engine Citroen C8 DAG 2008 1.G User Guide

54 II
Operation in automatic mode
Automatic changing between the
4 or 6 gears.
Selector on
D.
The gearbox always selects the
gear best adapted to the following
parameters:
- style of driving,
- route proile,
- vehicle load.
The gearbox then operates in
automatic mode, without requiring
any action on your part.
Notes:
When braking, the gearbox
shifts down automatically to offer
effective engine braking.
The gearbox also enhances
your safety by not changing up
when you lift your foot from the
accelerator abruptly.
To obtain maximum acceleration
without touching the lever, press
rapidly down on the accelerator
pedal (kick down). The gearbox
will automatically change down or
maintain the selected gear up to
maximum engine speed. A U T O M A T I C G E A R B O X
Warning:
- Never select N function if the
vehicle is moving.
- Never select P or R if the vehicle
is not stationary.
- Do not change from one function to another to try to improve
braking on a slippery surface.
If, while the vehicle is moving,
function N is engaged inadvertently,
let the engine idle before engaging
a function that is appropriate. Snow programme
In addition to the automatic
programme, you have this special
programme which facilitates
starting and traction when road
grip conditions are poor.
Press button
, after you have
have started the vehicle and
selected function D;
The gearbox adapts to driving on
slippery roads.
Note:
You can return to the automatic
programme at any time:
Press button
once more to
deactivate the programme en-
gaged.
-speed gearbox (diesel engine):
when the vehicle is stationary
with the gear lever in position
D
(drive), a vibration limiting device
is activated when pressing the
brake pedal.

5 II
Operation
When either the ESP or ASR system is brought into operation, the ESP/
ASR warning lamp lashes.
Deactivation
In exceptional conditions (vehicle stuck in snow, soft ground, e tc.) it may
prove useful to deactivate the ESP/ASR system to allow the wheels to spin
and thus regain traction.
- press control A.
- The ESP/ASR warning lamp lights up, accompanied by an audible signal
and the message ESP/ASR DEACTIVATED on the multifunction screen.
Then the ESP/ASR systems are no longer active.
The ESP/ASR systems will redeploy:
- automatically if the ignition has been switched off or as soon as the
vehicle reaches approx. 50 km/h (approx. 30 mph),
- manually by a renewed press on the control A.
Operational anomaly
If the system is malfunctioning, ESP/ASR warning lamp lights up al ong
with the SERVICE warning lamp, a beep and the message “ESP/ASR
FAULT” on the multifunction screen.
Consult a CITROËN dealer to have the system checked.
Electronic Stability Programme (ESP) and Traction Control (ASR)
These systems are closely connected to the ABS and additional to i
t. In
the event of a loss of control of the vehicle by the driver, the ESP system
acts automatically on one or more brakes and also on the engine to bring
the vehicle back on trajectory. The ASR system optimises traction and
prevents wheel spin by acting on the brakes of the driving whe els. It also
improves steering stability during acceleration. E L E C T R O N I C S T A B I L I T Y P R O G R A M M E
Safety recommendations
The ESP system offers increased
driving safety but is not in place
to encourage the driver to take
additional risks or to drive at
excessive speeds.
The functioning of this system is
subject to compliance with the
manufacturer’s recommendations
on wheels (tyres and rims), brake
parts and electronic components,
as well as with CITROËN’s
assembly and repair procedures.
After any collision, have this
system checked by a CITROËN
dealer.

