seats Citroen DS4 RHD 2013.5 1.G Owner's Manual

MULTIFUNCTION
SCREENSCOMFORT ACCESS VISIBILITY
64 Monochrome screen C
68 Colour screen
70 Tr i p c o m p u t e r78 Ventilation
80 Manual air conditioning
82 Dual-zone digital air
conditioning
86 Front demist - defrost
87 Rear screen demist - defrost
88 Front seats
92 Rear seats
93 Steering wheel adjustment
94 Mirrors100 Remote control key
110 Alarm
113 Doors
115 Boot
116 Electric windows
118 Fuel tank
121 Misfuel prevention
(Diesel)124 Lighting controls
125 Daytime running lamps
128 Automatic illumination of
headlamps
129 Welcome lighting
130 Headlamp adjustment
131 Directional lighting
133 Wiper controls
13 4 Automatic rain sensitive
wipers
138 Courtesy lamps
139 Interior mood lighting
14 0 Boot lamp
004004005005002002003003

SAFETY DRIVING FITTINGS CHILD SAFETY
194 Electric parking brake
202 Manual parking brake
203 Manual gearbox
204 Electronic gearbox
208 Automatic gearbox
212 Hill start assist
213 Gear effi ciency indicator
214 Ty r e u n d e r- i nfl ation detection
216 Stop & Start
219 Blind spot sensors
223 Speed limiter
225 Cruise control
227 Parking space sensors
229 Parking sensors 176 Direction indicators
176 Hazard warning lamps
17 7 Horn
17 7 Emergency or assistance
call
178 Braking assistance systems
179 Trajectory control systems
(ESP)
181 Front seat belts
185 Airbags 160 Child seats
162 Deactivating the passenger's
front airbag
169 ISOFIX child seats
173 Child lock 14 4 Interior fi ttings
15 0 Front armrest
15 4 Boot fi ttings
008008009009006006007007

Sitting comfortably


Head restraint height and angle


Front seats


Other functions available...

Lumbar massage.
Heated seats.

90



1.
Releasing the adjustment mechanism.

2.
Adjustment for height and reach.

3.
Locking the adjustment mechanism.


Steering wheel adjustment


93

As a safety precaution, these
operations must only be carried out
when stationary.

Lumbar


91

35

As a passenger, if you avoid connecting
your multimedia devices (film, music, video
game...), you will contribute towards limiting
the consumption of electrical energy, and so
of fuel.
Disconnect your portable devices before
leaving the vehicle.



Limit the causes of excess
consumption

Spread loads throughout the vehicle; place the
heaviest items in the bottom of the boot, as
close as possible to the rear seats.
Limit the loads carried in the vehicle and
reduce wind resistance (roof bars, roof rack,
bicycle carrier, trailer...). Use a roof box in
preference.
Remove roof bars and roof racks after use.

At the end of winter, remove snow tyres and
refit your summer tyres.



Observe the recommendations
on maintenance

Check the tyre pressures regularly, when
cold, referring to the label in the door
aperture, driver's side.
Carry out this check in particular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the tyres on
any trailer or caravan.

Have your vehicle ser viced regularly (engine
oil, oil filter, air filter...) and obser ve the
schedule of operations recommended by the
manufacturer.



When refuelling, do not continue after
the third cut-off of the nozzle to avoid any
over flow.
Switch off the headlamps and front foglamps
when the level of light does not require their
use.

Avoid running the engine before moving off,
particularly in winter; your vehicle will warm
up much faster while driving.

At the wheel of your new vehicle, it is only after
the first 1 800 miles (3 000 kilometres) that you
will see the fuel consumption settle down to a
consistent average.

Front seats
Seat consisting of a seat cushion, a seat back and a head restraint which can all be adjusted to
adapt your position for ease of driving and comfort.


Manual adjustments


Forwards-backwards




Raise the control and slide the seat
for wards or backwards.



Driver's or passenger's seat
height



Pull the control upwards to raise or push
it downwards to lower, as many times as
necessary, to obtain the position required.



Seat backrest angle




Turn the control knob to adjust the seat
backrest angle.


