light Citroen DS4 RHD 2011.5 1.G Workshop Manual

Invalid value during manualoperation
This symbol is displayed if a gear
is not engaged correctly (selector
between two positions).

Stopping the vehicle
Before switching off the engine, you canengage position Por N
to place the gearbox in neutral.
In both cases, apply the parking brake toimmobilise the vehicle, unless it is programmedto automatic mode.

If the lever is not in position P, when thePdriver's door is opened or approximately45 seconds after the ignition is switched off, there is an audible signal and amessage appears.)Return the lever to position P
; the audible signal stops and themessage disappears.


Operating fault

When the ignition is on, the lighting of this
warning lamp, accompanied by an audible
signal and a message in the multifunction
screen, indicates a gearbox malfunction.
In this case, the gearbox switches to back-up
mode and is locked in 3rd
gear. You may feel
a substantial knock when changing from Pto R
and from N
to R
. This will not cause any
damage to the gearbox.
Do not exceed 60 mph (10 0 km/h), local speed restrictions permitting.
Have it checked by a CITROËN dealer or aqualified workshop.
This warning lamp may also come on if a door
is opened.
You risk damaging the gearbox:


- if you press the accelerator and brake pedals at the same time,

- if you force the lever from position Pto another position when the batteryis flat.

To reduce fuel consumption when stationary for long periods with the engine running (traffic jam...), positionthe gear lever at Nand apply theparking brake, unless it is programmed in automatic mode.

Stop & Start The Stop & Start system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...).
The engine restar ts automatically - START mode - as soon as you want to move off. The restar t takes place instantly, quickly and silently.
Per
fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
Going into engine STOP mode
With the electronic gearbox system, for your comfor t during parking maoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear.STOP mode does not affect the functionality of the vehicle, such asbraking, power steering, for example.
Never refuel with the engine in STOPmode; you must switch off the ignition with the key. Th
e "ECO"warning lamp comes on
in the instrument panel and the engine goes into standby automatically:
-with a manual gearbox , at speeds below
12 mph (20 km/h), when you put the gear lever into neutral and release the clutchpedal,
- with the 6-speed electronic gearbox
system, at a speed below 5 mph (8 km/h),
when you press the brake pedal or put thegear lever into position N.
If your vehicle is fitted with the system, a time counter calculates
the sum o
f the periods in STOP
mode during a journey. It resets
itself to zero every time the ignition
is switched on with the key.
STOP mode is not invoked when:


- the driver’s door is open,

- the driver’s seat belt is not fastened,

- the vehicle has not exceeded 6 mph
(10 km/h) since the last engine start usingthe key,

- the electric parking brake is applied or
being applied,

-the engine is needed to maintain a comfortable
temperature in the passenger compartment,
- demisting is active,

- some special conditions (battery charge, engine temperature, braking assistance,ambient temperature...) where the engine isneeded to assure control of a system.


Special cases: STOP modeunavailable

In this case, the "ECO"
warning lamp
flashes for a few seconds, then goes off.
This operation is per fectly normal.

No aler t will be given in the following situations:


- in the presence of stationary objects(parked vehicles, barriers, street lamps,
road signs...),

- with vehicles moving in the opposite
direction,

- drivin
g on a sinuous road or a sharp corner,
The alert is given by a warning lamp whichcomes on in the door mirror on the side in
question as soon as a vehicle - car, lorry,cycle - is detected and the following conditions are fulfilled:
- all the vehicles must be moving in the same
direction,
- the speed of
your vehicle is between 7 and
75 mph (12 and 140 km/h),
- the difference in speed between your
vehicle and the other vehicles must be lessthan 6 mph (10 km/h),
- the traffic must be flowing normally,
- in the case of an overtaking manoeuvre,if this is prolonged and the vehicle being
over taken remains in the blind spot,
-
you are driving on a straight or slightlycurved road,- your vehicle is not pulling a trailer, a caravan...

