ignition Citroen DS3 2011 1.G Owner's Guide

11 7Visibility








Interior mood lighting
The dimmed passenger compar tment lighting improves visibility in the vehicle when the light is poor.


Switching on

At night, the illumination of footwells and the
central dashboard storage compartment comes
on automatically when the sidelamps are
switched on.


Switching off

The interior mood lighting switches off
automatically when the sidelamps are
switched off.
It can be switched off manually using the
instrument panel lighting rheostat button.


)
With the lighting on, press several times on
the left hand button of the instrument panel
to progressively reduce the dashboard
lighting level.

)
Press again to reduce the lighting level
to the minimum and switch off the interior
mood lighting.
This comes on automatically when the boot is
opened and switches off automatically when
the boot is closed.





Boot lamp

Different lighting times are provided:


- when the ignition is off,
approximately ten minutes,

- in energy economy mode,
approximately thirty seconds,

- when the engine is running, no limit.

121Fittings
Component which protects against sunlight
from the front or the side, also equipped with an
illuminated cour tesy mirror.


)
With the ignition on, raise the concealing
flap; the mirror is lit automatically.
This sun visor is also equipped with a ticket
holder.








Sun visor









Illuminated glove
box

This can be used to hold a water bottle.
Its lid has a location for storing the vehicle's
handbook pack.


)
To open the glove box, raise the handle.
It is lit when the lid is opened.
It houses the front passenger's airbag
deactivation switch A
.
It provides access to the ventilation nozzle B
,
distributing the same air as the vents in the
passenger compartment.









Centre armrest


Storage



)
For access to the closed storage box, lift
the lever to open the lid.

)
For access to the open storage box below
the armrest, lift the complete armrest
towards the rear.
These can be used for por table devices (mobile
phone, MP3 player...) which can be connected
to the USB port /auxiliary socket or charged
from the 12 V socket in the centre console. Comfor t and storage system for the driver and
front passenger.

Direction indicators

Selection of the left or right direction indicators
to signal a change of direction of the vehicle.


)
Left: lower the lighting stalk beyond the
point of resistance.

)
Right: raise the lighting stalk beyond the
point of resistance.







"Motorway" function



)
Press briefly upwards or downwards,
without going beyond the point of
resistance; the direction indicators will flash
3 times.










Hazard warning lamps

A visual warning by means of the direction
indicators to aler t other road users to a vehicle
breakdown, towing or accident.


)
Press this button, the direction indicators
flash.
They can operate with the ignition off.

Deactivation

In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft
ground...), it may be advisable to deactivate the
ASR and ESP systems, so that the wheels can
move freely and regain grip.


)
Press the "ESP OFF"
button, located on
the left below the steering wheel.

If this warning lamp comes on in the
instrument panel and the indicator
lamp in the button comes on, this
indicates that the ASR and ESP
systems are deactivated.


Reactivation

These systems are reactivated automatically
each time the ignition is switched back on or
from 30 mph (50 km/h) (except 1.6 litre
THP 150 and R ACING petrol engines).


)
Press the "ESP OFF"
button again to
reactivate them manually.



Operating fault

The ESP/ASR systems offer
exceptional safety in normal driving, but
this should not encourage the driver to
take extra risks or drive at high speed.
The correct functioning of these
systems depends on obser vation of the
manufacturer's recommendations on:


- wheels (tyres and rims),

- braking components,

- electronic components,

- assembly and repair procedures.
After an impact, have these systems
checked by a CITROËN dealer or a
qualified workshop.
If this warning lamp comes on,
accompanied by an audible signal and a
message in the multifunction screen, this
indicates a malfunction of these systems.
Have it checked by a CITROËN dealer or a
qualified workshop.

145Safety
Seat belts


Front seat belts


The front seat belts are fitted with a
pretensioning and force limiting system.
This system improves safety in the front
seats in the event of a front or side impact.
Depending on the severity of the impact, the
pretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the ignition is on.
The force limiter reduces the pressure of the
seat belt on the chest of the occupant, so
improving their protection.









Fastening



)
Pull the strap, then inser t the tongue in
the buckle.

)
Check that the seat belt is fastened
correctly by pulling the strap.