As a safety measure, seat adjustments
should only be done when stationary.

89Comfort











Front seats
Seat consisting of a seat cushion, a seat backrest and a head restraint which can all be adjusted to
adapt your position for ease of driving and comfort.


Driver's seat electric adjustments


Forwards-backwards




Push the control for wards or rear wards to
slide the seat.



Cushion height and angle




Tilt the rear part of the control upwards or
downwards to obtain the required height.


Tilt the front part of the control upwards or
downwards to obtain the required angle.



Seat backrest angle




Tilt the control for wards or rear wards to
adjust the angle of the seat backrest.


The electrical functions of the driver's seat
are deactivated approximately one minute
after the ignition is switched off.
To reactivate them, switch on the ignition.

Heated seats control

With the engine running, the front seats can be
heated separately.



Use the adjustment dial, placed on the side
of each front seat, to switch on and select
the level of heating required:

0:


Off.

1

:
Low.

2

:
Medium.

3

:
High.











Additional adjustments


Head restraint height and angle




To raise a head restraint, pull it upwards.


To lower the head restraint, press the lug A

and the head restraint at the same time.


To adjust the angle of the head restraint, tilt
its lower part for wards or rear wards.

The head restraint is fitted with a frame
with notches which prevents it from
lowering; this is a safety device in case
of impact.

The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.




Removing a head restraint




To remove the head restraint, press the
lug A
and pull the head restraint upwards.


To put the head restraint back in place,
engage the head restraint stems in the
openings keeping them in line with the seat
back and press the lug A
at the same time.


Never drive with the head restraints
removed; they must be in place and
adjusted correctly.

Rear seats
Bench seat with fixed one-piece cushion and split backrest (left hand 2/3, right hand 1/3) which can be folded individually to adapt the load space in the boot.



Move the corresponding front seat for ward
if necessary.


Position the seat belt between the outer
and centre head restraints to avoid
trapping the belt when repositioning the
seat backrest.


Place the head restraints in the low
position.

Folding the backrest



Pull control 1
for wards to release the seat
back 2
.


Fold the seat back 2
on to the cushion.



Straighten the seat back 2
and secure it.


Check that the red indicator, located next
to the control 1
, is no longer visible.


Put the seat belt back in place on the side
of the seat backrest.


Repositioning the seat backrest

When repositioning the seat backrest,
take care not to trap the seat belts.

11 5Access

















Boot

System allowing the mechanical unlocking
of the boot in the event of a battery or central
locking system malfunction.






Ta i l g a t e r e l e a s e


Unlocking




Fold back the rear seats to gain access to
the lock from inside the boot.


Insert a small screwdriver into hole A
of the
lock to unlock the tailgate.


Move the latch to the left.



After unlocking the boot or the vehicle
using the remote control or the key, press
the opening control, then raise the tailgate.



Opening
Closing




Lower the tailgate using the interior grab
handle.


If necessary, press down on the tailgate to
fully close it.


- when the engine is running
,
this warning lamp comes on,
accompanied by the display of an
alert message for a few seconds,

- when the vehicle is moving
(speed above
6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
the display of an alert message for a
few seconds.



Locking after closing

If the fault persists after closing again, the boot
will remain locked.
If the tailgate is not closed correctly:

Automatic adjustment of xenon headlamps

Do not touch the xenon bulbs.
Contact a CITROËN dealer or a
qualified workshop. This system adjusts the height of the xenon
headlamp beams automatically and when
stationary, according to the load in the vehicle, so
as to avoid causing a nuisance to other road user.
If a malfunction occurs, this
warning lamp is displayed in the
instrument panel, accompanied by
an audible signal and a message in the screen.
The system then places your headlamps in the
lowest position.






Manual adjustment
of halogen
headlamps

To avoid causing a nuisance to other road
users, the height of the halogen headlamps
should be adjusted according to the load in the
vehicle.

0.
1 or 2 people in the front seats.

-.
3 people.

1.
5 people.

-.
Intermediate setting.

2.
5 people + maximum authorised load.

-.
Intermediate setting.

3.
Driver + maximum authorised load.
The initial setting is position "0"
.