bulb Citroen DS5 2012 1.G Owner's Manual

005005006006007007008008SAFETY
PR ACTICAL
INFORMATION CHILD SAFETY VISIBILITY
132 Lighting controls
135Daytime running lamps
136Automatic illumination of headlamps
137Automatic headlamp dipping
140Headlamp adjustment
141Directional lighting
143 Wiper controls
145Automatic rain sensitive
wipers
147 Courtesy lamps
148Interior mood lighting
152 Child seats
158 ISOFIX child seats
161Child lock
164 Direction indicators
165Emergency or assistance call
165
Horn
166Tyre under-infl ation detection
167 ESP system
170 Seat belts
173 Airbags
180 Te m p o r a ry puncture repair
kit
186Changing a wheel
193Changing a bulb
201 Changing a fuse
20412 V battery
207 Energy economy mode
208Changing a wiper blade
209Towing the vehicle
210 Towing a trailer
212Fitting roof bars
213 Accessories

Manual adjustment
of halogen
headlamps







Automatic adjustment of xenon
headlamps
To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according to the load in the
vehicle.0.1 or 2 people in the front seats. -.Intermediate setting. 1. 5 people + maximum authorised load. -.Intermediate setting. 2.
Driver + maximum authorised load. -.Intermediate setting. 3.
5 people + maximum load in the boot.

The initial setting is position "0".
If a fault occurs, this warning lamp is displayedin the instrument panel,
accompanied by an audible signal and a
message in the instrument panel screen.
The s
ystem then places your headlamps in the lowest position.
In order to avoid causing a nuisance to other road users, this system corrects the height of the
xenon headlamps beam automatically and when
stationary, in relation to the load in the vehicle.

If a fault occurs, do not touch the xenonbulbs. Contact a CITROËN dealer or aqualified workshop.

193Practical information











Changing a bulb
Front lamps
Model with xenon headlamps
1.Main beam headlamps (H1- 35W).2.Directional dipped/directional
headlamps(D1S-35W).3.Daytime running lamps/sidelamps(light emitting diodes - LEDs).4.Direction indicators (HY21-21W).5.Directional foglamps(H11).
Model with halogen headlamps
1.Main beam headlamps (H1- 55W).2.
Dipped beam headlamps (H7-55W).3.Daytime running lamps/sidelamps
(Light emitting diodes - LEDs).4.Direction indicators (HY21-21W).5.Directional foglamps(H11).
For H7 type bulbs with lugs... take care to observe their correct installation so asto ensure the best lighting performance.

In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal surface of the glass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.


Risk of electrocution

Xenon bulbs (D1S-35W) must bereplaced by a CITROËN dealer or aqualified workshop.

(xenon model)
) Remove the protective plastic cover by
pulling on the tab.) Remove the connector with the bulb bypressing on the lug at the bottom. )
Remove the bulb and change it.
For reassembly, carry out these operations in reverse order.
The headlamps are fitted withpolycarbonate glass with a protectivecoating:)do not clean them using a dryor abrasive cloth, nor with adetergent or solvent product,)use a sponge and soapy water, )when using a high pressure washer on persistent marks, do not keepthe lance directed towards thelamps or their edges for too long,so as not to damage their protectivecoating and seals.
)Do not touch the bulb directly withyour fingers, use lint-free cloths. Changing a bulb should only be doneafter the headlamp has been switched off for a few minutes (risk of serious burns).
It is imperative to use only anti-ultraviolet (UV) type bulbs in order notto damage the headlamp. Always replace a failed bulb with a new bulb with the same type andspecification.
Dipped beam headlamps (xenon model)

D1S xenon bulbs must be changedby a CITROËN dealer or a qualifiedworkshop, as there is a risk of electrocution.
It is recommended that the D1S bulbsare changed at the same time when one of them fails.

Practical information
Dipped beam headlamps
(halogen model)





Main beam headlamps (halogen model)
)
Press on the top of the connector thenpivot the assembly downwards. )
Remove the connector with the bulb.)
Remove the bulb and change it.
For reassembly, carry out these operations in
reverse order, but engaging the bottom of thebulb first.

)
Remove the protective plastic cover by
pulling on the tab. )Remove the protective plastic cover bypulling on the tab.)Remove the connector with the bulb by pressing on the lug at the bottom. )Remove the bulb and change it.
For reassembly, carry out these operations in
r
everse order.

Daytime running lamps/sidelamps
For the replacement of this type of LED lamp and lighting guides, contact a CITROËN dealer
or a qualified workshop.

A replacement kit for the LEDs is available fromCITROËN dealers.
Direction indicators
Faster flashing of a direction indicator warning lamp (left or right) indicates a failed bulb on that side.

The direction indicator bulb is located below the front lamp.) Turn the bulb holder a quar ter turn and pull
it out.) Remove the bulb and change it.
For reassembly, carry out these operations in
reverse order.
You can also contact a CITROËN dealer or a
qualified workshop for the replacement of thesebulbs.

Practical information
Fr o nt f oglamps
) Remove the deflector under the body.)
Disconnect the bulb connector.)
Turn the bulb a quarter of a turn, withdraw
and change it.
To r e
fit, carry out these operations in reverseorder.
To replace these bulbs you may also contact a CITROËN dealer or a qualified workshop.
Integrated direction indicator
side repeaters Door mirror spotlamps
You should contact a CITROËN dealer or aqualified workshop for the replacement of thesebulbs.
Y
ou should contact a CITROËN dealer or a qualified workshop for the replacement of the
light emitting diode - LED.

1.Sidelamps(light emitting diodes - LEDs).2.Direction indicators (PY21W amber).3.Reversing lamps (P21W).4. Brake lamps (P21W).5.Foglamps (P21W).
Rear lamps
Direction indicators and brake
lamps (on the wings)
) Open the boot then remove the access cover.)
Disconnect the lamp connector. )
Remove the two lamp fixing nuts.
)Carefully remove the lamp unit from
outside. The retaining clips unclipautomatically. )Turn the bulb holder a quarter of a turn andchange the bulb.
For reassembly, carry out these operations in
reverse order.


Changing the light emittingdiode-LED lamps

For replacement, contact a CITROËN dealer or qualified workshop.

Practical information

Reversing lamp (tailgate)
)
Carefully remove the lamp from the
outside. The retaining clips unclip
automatically.) Turn the bulb holder a quarter of a turn and replace the bulb.
For reassembly, carry out these operations in reverse order.
Foglamp
)Open the tailgate.)Unclip the skir t of the lamp.)Remove the access cover and the lampfixing nut.
Access is by passing a hand under the bumper. ) Turn the bulb holder a quarter of a turn andpull it out.)
Change the bulb.
To r e f i t , c a r ry out these operations in reverseorder.
You can also contact a CITROËN dealer or a qualified workshop for the replacement of these bulbs.

Number plate lamps
) Insert a thin screwdriver into the slot in the lens.)
Push it outwards to unclip it.)
Remove the lens. )
Pull the bulb out and change it.


Third brake lamp(light emitting diodes - LEDs)
Contact a CITROËN dealer or qualified
workshop.