bonnet CITROEN DISPATCH SPACETOURER 2017 Handbook (in English)

4
Exterior
Filler cap, fuel tank 261-262
Misfuel prevention 26 2-263
Running out of Diesel fuel, priming

3
22
Under-inflation detection
2

58-260
Tyres, pressures

2
59 -260, 327
ESC system

1
59 -161
ABS, EBFD

1
59 -160
DSC, ASR

1
61
Grip control

1
61, 162-163
Snow chains

2
64
Front doors

6
5
AdBlue
® tank 2 78 -281
Tool box 2 82-284
Automatic illumination of headlamps
1
47
Automatic headlamp dipping
1
51-152
Direction indicators

1

46
Adjusting the headlamp beam height

1

53
Changing front bulbs

2

98 -304
Headlamp wash

1

56
Panoramic sunroof

1

20
Accessories
26

7-268
Opening the bonnet

2

71 Key
4
5
Key, remote control
4
5 -50
Changing the battery, reinitialisation
5
1
Keyless Entry and Starting
5
2- 62
Changing the battery, reinitialisation
6
2
Starting - switching off the engine
1
98-200
-

k

ey, remote control
-

K

eyless Entry and Starting remote
control
Locking - unlocking from inside
6
4
Alarm
8
3-85
Speed limit recognition

2

21-224
Collision Risk Alert

2

39 -242
Active Safety Brake

2

42-244
Changing a wiper blade

2

69
Automatic wiping

1

55 -156
Front demisting, defrosting

1

31
Front foglamps

1

45, 299, 304
Daytime running lamps

1

47, 300
Cornering lighting

1

50
Parking sensors

2

52-253
Towing
32

0-321
Over view

6
Instruments and
controlsCourtesy lamps 140
Interior mood lighting 1 53
-

c
ourtesy lamp
-

p
anoramic roof
Rear view mirror

1
43
Reversing camera on interior mirror

2
54
Emergency or assistance call

1
58, 328 -329
12 V accessory socket

1

13
USB port - JACK auxiliary socket

1

13 -114
Deactivating the passenger front airbag

1

70, 176 5/6 -speed manual gearbox

2
03
Gear efficiency indicator

2
04
Automatic gearbox
20

5-209
Electronic gearbox

2
10 -213
Stop & Start

2
14-217
Hill start assist

2
02
Manual air conditioning
1

25-126
Dual-zone air conditioning
1

27-130
Rear heating, air conditioning

1
36
Air recirculation

1
25, 130
Front demist - defrost

1
31
Rear screen demist -
def rost
13

3
Parking brake

2
01
Opening the bonnet

2

71
Dashboard fuses

3

11-314 Touch screen (CITROËN
Connect Nav)

4
1- 43, 331- 418
Touch screen (CITROËN Connect Radio)

4
1- 43, 419 - 472
Bluetooth audio system

4
4, 473 - 495
Air vents

1

34 Setting the date and time

4
4
Over view

9
Maintenance - Technical data
Dimensions 323
Identification markings 3 27
Running out of fuel,
(primimg pump)

3

22
Checking levels

2

73 -275
-

o

il
-

b

rake fluid
-

p

ower steering fluid
-
c

oolant
-

s

creenwash, headlamp wash fluid
-

a

dditive (Diesel with particle filter)
Checking components

2

76 -277
-
b

attery
-
a

ir filter - passenger compartment filter
-

o

il filter
-

p

article filter
-

b

rake pads - discs
Changing bulbs
2

98-310
-

f

ront
-

r

ear 12V battery

3
16 -320
Opening the bonnet

2

71
Under the bonnet

2

72
Engines
32

4-326
AdBlue
® 2 78 -281Weights
32
4-326
Load reduction, economy mode
2
66
Engine compartment
fuses
31
1- 312, 315
.
Over view