- when overtakin
g (or being over taken by) a
very long vehicle (lorr y, coach...) which is at the same time detected at the rear in theblind spot angle and present in the driver's
for ward field of vision,

- in ver
y heavy traffic: vehicles detected in
front and behind are confused with a lorryor a stationary object,

- when overtaking quickly.

Changing a bulb

The headlamps are fitted withpolycarbonate glass with a protectivecoating:)do not clean them using a dryor abrasive cloth, nor with adetergent or solvent product,)use a sponge and soapy water, )when using a high pressurewasher on persistent marks, do not keep the lance directed towards the lamps or their edges for too long, so as not to damage their protective coating and seals.
)Do not touch the bulb directly withyour fingers, use lint-free cloths.Changing a bulb should only be doneafter the headlamp has been switched off for a few minutes (risk of seriousburns).It is imperative to use onlyanti-ultraviolet (UV) type bulbs in order not to damage the headlamp.
Always replace a failed bulb with anew bulb with the same type and specification.


Risk of electrocution

Xenon bulbs (D1S-35W) must be replaced by a CITROËN dealer or aqualified workshop.


Bulbs with lugs, type H1, H7... take careto position them correctly to ensure thebest lighting.

Fusebox 1
Fuse N°RatingFunctions
F8
3 A Alarm siren, alarm ECU.
F13 10 A
Cigarette lighter.
F1410 A
12 V socket in boot.
F1
63 A Lighting for the large multifunctional storage unit, rear map
reading lamps, glove box illumination.
F17
3 A Sun visor illumination, front map reading lamps.
F2
815 A Audio system, radio (after-market).
F3
020 A Rear wiper.
F32 10 A
Hi-Fi amplifier.
Fusebox
2
Fuse N°RatingFunctions
F3
615 A
Rear 12 V socket.
F37
- Not used.
F38
- Not used.
F3
9- Not used.
F4
0- Not used.
Fuse tables

Practical information





Towing a trailer, ...


Towbar suitable for the attachment of a trailer
with additional lighting and signalling.
Your vehicle is primarily designed for
transporting people and luggage, but it mayalso be used for towing a trailer.
We recommend the use of genuineCITROËN towbars and their harnesses that have been tested and approved from the design stage of your vehicle, and that the fitting of the towbar is entrusted to a CITROËN dealer or a qualified workshop.If the towbar is not fitted by a CITROËNdealer, it is imperative that it is fitted in accordance with the vehicle manufacturer's instructions.
Driving with a trailer places greater demands
on the towing vehicle and the driver must take particular care.

The rear parking sensors will be deactivated automatically if a genuine CITROËN towbar is used.

Driving advice
Distribution of loads
)Distribute the load in the trailer so that theheaviest items are as close as possible to
the axle and the nose weight approaches the maximum permitted without exceeding it.
Air density decreases with altitude, thus reducing engine per formance. Above
1 000 metres, the maximum towed load must
be reduced b
y 10 % for every 1 000 metres of altitude.
Refer to the "Technical Data" section for details
of the weights and towed loads which apply to your vehicle.
Side wind
)Take into account the increased sensitivity
to side wind.

Cooling

Towing a trailer on a slope increases the
temperature of the coolant.
As the fan is electrically controlled, its cooling capacity is not dependent on the engine speed.)
To lower the engine speed, reduce your speed.
The maximum towed load on a long inclinedepends on the gradient and the ambient
temperature.
In all cases, keep a check on the coolant
temperature.

Braking

To w i ng a trailer increases the braking distance.
To a v o i d o v e r h e a t i ng of the brakes on a long
mountain type of descent, the use of enginebraking is recommended.


Tyres
)Check the tyre pressures of the towing
vehicle and of the trailer, obser ving the recommended pressures.



Lighting
)Check the electrical lighting and signalling on the trailer.
)If the warning lamp and the
STOP warning lamp come on, stop the vehicle and switch off
t
he engine as soon as possible.

