fuse box location CITROEN DS4 2023 Owners Manual

178
The location of the interior bonnet release
lever prevents opening of the bonnet when
the left-hand front door is shut.
Do not open the bonnet when there is a
very strong wind.
When the engine is hot, handle the
exterior safety catch and the stay with
care (risk of burns).
Closing
F Take the stay out of the support slot.
F C lip the stay in its housing on the back of
the bonnet.
F

L
ower the bonnet and release it near the
end of its travel.
F

P
ull on the bonnet to check that it is fully
latched.
Because of the presence of electrical
equipment under the bonnet, it is
recommended that exposure to water
(rain, washing, etc.) be limited.
Engines
Petrol
Diesel
These engines are examples provided as a
guide.
The locations of the following elements may
vary:
-

A
ir filter.
-

E
ngine oil dipstick.
-

E
ngine oil filler cap.
-
P

riming pump. 1.
Power steering fluid reservoir.
2. Screenwash and headlamp wash
reservoir.
3. Engine coolant reservoir.
4. Brake fluid tank.
5. Battery/Fuses.
6. Fusebox.
7. Remote earth point.
8. A i r f i l t e r.
9. Engine oil dipstick.
10. Engine oil filler cap.
11. Priming pump*
The Diesel circuit is under very high
pressure.
All work on this circuit must be carried out
only in the dealer network or a qualified
workshop.
*
D
epending on engine.
07
Practical information

205
Changing a fuse
Access to the tools
The extraction tweezers are attached to the
back of the fusebox cover of the dashboard or
the glove box.
Dashboard
F Unclip the cover by pulling at the top left, then right.
F

D
isengage the cover completely and turn it
ove r.
F

R
emove the carrier on which the tweezers
are fitted.
Glove box
F Open the glove box lid.
Changing a fuse
F identify the faulty fuse using the existing allocation tables and diagrams given in the
following pages.
To replace a fuse, you must:
F

u
se the special tweezers to extract the fuse
from its housing and check the condition of
its filament,
F

a
lways replace the defective fuse with a
fuse of the same rating (same colour); using
a different rating could cause a malfunction
(risk of fire).
If the fault recurs after replacing a fuse, have
the electrical system checked in the dealer
network or by a qualified workshop.
Replacement with a fuse not shown in
the allocation tables below may cause
a serious malfunction of your vehicle.
Contact the dealer network or a qualified
workshop.
F

U

nclip the fusebox cover by pulling at the
top right.
F

D

isengage the cover completely and turn it
ove r.
F

R

emove the carrier on which the tweezers
are fitted.
Before changing a fuse:
F

t

he cause of the failure must be identified
and rectified,
F

a

ll electrical loads must be switched off,
F

s

top the vehicle and switch off the ignition,
08
In the event of a breakdown