1
II
These actions do not cancel the cruise speed which
remains displayed on the screen.
Reactivation of cruise control

- By recalling the memorised cruise speed:
After a deactivation, press button 3.
Your vehicle returns automatically to the memorised
cruise speed which is displayed on the instrument
panel screen B.
If the memorised cruise speed is higher than the speed
at which you are currently travelling, the vehicle will
accelerate strongly to compensate.
- By selection of the current speed:
Press briely on button 2 or 4 when you are at your
desired speed.
The information “OFF” will then disappear from the
screen.
To cancel the function
- By moving the control from “CRUISE” position to
position 0.
- By stopping the engine.
The speed previously chosen is no longer
memorised.
In the event of a malfunction , a message is displayed,
accompanied by a sound signal and lighting of the
SERVICE warning lamp.
Consult your CITROËN dealer.
Cruise control must only be used where road conditions permit driving at a constant speed.
Do not use it on congested roads or when weather and ro ad conditions are poor.
The driver must still remain attentive and in complete co ntrol of the vehicle.
You are recommended to keep your feet within range of the pedals.
To exceed the cruise speed temporarily
While cruise control is operating, it is still possible to
go above the cruise speed by actioning the accelerator
pedal (for example to overtake another vehicle). The
speed displayed on the screen lashes. You have
only to release the accelerator pedal to return to the
memorised speed.
Adjusting the cruise speed while cruise control is
in operation
You can adjust the cruise speed,
displayed in zone B,
by pressing:
- Button 4 to increase the speed.
- Button 2 to reduce the speed.
Note: you can use successive presses to modify the
cruise speed in steps of 1 mph and a continuous press
to jump in steps of 5 mph.
Deactivation of cruise control with memorised
speed
- Either with a press on the brake pedal or clutch pedal.
- Or if ESP or ASR are activated.
- Or with a press on button 3.
Note: cruise control is disengaged when the gear lever
is in neutral position.
These actions bring up the dis-
play “OFF” in the instrument
panel screen. C R U I S E C O N T R O L

2 II
This driving assistance device allows you to choose a maximum speed.
This has to be over 30 km/h (approx. 20 mph).
Control
A for the speed limiter is situated below the lighting/sign alling
control stalk.
Note: The information relating to the speed limiter is displayed in the
instrument panel screen at B.
To select the function
Turn control 1 to position “LIMIT”.
On selection of the function via control 1, the last
speed memorised is displayed.
The information “OFF” then disappears from the
screen.
To adjust the maximum speed
Provided the engine is running, you can adjust the memorised spe
ed by
pressing:
- button 4 to increase the memorised speed,
- button 2 to decrease the memorised speed.
Note: you can use successive presses to modify the cruise speed in steps
of 1 mph and a continuous press to jump in steps of 5 mph.
To activate the speed limiter
If the desired limit speed is displayed, press button 3 to activate this limit.
While the function is active, pressing the accelerator pedal w ill not enable
you to go beyond the programmed speed unless you press the pedal
hard down past the tight spot (see “Temporary exceeding of the maximum
speed”).
Note: The vehicle speed may vary slightly from that memorised. S P E E D L I M I T E R

3
II
To deactivate the speed limiter
Press button
3 located on the end of control A.
A mat not approved by CITROËN risks sliding under the a ccelerator pedal, thus preventing you
from pressing past the tight spot.
It will then be impossible to exit from your speed limita tion, unless by resorting to the control
under the steering wheel.
The driver must still remain attentive and in complete co ntrol of the vehicle.
This action causes the information
“OFF” to appear in the instrument panel screen.
The memorised speed remains displayed and is not cancelled.
Temporary exceeding of the maximum speed
You can exceed the memorised maximum speed at any time by pressing th e accelerator pedal hard down past the
tight spot.
During the time the limit speed is being exceeded, the dis played speed lashes.
Simply release the accelerator pedal to return below the limit speed and make the function active again.
Note: if during use of the speed limiter the system is not able to retain the memorised speed (e.g. on a steep
descent), then the speed lashes. If necessary, adjust your driving speed.
The function will re-engage when your speed is again below the desired limit speed.
To cancel the function
- By moving the control from position “LIMIT” to position 0.
- By stopping the engine.
The speed previously chosen is memorised.
In the event of a malfunction , a message is displayed, accompanied by a sound signal and lig hting of the
SERVICE warning lamp. Consult your CITROËN dealer. S P E E D L I M I T E R