83
System which protects and provides a deterrent
against theft and break-ins.
AlarmExterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open
one of the doors or the bonnet.
Self-protection function
The system checks for the
disconnection of any of its components.
The alarm is triggered if the battery,
the button or the siren wiring is
disconnected or damaged.For all work on the alarm system,
contact a CITROËN dealer or a
qualified workshop.
Volumetric
The system monitors the passenger
compartment for any variation in volume.
The alarm is triggered if someone breaks
the windscreen, penetrates the passenger
compartment or moves around inside the
vehicle.
If your vehicle is fitted with the
programmable heating / ventilation,
volumetric monitoring is not compatible
with this system.
For more information on
Programmable Heating / Ventilation ,
refer to the corresponding section. F

L
ock the vehicle using the "Keyless Entry
and Starting" system.
Total protection
Activation
F Lock the vehicle using the remote control.
or
The monitoring system is active: the indicator
lamp in the button flashes once per second
and the direction indicators come on for about
2 seconds.
Following a command to lock the vehicle
using the remote control or the Keyless Entry
and Starting system, the exterior perimeter
monitoring is activated after a delay of
5

seconds, the interior volumetric monitoring
after 45 seconds.
If an opening (door, tailgate or side-hinged
doors, bonnet...) is not closed fully, the vehicle
is not locked but monitoring will be activated
after a delay of 45 seconds. F

Switch off the ignition and get out of the vehicle.
2
Access

213
With the ignition on, the flashing of A or AUTO,
a ccompanied by an audible signal and a
message, indicates a malfunction of the
gearbox.
Operating fault
Have it checked by a CITROËN dealer or a
qualified workshop.
Stopping the vehicle
Before switching off the engine, you can:
- m ove to position N to engage neutral,
or
-

l
eave the gear engaged; in this case, it will
not be possible to move the vehicle.
In both cases, you must apply the parking
brake to immobilise the vehicle.
At low speed, if reverse gear is
requested, the N

indicator flashes
and the gearbox goes into neutral
automatically. To engage reverse,
move the selector to position N , then
position


R . When immobilising the vehicle, with
the engine running, you must move the
selector to neutral N
.
Before doing anything under the bonnet
ensure that the selector is in neutral N
and that the parking brake is applied. Always press the brake pedal when
starting the engine.
In all parking situations, you must apply
the parking brake to immobilise the
vehicle.
To engage reverse gear, the vehicle must be
immobilised with your foot on the brake pedal.
Reverse
F Select position R
.
Engagement of reverse gear is accompanied
by an audible signal.
6
Driving

216
Deactivation / Activation
With the audio system
F Press the button, its indicator lamp comes on, the system is
deactivated.
F

P
ress this button, the indicator
lamp goes off, the system is
activated.
To deactivate the system:
With the touch screen
In the Driving
menu, activate/deactivate
" Stop
& Star t system ".
The system is reactivated automatically
every time the engine is started by
the
d

river.
If the system has been deactivated
in STOP mode, the engine restarts
immediately. Opening the bonnet
Before doing anything under the
bonnet, deactivate the Stop & Start
system to avoid the risk of injury
related to an automatic change to
START
mode.
Driving on flooded roads
Before driving through a flooded road,
it is strongly recommended that you
deactivate the Stop & Start system.
For more information on Driving
advice , particularly on flooded roads,
refer to the corresponding section.
To activate the system:
Driving

244
Clean the front bumper, removing the
snow, mud, ...
If one of the two sensors (camera
or radar) is masked or its visibility
is reduced, while the other sensor
is able to work normally, the system
still operates, but at a lower level of
per formance. This is not indicated by a
message or a warning lamp.
To ensure correct operation of the radar
radar, do not paint over the paintwork
on the vehicle's bumper.
Keep the windscreen in front of the
camera clean.
Do not allow snow to accumulate on
the bonnet or roof of the vehicle as this
could mask the camera's view.
Driving

