engine Citroen DS4 DAG 2010.5 1.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2010.5, Model line: DS4 DAG, Model: Citroen DS4 DAG 2010.5 1.GPages: 342, PDF Size: 10.62 MB
Page 54 of 342
Heated seats control
With the engine running, the front seats can be heated separately. Use the adjustment dial, placed on the side of each front seat, to switch on and select the level of heating required: 0: Off. 1: Low. 2: Medium. 3: High.
Additional adjustments
H e a d r e s t r a i n t h e i g h t a n d a n g l e adjustment
To raise a head restraint, pull it upwards. To remove the head restraint, press the lug A and pull the head restraint upwards. To put the head restraint back in place, engage the head restraint stems in the openings keeping them in line with the seat back. To lower the head restraint, press the lug Aand the head restraint at the same time. To adjust the angle of the head restraint, tilt
its lower par t for wards or rear wards.
The head restraint is fitted with a frame with notches which prevents it from lowering; this is a safety device in case of impact. T h e a d j u s t m e n t i s c o r r e c t w h e n t h e u p p e r e d g e o f t h e h e a d r e s t r a i n t i s l e v e l w i t h t h e t o p o f t h e h e a d . Never drive with the head restraints removed; they must be in place and
adjusted correctly.
Page 55 of 342
Comfort
Manual lumbar adjustment
Turn the knob to obtain the desired level of lumbar suppor t.
Electric lumbar adjustment
Press the front or rear of the control to obtain the desired lumbar suppor t.
This function provides a back massage; it only operates when the engine is running. Press the switch to activate the function. The warning lamp on the switch comes on and the massage function is activated for a period of 60 minutes. During this time, massage is per formed in 6 cycles of 10 minutes each cycle (6 minutes of massage followed by 4 minutes break). After an hour, the function is automatically
deactivated. The warning lamp in the switch goes off.
Deactivation
You can deactivate the massage function at any time by pressing the switch. The movement in progress continues until the initial non-
massage position is reached.
Massage function
Page 56 of 342
Storing driving positions
System which registers the electrical settings of the driver's seat and door mirrors. It enables you to store and recall two positions using the buttons on the side of the driver's seat.
Storing a position
Using buttons M/1/2
Switch on the ignition. Adjust your seat and the door mirrors. Press button M , then press button 1 or 2within four seconds. An audible signal indicates that the position has been stored.
Recalling a stored position
Ignition on or engine running
Press button 1 or 2 to recall the corresponding position. An audible signal indicates the end of the adjustment.
Storing a new position cancels the previous position.
You can interrupt the current movement by pressing button M , 1 or 2 or by using one of the seat controls. A stored position cannot be recalled
while driving. Recalling stored positions is deactivated 45 seconds after switching off the ignition.
Page 60 of 342
93Comfort
Mirrors
Each fitted with an adjustable mirror glass permitting the lateral rear ward vision necessary for over taking or parking. They can also be folded for parking in confined spaces.
D e m i s t i n g - D e f r o s t i n g
Adjustment
Move control A to the right or to the left to select the corresponding mirror. Move control B in all four directions to adjust. Return control A to the central position.
Door mirrors
The objects obser ved are, in reality, closer than they appear. Take this into account in order to correctly judge the distance of vehicles approaching from behind.
Folding
From outside: lock the vehicle using the remote control or the key. From inside: with the ignition on, pull control A rear wards.
Unfolding
From outside: unlock the vehicle using the remote control or the key. From inside: with the ignition on, pull control A rear wards.
If the mirrors are folded using control A , they will not unfold when the vehicle is unlocked. Pull again on control A .
The folding and unfolding of the door mirrors using the remote control can be deactivated by a CITROËN dealer.
Never fold or unfold the electric folding mirrors manually.
If your vehicle is fitted with heated mirrors, the demisting-defrosting operates with the engine running, by switching on the heated rear screen (refer to the "Rear screen demist-defrost"
page).
Page 61 of 342
Automatic tilting in reverse gear
System which provides a view of the ground during parking manoeuvres in reverse gear.
