seats Citroen DS4 RHD 2011.5 1.G Owner's Manual

MULTIFUNCTION
SCREENSCOMFORT ACCESS VISIBILITY
64Monochrome screenC
68 Colour screen and map
70Trip computer
78 Ventilation
80Manual air conditioning
82Dual-zone digital air conditioning
87 Rear screen demist - defrost
88 Front seats
92 Rear seats
93 Steering wheel adjustment
94 Mirrors
100 Remote control key
110 Alarm
113 Doors
115 Boot
116 Electric windows
118Fuel tank
120Misfuel prevention (Diesel)
124 Lighting controls
125 Daytime running lamps
128 Automatic illumination of headlamps
129Welcome lighting
130 Headlamp adjustment
131 Directional lighting
133 Wiper controls
13 4 Automatic rain sensitive
wipers
138Courtesy lamps
139Interior mood lighting
140 Boot lamp
004004005005002002003003

SAFETY DRIVING FITTINGS CHILD SAFETY
192Electric parking brake
200 Manual parking brake
201 Manual gearbox
202Gear effi ciency indicator
203 6 -speed electronic gearboxsystem
207 Automatic gearbox
211 Hill start assist
212Stop & Start
215 Blind spot sensors
219 Speed limiter
221Cruise control
223Parking space sensors
225 Parking sensors
172 Direction indicators
172 Hazard warning lamps
173 Horn
173 Emergency or assistance call
174 Tyre under-infl ation detection
176Braking assistance systems
17 7 Tr ajectory control systems(ESP)
179Front seat belts
183Airbags
160Child seats
166 ISOFIX child seats
169 Child lock
14 4 Interior fi ttings
15 0Front armrest
15 4Boot fi ttings
008008009009006006007007

Sitting comfortably
Head restraint height and angle
Front seats
Other functions available...
Lumbar massage.Heated seats.
90
1.
Releasing the adjustment mechanism. 2.Adjustment for height and reach. 3.Locking the adjustment mechanism.


Steering wheel adjustment
93

As a safety precaution, these operations must only be carried outwhen stationary.


Lumbar
91

35
Limit the causes of excess
consumption
Spread loads throughout the vehicle; placethe heaviest items in the bottom of the boot, as close as possible to the rear seats. Limit the loads carried in the vehicle andreduce wind resistance (roof bars, roof rack,bicycle carrier, trailer...). Use a roof box in preference. Remove roof bars and roof racks after use.


At the end of winter, remove snow tyres andrefit your summer tyres.



Observe the recommendations
on maintenance


Check the tyre pressures regularly, whencold, referring to the label in the door aperture, driver's side.
Carry out this check in par ticular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.


Have your vehicle ser viced regularly (engineoil, oil filter, air filter...) and obser ve theschedule of operations recommended bythe manufacturer.


When refuelling, do not continue after the 3 rdcut-off of the nozzle to avoid any overflow.

At the wheel of your new vehicle, it is only after the first 1 800 miles (3 000 kilometres) that you will see the fuel consumption settledown to a consistent average.
Switch off the headlamps and front foglamps when the level of light does not require their use.

Avoid running the engine before moving off,particularly in winter; your vehicle will warmup much faster while driving.

As a passenger, if you avoid connecting your multimedia devices (film, music, videogame...), you will contribute towards limitingthe consumption of electrical energy, and soof fuel. Disconnect your por table devices beforeleaving the vehicle.

Front seats Seat consisting of a seat cushion, a seat back and a head restraint which can all be adjusted to adapt your position for ease of driving and comfort.
Manual adjustments
Forwards-backwards adjustment
)Raise the control and slide the seatforwards or backwards.


Driver's or passenger's seat
height adjustment
) Pull the control upwards to raise or push
it downwards to lower, as many times as
necessary, to obtain the position required.

Seat back angle adjustment
)Turn the control knob to adjust the seat
backrest angle.




As a safety measure, seat adjustmentsshould only be done when stationary.

89Comfort











Front seats Seat consisting of a seat cushion, a seat back and a head restraint which can all be adjusted to
adapt your position for ease of driving and comfort.


Driver's seat electric adjustments


Forwards-backwards adjustment
)Push the control forwards or rearwards toslide the seat.
Seat cushion height and angle adjustment
)
Tilt the rear par t of the control upwards or
downwards to obtain the required height.) Tilt the front part of the control upwards or
downwards to obtain the required an
gle.

Seat back angle adjustment
)
Tilt the control forwards or rearwards to
adjust the angle of the seat back.

The electrical functions of the driver's seat are deactivated approximately one minute after the ignition is switched off.

To reactivate them, switch on the ignition.

Heated seats control
With the engine running, the front seats can be heated separately.)Use the adjustment dial, placed on the side
of each front seat, to switch on and select
the level of heating required: 0:


Off.1:Low.2:Medium. 3:
High.
Additional adjustments
Head restraint height and angle adjustment
)To raise a head restraint, pull it upwards.)To remove the head restraint, press thelug A
and pull the head restraint upwards.)To put the head restraint back in place, engage
the head restraint stems in the openings
keeping them in line with the seat back.)To lower the head restraint, press the lug A
and the head restraint at the same time.)To a djust the angle of the head restraint, tilt its lower part forwards or rearwards.
The head restraint is fitted with a framewith notches which prevents it fromlowering; this is a safety device in caseof impact. The adjustment is correct when theupper edge of the head restraint is level with the top of the head.Never drive with the head restraintsremoved; they must be in place andadjusted correctly.

Rear seats
)Move the corresponding front seat forwardif necessary. )Position the seat belt between the outer and centre head restraints to avoid trapping
the belt when repositioning the seat backrest. )Place the head restraints in the lowposition.
Folding the backrest
) Pull control 1
forwards to release the seat
back 2
. )
Fold the seat back 2
on to the cushion.

)Straighten the seat back 2and secure it. )Check that the red indicator, located next
to the control 1, is no longer visible. )Put the seat belt back in place on the sideof the seat backrest.

Repositioning the seat backrest

When repositioning the seat backrest, take care not to trap the seat belts.

115
Access

















Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Tailgate release
Unlocking
)
Fold back the rear seats to gain access to
the lock from inside the boot. ) Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )
Move the latch to the left.
)After unlocking the boot or the vehicle
using the remote control or the key, press
the openin
g control, then raise the tailgate.

Opening Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate
to fully close it.
-
when the engine is running,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,
- when the vehicle is moving
(speed above6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal andthe display of an aler t message for a fewseconds.



Locking after closing

If the fault persists after closing again, the boot
w
ill remain locked. If the tail
gate is not closed correctly:

Automatic adjustment of xenon headlamps
Do not touch the xenon bulbs. Contact a CITROËN dealer or a
qualified workshop. This s
ystem adjusts the height of the xenon
headlamp beams automatically and when
stationary, according to the load in the vehicle, so
as to avoid causing a nuisance to other road user.
I
f a malfunction occurs, this
warning lamp is displayed in the
instrument panel, accompanied byan audible signal and a message in the screen.
The system then places your headlamps in the lowest position.







Manual adjustment
of halogen
headlamps
To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according to the load in the
vehicle.0.1 or 2 people in the front seats. -.3 people.1. 5 people.-.Intermediate setting. 2.
5 people + maximum authorised load. -.Intermediate setting. 3.
Driver + maximum authorised load.
The initial setting is position "0".