271
BonnetOpeningClosing
F Take the stay out of its support slot.
F C lip the stay back into its housing.
F

L
ower the bonnet and release it at the end
of its travel.
F

P
ull on the bonnet to check that it has
latched correctly.
F

U
nclip the stay from its housing and place
it in the support slot to hold the bonnet
open.
Do not open the bonnet under very
windy conditions.
When the engine is hot, handle the
exterior safety catch and the stay with
care (risk of burns).
To avoid damaging electrical units,
it is strictly forbidden
to use a high
pressure jet wash under the bonnet. The cooling fan may star t after
switching off the engine: take care
with articles and clothing that might
be caught by the fan blades.
F

L

ift the safety catch, then raise the bonnet.
F

O

pen the door.
F

P

ull the release lever, located at the bottom
of the door aperture, towards you.
Before doing anything under the
bonnet, deactivate the Stop & Start
system to avoid any risk of injury
resulting from an automatic change to
START mode.
7
Practical information

273
Checking levels
Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could start at
any time (even with the ignition off).
Engine oil level
The check is carried out either when
the ignition is switched on using the
oil level indicator in the instrument
panel for vehicles so equipped, or
using the dipstick.Checking using the dipstick
The location of the dipstick is shown in the
corresponding underbonnet layout view.
F
T
ake the dipstick by its coloured grip and
remove it completely.
F

W
ipe the end of the dipstick using a clean
non-fluffy cloth.
F

R
efit the dipstick and push fully down, then
pull it out again to make the visual check:
the correct level is between the marks A
and B .
Check all of these levels regularly, in line with the manufacturer's service schedule. Top them up if necessary, unless other wise indicated.
If a level drops significantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.
A = MA X
To ensure that the reading is correct, your
vehicle must be parked on a level sur face
with the engine having been off for more than
30
m

inutes.
It is normal to top-up the oil level between
two services (or oil changes). CITROËN
recommends that you check the level, and top-
up if necessary, every 3 000 miles (5 000 kms). B = MIN
If you find that the level is above the A mark or
below the B mark, do not star t the engine .
-

I
f the level is above the MAX mark (risk
of damage to the engine), contact a
CITROËN dealer or a qualified workshop.
-

I
f the level is below the MIN mark, you
must top-up the engine oil.
7
Practical information

274
Oil grade
Before topping-up the oil or changing the oil,
check that the oil is the correct grade for your
engine and conforms to the manufacturer's
recommendations.
Topping-up the engine oil level
The location of the oil filler cap is shown in the
corresponding underbonnet layout view.
F
U
nscrew the oil filler cap to reveal the filler
aperture.
F

A
dd oil in small quantities, avoiding any
spills on engine components (risk of fire).
F

W
ait a few minutes before checking the
level again using the dipstick.
F

A
dd more oil if necessary.
F

A
fter checking the level, carefully refit the
oil filler cap and the dipstick in its tube.
After topping-up the oil, the check when
switching on the ignition with the oil
level indicator in the instrument panel
is not valid during the 30 minutes after
topping-up.
Engine oil change
Refer to the manufacturer's service schedule
for details of the interval for this operation.
In order to maintain the reliability of the engine
and emission control system, never use
additives in the engine oil. The brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.
Brake fluid level
Changing the fluid
Refer to the manufacturer's service schedule
for details of the interval for this operation.
Fluid specification
The brake fluid must conform to the
manufacturer's recommendations.
Coolant level
The coolant level should be close
to the "MA X" mark but should never
exceed it.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off the
engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up the level. The cooling fan may star t after switching
off the engine: take care with ar ticles and
clothing that might be caught by the fan
blades. When the engine is warm, the temperature of
the coolant is regulated by the fan.
Check the coolant level regularly, according
to the use made of your vehicle (every
3 000

miles or 5 000 kms / 3 months); if
necessary, top-up using coolant recommended
by the manufacturer.
Topping-up the coolant between services is
normal.
Power steering fluid level
The power steering fluid level should
be close to the "MA X" mark. With
the engine cold, unscrew the cap to
check the level.
Practical information