Programming
With the engine running, engage reverse gear. Select and adjust the left-hand and right-hand mirrors in succession. The adjustment is stored immediately.
S w i t c h i n g o n
With the engine running, engage reverse gear. Move control A to the right or to the left to select the corresponding mirror. The glass of the mirror selected tilts downwards, in accordance with its programming.
S w i t c h i n g o f f
Exit reverse gear and wait ten seconds. or Return control A to the central position. The mirror glass returns to its initial position. The mirror glass also returns to its initial position: - if the speed exceeds 6 mph (10 km/h), - if the engine is switched off.
Page 66 of 342
101Access
Press the closed padlock on the remote control. This will switch on the cour tesy lamps and the direction indicators will flash for a few seconds.
Locating your vehicle
This function allows you to identify
your vehicle from a distance, par ticularly in poor light. Your vehicle must be locked.
Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched on, this code must be recognised in order for star ting to be possible. This electronic engine immobiliser locks the engine management system a few minutes after the ignition is switched off and prevents star ting of the engine by anyone who does not have the key.
In the event of a fault, you are informed by illumination of this warning lamp, an audible signal and a message in the screen. In this case, your vehicle does not star t; contact a CITROËN dealer as soon as possible.
Folding the key
First press this button to fold the key.
Page 67 of 342
Starting the vehicle
Inser t the key in the ignition switch. The system recognises the star ting code. Turn the key fully towards the dashboard to position 3 (Star ting) . When the engine star ts, release the key.
Immobilise the vehicle.
Turn the key fully towards you to position 1 (Stop) . Remove the key from the ignition switch.
Switching the vehicle off
A heavy object (key fob...), attached to the key and weighing down on its shaft in the ignition switch, could cause a malfunction.
Key left in the "Ignition on" position
If the key has been left in the ignition switch, the ignition will be switched off automatically after one hour. To switch the ignition back on, turn the key to position 1 (Stop) , then back to position 2 (Ignition on) .
Page 70 of 342
101Access
Press the closed padlock on the remote control. This will switch on the cour tesy lamps and the direction indicators will flash for a few seconds.
Locating your vehicle
This function allows you to identify
your vehicle from a distance, par ticularly in poor light. Your vehicle must be locked.
Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched on, this code must be recognised in order for star ting to be possible. This electronic engine immobiliser locks the engine management system a few minutes after the ignition is switched off and prevents star ting of the engine by anyone who does not have the key.
In the event of a fault, you are informed by illumination of this warning lamp, an audible signal and a message in the screen. In this case, your vehicle does not star t; contact a CITROËN dealer as soon as possible.
Folding the key
First press this button to fold the key.
Page 72 of 342
Starting the vehicle
Inser t the key in the ignition switch. The system recognises the star ting code. Turn the key fully towards the dashboard to position 3 (Star ting) . When the engine star ts, release the key.
Immobilise the vehicle.
Turn the key fully towards you to position 1 (Stop) . Remove the key from the ignition switch.
Switching the vehicle off
A heavy object (key fob...), attached to the key and weighing down on its shaft in the ignition switch, could cause a malfunction.
Key left in the "Ignition on" position
If the key has been left in the ignition switch, the ignition will be switched off automatically after one hour. To switch the ignition back on, turn the key to position 1 (Stop) , then back to position 2 (Ignition on) .
Page 78 of 342
Doors
Opening
From outside
After unlocking the vehicle completely using the remote control or the key, pull the
door handle.
From inside
Pull the front door control to open the door; this unlocks the vehicle completely. Pull the rear door control to open the door; this unlocks only the door opened.
Closing
When a door is not closed correctly:
- when the engine is running , this warning lamp comes on, accompanied by a message in the multifunction screen for a few seconds,
- when the vehicle is moving (speed higher than 6 mph (10 km/h)), this warning lamp comes on, accompanied by an audible signal and a message in the multifunction screen for a few seconds.
When the selective unlocking is
activated, the first press of the remote control unlocking button permits unlocking of the driver's door only.
With the selective unlocking activated: - the driver's door control unlocks the driver's door only. - the passenger's door control unlocks the other doors and the boot.