Unfastening



)
Press the red button on the buckle.

)
Guide the seat belt as it is reeled in.



Seat belt not fastened/
unfastened warning lamp
When the ignition is switched on,
this warning lamp comes on in the
instrument panel, if the driver and/or
the front passenger has not fastened their
seat belt.
From approximately 12 mph (20 km/h)
this warning lamp flashes for two minutes
accompanied by an audible signal of increasing
volume. Once these two minutes have elapsed,
this warning lamp remains on until the driver
and/or the front passenger fastens their
seat belt.

Airbags


System designed to maximise the safety of the
occupants (with the exception of the rear centre
passenger) in the event of violent collisions.
It supplements the action of the force-limiting
seat belts (with the exception of the rear centre
passenger).
If a collision occurs, the electronic detectors
record and analyse the front and side impacts
sustained in the impact detection zones:


- in the case of a serious impact, the airbags
are deployed instantly and protect the
occupants of the vehicle (with the exception
of the rear centre passenger); immediately
after the impact, the airbags deflate rapidly
so that they do not hinder visibility or the
exit of the occupants,

- in the case of a minor or rear impact or in
cer tain roll-over conditions, the airbags
will not be deployed; the seat belt alone is
sufficient to provide optimum protection in
these situations.
The airbags do not operate when the
ignition is switched off.

This equipment will only deploy once.
If a second impact occurs (during the
same or a subsequent accident), the
airbag will not be deployed again.

Impact detection zones



A.
Front impact zone.

B.
Side impact zone.
Deployment of the airbag(s) is
accompanied by a slight emission
of harmless smoke and a noise, due
to the activation of the pyrotechnic
car tridge incorporated in the system.
This smoke is not harmful, but sensitive
individuals may experience slight
irritation.
The noise of the detonation may result
in a slight loss of hearing for a short
time.

Deactivation

Only the passenger's front airbag can be
deactivated:


)
with the ignition off
, inser t the key in the
passenger airbag deactivation switch,

)
turn it to the "OFF"
position,

)
then, remove the key keeping the switch in
the new position.
This warning lamp comes on in the
instrument panel when the ignition is
on and until the airbag is re-activated. To assure the safety of your child,
the passenger's front airbag must
be deactivated when you install a
"rear facing" child seat on the front
passenger seat.
Other wise, the child would risk being
seriously injured or killed if the airbag
were deployed.


Reactivation

When you remove a child seat that has been
fitted "rear wards facing", turn switch to the
"ON"
position to re-activate the airbag and so
assure the safety of your front passenger in the
event of an impact.

With the ignition on, this warning
lamp comes on in the instrument
panel for approximately one minute,
if the passenger's front airbag is
activated.


Operating fault

If this warning lamp flashes, contact
a CITROËN dealer or a qualified
workshop. The passenger's front
airbag may no longer be deployed in the event
of a serious impact.
If at least one of the two airbag
warning lamps come on continuously,
do not install a child seat on the front
passenger seat.
Have it checked by a CITROËN dealer
or a qualified workshop.
If this warning lamp comes on in the
instrument panel, accompanied by
an audible warning and a message in
the multifunction screen, contact a CITROËN
dealer or qualified workshop to have the
system checked. The airbags may no longer be
deployed in the event of a serious impact.

161Driving
If you press the accelerator pedal
beyond the point of resistance, the
gearbox selects the gear below to
permit sharper acceleration.
You must press the brake pedal while
star ting the engine.
Never select neutral N
while the vehicle
is moving.
Only engage reverse gear R
when the
vehicle is immobilised, with your foot on
the brake pedal.
In all cases, you must apply the parking
brake to immobilise the vehicle.


"Auto sequential" mode

In the automated mode, you can resume
control temporarily at any time using the
steering mounted control paddles.
The use of these paddles permits manual
selection of the gears in situations which
require a more rapid change-down than in
the automated mode (arrival at a roundabout,
leaving a car park with a steep gradient,
over taking...).
The gearbox engages the required gear if
the engine speed permits. AUTO
remains
displayed in the instrument panel.
After a few minutes, the gearbox resumes
automatic control of the gears.


