key Citroen DS3 2012.5 1.G User Guide

This is indicated by lighting of the cour tesylamps and flashing of the direction indicators for a few seconds.
Locating your vehicle
)
Press the closed padlock to locate your locked vehicle in acar park.
Anti-theft protection

Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switchedon, this code must be recognised in order for
star ting to be possible.
This electronic en
gine immobiliser locks theengine management system a few minutes
after the ignition is switched off and prevents
starting of the engine by anyone who does not
have the key.
In the event o
f a fault, you are
informed by illumination of this
warning lamp, an audible signal and a message
in the screen.
In this case, your vehicle will not start; contact
a CITROËN dealer as soon as possible.

- P
osition 1: Stop

- Position 2: Ignition

- Position 3: Starting
Ignition switch
Keep safely the label attached to thekeys given to you on acquisition of the vehicle.

93Access

Starting the vehicle
)Insert the key in the ignition switch.
The system recognises the star ting code. )Turn the key fully towards the dashboard toposition 3 (Starting).)When the engine star ts, release the key.
) Immobilise the vehicle.)
Turn the key fully towards you to
position 1 (Stop).)
Remove the key from the ignition switch.
Switching the vehicle off
Do not attach any heavy objects tothe key as this could weigh down on itwhen in the ignition switch and cause a fault.


Key reminder

If the key is left in the ignition switch, anaudible signal sounds when the driver's door is opened.

Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction, you can no longer unlock, lock or locate your
vehicle.)First of all, use the key in the lock to unlock
or lock your vehicle.
)Then, reinitialise the remote control.
If the problem persists, contact a CITROËN
dealer as soon as possible.
Remote control problem
Reinitialisation
)Switch off the ignition.)Turn the key to position 2 (Ignition).)Press the closed padlock immediately for afew seconds.)Switch off the ignition and remove the keyfrom the ignition switch.
The remote control is fully operational again.

Changing the battery

Battery ref.: CR1620/3 volts.)Unclip the casing by inserting a coin at the notch and rotating.
)Slide the flat battery out of its location.)Slide the new battery into its location
observing the original direction.
)Clip the casing in place, then the chrome
finisher. )Reinitialise the remote control.

If the batter
y is flat, you are
informed by lighting of this warninglamp in the instrument panel, an audible signal
and a message in the multifunction screen.
) Unfold the key.)
Release the chrome finisher by pressing on lug A.)
Maintain pressure on lug A
and remove thechrome finisher by sliding it off at 45°.

95
Access
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.
Lost keys

Visit a CITROËN dealer with the vehicle's registration document, your personalidentification documents and if possible the key code label.
The CITROËN dealer will be able to find the key code and the transponder code required to order a new key.


Remote control

The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from working and the remote control would have to be reinitialised.
The remote control does not operate when the key is in the ignition switch, even when the ignition is switched off, except for reinitialisation.


Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by theemergency ser vices more difficult in an emergency. As a safety precaution (with children on board), remove the key from the ignition switch
when you leave the vehicle, even for a shor t time.


Anti-theft protection

Do not make any modifications to the electronic engine immobiliser system; this couldcause malfunctions.


When purchasing a second-hand vehicle

Have the pairing of all of the keys in your possession checked by a CITROËN dealer, to ensure that only your keys can be used to open and star t the vehicle.

Locking the vehicle
with exterior
perimeter
protection only
To be effective, this deactivation mustbe carried out each time the ignition is switched off.

If the indicator lamp in button Aflashes rapidly, this indicates that the alarmwas triggered during your absence. When the ignition is switched on, thisflashing stops immediately.
To a v o i d t r iggering the alarm when washing your vehicle, lock it using the key in the driver’s door lock.
Deactivation of the interior volumetric protection
)Switch off the ignition.)Within ten seconds, press button Auntil
the indicator lamp is on continuously.
)Get out of the vehicle.)Lock or deadlock the vehicle without delay using the locking button on the remote control.
The exterior perimeter protection alone remains
activated; the indicator lamp in button A flashes
once per second.

Reactivation of the interior volumetric protection
)
Unlock the vehicle using the unlockingbutton on the remote control. )
Relock the vehicle using the remotecontrol.
The alarm is activated again with both types
of protection; the indicator lamp in button A
flashes once per second.



