lighters are on the central console below the air vents.
Operation
The cigar lighter operates when the ignition is on.
Push in and wait a few moments. The cigar lighter will release auto-matically: gradually emerging for easy removal.Note: The cigar lighter makes use of the 12 V accessory socket.
D r i v e r ' s fl o o r m a t
I f t a k i n g o u t t h e fl o o r m a t o n t h e driver's side, slide the seat rear-wards as far as it will go and r e m o v e t h e fi x i n g s .
W h e n r e fi t t i n g , p o s i t i o n t h e fl o o r mat correctly on the pins, then a t t a c h t h e fi x i n g s . C h e c k t h a t i t i s securely retained.
To avoid your feet becoming jammed under the pedals: U s e o n l y a fl o o r m a t t h a t i s s u i t e d t o t h e fi x i n g s , a l r e a d y present in the vehicle.
T h e u s e o f t h e s e fi x i n g s i s essential.
N e v e r fi t m o r e t h a n o n e fl o o r mat superimposed.
Page 107 of 189

124
IV
BC
A
i
1 2 V B A T T E R Y
STARTING THE ENGINE WITH AN ASSISTING BATTERY
If the battery is discharged, it is possible to use either a separate emergency battery or a battery on another vehicle.
If you use the battery on another vehicle, stop the engine on the latter. The two vehicles must not come into direct contact with each other.
C h e c k t h a t t h e a s s i s t i n g b a t t e r y h a s s u f fi c i e n t v o l t a g e (12 V).
Connect the cables according to the order indicated in orderthe diagram.
A Pole "+" on the vehicle being assisted (under the red cover).B Assisting battery.C Pole "–" on the assisted vehicle (under the bonnet).
Check that the leads are well secured (risk of sparks).
Start the engine of the assisting vehicle. Let the engine run for around 1 minute at a slightly accelerated idle.
Operate the starter on the vehicle being assisted.
It is essential to follow the indicated sequence correctly.
ADVICE
Do not touch the leads during the operation.
Do not lean over the batteries.
Disconnect the cables in reverse order, making sure they do not touch together.
N e v e r a p p r o a c h w i t h a fl a m e o r c r e a t e s p a r k s i n t h e v i c i n i t y o f t h e b a t t e r y ( e x p l o s i v e g a s ) .
The battery contains dilute sulphuric acid which is hig hly corrosive.
When handling batteries, always protect your face and es pecially your eyes.
In the event of any contact with the skin, rinse immediatel y with copious amounts of fresh water.