Stopping the vehicle

Before switching off the engine, you can
change to position N
to be in neutral.
In this case, you must apply the parking brake
to immobilise the vehicle.


Reinitialisation

Following disconnection of the battery, the
gearbox must be reinitialised.


)
Switch on the ignition.

AUTO
and -
appear in the instrument
panel.


)
Select position N
.

)
Press the brake pedal.

)
Wait approximately 30 seconds until N
or a
gear appears in the instrument panel.

)
Release the brake pedal.
The gearbox is operational again.


Operating fault

With the ignition on, if this warning
lamp comes on and AUTO
flashes,
accompanied by an audible signal and a
message in the multifunction screen, this
indicates a gearbox fault.
Have it checked by a CITROËN dealer or a
qualified workshop.

165Driving

Manual operation


D
disappears and the gears engaged
appear in succession on the
instrument panel.
If the engine speed is too low or
too high, the gear selected flashes for a few
seconds, then the actual gear engaged is
displayed.
It is possible to change from position D

(automatic) to position M
(manual) at any time.
When the vehicle is stationary or moving
very slowly, the gearbox selects gear M1

automatically.
The spor t and snow programmes do not
operate in manual mode.

Invalid value during manual
operation

)
Select position M
for sequential
changing
of the four gears.

)
Push the lever towards the +
sign to
change up a gear.

)
Pull the lever towards the -
sign to change
down a gear.
It is only possible to change from one gear to
another if the vehicle speed and engine speed
permit; other wise, the gearbox will operate
temporarily in automatic mode. This symbol is displayed if a gear
is not engaged correctly (selector
between two positions).



Stopping the vehicle

Before switching off the engine, you can engage
position P
or N
to place the gearbox in neutral.
In both cases, apply the parking brake to
immobilise the vehicle. When the ignition is on, the lighting
of this warning lamp, accompanied
by an audible signal and a message in the
multifunction screen, indicates a gearbox fault.
In this case, the gearbox switches to back-up
mode and is locked in 3rd gear. You may feel
a substantial knock when changing from P

to R
and from N
to R
. This will not cause any
damage to the gearbox.
Do not exceed 60 mph (100 km/h), local speed
restrictions permitting.
Contact a CITROËN dealer or a qualified
workshop as soon as possible.

Operating fault

If the lever is not in position P
,
when the driver's door is opened or
approximately 45 seconds after the
ignition is switched off, a message
appears in the multifunction screen.


)
Return the lever to position P
; the
message disappears.
There is a risk of damage to the
gearbox:


- if you press the accelerator and
brake pedals at the same time,

- if you force the movement of the
gear lever from the P
position to
another position when the battery
is flat.
To reduce fuel consumption when at
a prolonged standstill with the engine
running (traffic jam...), put the gear lever in
the N
position and apply the parking brake.

Stop & Start
The Stop & Start system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, etc...). The engine
restarts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Start system reduces fuel consumption and exhaust emissions as well as offering the comfort of silence when
stationary.

Operation


Going into engine STOP mode

For your comfort when parking, STOP
mode is not available for a few seconds
after coming out of reverse gear.
STOP mode does not affect the
functionality of the vehicle, such as
braking, power steering, for example.
Never refuel with the engine in STOP
mode; you must switch off the ignition
with the key. The "ECO"
warning lamp comes
on in the instrument panel and the
engine goes into standby:


- with a manual gearbox
, at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral, and you release the
clutch pedal,
A time counter calculates the sum
of the periods in STOP mode
during a journey. It rests itself
to zero every time the ignition is
switched on with the key. STOP mode is not invoked when:


- the driver's door is open,

- the driver's seat belt is not fastened,

- the vehicle has not exceeded 6 mph
(10 km/h) since the last engine star t using
the key,

- the engine is needed to maintain a
comfor table temperature in the passenger
compartment,

- demisting is active,

- some special conditions (battery charge,
engine temperature, braking assistance,
ambient temperature...) where the engine is
needed to assure control of a system.


Special cases: STOP mode
unavailable
The "ECO"
warning lamp flashes for
a few seconds, then goes off.

This operation is per fectly normal.