Tr iggering of the alarm


This is indicated by sounding of the siren
and flashing of the direction indicators for
approximately thirty seconds.
After it has been triggered, both types of protection are again operational.
If the alarm is triggered ten times in succession, the eleventh time will result in it
becoming inactive.

99Access

Failure of the remote control
)Unlock the vehicle using the key in thedriver’s door lock. )Open the door; the alarm is triggered.)Switch on the ignition; the alarm stops.
Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the keyin the driver’s door lock.


Malfunction
When the ignition is switched on, illumination of
the indicator lamp in button Afor ten seconds indicates malfunction with the siren.
Have it checked by a CITROËN dealer or a
qualified workshop.

*
Accordin
g to country.


Automatic activation *



2 minutes after the last door or the boot is closed, the alarm is activated automatically. )
To avoid triggering the alarm on enteringthe vehicle, first press the unlocking button on the remote control.

101Access
In the event of unwanted opening of the window on closing (for example in the presence of frost): )
press the switch beyond the pointof resistance and release it; thewindow opens completely, )
then immediately pull the switchwithout going beyond the point of resistance until the window closesfully,)
continue to hold the switch for approximately one second after thewindow has closed. The safety anti-pinch function is not active during these operations.


Safety anti-pinch
On the driver's side, the one-touch front electric
window has a safety anti-pinch function.
When the window rises and meets an obstacle,
it stops and partially lowers again.
Reinitialisation
Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operationof the windows, reverse the movement of the window. To do this, press thecorresponding switch.
When the driver operates thepassenger electric window switch, they should ensure that no one is preventing correct closing of the window.
The driver should ensure that thepassenger uses the electric windowcorrectly.
Be aware of children when operatingthe windows. In the event of a malfunction
you have to
reinitialise the operation of the electricwindows: ) release the switch and pull it again until the
window closes completely,) hold the switch for approximately
one second after closing, ) press the switch to lower the window
automatically.The safety anti-pinch function is not activeduring these operations.

Doors
Opening
From out side
)After unlocking the vehicle using theremote control or the key, pull the door handle.



From inside
)
Pull the door lever to open the door; thisunlocks this vehicle completely.




Closing

When a door is not closed correctly:
-when the engine is running,this warning lamp comes on,
accompanied by a message in
the multifunction screen for a
few seconds,
-when the vehicle is moving(speedhigher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by anaudible signal and a message in the multifunction screen for a few seconds.

Version withdeadlocking

The interior door controls donot operate when the vehicle is deadlocked.

103Access
System which provides full manual locking or
unlocking of the doors from the inside.
Manual centralised control

Locking
)Press button Ato lock the vehicle.
The red indicator lamp on the button comes on.
Unlocking
) Press button A
again to unlock the vehicle.
The red indicator lamp on the button
switches off.
If one of the doors is open, central locking from the inside does not take place.
If the vehicle is locked from the outside,the red indicator lamp flashes andbutton A
is inactive.)In this case, use the remote control or the key to unlock the vehicle.




Automatic centralised
control

System which provides full automatic locking or unlocking of the doors and the boot while
driving.
You can activate or deactivate this function.


Locking

When the speed exceeds 6 mph (10 km/h), the
doors and the boot lock automatically.
Unlocking
)
Above 6 mph (10 km/h), press button Ato unlock the doors and the boot
temporarily.


If one of the doors is open, theautomatic central locking does not take place.
If the boot is open, the automatic central locking of the doors is active.

Activation
)Press button Afor more than two seconds.
A confirmation message appears on themultifunction screen, accompanied by an audible signal.
Deactivation
)Press button Aagain for more than
two seconds.
A confirmation message appears on themultifunction screen, accompanied by an
audible signal.
To lock or unlock the doors mechanicall
y in the event of a central locking system failure or flatbattery.
Emergency control


Locking the driver’s door
)
Inser t the key in the lock, then turn it to theleft.


Unlocking the driver’s door
)
Inser t the key in the lock, then turn it to the
right.

Locking the passenger’s door
)Remove the black cap, on the edge of the
door, using the key. )Inser t the key in the cavity, then turn it fully. )Remove the key and refit the cap.



Unlocking the passenger’s door
)Pull the interior door opening control.
In the event of a fault with the central locking system, you must disconnectthe battery to lock the boot and so ensure the complete locking of the vehicle.