285
Technical data
WEIGHTS AND TOWED LOADS (in kg)
Petrol enginesVTi 120THP 155THP 160THP 200
GearboxesManualElectronic gearbox systemAutomaticManual
Model codes: NX...5FS05FV8/P5FMA5FU8


- Unladen wei
ght 1 2051 284 1 363
1 316



- Kerb weight 1 280
1 359
1 438
1 391



- Gross vehicle weight (GVW)
1 755

1 795

1 835

1 820



-
Gross train weight (GTW)
on a 12 % gradient
2 955
3 195

2 635

2 820



- Braked trailer
(within the GTW limit)
on a 12 % gradient 1 200
1 400
8001 000



- Braked trailer * (with load transfer within the
GTW limit) 1 4501 650 1 0001 250



- Unbraked trailer 640
680

715695



- Recommended nose weight
75

75
7575


*
The weight of the braked trailer can be increased, within the GTW limit, if the GV W of the towing vehicle is reduced by an equal amount. Warning:
towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.
The
GTW and towed load values indicated are valid up to a maximum altitude of 1 000 metres; the towed load mentioned must be reduced by 10 % for each additional 1 000 metres of altitude.
The speed of a towing vehicle must not exceed 60 mph (10 0 km/h) (comply with the legislation in force in your country).
High ambient temperatures may result in a reduction in the performance of the vehicle to protect the engine; if the ambient temperature is above 37 °C,
limit the towed load.

Technical data
WEIGHTS AND TOWED LOADS (in kg)
Diesel enginesHDi 90 PEFHDi 110 PEFe-HDi 110 PEFHDi 160 PEF
GearboxManualManualManualElectronic gearbox systemManual
Model codes:NX...9HP09HR89HR8/S9HR8/PSRHH8


- Unladen wei
ght 1 205 1 2901 295 1 3001 320



- Kerb weight 1 280 1 365
1 370 1 375
1 395


-
Gross vehicle weight (GVW)

1 765

1 805

1 8101 815
1 880



-
Gross train weight (GTW)
on a 12 % gradient
2 865
3 105
3 110
3 115
3 180



- Braked trailer
(within GTW limit) on 12 % gradient
1 100
1 300
1 300
1 300 1 300


- Braked trailer
*
(with load transfer with the
GTW limit)
1 3501 550
1 550
1 550
1 550



-
Unbraked trailer 640
680
680680695



- Recommended nose weight 75 75 75 75 75

*

The wei
ght of the braked trailer can be increased, within the GTW limit, if the GV W of the towing vehicle is reduced by an equal amount. Warning:
towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.
The
GTW and towed load values indicated are valid up to a maximum altitude of 1 000 metres; the towed load mentioned must be reduced by 10 % for each additional 1 000 metres of altitude.
The speed of a towing vehicle must not exceed 60 mph (10 0 km/h) (comply with the legislation in force in your country).
High ambient temperatures may result in a reduction in the performance of the vehicle to protect the engine; if the ambient temperature is above 37 °C,
limit the towed load.

301
04
""""""""""""ggggggggggNavigation guidanceNavigation guidanceNavigation guidanceNavigation guidanceNavigation guidanceNavigation - guidanceNavigation - guidanceNavigation - guidanceNavigation - guidanceNavigation guidanceNavigation guidanceNavigation guidanceNavigation guidanceN i ti idN i ti idN i ti idN i ti idN i ti idN i ti idN i ti idN i ti idN i ti idNi i id""""""""""""

To delete the list of recent destinations, select "Guidance options" in the navigation menu then select "Delete last destinations" and confi rm. Select "Ye s" then confi rm.
Deleting just one destination is not possible.


Go from the list to the menu (left/right).

NAVIGATION - GUIDANCE







Access to the "NAVIGATION" menu
Press NAV.
or


Contact a CITROËNdealer for mappingupdates.


A long press on the end of the lighting control stalk repeats the last navigation message.