1
2
M
92 III
Memorisation of driving positions
It is possible to memorise two driving positions using buttons
1 and 2:
- turn the ignition key to the drive position “ M”,
- adjust your seat,
- press successively on control M then on button 1 “irst driving position” or on button 2 “second driving position”.
The memorisation is recognised by an audible signal. Memorising o f a new position cancels the previous one.
Recall of a memorised driving position
Engine stopped
- Press briely on button 1 or 2 to recall the corresponding memorised position.
Note: after several consecutive recalls of a memorised position, the fun ction will be deactivated until the engine
is started.
Engine running
- Keep button 1 or 2 pressed until the adjustment of the corresponding memorised posi tion has been completed.
F R O N T S E A T S

10 IV O P E N I N G T H E B O N N E T
Bonnet
This should only be operated
when the vehicle is stationary.
Lift the cover located under the
dashboard close to the door pillar
and pull the lever upwards.
Bonnet open alert
This function is available in
conjunction with the alarm option.
When the engine is running or the
vehicle is moving, if the bonnet is
incorrectly closed, you are alerted
by a symbol on the multifunction
screen accompanied by an audible
signal. Lift latch
A, located under the
centre forward edge of the bonnet
and pull the bonnet up. Position the bonnet stay as shown
in the illustration.
Ensure that it is securely in place.
Closing
Reposition the bonnet stay in its
clip and press irmly in place.
Lower the bonnet and then allow it
to drop shut.
Make sure that the bonnet is securely locked

10 IV
Due to the fact that the diesel
system is a high pressure
system:
IT IS FORBIDDEN TO CARRY
OUT ANY REPAIRS TO THE
SYSTEM. HDi engines are of a highly technical nature.
All maintenance and repairs require speciic qualiica tions which
only your CITROËN Dealer can guarantee.
2 . 0 H D i 1  V 1 2 0 E N G I N E
2 . 0 H D i 1  V 1 3  F A P E N G I N E

10 IV
Due to the fact that the diesel
system is a high pressure
system:
IT IS FORBIDDEN TO CARRY
OUT ANY REPAIRS TO THE
SYSTEM. HDi engines are of a highly technical nature.
All maintenance and repairs require speciic qualiica tions which
only your CITROËN Dealer can guarantee.
2 . 2 H D i 1  V 1 7 0 F A P E N G I N E

A
110 IV Air ilter
Follow the recommendations
in the Maintenance Guide.
When working under the bonnet, the cooling fan could
operate if the power unit is hot (even when switched off).
The engine oil level should be checked frequently
between services (as recommended by the manufacturer), as well as before long journeys.
Engine coolant
The coolant level should
be between the
MAX and
MIN marks on the header
tank.
If the engine is hot, wait
15 minutes.
Quality: Consult the Maintenance
Guide.
Never work on the cooling
system if the engine is hot. (See
“Levels”). Engine oil
Check the oil level with the
vehicle parked on horizon-
tal ground, the engine ha-
ving been switched off for at least
15 minutes.
Level: see “Capacities”.
Quality: Consult the Maintenance
Guide. Brake luid
The luid level must be si
-
tuated within the minimum
and maximum marks visi-
ble on the reservoir
Level: See “Levels”.
Quality: Consult the Maintenance
Guide.
If the warning lamp comes on:
stop the vehicle
Power steering oil
For topping up, it is neces-
sary to go to a CITROËN
dealer.
Oil quality: Consult the Mainte-
nance Guide.
Take out the oil dipstick.
The level must be between
the
MAX and MIN marks
on the dipstick
It should never exceed the maximum mark.
L E V E L S
R e f e r t o t h e c h a p t e r U s e r P r e c a u t i o n s
Windscreen, rear screen
and headlamp washer
luid
It is recommended that you use
products approved by CITROËN.
Level: see “Capacities”.
MAX
MIN