ignition CITROEN DS3 2009 Owner's Guide

Pro
grammin
g
Operatin
g faults
If there is an operating
fault, when reverse gear
is engaged this warning lamp comes on on the
instrument panel, accompanied by an audible
signal (short beep) and a message on the
m
ultifunction screen.
You can act
ivate or
deact
ivate t
he system
by
means of the multifunction screen configuration menu. The system state is memorised whenswitching off the ignition.
For more information on access to the parkin
g
assistance menu, re
fer to vehicle con
figuration
in the "Multifunction screens" section correspon
ding to
your screen.
The system w
ill be deact
ivate
d
automat
ically w
hen tow
ing a tra
iler or
when a bicycle carrier is fitted (vehicle fitted with a towbar or bicycle carrier recommended by CITROËN).
In bad or w
intry weat
her, ensure t
hat
the sensors are not covere
d with mu
d,
frost or snow.

Practical information
Removing the wheel

Parking the vehicle
Imm
obilise the vehicle wh
ere it does

not block traffic: the ground must belevel, stable and not slipper
y.
Appl
y the parkin
g brake, switch o
ff the
ignition and en
gage first
gear
* to lock
the w
heels.
If necessary, place a chock under thewheel diagona
lly oppos
ite t
he w
heel to
be changed.
It is imperative that you ensure that the occupants get out of the vehicle andwait where the
y are safe.
Never
go un
derneat
h a ve
hicle ra
ised
using a jack; use an axle stand.
List of o
perations
)
Remove the chromed bolt cover from eac
h
o
f the bolts usin
g the tool
3(allo
y wheels
only).
)
Fit the socket
4 on t
he w
heelbrace
1
to
slacken the security bolt.
)
Slacken the other bolts using the wheelbrace
1 only.
* position
P for an automatic
gearbox.

Fuse
N°
Rating
Functio
ns
F820 A
Multi
function screen, audio s
ystem, navi
gation radio, alarm
contro
l un
it, a
larm s
iren.
F
9
30 A
12 V socket, portable navigation support supply.
F10
15 A
Steering wheel controls.
F11
15 A
Ignition,
diagnost
ic soc
ket, automat
ic gear
box contro
l un
it.
F12
15 A
Rain/bri
ghtness sensor, trailer rela
y unit.
F
13
5 A
Main stop switch, engine relay unit.
F14
15 A
Parking sensors control unit, airbag control unit, instrument
panel, di
gital air conditionin
g, USB Box, Hi-Fi amplifier.
F15
30 A
Lockin
g.
F
16
-
Not used
.
F
17
40 A
Rear screen and door mirrors demisting/defrosting.
SH
-

PA R
C shunt.

Fuse ta
ble
Fuse N°
Rating
Functions
F
1
20 A
Engine control unit supply, cooling
fan unit control relay,
multifunction engine control main relay, injection pump
(Diesel).
F2
15 A
Horn.
F
3
10 A Front
/rear wash-wi
pe.
F4
20 A
LED lamps.
F5
15 A
Diesel heater
(Diesel
), particle
filter additive pump
(Diesel
),
air
flow sensor
(Diesel
), blow-by heater and electrovalves
(VTi).
F
6
10 A
ABS/ESP control unit, secondar
y stop switch.
F7
10 A
Electric power steerin
g, automatic
gearbox.
F8
25 A
Starter control.
F
9
10 A
Switching and protection unit (Diesel).
F10
30 A

Fuel heater (Diesel), blow-by heater (Diesel), fuel pump
(VTi), injectors and ignition coils (petrol).
F11
40 A H
eater blower.

195
Practical information
Fuse
N°
Rating
Functio
ns
F12
30 A

Windscreen wipers slow/fast speed.
F13
40 A
Built-in s
ystems inter
face suppl
y (ignition positive
).
F14
30
A

Valvetronic suppl
y (VTi
).
F
15
10 A

Right-hand main beam headlamps.
F16
10 A

Left-hand main beam headlam
ps.
F17
15 A

Left-hand di
pped beam headlam
ps.
F1
8
15 A
Righ
t-hand dippe
d beam
headlamps.
F19
15 A

Oxygen sensors and electrovalves (VTi), electrovalves (Diesel), EGR electrovalve (Diesel).
F20
10 A

Pumps, electronic thermostat (VTi), timimg electrovalve (THP), water in fuel sensor (Diesel).
F21
5 A

Fan assembl
y control suppl
y, AB
S/ESP, turbo pump
(THP
).

Charging the battery usinga batter
y char
ger
Batteries contain harm
ful substances
such as sulphuric acid and lead. Theymust be disposed of in accordance with re
gulations and must not, in an
y
circumstances, be discarded with household
waste.

Take used remote control batteries and vehicle batter
ies to a s
pecial co
llect
ion
point.It is a
dvisable to
disconnect t
he batter
y
if the vehicle is to be left unused for more than one month.
Do not
disconnect t
he term
inals w
hile the en
gine
is runn
ing.
Do not char
ge the batteries without disconnectin
g the terminals
first.
)
Disconnect the batter
y from the vehicle.
)
Follow the instructions
for use provided b
y
the manu
facturer o
f the char
ger.
)
Reconnect start
ing w
ith the negat
ive
terminal
(-).
)
Check that the terminals and connectorsare clean. If they are covered with sulphate
(whitish or greenish deposit), remove them and clean th
em.
Be
fore disconnectin
g
the batter
y
Wait 2 minutes a
fter switchin
g off the
ignition be
fore disconnectin
g the batter
y.
Close the windows and the doors be
fore
disconnect
ing the batter
y.

Followin
g reconnection o
f
the batter
y

Followin
g reconnection o
f the batter
y,
switch on the i
gnition and wait 1 minute
before startin
g to permit initialisation o
f
the electronic s
ystems. However, i
f mino
r
problems persist
following this operation,
contact a CITROËN dealer.
Referring to the corresponding section,you should yourself reinitialise: - the remote control ke
y,
- the
GPS satellite navi
gation s
ystem.

Changing a front or rear wiper blade Procedure for replacing a worn wiper blade with a new one without the use of tools.Be
fore removing a
front
w
iper
bl
ade
)
Within one minute a
fter switchin
g off the
ignition, operate t
he w
iper sta
lk to pos
ition
the w
iper blades
in the vert
ical position.
Thi
s position must
be use
d in or
der to avo
id
damaging the wiper blade and the bonnet.Remova
l
)
Raise t
he correspon
ding wiper arm.
)
Unclip the w
iper blade an
d remove
it.

Fitting) At the front, check the size of the wipe
r
blade
as the shorter blade
is fitt
ed to the
passen
ger side of the vehicle.
) Put t
he correspon
ding new w
iper
blade in
place an
d clip it.
)
Fold down the wiper arm care
fully.

After fittin
g a front wipe
r
blade ) Switch on the ignition.
) Operate the wiper stalk again to park the wiper blades.